• Journal of Yeungnam Medical Science
• /
• v.6 no.1
• /
• pp.121-131
• /
• 1989

The temperature-corrected values of blood gas analysis were compared to uncorrected values in 40 cases of open heart surgery under moderate hypothermic cardiopulmonary bypass. The results were as follows. 1. The corrected value of pH was significantly higher than uncorrected value, and it's relationship was ${\Delta}pH=-0.015$ ${\Delta}Temp+0.005$(r=0.81, P<(0.01). 2. The corrected value of $PCO_2$ was lower than uncorrected value, and it's relationship was ${\Delta}PCO_2=1.11$ ${\Delta}Temp+1.81$(r=0.50, P<0.01). 3. The corrected value of $PO_2$ was lower than uncorrected value, and it' s relationship was ${\Delta}PO_2=5.21$ ${\Delta}Temp-1.45$(r=0.32, P<0.01). But there was no clinical significance. 4. The corrected values of $HCO_{3^-}$, base excess, $CO_2$ content and oxygen saturation were similar with uncorrected values. In summery, the values of pH and $PCO_2$were significantly changed by temperature-correction. Because of the neutral point of water (pH=pOH) rises as temperature falls and it change in parallel with the changes in blood pH, a corrected pH of 7.4, $PaCO_2$ of 40mmHg during deep hypothermia would reflect a profound respiratory acidosis. Therefore, the use of the uncorrected value at $37^{\circ}C$ is more preferable and valid means of assessing acid-base management regardless of actual patient temperature.

• 한국연소학회:학술대회논문집
• /
• 2014.11a
• /
• pp.91-94
• /
• 2014

In this study, the laminar burning velocities of SNG fuel were studied using both experimental measurements and kinetic simulations. They were measured using the angle method of Bunsen flame configuration and the annular diverging channel combustor. And they were also numerically calculated by CHEMKIN Package with GRI 3.0 mechanisms. Spectrometer was used for characteristics of flame chemiluminescence of SNG fuels. From results of this work, first, we found that according to adding $H_2$ contents in the fuels the laminar burning velocities of SNG fuels were increased. And second, we also discovered existence of OH*, CH*, $C_2*$, HCO*, $CH_2*$ radicals and their correlation.

• Journal of Microbiology
• /
• v.34 no.3
• /
• pp.270-273
• /
• 1996

Micrococcus luteus purine nucleoside phosphorylase (PNP) has been purified and characterized. The physical and kinetic properties have been described previously. Chemical modification of the enzyme was attempted to gain insight on the active site. The enzyme was inactivated in a time-dependent manner by the arginine- specific modifying reagent phenylglyoxal. There was a linear relationship between the observed rate of inactivation and the phenylglyoxal concentration. At 30 $^{\circ}C$ the bimolecular rate constant for the modification was 0.015 $min^{-1}mM^{-1}$ in 50 mM $NaHCO_3$ buffer, pH 7.5. The plot of logk versus log phenylglyoxal concentration was a strainght line with a slope value of 0.9, indicating that modification of one arginine residue was needed to inactivate the enzyme. Preincubation with saturated solutions of substrates protected the enzyme from inhibition of phenylglyoxal, indicating that reactions with phenylglyoxal were directed at arginyl residues essential for the catalytic functioning of the enzyme.

• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.2
• /
• pp.106.2-106.2
• /
• 2011

The two competing theories of star formation are based on turbulence and ambipoar diffusion. I will first briefly explain the two theories. There have been analytical (or semi-analytic) models, which estimate star formation rates in a turbulent cloud. Most of them are based on the log-normal density PDF (probability density function) of the turbulent cloud without self-gravity. I will first show that the core (star) formation rate can be increased significantly once self-gravity of a turbulence cloud is taken into account. I will then present the evolution of molecular line profiles of HCO+ and C18O toward a dense core that is forming inside a magnetized turbulent molecular cloud. Features of the profiles can be affected more significantly by coupled velocity and abundance structures in the outer region than those in the inner dense part of the core. During the evolution of the core, the asymmetry of line profiles easily changes from blue to red, and vice versa. Finally, I will introduce a method for incorporating ambipolar diffusion in the strong coupling approximation into a multidimensional magnetohydrodynamic code.

• Journal of Biomedical Engineering Research
• /
• v.40 no.3
• /
• pp.81-96
• /
• 2019

The purpose of this study is to evaluate the effects of ultraviolet blood irradiation on the blood when a low dose of ultraviolet (UV) C is directly irradiated to the blood in a diabetic rabbit model and to evaluate the effects on treatment for diabetes. This study results indicate that the reduced body weight is increased and blood glucose levels are significantly reduced after the UBI treatment is performed when compared to those prior to the UBI treatment. In addition, $HCO_3{^-}$ levels and blood pH were elevated and lowered, respectively. When the UBI treatment is performed in a diabetic rabbit model, in this result indicate that blood glucose levels are reduced.

• Journal of the Korean Ceramic Society
• /
• v.41 no.3
• /
• pp.190-196
• /
• 2004

Yttrium Aluminum Garnet (YAG) powders were synthesized by precipitation of solutions of Al and Y nitrates using ammonium hydrogen carbonate as a precipitant. Y$_2$O$_3$ and YAG phases were formed in the precipitates, which had been attrition-milled. Well-crystallized, phase-pure YAG powders were obtained after calcination of the milled precipitates at 1100$^{\circ}C$ for 1 h. The powders were found to exhibit an excellent sinterability regardless of the addition of SiO$_2$(500 ppm Si) as a sintering aid. All samples already densified to relative densities greater than 70% at 1300$^{\circ}C$ and relative densities of ∼83％ at 1400$^{\circ}C$. The samples doped with SiO$_2$ showed a little improvement in densification as compared with those for the undoped samples and resulted in a relative density of 97% at 1600$^{\circ}C$.

