• Journal of Korean Society for Atmospheric Environment
• /
• v.13 no.5
• /
• pp.383-396
• /
• 1997

Numerical prediction of the pollutant dispersion over a two-dimensional hilly terrain is presented. The dispersion model used in the present work is based on the gradient diffusion theory and the finite-volume method on a non-orthogonal boundary-fitted grid system. The numerical model is validated by comparing the results with the available experimental data for the flat-floor dispersion within a turbulent boundary-layer. The numerical error analysis is performed based on the guideline of Kasibhatla et al.(1988) for the elevated-source dispersion in the flat-floor boundary layer having a power-law velocity and linear eddy-diffusivity profile. The influences of the two-dimensional hilly terrain on the dispersion from a continuously released source are numerically investigated by changing the emission locations and heights. It is found that the distributions of ground-level concentration are strongly influenced by the source location and the emission height. Hence, the terrain amplification factor is greatly enhanced when the pollutant source is located within a flow separation region. Dispersion from a source of short duration is also simulated and the duration time of the pollutant is compared at several downstream locations on a hilly terrain. The results of the numerical prediction are applied to the evaluation of environmental impacts due to the automobile exhausts at the seashore highway with a parallel mountain range.

• Journal of Society of Preventive Korean Medicine
• /
• v.19 no.3
• /
• pp.103-113
• /
• 2015

Objective : Five most generally adopting basic oriental prescriptions (yookmijihwangtang, ojeoksan, sipjeondaebotang, samultang, bojoongikgitang) samples were collected from 10 oriental hospitals nationwide and the transferring ratio to aqueous phase (TRAP) were calculated. Method : The samples are grounded evenly and the decocted at $120^{\circ}C$ for 12 min on hot plate and then filtered. The concentrations of As, Cd, Co, Cr and Pb in before and after decoction were measure by ICP/MS and the TRAPs were calculated. Results : The concentrations of As, Cr and Pb in the ground samples before decoction were all below criteria level, and TRAP values were also very low (<10%). For Cd, although some ground samples before decoction showed relatively high concentration level compare to the criteria level, because of their low TRAP (~3%), the actual concentrations in the decoction were quite low compare the criteria level. The Co's concentrations in the ground samples before decoction were all relatively low level. However, the TRAP of Co was astonishingly high value of around 40% average. Conclusion : The toxic heavy metal concentrations in the decoction were very low compare to the criteria level. The TRAPs are less than <10% except Co. The toxic heavy metals in the prescriptions are mainly remained in the residue and the only very small fraction may transferred to the decoctions. Therefore the toxicity of the oriental herbal medicine about the toxic heavy metal may be overstressed. The Co's TRAP turned out to be quite high value (40% average). Since the criteria level wes not established yet, the safety of decoctions according to Co was not fully confirmed.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.11 no.3
• /
• pp.169-175
• /
• 2008

A fine carbon fibers dispersion model is implemented to calculate the scattering range and ground level concentration of carbon fibers emitted at certain altitudes of atmospheric boundary layer. This carbon fibers dispersion model was composed by coupling a commonly used atmospheric dispersion model and an atmospheric boundary layer model. The atmospheric boundary layer model, applying the Monin-Obukov Similarity Rule obtained from measurement input data at ground level, was used to create the atmospheric boundary layer structure. In the atmospheric dispersion model, the Lagrangian Particle Model and the Markov Process were applied to calculate the trajectory of scattered carbon fibers relative to gravity and aerodynamic force, as well as carbon fibers specification.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.22 no.11
• /
• pp.773-780
• /
• 2010

The dispersion of plume which is emitted from a chimney is governed by a lot of factors： wind, local terrain, turbulence intensity of atmosphere, and temperature, etc. In this study, we numerically investigate the plume dispersions for various altitudinal temperature gradients and wind speeds. The normal atmosphere has the temperature decrease of $0.6^{\circ}C/100m$, however, actually the real atmosphere has the various altitudinal temperature profiles according to the meteorological factors. A previous study focused on this atmospheric temperature gradient which induces a large scale vertical flow motion in the atmosphere thus makes a peculiar plume dispersion characteristics. In this paper, the effects of the atmospheric temperature gradient as well as the wind speed are investigated concurrently. The results for the developing processes in the atmosphere and the affluent's concentrations at the ambient and ground level are compared under the various altitudinal temperature gradients and wind speeds.

• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.19 no.4
• /
• pp.39-52
• /
• 2023

This study analyzes the energy performance of a elderly care center building and the applicability of a ground source heat pump (GSHP) system through simulation approach. For this purpose, a building information modeling (BIM) program and an energy performance calculation program were used. The impact of the mechanical ventilation system on the energy requirements of the heating and cooling system and the indoor environment was also analyzed, focusing on the change in indoor carbon dioxide (CO₂) concentration, which is a representative indicator of the indoor environment (air quality). The simulation results showed that the target building exceeds Level 7 in terms of simulated primary energy consumption or actual energy consumption. In addition, it was analyzed that the target building could not maintain the indoor CO₂ concentration below the standard concentration by natural ventilation through window opening alone. Combining the GSHP system with the mechanical ventilation system (Case B and Case C) can further reduce the overall energy consumption by reducing the amount of outdoor air introduced by opening windows. The cost savings compared to the baseline case are estimated to be 67.3% for Case A, 63.7% for Case B, 65.5% for Case C, and 42.5% for Case D. It is necessary to analyze the impact of various renewable energy technologies and passive ones on the energy performance and indoor environment of elderly care centers.

• Journal of the Korean Geosynthetics Society
• /
• v.17 no.1
• /
• pp.127-137
• /
• 2018

Gravel Compaction Pile (hereinafter referred to as GCP) is a ground improvement technique by packing crushed stones on fragile clay ground, pressing it, and forming stakes on the foundation. Although many researchers have analyzed stress behavior of GCP composite ground on domestic GCP technique using laboratory experiment and field experiment, analyses of stress behavior according to the difference of stiffness of mat foundation loaded on the upper foundation of GCP composite ground have not been done actively. Therefore, this study aimed to identify the stress concentration ratio in accordance with the difference of basis stiffness by interpreting figures. To perform this, replacement ratio was changed and modelled using ABAQUS, software for finite element analysis and analyzed the stress concentration ratio, amounts of settlement, and maximum amounts of horizontal displacement of composite ground in accordance with the difference of stiffness. An analysis showed that the stress concentration ratio of rigid foundation was highly assessed than unloading of flexible foundation in case of unloading, while amounts of settlement under flexible unloading condition were slightly higher than under rigid condition. This indicates that the characteristic of stress behavior on the different stiffness of upper foundation needs to be clarified. In addition, the maximum horizontal displacement was generated in a constant level regardless of the difference of stiffness.

• Proceedings of the Korean Institute of Industrial Safety Conference
• /
• 2003.05a
• /
• pp.17-20
• /
• 2003

In a recent paper (Hartwig, ms.) I have shown that it is possible to understand and discuss the changing Austausch (i.e., exchange of air parcels between different atmospheric layers) between the stratosphere and troposphere by means of long-term measurement on series of spallation products. It is well known (Friend 1961; Muet et al. 1966, Hartwig et al. 1969) that there is a seasonal pattern in the 7Be concentration of ground-level air with a maximum during May-June. This maximum is caused by enhanced exchange processes between the atmospheric compartments of the stratosphere and troposphere during this interval. Generally, those exchange processes are a consequence of stability and dynamics of the atmospheric compartments, which themselves result from, among other factors, the distribution of the heat sources in those compartments, namely the ground and the ozone layer. Because of the growing importance of anthropogenic infrared-active gases in the atmosphere, it is to be expected that the relative importance of those original, naturally occurring heat sources will be of lesser significance, thus altering the Austausch. And indeed, it has been shown (Hartwig, ms.) by considering the ratio of the annual maximum and minimum during a 28-yr period of 7Be ground-level concentration at Braunschweig, Germany (10$^{\circ}$33'E, 52$^{\circ}$17'N) (Kolb 1992; Wershofen 1993), that there is a steady decline in that ratio, thus indicating alteration of atmospheric Austausch within the last three decades.(omitted)

