• Journal of Advanced Marine Engineering and Technology
• /
• 제33권6호
• /
• pp.896-902
• /
• 2009

EGR is applied in order to lower temperature of combustion chamber by using the specific heat of carbon dioxide in engine exhaust gas. However, the problem of EGR system in diesel engine is high PM concentration. Combined EGR system can be reduced it by mixing exhaust gas of gas engine into the intake air of diesel engine. This experimental study was designed for EGR system for both engines use. The results of EGR experimental study by using diesel engine and gas engine are as follows. 1) The pressure of combustion and rate of heat release decreased. 2) The specific fuel consumption increased. But, up to middle load, it little increased. 3) NO concentration has decreased up to 50% in almost all combustion area. 4) The variation of the PM concentration at low load is not so seen. But at high load, PM increased rapidly when concentration of oxygen is decreased and most of it caused the increasing of Dry Soot.

• 반도체디스플레이기술학회지
• /
• 제17권4호
• /
• pp.37-41
• /
• 2018

$Y_3A_{l5}O_{12}:Ce^{3+},Pr^{3+}$ single crystal phosphor was prepared by floating zone method. single crystal was confirmed to have a Ia-3d (230) space group of cubic structure and showed regular morphology. The optical properties, single crystal exhibited a emission band from green, yellow wide wavelength and 610nm, 640nm red wavelength vicinity. The luminance maintenance rate was decreased by phonon with increasing temperature, but high luminance is maintained more than powder phosphor. In addition, $Y_3A_{l5}O_{12}:Ce^{3+},Pr^{3+}$ single crystal phosphor was applied to a high power blue laser diode, we implemented high power white laser lightings. and it was confirmed that thermal properties over time, due to the effective heat transfer of complete crystal structure. We confirmed that excellent radiant heat properties than powder phosphor was applied to a high power white laser diode.

• 한국수소및신에너지학회논문집
• /
• 제30권5호
• /
• pp.436-447
• /
• 2019

The circulating fluidized bed boiler has an advantage that can burn a variety of fuels from low-grade fuel to coal. In this study, for the design of a circulating fluidized bed boiler using wood pellets, a circulating fluidized bed combustion test device using no external heater was manufactured and used. According to the increase of co-combustion rate with wood pellet, combustion fraction and heat flux by combustor height were measured and pollutant emission characteristics were analyzed. In terms of combustibility, the effect on primary and secondary air ratio were also studied. In addition, as a result of analysis of the effect of corrosive nanoparticles on the combustion of coal with wood pellets, it was confirmed that coal is mostly composed of Ca and S, whereas wood pellets are mostly composed of K, Cl, and Na.

• 한국화재소방학회논문지
• /
• 제34권2호
• /
• pp.22-29
• /
• 2020

본 연구에서는 개발 중인 현장지휘관 훈련 콘텐츠에 적용될 화재상황의 현실성 및 전문성 확보를 위하여 선행연구에서 선정한 7개 화재유형별 중 주거목적시설의 대표 가연물 화재실험을 통해 화재양상 및 열방출량, 연기발생량을 분석하였다. 측정결과 최대 열방출량은 소파가 728.6 kW로 가장 높게 측정되었으며, 다음으로는 매트리스+전기장판, 책상+의자, TV, 매트리스 순으로 나타났다. 총열방출량의 경우 소파가 226.2 MJ, 총 연기발생량은 경우 매트리스+전기장판이 2,259.5 ㎡로 가장 많이 발생하였다. 본 연구에서는 가연물의 화재양상 및 특성에 주안점을 두고 시험수행을 하였다는 한계점이 있으며, 추후 다양한 데이터 확보와 FDS를 활용한 시뮬레이션 평가가 이루어져야 할 것으로 판단된다.

• 대한기계학회논문집B
• /
• 제38권10호
• /
• pp.837-844
• /
• 2014

최근 자동차 제조사는 강화되는 배출가스 규제를 만족시키고 엔진 효율을 향상시키기 위해 다양한 기술을 연구하고 있다. 그 중 직접분사식 초희박 연소기술은 정밀한 연소제어를 통해 연소효율을 극대화 하고 연비를 향상시킬 수 있는 차세대 기술로 평가받고 있다. 기존 가스엔진에 초희박 직접분사기술을 적용하기 위해 기존의 MPI 엔진의 헤드를 재설계하였다. 기존 압축비10:1에서 12:1로 증가시킴으로써 이에 따른 압력선도, 열방출률, 연료소비율 등의 연소특성과 배출가스특성을 파악하였다. 압축비를 증가시킴에 따라 불안정한 연소상태로 인하여 연료소비율의 개선이 어려웠으나 탄화수소(THC)와 질소산화물(NOx)의 배출은 감소되었다.

