• Journal of Korean Society on Water Environment
• /
• v.27 no.2
• /
• pp.228-234
• /
• 2011

The goal of water quality management on stream and watershed is to focus not on discharged loads management but on a water quality management. Discharged loads management is not goal of water quality management but way for perform with total maximum daily loads management. It is necessary to estimate the relation between non-point source with stromwater runoff (NPSSR) and water quality to select a watershed where it is required to manage NPSSR for water quality improvement. To evaluate the effects of NPSSR on stream's water quality, we compare the aspects of water quality in dry and wet seasons using flow duration curve analysis based on flow rate variation data by actual surveying. In this study we attempt to quantify the variation characteristic of water quality and estimate the Inflow characteristic of pollution source with water quality and flow rate monitoring on 10 watersheds. We try to estimate water quality and flow rate by regression analysis and try again regression analysis with each high and low water quality data more than estimations. An analysis of relation between water quality and flow rate of 10 watersheds shows that the water quality of the Nonsan and the Ganggyeong streams had been polluted by NPSSR pollutants. Other eight streams were important point source more than NPSSR. It is wide variation range of $BOD_5$ also high average concentration of $BOD_5$. We have to quantify water quality variation by cv1 in wet season and cv365 in dry season with comparing the estimate of high water quality and low water quality. This method can be used to indicator for water quality variation according to flow rate.

• Journal of Korean Society on Water Environment
• /
• v.23 no.6
• /
• pp.889-896
• /
• 2007

From the direct outflow of Chungju Dam to the junction of water body and watershed in Paldang lake is the scope of this research. This study performed to investigate the main cause of water quality deterioration and the influenced region in the middle field range of the Namhan river Basin with the onsite measurement of water quality and flow rate simultaneously during spring dry season. The purpose of this study is to find out the time-spatial variation characteristics of water quality and flow rate. Following the flow direction $BOD_5$ and $COD_{Mn}$ concentration increased to the highest value of 3.7 mg/L, 5.9 mg/L at Wolgesa respectively. Chl.a concentration increased to $50mg/m^3$ or so at Kangsang, after that it decreased to $37mg/m^3$ at the junction of Paldang lake. Organic matter concentration variation trend showed similar than that of Chl.a. Also $BOD_5$ concentration tendency was similar to Chl.a in every measuring sites except Paldang lake mixing zone. The major factors of water quality deterioration in Namhan river and Paldang lake during dry season were algal bloom and followed internal production. High phosphorus load from Dalcheon and Seom river caused dry season algal bloom and internal production in transitional zone which was stagnant area in downstream of Namhan river.

• Asian-Australasian Journal of Animal Sciences
• /
• v.17 no.2
• /
• pp.283-300
• /
• 2004

Currently commercial dry sows are housed in individual stalls and subject to restricted feeding. These sows often show stereotypic behaviours which increase their maintenance energy requirement. Group housing is desirable to improve animal welfare and public perception. However, under restricted feeding systems, group-housed dry sows are also aggressive. The feed intake of these sows is variable, depending on their social rank, which results in different milk production and variable piglet performance. These problems can be solved by ad libitum feeding systems, but the large capacity of intake by dry sows will not allow this feeding system to be practical as high feeding level during pregnancy can reduce reproduction performance of sows. Current research indicates that feeding high fibre diets to dry sows enables sows to be fed ad libitum, but the effect of dietary fibre on feed intake and nutrient utilisation is dependent on the quality of fibre sources. Most research has focused on sugar beet pulp, straw, lucerne meal and by-products, but there is a need to identify and evaluate some widely available and cheap fibre materials and feed grains for developing the best strategy to control nutrient intake of dry sows while feeding ad libitum.

• Journal of Environmental Science International
• /
• v.5 no.3
• /
• pp.347-359
• /
• 1996

A study was carried out on the distribution of chlorophyll a and water quality in the dry season in Yosuhae bay and adjoining sea, Southern Korea, in July of 1994. Concentration of salinity and phosphate were lower in the outer bay than in the inner bay. While nitrate and silicate were higher in the former than in the latter. We were identified with coastal waters of origin from China with the lower salinity in outer bay. The China coastal water was characteristic of high nutrients and phytoplankton biomass, such as chlorophyll a. The principal component analysis-(PCA) on the analytical data proved that high density of phytoplankton biomass , occurred under the condition of low salinity and high concentration of nissoived Inorganic nutrients. It is thought that the thermoharine structure and biological produtions of Yosuhae bay were controlled by the China coastal water in the outer bay.

• Plant Resources
• /
• v.7 no.3
• /
• pp.206-210
• /
• 2004

In order to find out the optimum harvest (dipping) date combined with sowing date on yield and nutrient quality of forage rye which is suitable at the Southern part of Korea, Paldanghomil variety was grown Sep. 2001 to May 2002 at Sunchon National University, and yield and nutrient quality of plant were observed. As harvest date and sowing date were delayed, the plant length was longest, number of leaves per plant was increased in the time of May 20 clipping. Fresh yield was the heaviest in the time of May 20 clipping and Oct. l0 sowing, and the most dry matter yield was the heaviest in the time of May 20 clipping and Oct. 10 sowing. Content of crude protein was the highest and that of crude fiber such as NDF, ADF, hemicellulose, cellulose and lignin were the lowest in the late time of clipping and sowing. Further more IVDMD was high and dry matter yield and digestible dry matter yield were the highest in the time of May 20 dipping and Oct. 10 sowing. Judging from the results reported above, at optimum harvest (dipping) date combined with sowing date for yield and nutrient quality of forage rye seemed to be the time of May 20 clipping and Oct. 10 sowing.

