• 한국물환경학회지
• /
• 제29권1호
• /
• pp.55-65
• /
• 2013

It is very difficult to apply stream flow data directly to the management of Total Maximum Daily Loads because there are some differences between the unit watershed and the stream flow monitoring network in their characteristics such as monitoring locations and its intervals. Flow duration curve can be developed by linking the daily flow data of stream monitoring network to 8 day interval flow data of the unit watershed. This study investigated the current operating conditions of the stream flow monitoring network and the flow relationships between the unit watershed and the stream flow monitoring network. Criteria such as missing and zero value data, and correlation coefficients were applied to select the stream flow reference sites. The reference sites were selected in 112 areas out of 142 unit watersheds in 4 river basins, where the stream flow observations were carried out in relatively normal operating conditions. These reference sites could be utilized in various ways such as flow variation analysis, flow duration curve development and so on for the management of Total Maximum Daily Loads.

• 한국농공학회논문집
• /
• 제52권4호
• /
• pp.19-26
• /
• 2010

To provide the basic information for the water quality management of the Sumjin River Basin, delivery ratios for flow duration were studied. Using the day-interval data set of discharge and water quality observed from the Chooryeong-cheon watershed, the flow-duration and discharge-load relation curves for the watershed were established, then the load-duration curve was constructed. Delivery ratios for flow duration were also developed. Delivery ratios showed wide variation according to flow conditions. In general, delivery ratio of high flow condition showed higher value reflecting nonpoint source pollution contribution from the forest dominating watershed. To resolve this problem, a regression model explaining the relation between flow rate and delivery ratio was suggested. The delivery ratios for different flow regime could be used for pollutant load estimation and TMDL (Total maximum daily load) development.

• 한국물환경학회지
• /
• 제27권5호
• /
• pp.689-698
• /
• 2011

In South Korea, Total Maximum Daily Load (TMDL) has been enforced since 2004 to restore and manage water quality in the watersheds. However, the appraisal of TMDL in South Korea has lots of weaknesses to establish the plan for recovery of water quality because it just evaluates the target water quality during the particular flow duration interval. In the United States, Load Duration Curve (LDC) method bas been widely used in the TMDL to evaluate the water quality and pollutant loads considering variation of stream flow. In a recent study, web-based Load Duration Curve system was developed to create the LDC automatically and provide the convenience of use. In this study, web-based Load Duration Curve system was applied in the Gapyeongcheon watershed using the daily flow and 8-day interval water quality data, and Q-L Rating Curve was used to evaluate the water quality and pollutant load in the watershed, also. As a result of study, water quality and pollutant load in Gapyeongcheon watershed were met with water quality standard and allocated load in the all flow durations. Web-based Load Duration Curve system could be applied to the appraisal of South Korean TMDL because it can be used to judge the impaired flow duration and build up the plan of load reduction, and it could enhance the publicity. But, web-based Load Duration Curve system should be enhanced through addition of load assessment tools such as Q-L rating curve to evaluate water quality and pollutant load objectively.

• Journal of Animal Science and Technology
• /
• 제46권4호
• /
• pp.517-524
• /
• 2004