• 한국자동차공학회논문집
• /
• 제14권2호
• /
• pp.114-120
• /
• 2006

The basic effects of hydrogen addition for engine performance and emission were investigated in single cylinder research engine. Seven commercial injectors were tested to choose a suitable injector for hydrogen injection prior to its engine implementation. The hydrogen fuel leakage and flow rate were evaluated for each injector and KN3-1(Keihin, CO.) showed the best performance for hydrogen fuel. At the higher excess air ratio(${\lambda}=1.7$, 2.0), the better combustion stability was found with hydrogen addition even though its effect was small at lower excess air ratio (${\lambda}=1.0$, 1.3). Stable operation of the engine was even guaranteed at ${\lambda}=2.0$, if the amount of hydrogen gas was near 15% of total energy. In the lean region, ${\lambda}>1.3$, thermal efficiency was improved slightly while it was not clearly observed at ${\lambda}=1.0$, 1.3. It is considered that, in some cases, high temperature environment due to hydrogen combustion caused further heat loss to surroundings. Except for ${\lambda}=1.0$, with larger amount of hydrogen addition, CO was reduced drastically but it was emitted more at the leaner region. Nitric oxides(NOx) was increased a little more with hydrogen addition at ${\lambda}=1.0$, 1.3. However, at ${\lambda}>1.3$ its relative amount of emission was low. In addition, the amount of NOx was continuously decreased with hydrogen addition, but, at ${\lambda}=2.0$ the amount of NOx was lowered to 1/100 of that of ${\lambda}=1.0$. THC emission was significantly increased as air/fuel ratio was raised to leaner region due to misfire and partial burn.

• Transactions on Electrical and Electronic Materials
• /
• 제17권3호
• /
• pp.139-142
• /
• 2016

β-AgVO₃ nanorods have been successfully synthesized using a soft chemistry route followed by heat treatment. They were characterized by X-ray diffraction and field emission scanning electron microscopy, and their electrochemical properties were investigated using cyclic voltammetry, impedance spectra, and charge-discharge tests. The results showed that the smooth-surfaced nanorods are very uniform and well dispersed, with diameters of ~100-200 nm and lengths of the order of several macrometers. The nanorods deliver a maximum specific discharge capacity of 275 mAh g^-1 at 30 mA g^-1. They also demonstrated good rate capability with a discharge capacity at the 100^th cycle of 51 mAh g^-1.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2014년도 제49회 KOSCO SYMPOSIUM 초록집
• /
• pp.103-106
• /
• 2014

The effects of hydrogen ($H_2$) ratio on combustion and emission characteristics in a $H_2/diesel$ dual-fuel engine were investigated. Dual-fuel strategy was applied to improve the control of combustion phasing. The combustion phasing was retarded with increasing $H_2$ fraction. This can be explained by both reduced diesel concentration and chemical effect of $H_2$, which reduce the heat release rate during the low temperature reaction stage. Hydrocarbon and carbon monoxide emissions of the engine were decreased drastically when $H_2$ ratio was increased.

• 한국자동차공학회논문집
• /
• 제10권1호
• /
• pp.17-23
• /
• 2002

In order to reduce exhaust emissions from diesel engine under wide operating range, an experimental study based on a new concept of combustion called HCDC(Homogeneous Charge Diesel Combustion) was conducted. In this concept, most of the fuel is supplied as premixed homogeneous charge and the rest is directly injected into a cylinder to ignite. In this study we compared combustion characteristics of an HCDC engine with those of conventional diesel engines. At high premixed fuel ratio and high load range, it was observed that premixed combustion heat release rate was low and diffusion combustion duration was shorten. from this experiment, it was found that NOx is reduced by the lower maximum temperature and soot is reduced by rapid combustion during diffusion combustion phase.

• 대한기계학회논문집B
• /
• 제32권7호
• /
• pp.513-517
• /
• 2008

A parametric study was made to understand the fundamentals of combustion of CNG fuel in a constant volume chamber in the respect of swirl effect, and the numbers of spark ignition. Optical devices were applied for the visualization of the physics of combustion, and combustion pressures and exhaust emission were measured at several equivalence ratios by controlling speeds of a swirling motor. When the speed of a swirling motor was raised the combustion conditions were improved. The corresponding maximum combustion pressure and heat release rate were increased and the speed of flame propagation was getting faster. This research may contribute to improve the performance of CNG engine and reduce emissions in future.