• Journal of Korean Society of Transportation
• /
• v.17 no.1
• /
• pp.187-196
• /
• 1999

The increasing interest in the use of Automated Speed Enforcement (ASE) systems in Korea enables to enforce speed violation by National Police Agency. We have analyzed the mechanism of ASE systems on traffic safety throughout Korea. 1 The data collected on a 2km road-section of each 32 ASE stations during one rear period indicate significant safety improvement. The results were (a) a decrease in the total number of accidents of 28%, (b) a decrease in the number of fatalities of 60%. 2. The study also that ASE systems are effective to reduce average speed, speed variance, and short headway. 3. Based on the operational data collected at 15 locations, an aggregate safety prediction model is proposed as a multiple regressions form. The primary operational variables that appear to affect the frequencies of accident are : average speed, speed variance, and the number of vehicles exceeding 30km/h of posted speed limit.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.41 no.2
• /
• pp.143-150
• /
• 2021

Roundabouts have been spreading out all over the world quickly with their attractions including capacity enhancement, safety increase and pollutant emission decrease. The history of Korean roundabout has already been 10 years. However, due to the accumulation of unclear right of way and insufficient data, the advantages of the roundabout are not fully utilized so far. Moreover, there are some differences in the capacity model of roundabouts compared to overseas capacity models. In addition, most research tend to concentrate in evaluation of roundabout performance using computer software. This paper, therefore, investigated overseas typical roundabout capacity models; empirical model and gap acceptance model, and then KHCM 2013 was compared to SIDRA model and USHCM 2010 model. It is expected that this paper will assist and guide practitioners in analyzing and estimating roundabout capacity more precise.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.8
• /
• pp.1074-1081
• /
• 2021

It has recently been noticed that the headway of unlicensed wireless technology is necessary as user's demands of wireless tech increase and the development of high-speed data service by using low-power short-range wireless network is needed. Hence, it is inevitable to study sharing and coexistence for broadband spectrum of diverse unlicensed application with wide bandwidth. In this paper, an interference examination between unlicensed WiFi (Wireless Fidelity) in the 6GHz and OB (Outside Broadcasting) system which is an incumbent service in the same frequency band was conducted and it suggests separation distance for the coexistence. Thus, MCL (Minimum Coupling Loss) and MC (Monte Carlo) methods were used to set up interference scenarios for the interference analysis and compute the separation distance between two systems according to the same frequency band and frequency separation.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.21 no.3
• /
• pp.73-82
• /
• 2022

Driver acceptance of autonomous driving is very important. The autonomous driving longitudinal controller, which is one of the factors affecting acceptability, consists of a high-level controller and a low-level controller. The host controller decides the cruise control and the space control according to the situation and creates the required target speed. The sub-controller performs control by creating an acceleration signal to follow the target speed. In this paper, we propose an algorithm to improve the inter-vehicle distance fluctuations that occur in the cruise control and space control switching problems in the host controller. The proposed method is to add an approach algorithm to the cruise control at the time of switching from cruise control to space control so that it is switched to space control at the correct switching distance. Through this, the error was improved from 12m error to 4m, and actual vehicle verification was performed.

• International Journal of Computer Science & Network Security
• /
• v.22 no.7
• /
• pp.315-319
• /
• 2022

Cloud computing has emerged to be the most effective headway for investigating crime especially cybercrime in this modern world. Even as we move towards an information technology-controlled world, it is important to note that when innovations are made, some negative implications also come with it, and an example of this is these criminal activities that involve technology, network devices, and networking that have emerged as a result of web improvements. These criminal activities are the ones that have been termed cybercrime. It is because of these increased criminal activities that organizations have come up with different strategies that they use to counter these crimes, and one of them is carrying out investigations using the cloud environment. A cloud environment has been defined as the use of web-based applications that are used for software installation and data stored in computers. This paper examines problems that are a result of cybercrime investigation in the cloud environment. Through analysis of the two components in play; cybercrime and cloud environment, we will be able to understand what are the problems that are encountered when carrying out investigations in cloud forensics. Through the use of secondary research, this paper found out that most problems are associated with technical and legal channels that are involved in carrying out these investigations. Investigator's mistakes when extracting pieces of evidence form the most crucial problems that take a lead when it comes to cybercrime investigation in the cloud environment. This paper not only flags out the challenges that are associated with cybercrime investigation in cloud environments but also offer recommendations and suggested solutions that can be used to counter the problems in question here. Through a proposed model to perform forensics investigations, this paper discusses new methodologies solutions, and developments for performing cybercrime investigations in the cloud environment.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.3D
• /
• pp.335-345
• /
• 2009

Generally, density is used as a measure of effectiveness (MOE) of the level of service (LOS) for the basic segment of the roadway facility, but can not express the operational condition of the roadway facility properly because there can be an error in the computed density compared with the density measured in the field. Thus, the purpose of this study is to investigate the real-time traffic characteristic data (traffic flow, speed, occupancy, headway, spacing, etc.) from the detectors installed on the mainline section of urban freeway under the study, analyze the maximum flow rate from the relationship between the real-time traffic characteristics collected, and evaluate the LOS criteria within the basic segment of the urban freeway based on the relationship between the occupancy and the v/c ratio depending on the level of service.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.23 no.1
• /
• pp.42-60
• /
• 2024

