• Journal of Biosystems Engineering
• /
• v.3 no.2
• /
• pp.100-113
• /
• 1978

Drying grain with conventional artificial drying methods requires great quantities of petroleum fuels. Depletion of fossil fuel increases the need of the utilization of solar energy as an alternative to petroluem fuels for drying grain , an energy intensive agricultural operation. Many techniques for the utilization of solar energy in grain drying have been developed, however, there are many problems in adopting solar energy as an energy sources for drying grain. Futhermore, very little research has been done on solar grain drying in Korea. This study was conducted to evaluate the availability of solar energy for drying of rough rice in Chuncheon, Suweon, and Jinju areas based on 50year meteorological data, and to analyze experimentally the performance of a solar air collector for dying grain, and to find the effects of solar heated air compared to unheated air on the rate of drying and energy consumption required for drying of rough rice. The results of this study was may be summarized as follows ; 1. Monthly average daily total radiation on a horizontal surface in October was 260.6 ly/day for Chuncheon, 240.3 ly/day for Suweon , and 253.4 ly/day for Jinju area, respectively. 2. the ratio of monthly average daily diffuse radiation to daily total radiation on a horizontal surface was approximately 0.41 for Chuncheon, 0.45 for Suweon, and 0.44 for Jinju area, respectively. 3. Although the statistical distribution curves of daily total radiation for the three locations were not identical , the differences among them were not large and may be neglected for many practical purposes. 4. I was estimated that the optimum tilting angle of the collector in October was approximately 46 degrees for Chuncheon and Suweon and 45 degrees for Jinju. 5. The ratio of the total radiation on a optimum tilting plane to that on a horizontal plane was estimated to be 1.36 for Chuncheon, 1.31 for Suweon, and 1.27 for Jinju , respectively. 6. The collection efficiency of the solar air collector ranged from 47. 8 to 51. 5 percent at the air flow rates of 251. 1-372.96 $m^3$/hr. High efficiency remained nearly , constant during the best sunshine hours, 10 a.m. to 2 p.m. and decreased during other hours. More energy was collected as the air flow rate incresed. 7. The average temperature rise in the drying air from the solar collector for the test period varied from $6.5^\circC$ to $21.8^\circC$ above the ambient air temperature. 8. Solar-dried rough rice averaged 13.7 percent moisture (w.b.) after 130 hours of drying with the air flow rate of 1. 64 ccm/$m^3$, and rough rice dried with natural air averaged 15.1 percent moisture (w.b.) after 325 hours of drying with the same air flow rate. 9. Energy saving of 2.4 kwh per $m^3$ percentage point of moisture removed was obtained from solar heated air drYing. The solar bin used 53.3 percent less energy per percentage point of moisture removed than the natural air bin.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.13 no.2
• /
• pp.155-161
• /
• 2015

Technetium-99m (^99mTc) is an important, short-lived decay product of molybdenum-99 (⁹⁹Mo), and it is considered the backbone of the modern nuclear diagnostic procedures. Since fission of ²³⁵U is the main source of production of ⁹⁹Mo, either highly-enriched uranium (HEU) targets or low-enriched uranium (LEU) targets are irradiated in the research reactors. The use of LEU targets is being promoted by the international community to avoid the proliferation issues linked with the use of HEU. In order to define the waste management strategy at the planning stage of establishment of an LEU based ⁹⁹Mo production facility, the impact of the use of LEU targets on the radioactive waste stream of the ⁹⁹Mo production facility was analyzed. Because the volume of uranium waste is estimated to increase six times, the use of high uranium density targets and the utilization of hot isostatic pressing were recommended to reduce the increased waste volume from the use of LEU based targets.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.1
• /
• pp.47-54
• /
• 2015

Recently, rapid urbanization and industrialization had increased the air pollution in major cities by increasing the fuel consumption. Air pollution models have been widely used for air quality management in many countries. Also, a lot of related studies have been conducted using air dispersion models. In this study, The meteorological preprocessing program was developed to convert the korea meteorological data to the U.S. meteorological data and to expand the usability of air dispersion models of U.S. EPA. In addition, the usability evaluation was carried out through a case study. In the results of the evaluation of the program, this program was accurately convert the Korea meteorological data to the U.S. meteorological data, and the prediction was carried out without a error in air quality modeling. Therefore, the program showed a high utilization as meteorological data pre-processing tool.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.20 no.3
• /
• pp.77-82
• /
• 2012