• Journal of Korean Biological Nursing Science
• /
• v.19 no.2
• /
• pp.76-85
• /
• 2017

Purpose: The purpose of this study was to compare the effects of $21^{\circ}C\;CO_2$ and $37^{\circ}C\;CO_2$ pneumoperitoneum on body temperature, blood pressure, heart rate, and acid-base balance. Methods: Data were collected at a 1300-bed university hospital in Incheon, from February through September 2012. A total of 74 patients who underwent laparoscopic colectomy under general anesthesia with desflurane were randomly allocated to either a control group or an experimental group. The control group received $21^{\circ}C\;CO_2$ pneumoperitoneum; the experimental group received $37^{\circ}C\;CO_2$ pneumoperitoneum. The pneumoperitoneum of the two groups was under abdominal pressure 15 mmHg. Body temperature, systolic blood pressure, heart rate and acid-base balance were assessed at 30 minutes and 90 minutes after pneumoperitoneum, and again at 30 minutes after arriving at the Post Anesthesia Care Unit. Results: Body temperature in the $37^{\circ}C\;CO_2$ pneumoperitoneum group was significantly higher (F= 9.43, p< .001) compared to the $21^{\circ}C\;CO_2$ group. However, there were no statistically significant differences in systolic blood pressure (p= .895), heart rate (p= .340), pH (p= .231), PaCO2 (p= .490) and HCO3- (p= .768) between the two groups. Conclusion: Pneumoperitoneum of $37^{\circ}C\;CO_2$ is effective for the increase of body temperature compared to pneumoperitonium of $21^{\circ}C\;CO_2$, and it does not result in a decrease of blood pressure, heart rate or acid-base imbalance.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.03a
• /
• pp.135-135
• /
• 2003

This paper presents the preparation of SnO$_2$ films by Sol-Gel process and using spin coating method, and their sensing properties in CO gas. Experimental procedure consisted of following steps: (1) Tin chloride(SnCl$_4$) and Ammonium hydrogen carbonate (NH$_4$HCO$_3$) were used as precursors; (2) the Sol solution with concentration of about 10wt% SnO$_2$ was prepared from washed Gel-precipitate for spin coating step; (3) thereafter, the coating solution was dropped onto the alumina (Al$_2$O$_3$) substrate that was then spun, the spin coating was carried out with total 10 times; (4) finally, the films were calcined for 3 hours at 50$0^{\circ}C$ or higher temperature (600, 700, 800 or 90$0^{\circ}C$) in order to obtain various gram sizes. The average grain size was calculated by Scherrer's equation using main peaks in XRD spectra; meanwhile the thickness, microstructure and surface morphology of the films were observed by FE-SEM.

• Journal of The Korean Astronomical Society
• /
• v.33 no.1
• /
• pp.37-45
• /
• 2000

We have investigated the properties of the high-latitude cloud MBM 7 using the 3 mm transitions of CO, CS, HCN, $HCO^+,\;C_3H_2,\;N_2H^+$, and SiO. The molecular component of MBM 7 shows a very clumpy structure with a size of $\le$0.5 pc, elongated along the northwest-southeast direction, perpendicularly to an extended HI component, which could be resulted from shock formation. We have derived physical properties for two molecular cores in the central region. Their sizes are 0.1-0.3 pc and masses 1-2 M$\bigodot$ having an average volume density $\~2{\times}10^3 cm^{-3}$ at the peak of molecular emission. We have tested the stability of the cores using the full version of the virial theorem and found that the cores are stabilized with ambient medium, and they are expected not to be dissipated easily without external perturbations. Therefore MBM 7 does not seem to be a site for new star formation. The molecular abundances in the densest core appear to be much less (by about one order of magnitude) than the 'general' dark cloud values. If the depletions of heavy elements are not significant in the HLCs compared with those in typical dark clouds, our results may suggest different chemical evolutionary stages or different chemical environments of the HLCs compared with dense dark clouds in the Galactic plane.

• Journal of Microbiology
• /
• v.43 no.1
• /
• pp.28-33
• /
• 2005

The purpose of this study was to develop a multipurpose incubator, without the gas cylinders (bottles) which are required for $H_2$ and $CO_2$ supplementation. In our bottle-free multipurpose incubator, the $H_2$ and $CO_2$ were generated by chemical reactions induced within the chamber. The reaction between sodium borohydride and acetic acid at a molar ratio of 1:1 was used to generate $H_2$, according to the following formula: $4NaBH_4+2CH_3COOH+7H_2O{\rightarrow} 2CH_3COONa+Na_2B_4O_7+16H_2$, whereas the other reaction, citric acid and sodium bicarbonate at a 1:1 molar ratio, was used to generate $CO_2$, according to the following formula: $C_6H_8O_7+3NaHCO_3{\rightarrow}Na_3(C_6H_5O_7)+3H_2O+3CO_2$. Five species of obligate anaerobic bacteria, one strain of capnophilic bacterium, and one strain of microaerophilic bacterium were successfully cultured in the presence of their respective suitable conditions, all of which were successfully generated by our bottle-free multipurpose incubator. We conclude that, due to its greater safety, versatility, and significantly lower operating costs, this bottle-free multipurpose incubator can be used for the production of fastidious bacterial cultures, and constitutes a favorable step above existing anaerobic incubators.