This study analyzed the characteristics of mixed traffic flows with autonomous vehicles on highway weaving sections and assessed the safety of vehicle-following pairs based on surrogate safety indicators. The intelligent driver model (IDM) was utilized to emulate the driving behavior of autonomous vehicles, and the weaving sections were divided into lengths of 300 and 600 meters for analysis within a micro-traffic simulation (VISSIM). Although significant differences were found in the average speed, density, and headway between the two sections through t-test results, no significant differences were observed when comparing the number of conflicts per indicator and the vehicle-following pair. Four safety indicators were selected for the mixed traffic evaluation based on their ability to represent risk levels similar to those perceived by drivers. The safety analysis, based on the selected four indicators, determined that autonomous vehicles following other autonomous vehicles were the safest pairing. Future research should focus on integrating these indicators into a single comprehensive index for analysis.

• International Journal of Computer Science & Network Security
• /
• v.23 no.12
• /
• pp.235-245
• /
• 2023

Smart applications based on the Network of Everything also known as Internet of Everything (IoE) are increasing popularity as network connectivity requires rise further. As a result, there will be a greater need for developing 6G technologies for wireless communications in order to overcome the primary limitations of visible 5G networks. Furthermore, implementing neural networks into 6G will bring remedies for the most complex optimizing networks challenges. Future 6G mobile phone networks must handle huge applications that require data and an increasing amount of users. With a ten-year time skyline from thought to the real world, it is presently time for pondering what 6th era (6G) remote correspondence will be just before 5G application. In this article, we talk about 6G dreams to clear the street for the headway of 6G and then some. We start with the conversation of imaginative 5G organizations and afterward underline the need of exploring 6G. Treating proceeding and impending remote organization improvement in a serious way, we expect 6G to contain three critical components: cell phones super broadband, very The Web of Things (or IoT and falsely clever (artificial intelligence). The 6G project is currently in its early phases, and people everywhere must envision and come up with its conceptualization, realization, implementation, and use cases. To that aim, this article presents an environment for Presented Distributed Artificial Intelligence as-a-Services (DAIaaS) supplying in IoE and 6G applications. The case histories and the DAIaaS architecture have been evaluated in terms of from end to end latency and bandwidth consumption, use of energy, and cost savings, with suggestion to improve efficiency.

• Journal of Korean Society of Transportation
• /
• v.24 no.3 s.89
• /
• pp.17-27
• /
• 2006

Car following model is a theory that examines changes of condition and interrelationship of acceleration deceleration. headway, velocity and so on closely based on the hypothesis that the Posterior vehicle always follows the preceding vehicle. Car following mode) which is one of the research fields of microscopic traffic flow was first introduced in 1950s and was in active progress in 1960s. However, due to the limitation of data gathering the research depression was prominent for quite a while and then soon was able to tune back on track with development in global positioning system using satellite and generalization of computer use. Recently, there has been many research studies using reception materials of global Positioning system(GPS). Introducing GPS technology to traffic has made real time tracking of a vehicle position possible. Position information is sequential in terms of time and simultaneous measurement of several vehicles in continuous driving is also practicable. Above research was focused on judging whether it is feasible to overcome the following model research by adopting the GPS reception device that was restrictively proceeded due to the limitation of data gathering. For practical judgment, we measured the accuracy and confidence level of the GPS reception devices material by carrying out a practical experiment. Car following model is also being applied in simulations of traffic flow analysis, but due to the difficulty of estimating parameters the basis of the above result. it is our goal to produce an accurate calibration of car following model's parameters that is suitable in this domestic actuality.

• Journal of Korean Society of Transportation
• /
• v.25 no.6
• /
• pp.129-140
• /
• 2007

The planning procedure of a transit operation consists of design, operation, and evaluation according to the research characteristics. There are some review studies on the operation and evaluation procedure, but the research on the design procedure has not yet been organized systematically. In this study, the research on transit system design was reviewed and the model structure and its solution method were arranged. The decision variables of the design procedure are network structure, line spacing or position, stop spacing, dispatching headway, and fleet size. In the analytical research on design procedure, system total cost is generally used as the objective function. System total cost is comprised of user cost, which is the sum of user access, waiting, and travel cost, and operating cost. Total cost of the transit system, used as the objective function, has the unique minimum because it is differentiable. There is a certain decision variable that makes the derivative of the objective function equal to zero and the second derivative of the objective function is positive. Therefore the decision variable that makes the first derivative of the objective function zero is the optimum that minimizes the objective function, and each of the cost components of the objective function become the same. This study is expected to help understanding about the research on the design procedure of transit operation planning and to help be a catalyst for relevant research.