• Journal of the Korean Vacuum Society
• /
• v.8 no.4A
• /
• pp.397-402
• /
• 1999

The base pressure of the vacuum vessel of KSTAR tokamak is to be ultra high vacuum, $10^{-6}\sim10^{-7}Pa$, to produce a clean plasma with low impurity concentrations. For this purpose, vessel and plasma facing components need to be baked up to $250^{\circ}C$, $350^{\circ}C$ respectively to remove impurities from the plasma-material interaction surfaces. Here the required heating power to be supplied for baking has been calculated according to pre-assumed different temperature profiles (baking scenario and proper baking plan for KSTAR tokamak has been proposed. Mass flow rate and temperature of nitrogen gas for baking has also been calculated.

• Nuclear Engineering and Technology
• /
• v.50 no.8
• /
• pp.1412-1420
• /
• 2018

An experiment was performed using the large-scale test facility (LSTF), which simulated a 1% vessel upper head small-break loss-of-coolant accident with an accident management (AM) measure under an assumption of total-failure of high-pressure injection (HPI) system in a pressurized water reactor (PWR). In the LSTF test, liquid level in the upper head affected break flow rate. Coolant was manually injected from the HPI system into cold legs as the AM measure when the maximum core exit temperature reached 623 K. The cladding surface temperature largely increased due to late and slow response of the core exit thermocouples. The AM measure was confirmed to be effective for the core cooling. The RELAP5/MOD3.3 code indicated insufficient prediction of primary coolant distribution. The author conducted uncertainty analysis for the LSTF test employing created phenomena identification and ranking table for each component. The author clarified that peak cladding temperature was largely dependent on the combination of multiple uncertain parameters within the defined uncertain ranges.

• Korean Journal of Pharmacognosy
• /
• v.17 no.4
• /
• pp.263-271
• /
• 1986

In order to investigate experimentally the clinical effects of Taeksa-Tang that was prescribed to cure the severe dizziness, the water extract of Taeksa-Tang was experimented about the effects on the diuretic action, the serum lipid, the isolated ileum and heart, the blood vessel, the blood pressure and respiration. The results of this study were obtained as follows: The diuretic action was significantly shown in rabbits. The level of total cholesterol, triglyceride and phopholipid in serum of rabbits given high cholesterol diet were significantly decreased. The contraction of the isolated ileum of mice induced by acetylcholine chloride and barium chloride was remarkably inhibited. The vasodilating and hypotensive actions were noted in rabbits. Negative inotropic action on the isolated frog heart was recognized.

• Applied Biological Chemistry
• /
• v.34 no.4
• /
• pp.334-338
• /
• 1991

Synthesis of $(D-Phe^7\;-Leu^8)$ bradykinin and bradykinin by solid phase method using a new reaction vessel was carried out. Coupling was performed by dicyclohexylcarbodiimide. After cleavage with dried HBr the peptides were purified by high pressure liquied chromatography. Their purify was assayed by paper and thin layer chromatography, melting point and amino acid analysis. $(D-Phe^7\;-Leu^8)$ bradykinin and bradykinin were incubater in vitro endopeptidase $({\alpha}-chymotrysis)$ and exopeptidase(carboxypeptidase A, leucine aminopeptidase) in order to study the degradation pattern of peptides. $(D-Phe^7\;-Leu^8)$ bradykinin and bradykinin were rapidly degradated by ${\alpha}-chymotrypsin$ and carboxypeptidase A $(D-Phe^7\;-Leu^8)$ bradykinin and bradykinin coution$(D-Phe^7\;-Leu^8)$ bradykinin and bradykinin contain imino peptide bound from proline at N-terminal and therefore they were not attacted by leucine aminopeptidase.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2008.10a
• /
• pp.141-144
• /
• 2008

Geological storage of carbon dioxide has been studying in advanced countries to reduce greenhouse gases and a pilot site for geological storage is also in operation in the deep saline aquifer. Seismic wave and electrical resistivity tomography methods are applicable to monitoring techniques and they are used to evaluate the distribution range and behavior of the carbon dioxide injected in the porous sandstone formations. This paper describes the construction of an experimental apparatus which consists of a high pressure vessel and a measurement system for geological storage of carbon dioxide. The experiment apparatus will be used to measure seismic velocities and resistivities during the injection of carbon dioxide at the supercritical phase in the porous sandstones.

• Special Issue of the Society of Naval Architects of Korea
• /
• 2011.09a
• /
• pp.112-116
• /
• 2011

The noise analysis is usually carried out in the early structure design stage for the main areas in a vessel such as an accommodation, an engine room, HVAC System and etc. If the analysis results are higher than the noise limits based on guideline, appropriate countermeasures are established to reduce noise levels and applied to the vessel. But excessive noise induced the main or auxiliary equipment and high pressure steam system is very difficult to check in the initial design stage, and local noise problems frequently appear in actual vessels. This paper deals with excessive noise of the engine control room on LNG carrier. It includes the cause analysis of excessive noise, the countermeasure, and verification. Also, it proves suitability of the countermeasure through the on-board test.

