• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.11
• /
• pp.2108-2113
• /
• 2010

The Long Term Evolution (LTE) system is based on the Orthogonal Frequency Division Multiplexing (OFDM) and relies its channel estimation on the lattice-type pilot samples in the multipath fading channel environment. The estimation of the channel frequency response (CFR) makes use of the least squares estimate (LSE) for each pilot samples, followed by an interpolation both in time- and in frequency-domain to fill up the channel estimates for subcarriers corresponding to data samples. Any interpolation scheme could be adopted for this purpose. Depending on the requirements of the target system, we may choose a simple linear interpolation or a sophisticated one. For any choice of an interpolation scheme, these is a trade-off between estimation accuracy and numerical cost. For those wireless communication systems based on the OFDM and the preamble-type pilot structure, the DFT-based channel estimation and its variants have been successfully. Yet, it may not be suitable for the lattice-type pilot structure, since the pilot samples are not sufficient to provide an accurate estimate and it is known to be sensitive to the location as well as the length of the time-domain window. In this paper, we propose a simple interpolated based on the upsampling mechanism in the multirate signal processing. The proposed method provides an excellent alternative to the DFT-based methods in terms of numerical cost and accuracy. The performance of the proposed technique is verified on a multipath environment suggested on a 3GPP LTE specification.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.1
• /
• pp.35-41
• /
• 2014

This paper presents a design method of programmable low pass filter(PLPF) which reduce an estimation error of a zero crossing point(ZCP) for a high speed brushless DC(BLDC) motor drive. BLDC motor sensorless drive is possible by estimation of ZCP. The ZCP estimated by detecting a change of back-EMF polarity has the estimation error because noises exist on the measured back-EMF. Therefore a calculated commutation timing using the ZCP is inaccurate. And the inexact commutation timing leads to ripples of 3-phase current and degradation of drive performance. This paper proposes the design method of the PLPF to overcome these problems. First, a speed calculated a inaccurate period of the ZCP is analyzed in the frequency domain. Then, the PLPF that has varying cut-off frequency according to change of the speed is designed on the frequency analysis result. The proposed method is verified by the experiment.

• Journal of Broadcast Engineering
• /
• v.17 no.5
• /
• pp.864-875
• /
• 2012

In this paper, we propose a carrier frequency offset estimation method for single-carrier MIMO systems. In the proposed method, phase rotated PN (Pseudo-Noise) sequences are transmitted to prevent a cancelling out of partial PN sequences. After removing a modulation of received PN sequences by multiplying of complex conjugated PN Sequences which are locally generated in receiver, a CFO (Carrier Frequency Offset) is accurately estimated by employing L&R method which is a kind of ML (Maximum Likelihood) estimation algorithm and uses multiple auto-correlatos. In addition, the frequency offset estimation scheme by using channel state information is proposed for accurate CFO estimation in time-varying Rayleigh channel. By performing computer simulations, MSE (Mean Square Error) performance of proposed method is almost same as MSE performance of SISO systems in AWGN channel. Moreover, MSE Performance of proposed method with using channel information is higher than MSE performances of SISO system and conventional method in time-varying Rayleigh channel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.1
• /
• pp.12-22
• /
• 2016

Convenience and safety are the key words for the automotive driving and various sensor technologies have been studied for enhanced perception of driving environments. In frequency modulated continuous wave (FMCW) radar systems, single antenna is enough for range and velocity detection of multiple targets. Multiple array antenna is needed for estimating direction of arrival(DoA). Using DoA estimation algorithm in time domain as in the conventional systems, it is difficult to distinguish vehicles lie in the same angle. In order to facilitate the enhanced angle estimation, DoA estimation algorithm is applied in frequency domain. In this paper, the method for applying multiple signal classification(MUSIC) algorithm in frequency domain is suggested and the performance is analyzed.