본 연구는 유우의 착유 지속시간, 평균 유속 및 최대 유속에 영향하는 환경 요인을 추정하고 이들 형질들과 산유량간의 관련성을 규명하여 진공압에 의한 착유기를 이용한 여건에서 비유 특성에 대해 알아보고 또한 향후 진행될 수 있는 착유우의 유방관련 질병과의 관계에 대한 연구 기초자료를 제공하고자 실시하였다. 조사된 착유 지속 시간 및 유속에 대해 분석 모형에 고려한 분만계절, 산차, 비유 월수 및 착유 시간 간격의 환경 요인들이 대부분 유의적인 효과를 가지는 것으로 추정되었다. 착유 유량과 착유 지속 시간 및 유속간의 상관관계 조사를 통해 유속이 빠를수록 유량이 많아지고, 착유 지속 시간과 유속간의 부의 상관관계가 존재하여, 착유 시간에 대한 경제적 가치를 고려한 투입비용의 절감을 위해 착유시간이 짧은 착유우가 바람직하면서 동시에 착유 유속이 빠르고 착유 유량이 많아질 것으로 기대할 수 있으나, 착유 유속과 유성분내의 체세포 수 및 유방염의 발생 빈도에 대한 기존의 보고들을 고려할 때 질병 발생에 따른 치료비용 및 유질의 저하로 인한 손실을 주의해야 하며, 착유 유량과 착유 지속 시간간의 높은 상관으로 인해 형질간 상관 반응에 대하 해석에 주의가 필요한 것으로 생각되므로 본 연구에서 조사한 착유 유량, 착유 유속 및 착유 지속 시간 뿐만 아니라 체세포 수와 유방염 자료 조사를 통해 다각적인 경제 가중치가 고려된 종합적인 지수식으로 해석하는 것이 적절하며 이에 대한 추가적인 연구가 필요할 것으로 생각된다.

• 한국물환경학회지
• /
• 제28권2호
• /
• pp.224-231
• /
• 2012

It is necessary to develop flow duration curve (FDC) on each unit watershed in order to analyze flow conditions in the stream for the management of Total Maximum Daily Loads (TMDLs). This study investigated a simple method to develop FDC for the general use of the curve. A simple equation for daily flow estimation was derived from the regression analysis between the 8-day interval flow data of a unit watershed and the daily flow monitoring data of an adjacent upstream region. FDC can be prepared with the calculation of daily flow by the equation for each unit watershed. An annual and a full-period FDC were drawn for each unit watershed in Guem river basin. Standard flow such as low and ordinary flow can be obtained from the annual FDC. Major percentile of flow such as 10, 25, 50, 75 or 90% can be obtained from the full-period FDC. It is considered that this simple method of developing FDC can be utilized more widely for the calculation of standard flow and the assessment of water quality in the process of TMDLs.

• Environmental Engineering Research
• /
• 제24권2호
• /
• pp.298-308
• /
• 2019

This work deals with the membrane fouling mode and the unclogging in seawater ultrafiltration process. The identification of the fouling mechanism by modeling the experimental flux decline was performed using both the classical models of Hermia and the combined models of Bolton. The results show that Bolton models did not bring more precise information than the Hermia's and the flux decline can be described by one of the four Hermia's models since the backwash interval is ${\leq}60$ min. An experimental screening study has been then conducted to choose among 5 parameters (backwash interval, duration, pulses and the flow-rate or injected hypochlorite concentration) those that are the most influential on the fouling and the net water production. It has emerged that fouling is mainly affected by the backwash interval; its prolongation from 30 to 60 min engenders an increase in the reversible fouling and a decrease in the irreversible fouling. This later is also significantly reduced when the hypochlorite concentration increases from 4.5 to 10 ppm. Moreover, the net water production significantly increases with increasing the filtration duration up to 60 min and decreases with decreasing the backwash duration and backwash flow-rate from 10 to 40 s and from 15 to ${\geq}20L.min^{-1}$, respectively.

• 한국물환경학회지
• /
• 제35권6호
• /
• pp.481-496
• /
• 2019

The Ministry of Environment has measured streamflow at eight-day intervals for the estimation of standard flow of the Total Maximum Daily Loads (TMDL) system. This study identified the availability of the partially measured the eight-day interval data for estimating standard flow and found the optimal extension techniques of standard flow. The study area was selected for the Nakbon-A watershed in the Nakdong River, and four streamflow record extension techniques of standard flow were considered: extension, percentile, drainagearea, and regional regression methods. The flow duration curve (FDC) using the eight-day interval streamflow data indicated very high Nash and Sutcliffe Efficiency (NSE) values above 90 % from FDC-II to FDC-VII compared to FDC-VIII, the standard FDC. This result demonstrates that FDC using daily data of three-six cumulative years could represent standard FDC fairly well. For the streamflow record extension techniques of standard flow, the percentile method was selected as the optimal alternative, showing the minimal difference from FDC-VIII. These results validate the availability of the eight-day interval streamflow data in the standard flow estimation and the application of extension techniques. It seems that these results could reduce the uncertainty of partially measured streamflow data for water quantity and quality management.