• Journal of the Korean institute of surface engineering
• /
• v.50 no.5
• /
• pp.373-379
• /
• 2017

Dry processes like evaporation and sputtering in vacuum chamber are difficult to make a uniform, large area and high quality film on thin PET substrate because of PET degradation and bad adhesion. On the other hand, wet processes like electro or electroless plating have complex processes and require high environmental cost. In this study, we successfully prepared $2{\mu}m$ Zn/Cu/Ni multilayers coated on $12{\mu}m$ polyethylene terephthalate (PET) substrate by using dry-wet mixing processes. Their surface electric resistances were evaluated around $0.2{\Omega}$ by using 4 probe measurements. Furthermore, their corrosion resistance also evaluated by natural potential test and compared with other wet, dry and mixing process samples.

• Journal of Ginseng Research
• /
• v.28 no.4
• /
• pp.165-172
• /
• 2004

Ginseng is traditionally cultivated worldwide in cold continental climates. It is now also being cultivated in maritime environments such as New Zealandis. This paper reports a number of growth and quality parameters for plants grown under those conditions over two growing seasons and the intervening winter dormant period. While shoot biomass peaked mid-summer, in contrast, root biomass peaked late autumn/early winter. Starch, sucrose, fructose, glucose and inositol were detected in the roots. Starch concentrations were highest in early autumn (mean 470 mg $g^{-1}$ dry weight) and lowest in mid spring (218 mg $g^{-1}$ dry weight). Sucrose concentrations were low during early summer until late autumn but increased rapidly with the onset of winter and peaked during mid spring (168 mg $g^{-1}$ dry weight). Fructose and glucose concentrations were similar and peaked in late spring (5.3 and 6.2 mg $g^{-1}$ dry weight). Inositol concentrations peaked in mid summer (1.7 mg $g^{-1}$ dry weight). Starch/sugar ratios were high during summer and autumn and low during winter and spring. Ginsenoside concentrations and profiles showed that the six major ginsenosides, Rgl, Re, Rb1, Rc, Rb2 and Rd, were present, but Rf was absent. Concentrations did not vary with sampling date. The most abundant ginsenosides were Re (15.9 to 17.5 mg $g^{-1}$ dry weight) and Rb1 (10.7 to 18.1 mg $g^{-1}$ dry weight). Combined, they accounted for < $75{\%}$ of total ginsenoside concentrations. Limited taste tests indicated that highest root quality occurred during late autumn, after the shoots had senesced. However, quality could not be related to plant chemistry.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2004.10a
• /
• pp.238-244
• /
• 2004

This research conducted milling tests to study effects of cutting environment conditions of ball end milts on the characteristics of high speed milling cutting process. KP4 steels and STD11 heat treated steels were used as the workpiece and WC-Co ball end mill tools with TiAIN coated were utilized in the cutting tests. Dry cutting without coolant and semidry cutting using botanical oil coolant by the MQL(Minimum Quantity Lubricant) device were conducted. Cutting forces, tool wear and surface roughness were measured in the cutting tests. Results showed that MQL spray cutting of KP4 and hardened STD11 specimens produced better surface quality and wear performance than dry cutting did.

• Proceedings of the Korean Institute of Resources Recycling Conference
• /
• 2006.09a
• /
• pp.3-12
• /
• 2006

The main feature of these total technologies is that we can constitute the optimum treatment scheme fitting to the property of wastes, amount of wastes and energy requirement. For high moisture content wastes or biomass resources, high pressure steam process (MMCS) for crush, dry and deodorize wastes to produce high quality fertilizer of fuel is most appropriate. For dry or semi-dry solid wastes, the STAR-MEET system can be applied to produce low-BTU gases for power generation using duel fueled diesel engines of Stirling engines, and the REPRES and HyPR-MEET systems can be applied to produce hydrogen rich medium-BTU gas. For waste plastics and oils, liquefaction technology is best fit to produce light oil or kerosene equivalent fuel oils. These total technologies are completely different from the existent waste treatment technologies based on land-filling or incineration, and are expected to disseminate all over the world in the near future.

• Journal of the Korean Society of Tobacco Science
• /
• v.20 no.1
• /
• pp.26-32
• /
• 1998

This study was conducted to obtain the basic information on the burley tobacco (Nicotiana tabacum L.) curing methods. The effects of the three kinds of curing methods on the dry weight losses during curing, chemical contents and physical properties of cured leaves, and organoleptic and smoking qualities were observed. The dry weight losses during curing was the highest in the stalk curing, and the lowest in the conventional priming. The longer the curing periods was, the more the loss of dry weight. The percent of the excessive dried leaves was high and the price per kilogram was low in the conventional priming. The chemical contents and the physical properties of the cured leaves in the conventional priming were similar to those of yellowing or browning stage of curing. But, the chemical contents and the physical properties of the cured leaves in the stalk curing were comparable to those of the air curing. The smoking quality was the best in the stalk curing.