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.397-400
• /
• 2007

For mapping the distribution of heavy metals in the mining area, field spectroscopy and hyperspectral remote sensing were used in this study. Although heavy metals are spectrally featureless from the visible to the short wave infrared range, possible variations in spectral signal due to heavy metals bound onto minerals can be explained with the metal binding reaction onto the mineral surface. Variations in the spectral absorption shapes of lattice OH and oxygen on the mineral surface due to the combination of heavy metals were surveyed over the range from 420 to 2400 nm. Spectral parameters such as peak ratio and peak area were derived and statistically linked to metal concentration levels in the streambed samples collected from the dry stream channels. The spatial relationships between spectral parameters and concentrations of heavy metals were yielded as well. Based on the observation at a ground level for the relationship between spectral signal and metal concentration levels, the spectral parameters were classified in a hyperspectral image and the spatial distribution patterns of classified pixels were compared with the product of analysis at the ground level. The degree of similarity between ground dataset and image dataset was statistically validated. These techniques are expected to support assessment of dispersion of heavy metal contamination and decision on optimal sampling point.

• Asian Journal of Atmospheric Environment
• /
• v.8 no.3
• /
• pp.162-174
• /
• 2014

An abnormal decrease in ozonesonde sensor signal occurred during air-pollution study campaigns in November 2011 and March 2012 in Mexico City Metropolitan Area (MCMA). Sharp drops in sensor signal around 5 km above sea level and above were observed in November 2011, and a reduction of signal over a broad range of altitude was observed in the convective boundary layer in March 2012. Circumstantial evidence indicated that $SO_2$ gas interfered with the electrochemical concentration cell (ECC) ozone sensors in the ozonesonde and that this interference was the cause of the reduced sensor signal output. The sharp drops in November 2011 were attributed to the $SO_2$ plume from Popocat$\acute{e}$petl volcano southeast of MCMA. Experiments on the response of the ECC sensor to representative atmospheric trace gases showed that only $SO_2$ could cause the observed abrupt drops in sensor signal. The vertical profile of the plume reproduced by a Lagrangian particle diffusion simulation supported this finding. A near-ground reduction in the sensor signal in March 2012 was attributed to an $SO_2$ plume from the Tula industrial complex north-west of MCMA. Before and at the time of ozonesonde launch, intermittent high $SO_2$ concentrations were recorded at ground-level monitoring stations north of MCMA. The difference between the $O_3$ concentration measured by the ozonesonde and that recorded by a UV-based $O_3$ monitor was consistent with the $SO_2$ concentration recorded by a UV-based monitor on the ground. The vertical profiles of the plumes estimated by Lagrangian particle diffusion simulation agreed fairly well with the observed profile. Statistical analysis of the wind field in MCMA revealed that the effect Popocat$\acute{e}$petl was most likely to have occurred from June to October, whereas the effect of the industries north of MCMA, including the Tula complex, was predicted to occur throughout the year.

• The Korean Journal of Pesticide Science
• /
• v.18 no.4
• /
• pp.236-246
• /
• 2014

Pesticide is used to protect the crops, but also become a cause of polluting the environment. Perform a risk assessment using physical and chemical properties, environmental fate and toxicity data in order to determine the pesticide registration. The aquatic model estimates pesticide concentrations in water bodies that result from pesticide applications to rice paddies and apple orchard. The used models are the PRZM, EXAMS and AGRO shell (PA5), Rice Water Quality Model (RICEWQ) and Screening Concentration In GROund Water (SCI-GROW). The residual concentration of water body was estimated using meteorological data, crop calendar and soil series of Korea. The chosen pesticides were butachlor, carbofuran, iprobenfos and tebuconazole. It has shown the potential that the RICEWQ is possible to predict residue level in water of butachlor and iprobenfos, because the maximum value in water monitoring data is lower than the peak concentration of the model, and the minimum value is lower than the average annual concentration of the model. But RICEWQ was insufficient to predict exposure concentrations in ground water. The estimated exposure concentrations of carbofuran in ground water is very higher than in surface water because of its low soil adsorption coefficient. Although tebuconazole were not detected in the water monitoring that means very low concentration, it is possible that the PA5 can be used to predict residue level in water.