It is well known that the targeted fuel efficiency could only be achieved by more than 40% reduction of the vehicle weight through improved design and extensive utilization of lightweight materials. In order to obtain the goal of the weight reduction of automobiles, the researches about lighter and stronger rear sub-frame have been studied without sacrificing the safety of rear sub-frame. In this study, the weight reduction design process of rear sub-frame could be proposed based on the variation of von-Mises stress contour by substituting an AA6061 (aluminum 6061 alloy) having tensile strength of 310 MPa grade instead of SAPH440 steels. In addition, the stress ratio variations (stress over fatigue limit) of the rear sub-frame were examined and compared carefully. It could be reached that this approach method could be well established and be contributed for light-weight design guide and the optimum design conditions of the automotive rear sub-frame development.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.06a
• /
• pp.416-421
• /
• 2005

Most of solar system dissemination has been focused on domestic hot water system of which utilization to a building is relatively simple and safe than solar heating system. Through the survey on a cause of solar house dissemination failure in Korea, we conclude that design integration and systematic approach method for technology application are the most important element for a successful solar house. KIER(Korea Institute of Energy Research) and Hanbat National University have started new project on a development of Zero energy Solar House, called ZeSH which can be sustained just by natural energy without the support of existing fossil fuel. This is the 1st phase research of 10 years long-term ZeSH plan which develops a low-cost and $100\%$ self sufficient ZeSH. The goal of 1st phase ZeSH research is to get a $70\%$ self sufficiency only in thermal loads. Actual demonstration house, named KIER ZeSH I was designed and constructed as a result of 1st phase research work in the end of 2002. Various innovative technologies such as super insulation, high performance window, passive and active solar systems, ventilation heat recovery system are applied and evaluated to the KIER ZeSH I. A lot of computer simulations had been conducted for the optimal design and system integration in every design steps. Considering all the results from detailed hourly computer simulation, it is expected that at least $70\%$ self-sufficiency in thermal loads which is 1st phase target value can be excessively achieved in actual demonstration house. Besides, many valuable findings from the design and analysis to construction could be established such as collaboration method among the participants, practical design and construction techniques for system integration and the others. The purpose of this paper is to introduce the main findings through the development of KIER ZeSH I project. Practical guidelines in every design step for new low- or zero- energy solar house is proposed as result.

• Journal of the Korean Wood Science and Technology
• /
• v.10 no.3
• /
• pp.194-195
• /
• 1982

Recommendaton: These are the highlights of the findings of the Timber Consumption Survey carried out by the Project in 1966, and covering consumption for the period from 1961 to 1965. The survey was oriented towards consumption for structural, commercial and industrial purposes and existing estimates for local (village-level) consumption as fuel and the like were adopted. A full report on the survey was submitted to the Bureau of Forestry in 1966. Long-term Trends: After allowance for anticipated population increase, this ten year's increase in industrial wood consumption represents a gain of about 30% in per capita consumption (from 0.0913 cu.m. per capita to 0.118 cu.m. per capita). This is only about half the expected general economic growth of about 75% (7% per annum). It is therefore likely (a) that the 1975 estimate is conservative, (b) that the consumption demand beyond 1975 may be expected to build up at a greatly increased rate. Estimated income elasticity coefficients are high, and with expected ir,creases in prosperity and population, the consumption is expected to rise to 10 million cu. meters by the year 2,000. Consumption Pattern: The breakdown of industrial consumption (1965) is given in Table 4-2, showing sawnwood consumption as the most important in 1965. The upward trend in all sectors over the 1961-65 period is expected to continue. The general consumption pattern is expected to change through 1975 with a sharp increase in the relative importance of pulp products (to 30% of total consumption) offset by declining relative importance of sawlogs. The following recommendations follow from the study: (i) Industrial forests. - A programme of establishment of consolidated industrial forests should be initiated as a matter of urgency. (ii) Fuelwood forests - Properly sited, protected and managed fuelwood forest, worked on a 20-year rotation, should be established as a nation wide basis. (iii) Hardwood utilization - Detailed investigations are required into the use of indigenous hardwoods for the pulp, particle board and hardboard industries. (iv) Mining timber - Preservation treatment of all mining timber should be enforced by law. (v) Sawmills - Licencing restrictions should be enforced to reduce the number of small, inefficient sawmills. b. Extension work should be undertaken bv government to improve sawmilling practices.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.18 no.2
• /
• pp.111-125
• /
• 1990

