• 유체기계공업학회:학술대회논문집
• /
• 2003.12a
• /
• pp.88-91
• /
• 2003

A fuel spiking test was performed to measure the surge margin of gas turbine engines. The surge marin was mainly determined by the compressors and fuel spiking was used to change the operating point in the compressor characteristic map while speed remained constant. To access the surge margin region different spiking signals were applied by modulations of time(frequency) and fuel flow rate(amplitude). The test results showed good agreements with expected fuel spiking patterns and possibility of further studies.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 1997.10a
• /
• pp.96-100
• /
• 1997

A design modification was made on the 9-th stage wheel dovetail of a high-intermodiate pressure (HIP) turbine rotor for a fossil power plant that necessitates the use of new long-shank buckets for the row. A bucket vibration test is necessary to verify that the new 9-th stage buckets have adequate frequency margin from a nozzle passing frequency when running at speed. A finite element analysis (FEA) has been performed using a commercial S/W to approximately estimate bucket natural frequencies, and thus to help the vibration test. A row of the new buckets has been assembled on the HIP rotor for the vibration tests using dynamic balancing facilities. The tests have been done during deceleration run with air excitation. The test results are compared with the calculation using our empirical formula, and show that the modified design meets the frequency-margin requirements.

• Journal of electromagnetic engineering and science
• /
• v.6 no.3
• /
• pp.189-195
• /
• 2006

In this paper, the derivation of the protection ratio for the digital microwave system with diversity is newly suggested for a basic guidance of initial planning for frequency coordination, and computational results are presented for an actual radio frequency band. The net filter discrimination has been also examined to see the effect of the adjacent channel protection ratio caused by adjacent channel interference. In addition, the protection ratios for the space or frequency diversity system are analyzed in terms of diversity improvement factors to find out an equivalent allowable noise-to-interference ratio (N/I) from degraded fade margin. According to results for 6.2 GHz system, with the space diversity of 25 m distance between antennas or the frequency diversity of ${\Delta}f/f=0.05$, under 64-QAM and 60 km at BER $10^{-6}$, the protection ratio can be greatly reduced in comparison to the non-diversity system. So, assuming that only the same protection ratio as the non-diversity system is kept, it is shown that the system with diversity may get more interference level of N/I allowing from 9.0 to - 5.9 dB or from 6.0 to - 4.3 dB for the space or frequency diversity. In consequence, it is concluded that the diversity system is more robust or tolerable for interferences or fades, which may play an important role in overcoming N/I to some extent.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.40 no.6
• /
• pp.68-77
• /
• 2003

An improved negative capacitance circuit that cancels out input impedance of a front-end in a bioimpedance measurement and operates stably with a low gain margin has been proposed. Since the proposed circuit comprises wide-band operational amplifiers, selecting operational amplifiers is easy, while an operational amplifier of prefer bandwidth should be chosen to apply conventional circuit. Also, since gain margin can be controlled by a feedback resistor connected serially with a feedback capacitor, gain margin is tuneable with a potentiometer. The input impedance of the proposed circuit is two times larger than that of the conventional circuit and 40-times than that without a negative capacitance circuit. Furthermore, closed-loop phase response of the proposed circuit is better than that of the conventional circuit or without a negative capacitance circuit. Above all, for the proposed circuit, the frequency at which a gain peaking occurs is higher than the frequency at which the loop gain becomes a maximum. Thus, the proposed circuit is not affected by a gain peaking and can be operated with a very low gain margin.

• The Korean Journal of Nuclear Medicine
• /
• v.21 no.1
• /
• pp.17-24
• /
• 1987

Authors classified 161 cases of photon defects due to the gall bladder on hepatic parenchymal scintigraphy on $^{99m}Tc-phytate$ and $^{99m}Tc-DISIDA$ according to the position of the gall bladder, the pattern of photon defects and the hepatobiliary diseases. The results were as follows; 1) Conocordance of $^{99m}Tc-DISIDA$ and $^{99m}Tc-phytate$ hepatic parenchymal images in photon defect due to the gall bladder was 94% of 32 cases. 2) The frequency according to the position of the gall bladder was in order to 68% of the gall bladder of the lower margin of the liver, 30% of the intrahepatic gall bladder and 2% of the extrahepatic gall bladder, and the frequency of the photon defects due to the gall bladder was in order to 81% of the intrahepatic gall bladder, 71% of the gall bladder of the lower margin of the liver and 20% of the extrahepatic gall bladder. 3) The pattern of the photon defects due to the gall bladder was 47% of funnel shape in the intrahepatic gall bladder, 69% of semilunar shape in the gall bladder of the lower margin of the liver and 100% of semilunar shape in the extrahepatic gall bladder. 4) All of 9 cases of the intrahepatic gall bladder at the lateral area of the right lobe and the gall bladder of the lower margin of the liver at the right hepatic angle were associated with liver cirrhosis with the right lobe atrophy and the left lobe hypertrophy, 2 cases of the gall bladder of the lower margin of the liver at just-left side of the porta hepatis with hepatoma in the right lobe and 1 case of the intrahepatic gall bladder at the central portion of the right lobe with choledochal cyst.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.12A
• /
• pp.951-957
• /
• 2003