• Archives of Plastic Surgery
• /
• v.42 no.2
• /
• pp.150-158
• /
• 2015

Background Fat is widely used in soft tissue augmentation. Nevertheless, it has an unpredictably high resorption rate. Clinically, external expansion with negative pressure is used to increase fat graft survival. In this study, fat graft recipient sites were preconditioned by external application of negative pressure in order to test for improvements in vascularity and fat graft survival. Methods Negative pressure was applied randomly to either the left or right dorsal ear of 20 New Zealand male white rabbits at a pressure of -125 mm Hg. The negative pressure was removed one week after the skin perfusion was measured. The skin flap at each ear was elevated, and 1 g of fat was grafted above the dorsal perichondrium. After one week, the fat weight, microvessel density, mature vessel density of the skin and fat, and amount of glycerol released were measured. Three months after the grafting, the same measurements were performed, with the exception of glycerol release. Results The fat survival rate of the experimental group ($75.4%{\pm}3.9%$) was higher than that of the control group ($53.1%{\pm}4.3%$) (P<0.001). Skin perfusion was higher in the experimental group. The glycerol release in the experimental group was significantly higher than in the control. The microvessel density of the skin and fat was significantly higher in the experimental group. Three months after the grafting, the skin and fat mature vessel density was significantly higher in the experimental groups. Conclusions Negative pressure prior to fat grafting increased the vascularity of the recipient site, and, accordingly, enhanced fat graft survival.

• Transactions of the Korean Society of Machine Tool Engineers
• /
• v.10 no.4
• /
• pp.7-13
• /
• 2001

This Study is to investigate the influence of weld residual stresses on the fatigue crack growth behaviors in pressure ves-sel reinforcement. In order to perform this study, the automatically welded specimens are prepared. The material is ASTM A516 grade 60 steel used in pressure vessel mainly. For pad-on-plate of skip welding continuous welding and PWHT specimen, fatigue crack initiation is generally initiat-ed at weld starting and end toe zone, and ruptured at weld starting toe zone, Fatigue life if pad-on-plate continuous speci-men is increased more than that of pad-on-plate skip fillet welding specimene about 85% under low load, about 20% under high load, and decreased than that of two-pad continuous welding specimen about 85%. In da/dN-$\Delta$ Κ curve under low load, pad-on-plate skip fillet welding specimen showed retardation on the initial crack, and the fatigue crack growth rate at the low region of $\Delta$Κ greater specimene E(3.8{\times}10^{-6}$mm/cycle). And the fatigue life of welding specimen was smaller than that of PWHT specimen.

• Journal of the Korean Society of Safety
• /
• v.32 no.2
• /
• pp.1-6
• /
• 2017

Modern society has been experiencing by population growth and urbanization that bring, a change of eating habits which has occurred a various types of waste in a large amount. Even though these wastes are required an immediate treatment with difficulties unsanitary handling and existing waste treatment method are by incineration, fermentation, drying and etc. however a bad smell occurs after the treatment that need's a lot of energy in processing organic wastes with high moisture contents and wasteful and inefficient problem. The strength assessment of the organic waste agitating vessel is required in terms of safety due to the differences of loading on the shaft that was treated by agitating the mixture of food waste. The damage of agitating axis is depended on steam pressure, temperature condition and the force moment that exerted by the food waste. Thus the strength assessment and stability evaluation are very important, especially to handle a hard waste. In this study the rotation capacity of agitation is about 5 tons considering general structural rolled steel pressure vessel strength and steam pressure. The purpose is to estimate the safety and strength evaluation for a agitator axis and impellers according to the rotating angle of the axis under the condition of the 3.2 ton capacity reactor.

• Archives of Plastic Surgery
• /
• v.39 no.4
• /
• pp.417-421
• /
• 2012

We present a case of a near total amputation at the distal tibial level, in which the patient emphatically wanted to save the leg. The anterior and posterior tibial nerves were intact, indicating a high possibility of sensory recovery after revascularization. The patient had open fractures at the tibia and fibula, but no bone shortening was performed. The posterior tibial vessels were reconstructed with an interposition saphenous vein graft from the contralateral side and a usable anterior tibial artery graft from the undamaged ipsilateral distal portions. The skin and soft tissue defects were covered using a subatmospheric pressure system for demarcating the wound, and a latissimus dorsi myocutaneous free flap for definite coverage of the wound. At 6 months after surgery, the patient was ambulatory without requiring additional procedures. Replantation without bone shortening, with use of vessel grafts and temporary coverage of the wound with subatmospheric pressure dressings before definite coverage, can shorten recovery time.