• ETRI Journal
• /
• v.34 no.5
• /
• pp.767-770
• /
• 2012

This letter presents a novel compact circularly polarized patch antenna for Global Positioning System/Global Navigation Satellite System (GPS/GLONASS) applications. The proposed antenna is composed of a simple square radiating patch fed by a capacitive dual-feeder to increase the impedance bandwidth and a lumped element hybrid coupler to achieve the broadband characteristic of the axial ratio (AR). The realized antenna dimensions are $28mm{\times}28mm{\times}4mm$, which is the most compact size among the dual-band GPS/GLONASS antennas reported to date. The measured results demonstrate that the proposed antenna has a gain of 2.5 dBi to 4.2 dBi and an AR of 0.41 dB to 1.51 dB over the GPS/GLONASS L1 band (1.575 GHz to 1.61 GHz).

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.1
• /
• pp.61-67
• /
• 2011

The GPS new civil signal is modulated on the L2 carrier at a frequency of 1227.6MHz. The L2C signal is composed of two multiplexed code signals, which include CM code with a 10,230 chip sequency repeating every 20ms, and CL code which has a 767,250 chip sequency repeating every 1.5 seconds. Thus, the new civil signal have much improved cross correlation properties so that the position fixing can be possible even with very weak signals. However, it requires very long acquisition time because of its long code length. This paper presents an efficient signal acquisition method for L2C AGPS receiver. Snapshot mode and coarse time assistance are assumed and total integration time is given by 1.5 sec. By SNR worksheet and computer simulation, it is proven that L2C signal can be acquired with very weak power less than -150dBm. Considering the acquisition time and the sensitivity, it is recommended that the highest power signal is acquired with CM code first to reduce TTFF. By the timing synchronization, at this time, search space of the code phase for other signals can be greatly reduced so that CL code can be used in signal acquisition to maximize sensitivity with small computation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.6C
• /
• pp.512-519
• /
• 2012

To design a new Navigation Satellite System signal, we should analyze the influence of inter-system interference to existing Global Navigation Satellite Systems(GNSS). Various GNSS systems such as GSP, GALILEO, Compass use same frequence band and incur inter-system interference due to the overlapping spectrums. In this paper, we consider L2 Band for new Navigation Satellite System and propose the BOCcos(15,2.5) signal what has least Spectral Separation Coefficient with GPS L2 system. Assuming 4 stationary satellite over Korea, we simulate the effect of interference. As a result, proposed system shows very small mutual interference effect and negligible effective signal to noise ratio(SNR) loss, compared to the interferences between GNSS systems in L1 Band.

• Journal of Satellite, Information and Communications
• /
• v.12 no.1
• /
• pp.13-17
• /
• 2017

This paper presents an approach to enable a typical GPS receiver to be much less susceptible to intentional disruption such as jamming and change in link environment. In order for the GPS receiver to cope with jamming and to get adaptivity, a $4{\times}4$ beamforming antenna is designed using metamaterials. The design results show the antenna gain much higher than 5 dBi and the movable beam.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.31 no.5
• /
• pp.375-384
• /
• 2013

Most of regions within the city of Mokpo, located on the southwest coast of the Korean Peninsula, are subjected to significant subsidence because about 70% of the city is land reclaimed from the sea (Kim et al., 2005). In this study, we aimed to estimate the rate of subsidence over Mokpo by using PALSAR L-band dataset from 2006 to 2010. Time series analysis was performed as well using GPS surveying data from 2010 to 2012. Results from these two independent datasets are then compared and analyzed over the common period of time. GPS data processing provides the results of seasonal variation on the surface, that is, via repeatedly rising and falling in association with the periodic cycle. Therefore, a time series analysis was performed to calculate the rate of ground subsidence. The deformation rates calculated for the same point are 3.89cm/yr and 2.65cm/yr from the GPS data and SAR data, respectively. SAR and GPS data processing results show a very similar pattern in terms of magnitude of annual subsidence. Thus, if the two datasets are integrated together, new modeling on ground subsidence is feasible. Lastly, subsidence was detected in a landfill area in the city of Mokpo, which has been continuously occurring through 2012.