The analysis of RF performance requirement conditions on communication system is critical indicator to predict the performance of system. UWB(Ultra Wide Band) system which the standard is not established yet is difficult to derive the precise system performance requirement condition. Also, there are differences between conventional UWB system and multi-band system about RF performance requirement condition. In this thesis, the differences are analyzed and performance requirement conditions of multi-band UWB system are described on the basis of the differences. Throughput, maximum transmit power, and sensitivity of multi-band UWB system is varied with respect to the number of Sub-Bands. In addition, because of Multi-path effect, if PRF(Pulse Repetition Frequency) is changed, the Multi-path link margin is happened to compensate for Multi-path Energy Loss which is contributed by increasing of the Link Margin. According to Multi-path Margin, the variation of the resistance with respect to sensitivity and interference signal is observed and analyzed through the simulation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.6A
• /
• pp.782-793
• /
• 2000

This paper presents a simple dynamical prediction scheme of the signal level which is attenuated and varied due to rain fading in satellite communication links using above 10GHz frequency bands. The proposed prediction scheme has four functional blocks for discrete-time low-pass filtering, slope-based prediction, mean-error correction and hybrid fixed/variable prediction margin allocation. Through simulations using Ka-band attenuation data obtained from the data measured over Ku-band by frequency-scaling, it is shown that the slope-based prediction with the mean-error correction has as small standard deviation of prediction error as below 1 dB, and that the error is about 1.5 to 2.5 times as small as that without the mean-error correction. The hybrid prediction margin allocation requires smaller average margin than those of both fixed and variable methods.

• Journal of Broadcast Engineering
• /
• v.15 no.1
• /
• pp.99-111
• /
• 2010

In this paper as a follow-up to Paper I, the required fade margin derived in Paper I to preserve the same service quality has been examined by analyzing system and propagation characteristics as well as measured data. The comparison of the fade margin between simulated and measured results is also performed for the actual operating line-of-sight(LOS) and non-LOS links, and practical usefulness as an analysis tool is revealed by checking service quality of M/W system relevant to frequency reallocation. According to simulated and measured results, there was a little difference for LOS link between Mt. Moodung and Mt. Mangun, but a fairly good agreement was reached for non-LOS link between Andong KBS and transmitter site.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.28 no.3
• /
• pp.32-43
• /
• 2014

This paper presents the intra capacitance modeling according to the winding method, section bobbin and coil structure for hybrid choke coil capable of the EMI attenuation of broad bands from lower frequency bands to higher frequency bands and high frequency type common-mode choke coil capable of the EMI attenuation of high frequency band used in the EMI Block of LED-TV SMPS. In case of high frequency type CM choke coil, it can be explained the parasitic capacitance of A type and section bobbin type winding methods among them is much smaller than the other. The first resonant frequency of the proposed CM choke coil tends to increase as the parasitic capacitance becomes small and its impedance characteristics also show improved performance as the first resonant frequency increases. In case of hybrid choke coil using rectangular copper wire, it has investigated its parasitic capacitance compared to CM choke coil of conventional toroidal type becomes small. Also it has confirmed through the experiment results that CE margin and RE margin in frequency bands 0.5MHz to 5MHz and 30MHz to 200MHz are respectively 10dB and 15dB greater than that of conventional type in case of one stage EMI filter structure adopting hybrid choke coil compared to two stage EMI Filter structure using two of each CM choke coil used in the lower and higher frequency bands or two of CM choke coil used in only the lower frequency bands. In the future, the hybrid choke coil and CM choke coil of high frequency type show it can be practically used in not only LED/LCD-TV SMPS but also several applications such as LED Lighting, Laptop Adapter, Server Power Supply and so on.

• 제어로봇시스템학회:학술대회논문집
• /
• 1986.10a
• /
• pp.362-366
• /
• 1986

Using simple linear prediction algorithm a design procedure of robust PI and PID controllers for SISO system, usually called 'PID predictor controllers, is developed. The design procedure is able to properly adjust gain margin and phase margin and control coefficients are selected in frequency domain. The performance of the PID predictor controller is superior to that of the normal PID controller in terms of robustness in design and disturbance rejection.