Korea is a nation with poor natural resources. There is a greats need to save resources that are running out in fast face. The purpose of this thesis is to bind the means to save rosources in housing site, especially in highrise apartment. The reason why the high-rise apartments are chosen as a case is 7hat the high-rise is becoming the major form of dwelling in most urban areas. As a tool of saving the ecological way is chosen because ecological energy is free, clean and unlimited. The resources to be saved are divided into two categories, namely energy and non - energy resources as water, land and food. The contents of the thesis are comprised of 4 chapters. The early chaspters are devoted to the understanding of the ecosystem and problems of current energy consumption in the apartment. It is fellowed by the introduction of the hypothesis that can possibly save reouruces. The hypothesis are then transformed into the actual theories through verification, to be established as the new techniques of the site planning. The ecosystem is the functional relationship between the living organisms and their physical surroundings. The living organisms are the plants that produce, animals that consume and bacterias that decompose. They live in the environment which consists of the three worlds of atmosphere, hydrosphere and lithosphere. The whole system is activated by the solar energy that turns the inorganic mallet- into the living organism and back to the inorganic. It is the recycling principle of the ecosystem. The elements of ecosystem that fan be unilimited as the tools of resources -saving are the sun, wind, water, soil, plant and waste. They are unlimited sources of energy. free of pollution and cheap in price. Each of these ecological elements Provide the opportunities that can save the heating fuel, air conditioning energy, water resource, land and food. The ecological approch should be pursued actively in this age of short resources and growing pollution. In the scale of total energy consumption the housing takes the second position next to the industrial use. It is followed by the transportation which shows for less consumption than former two.

• Journal of Energy Engineering
• /
• v.20 no.2
• /
• pp.123-142
• /
• 2011

Coal Gasification Technology is one of the best alternatives among clean fossil fuel utilization. Major technology holding companies are devoting their efforts to develop more advanced technology to dominate the market in advance because of its importance on the applications such as IGCC, CTL, coal to SNG, various chemicals and so on. Japan and China, as well as America and European countries, have developed couple of thousands ton/day-class coal gasification technology. However, our gasification technology remains in the development stage with couple of ton/day-class pilot plant. So, we should be interested in developing this technology considering that we are heavily dependent of coal energy. In this paper, we summarized the trend and status of coal gasification technology development and commercial deployment of major technology holding companies mainly from the presentation materials of 'Gasification Technology Conference 2010', which is the biggest place of information exchange for recent coal gasification technology.

• Journal of Energy Engineering
• /
• v.21 no.4
• /
• pp.373-377
• /
• 2012

Among the fossil fuels, the brown coal is a great deal of resources. However, it is hardly used due to the high moisture content and low calorific value. It has both the week points such as spontaneous combustion and high volatile content and the strong points such as the low-sulfur and low ash content. If we overcome these week points, the using amount of brown coal would be increased. Also, it is well known that biomass is one of the important primary renewable energy sources because of carbon neutral energy. Furthermore, the utilization of biomass has been more and more concerned with the depletion of fossil fuel sources as well as the global warming issues. Combustion and thermal decomposition of biomass is one of the more promising techniques among all alternatives proposed for the production of energy from biomass. In this study, combustion of brown coals and mushroom waste was done. Mass change of samples and emission of hydrocarbon components were measured. As the results, we obtained combustion rate constant. Also activation energy was calculated in char combustion step. Hydrocarbon components were more generated in low oxygen concentration than high. Emission amount of hydrocarbon components in mushroom waste was significantly increased comparing to brown coal.

• The Korean Journal of Pharmacology
• /
• v.30 no.1
• /
• pp.59-65
• /
• 1994

The experiments were performed to determine whether lidocaine interferes with the utilization of lipid as source of energy fuel for the contractile process by the isolated rat atria. Rats were starved for two days in order to inerease the lipid content of the heart. Atria from starved rats were better able to maintain their contractility in the absence of exgenous substrate, and also were more resistant to depression by lidocaine than atria from fed rats. Starvation results in a marked loss of body weight in rats. In contrast to the starved rats, the body weight of fed rats inereased with time. The smaller reduction in contractile activity of atria from the starved rats may suggest that endogenous lipid accumulates during starvation period and is used as an energy source for the contractile process in the face of a lidocaine-induced blockade in glycolysis.