• Journal of the Korea Society of Computer and Information
• /
• v.28 no.1
• /
• pp.49-54
• /
• 2023

The Global Positioning System (GPS) was developed for military purposes and developed as it is today by opening civilian signals (GPS L1 frequency C/A signals). The current satellite orbits the earth about twice a day to measure the position, and receives more than 3 satellite signals (initially, 4 to calculate even the time error). The three-dimensional position of the ground receiver is determined using the data from the radio wave departure time to the radio wave Time of Arrival(TOA) of the received satellite signal through trilateration. In the case of navigation using GPS in recent years, a location error of 5 to 10 m usually occurs, and quite a lot of areas, such as apartments, indoors, tunnels, factory areas, and mountainous areas, exist as blind spots or neutralized areas outside the error range of GPS. Therefore, in order to acquire one's own location information in an area where GPS satellite signal reception is impossible, another method should be proposed. In this study, IMU(Inertial Measurement Unit) combined with an acceleration and gyro sensor and a geomagnetic sensor were used to design a system to enable location recognition even in terrain where GPS signal reception is impossible. A method to track the current position by calculating the instantaneous velocity value using a 9-DOF IMU and a geomagnetic sensor was studied, and its feasibility was verified through production and experimentation.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.235-240
• /
• 2006

Ionospheric scintillation induces a rapid change in the amplitude and phase of radio wave signals. This is due to irregularities of electron density in the F-region of the ionosphere. It reduces the accuracy of both pseudorange and carrier phase measurements in GPS/satellite based Augmentation system (SBAS) receivers, and can cause loss of lock on the satellite signal. Scintillation is not as strong at mid-latitude regions such that positioning is not affected as much. Severe effects of scintillation occur mainly in a band approximately 20 degrees on either side of the magnetic equator and sometimes in the polar and auroral regions. Most scintillation occurs for a few hours after sunset during the peak years of the solar cycle. This paper focuses on estimation of the effects of ionospheric scintillation on GPS and SBAS signals using a software receiver. Software receivers have the advantage of flexibility over conventional receivers in examining performance. PC based receivers are especially effective in studying errors such as multipath and ionospheric scintillation. This is because it is possible to analyze IF signal data stored in host PC by the various processing algorithms. A L1 C/A software GPS receiver was developed consisting of a RF front-end module and a signal processing program on the PC. The RF front-end module consists of a down converter and a general purpose device for acquiring data. The signal processing program written in MATLAB implements signal acquisition, tracking, and pseudorange measurements. The receiver achieves standalone positioning with accuracy between 5 and 10 meters in 2drms. Typical phase locked loop (PLL) designs of GPS/SBAS receivers enable them to handle moderate amounts of scintillation. So the effects of ionospheric scintillation was estimated on the performance of GPS L1 C/A and SBAS receivers in terms of degradation of PLL accuracy considering the effect of various noise sources such as thermal noise jitter, ionospheric phase jitter and dynamic stress error.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.5 s.347
• /
• pp.169-175
• /
• 2006

In this paper, a microstrip patch antenna with the T-shaped slits is designed and fabricated for GPS. The resonant frequency of the microstrip patch antenna with the slits is lower than that of a microstrip patch antenna without the slits so it can be reduced the size of patch. In order to calculate resonant frequency of the microstrip patch antenna with the slits, the resonant frequency formulas are derived from the surface current distribution on microstrip patch antenna. Using the Ensemble 6.0 simulation tool, the accuracy of approximate equations is verified. The microstrip patch antenna with the slits is designed by using these equations. The size of the designed antenna with T-shaped slits can be reduced to 29% compared with that without the slits. The microstrip patch antenna with slits have a very narrow bandwidth. In order to improve the narrow bandwidth of microstrip patch antennas with the slits, a microstrip patch antenna with rectangular slot is proposed. As the result of the measurements, the resonant frequency of the proposed microstrip patch antenna with the T-shaped slits is 1.575GHz and the bandwidth is about 50MHz.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.5
• /
• pp.959-968
• /
• 2022

In this paper, we intend to develop a cart with the convenience of moving objects or items that are difficult to hold by the hand of the disabled and the elderly from outdoor activities to a moving location. Using GPS module, DC motor, Bluetooth module, magnetometer sensor, and Blynk application, the smart follow cart was programmed to accurately know the owner's location while following the cart. The values of latitude and longitude of the magnetometer sensor are set so that the correct leverage value can be obtained in the lead for fine adjustment of the start and stop angles so that the user's position can be freely detected. The above motor driver L298n was connected to the motor to drive the DC motor at a fine angle. A smart follow cart was implemented that receives location signals according to the direction of the owner by turning on/off the mobile phone app as a switching role by connecting the GPS through Bluetooth wireless communication using a smartphone.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.26 no.5
• /
• pp.493-504
• /
• 2008

Space-Based Augmentation System (SBAS), which is one of the GPS augmentation systems, is a Wide-Area Differential GPS that provides differential GPS corrections and integrity data. In this study, we did performance analysis of kinematic SBAS surveying by conducting Real-Time Kinematic (RTK), DGPS, standalone, and SBAS surveys. Considering static survey results as truth, 2-D Root Mean Square (RMS) error and 3-D RMS error were computed to evaluate the positioning accuracy of each survey method. As a result, the 3-D positioning error of RTK was 13.1cm, DGPS 126.0cm, standalone (L1/L2) 135.7cm, standalone (C/A) 428.9cm, and SBAS 109.2cm. The results showed that the positioning accuracy of SBAS was comparable to that of DGPS.