• 한국물환경학회지
• /
• 제28권2호
• /
• pp.247-254
• /
• 2012

Soil and Water Assessment Tool (SWAT) model has been widely used in estimation of flow and water quality at various watersheds worldwide, and it has an auto-calibration tool that could calibrate the flow and water quality data automatically from thousands of simulations. However, only continuous measured day flow/water quality data could be used in the current SWAT auto-calibration tool. Therefore, 8-day interval flow and water quality data measured nationwide by Korean Ministry of Environment (MOE) could not be used in SWAT auto-calibration even though long-term flow and water quality data in the Korean Total Maximum Daily Load (TMDL) watersheds available. In this study, current SWAT auto-calibration was modified to calibrate flow and water quality using 8-day interval flow and water quality data. As a result of this study, the Nash and Sutcliffe Efficiency (NSE) values for flow estimation using auto-calibration are 0.77 (calibration period) and 0.68 (validation period), and NSE value for water quality (T-P load) estimation (using the 8-day interval water quality data) is 0.80. The enhanced SWAT auto-calibration could be used in the estimation of continuous flow and water quality data at the outlet of TMDL watersheds and ungaged point of watersheds. In the next study, the enhanced SWAT auto-calibration will be integrated with Web based Load Duration Curve (LDC) system, and it could be suggested as methods of appraisal of TMDL in South Korea.

• Korean Chemical Engineering Research
• /
• 제57권4호
• /
• pp.531-538
• /
• 2019

고분자전해질 연료전지(PEMFC)의 성능이 개선됨에 따라 생성물인 물과 열의 발생이 증가하고 이를 처리하기 위한 관리기법이 중요해지고 있다. 본 연구에서는 물 관리 기법으로 수소 재순환을 적용하였고, 수소 재순환 유량(flow rate)과 퍼지 간격(purge interval) 및 지속 시간(duration)이 연료전지의 성능에 미치는 영향에 대한 실험을 수행하였다. Purge 조건의 영향을 해석하기 위하여 수소극의 압력, 연료의 습도, 운전 간의 연료 이용 효율과 물 배출 양을 측정하였다. 수소 재순환 유량이 증가할수록 수소극 출구의 압력 저하로 인하여 스택 성능이 낮아졌다. Purge 조건에 따라서 물을 효과적으로 배출하지 못해 순간적인 전압 강하가 발생하거나 혹은 잦은 purge로 인해 수소극의 습도를 유지하지 못하여 성능이 점차적으로 감소하는 것을 확인하였다. Purge 조건 실험을 통하여 수소극의 습도를 유지하고 응축된 물을 충분히 배출할 수 있는 purge interval과 duration을 선정하였고, 이를 통하여 스택의 성능과 연료 이용 효율을 향상시킬 수 있었다.

• 한국농공학회논문집
• /
• 제51권6호
• /
• pp.25-31
• /
• 2009

In this study, pollutant loads delivery ratio by flow duration in Hwangryoung A watershed was estimated. The delivery ratio was estimated with measured data by Ministry of Environment(MOE) and the regression equation based on geomorphic parameters. Eight day interval flow data measured by the MOE were converted to daily flow to calculate daily load and flow duration curve by correlating data of neighboring station which has daily flow data. Regression equation developed by previous study was tested to study watershed and found to be satisfactory. The delivery ratios estimated by two methods were compared. For the case of Biochemical oxygen demand(BOD), the delivery ratios of low flow condition were 7.6 and 15.5% by measured and regression equation, respectively. Also, the delivery ratios of Total phosphorus(T-P) for normal flow condition were 13.3 and 6.3% by measured and regression equation, respectively.