• Proceedings of the KIEE Conference
• /
• 2002.07a
• /
• pp.563-565
• /
• 2002

The designed frequency compensator is proposed to make the estimation of amplitude of fundamental frequency immune to frequency variation. The designed method which has a simple structure and low calculation burden is proper to apply digital protective relay. The results of experimental demonstrate that the frequency compensator has good performance to the estimation of amplitude of fundamental frequency against frequency variation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.6C
• /
• pp.656-663
• /
• 2009

Recently, frequency offset estimation method for orthogonal frequency division multiplexing has been proposed by Ren et al. (REA). The method can estimate an frequency offset independently from training symbol structure. In REA method, however, the detection probability of integer frequency offset is varying according to fractional frequency offset. In this paper, we first analysis REA frequency offset estimation method, and define new detection criteria suitable for the method. Then, we propose efficient integer frequency offset estimation method based on the new detection criteria and maximum likelihood method. The proposed method still has the advantages of REA method, while overcome the drawback. The numerical results demonstrate that the proposed methods outperform the REA method, in terms of integer frequency offset detection probability.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.5
• /
• pp.787-793
• /
• 2018

In this paper, we propose a new single carrier - frequency domain equalization (SC-FDE) structure to cope with narrow band interference. In the conventional SC-FDE structure, when a high-power narrow band interference exists, channel estimation and data recovery is difficult. To relieve from this problem, this paper proposes a new SC-FDE frame structure to enable frequency-domain channel estimation in the environments that exist narrow band interference. Specifically, in the conventional method, the channel estimation is performed in time-domain first and from that, the frequency-domain channel is obtained by Fourier transform. In contrast, we proposed a new SC-FDE structure to enable frequency-domain channel estimation directly from received signals without time-domain channel estimation. The receiver performance improvement is verified through computer simulation. According to the results, the proposed technique can detect the signal with less than 2 dB loss compared with jammer-free environments, while the conventional method does not communicate with each other.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.10C
• /
• pp.1000-1010
• /
• 2006

This paper proposes a new architecture for DCT-based motion estimation and compensation. Previous methods do riot take sufficient advantage of the sparseness of 2-D DCT coefficients to reduce execution time. We first derive a recursion equation to perform DCT domain motion estimation more efficiently; we then use it to develop a wavefront array processor (WAP) consisting of processing elements. In addition, we show that the recursion equation enables motion predicted images with different frequency bands, for example, from the images with low frequency components to the images with low and high frequency components. The wavefront way Processor can reconfigure to different motion estimation algorithms, such as logarithmic search and three step search, without architectural modifications. These properties can be effectively used to reduce the energy required for video encoding and decoding. The proposed WAP architecture achieves a significant reduction in computational complexity and processing time. It is also shown that the motion estimation algorithm in the transform domain using SAD (Sum of Absolute Differences) matching criterion maximizes PSNR and the compression ratio for the practical video coding applications when compared to tile motion estimation algorithm in the spatial domain using either SAD or SSD.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11C
• /
• pp.1581-1591
• /
• 2004

In this paper, we investigate the design of three low-complexity joint estimation algorithms(LJEAs) for frequency offset and carrier phase. The proposed LJEAs are based on the interpolation technique of correlation values of the received signal in frequency and phase domains. With these algorithms, the estimation ranges $\Delta$f$_{d}$${\times}$T$_{s}$ . are less than 1/2N$_{s}$ , and 1/N$_{s}$ which are comparable to conventional algorithms. The Proposed LJEAs require only 2N$_{s}$ or 4N$_{s}$ complex multiplications which are very simple compared with the conventional algorithms. Nevertheless the estimation accuracies of the LJEAs are as good as those of the conventional algorithms. Suitable areas of application include joint estimation of frequency offset and carrier phase in burst-mode digital transmission such as satellite communications.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.12
• /
• pp.5860-5876
• /
• 2018

A single snapshot data can only provide limited amount of information so that the rank of covariance matrix is not full, which is not adopted to complete the parameter estimation directly using the traditional super-resolution method. Aiming at solving the problem, a joint time delay and angle estimation using matrix pencil method based on information reconstruction vector for orthogonal frequency division multiplexing (OFDM) signal is proposed. Firstly, according to the channel frequency response vector of each array element, the algorithm reconstructs the vector data with delay and angle parameter information from both frequency and space dimensions. Then the enhanced data matrix for the extended array element is constructed, and the parameter vector of time delay and angle is estimated by the two-dimensional matrix pencil (2D MP) algorithm. Finally, the joint estimation of two-dimensional parameters is accomplished by the parameter pairing. The algorithm does not need a pseudo-spectral peak search, and the location of the target can be determined only by a single receiver, which can reduce the overhead of the positioning system. The theoretical analysis and simulation results show that the estimation accuracy of the proposed method in a single snapshot and low signal-to-noise ratio environment is much higher than that of Root Multiple Signal Classification algorithm (Root-MUSIC), and this method also achieves the higher estimation performance and efficiency with lower complexity cost compared to the one-dimensional matrix pencil algorithm.