As far as an opening device of fishing gears is concerned, applications of a kite are under development around the world. The typical examples are found in the opening device of the stow net on anchor and the buoyancy material of the trawl. While the stow net on anchor has proved its capability for the past 20 years, the trawl has not been wildly used since it has been first introduced for the commercial use only without sufficient studies and thus has revealed many drawbacks. Therefore, the fundamental hydrodynamics of the kite itself need to ne studied further. Models of plate and canvas kite were deployed in the circulating water tank for the mechanical test. For this situation lift and drag tests were performed considering a change in the shape of objects, which resulted in a different aspect ratio of rectangle and trapezoid. The results obtained from the above approaches are summarized as follows, where aspect ratio, attack angle, lift coefficient and maximum lift coefficient are denoted as A, B,
The objectives of the 1963 Tokyo Convention cover a variety of subjects, with the intention of providing safety in aircraft, protection of life and property on board, and promoting the security of civil aviation. These objectives will be treated as follows: first, the unification of rules on jurisdiction; second, the question of filling the gap in jurisdiction; third, the scheme of maintaining law and order on board aircraft; fourth, the protection of persons acting in accordance with the Convention; fifth, the protection of the interests of disembarked persons; sixth, the question of hijacking of aircraft; and finally some general remarks on the objectives of the Convention. The Tokyo Convention mainly deals with general crimes such as murder, violence, robbery on board aircraft rather than aviation terrorism. The Article 11 of the Convention deals with hijacking in a simple way. As far as aviation terrorism is concerned 1970 Hague Convention and 1971 Montreal Convention cover the hijacking and sabotage respectively. The Problem of national jurisdiction over the offence and the offender was as tangled at the Hague and Montreal Convention, as under the Tokyo Convention. Under the Tokyo Convention the prime base of jurisdiction is the law of the flag (Article 3), but concurrent jurisdiction is also allowed on grounds of: territorial principle, active nationality and passive personality principle, security of the state, breach of flight rules, and exercise of jurisdiction necessary for the performance of obligations under multilateral agreements (Article 4). No Criminal jurisdiction exercised in accordance with national law is excluded [Article 3(2)]. However, Article 4 of the Hague Convention(hereafter Hague Article 4) and Article 5 of the Montreal Convention(hereafter Montreal Article 5), dealing with jurisdiction have moved a step further, inasmuch as the opening part of both paragraphs 1 and 2 of the Hague Article 4 and the Montreal Article 5 impose an obligation on all contracting states to take measures to establish jurisdiction over the offence (i.e., to ensure that their law is such that their courts will have jurisdiction to try offender in all the circumstances covered by Hague Article 4 and Montreal Article 5). The state of registration and the state where the aircraft lands with the hijacker still on board will have the most interest, and would be in the best position to prosecute him; the paragraphs 1(a) and (b) of the Hague Article 4 and paragraphs 1(b) and (c) of the Montreal Article 5 deal with it, respectively. However, paragraph 1(b) of the Hague Article 4 and paragraph 1(c) of the Montreal Article 5 do not specify if the aircraft is still under the control of the hijacker or if the hijacker has been overpowered by the aircraft commander, or if the offence has at all occurred in the airspace of the state of landing. The language of the paragraph would probably cover all these cases. The weaknesses of Hague Article 4 and Montreal Article 5 are however, patent. The Jurisdictions of the state of registration, the state of landing, the state of the lessee and the state where the offender is present, are concurrent. No priorities have been fixed despite a proposal to this effect in the Legal Committee and the Diplomatic Conference, and despite the fact that it was pointed out that the difficulty in accepting the Tokyo Convention has been the question of multiple jurisdiction, for the reason that it would be too difficult to determine the priorities. Disputes over the exercise of jurisdiction can be endemic, more so when Article 8(4) of the Hague Convention and the Montreal Convention give every state mentioned in Hague Article 4(1) and Montreal Article 5(1) the right to seek extradition of the offender. A solution to the problem should not have been given up only because it was difficult. Hague Article 4(3) and Montreal Article 5(3) provide that they do not exclude any criminal jurisdiction exercised in accordance with national law. Thus the provisions of the two Conventions create additional obligations on the state, and do not exclude those already existing under national laws. Although the two Conventions do not require a state to establish jurisdiction over, for example, hijacking or sabotage committed by its own nationals in a foreign aircraft anywhere in the world, they do not preclude any contracting state from doing so. However, it has be noted that any jurisdiction established merely under the national law would not make the offence an extraditable one under Article 8 of the Hague and Montreal Convention. As far as international aviation terrorism is concerned 1988 Montreal Protocol and 1991 Convention on Marking of Plastic Explosives for the Purpose of Detention are added. The former deals with airport terrorism and the latter plastic explosives. Compared to the other International Terrorism Conventions, the International Aviation Terrorism Conventions do not have clauses of the passive personality principle. If the International Aviation Terrorism Conventions need to be revised in the future, those clauses containing the passive personality principle have to be inserted for the suppression of the international aviation terrorism more effectively. Article 3 of the 1973 Convention on the Prevention and Punishment of Crimes Against Internationally Protected Persons, Including Diplomatic Agents, Article 5 of the 1979 International Convention against the Taking of Hostages and Article 6 of the 1988 Convention for the Suppression of Unlawful Acts Against the Safety of Maritime Navigation would be models that the revised International Aviation Terrorism Conventions could follow in the future.
Drilling position is one of the most important factors affecting on the blasting effects. There has been many reports on several blasting factors of burn-cut by Messrs. Brown and Cook, but in this study the author tried to compare drilling positions of burn-cut to pyramid-cut, and also to correlate burn-cut effects of drilling patterns, not being dealt by Prof. Ito in his theory, which emphasized on dynamical stress analysis between explosion and free face. According to former theories, there break out additional tensile stress reflected at the free face supplemented to primary compressive stress on the blasting with one-free-face. But with these experimented new drilling patterns of burn-cut, more free faces and nearer distance of each drilling holes make blasting effects greater than any other methods. To promote the above explosive effect rationary, it has to be considered two important categories under-mentioned. First, unloaded hole in the key holes should be drilled in wider diameter possibly so that it breaks out greater stress relief. Second, key holes possibly should have closer distances each other to result clean blasting. These two important factors derived from experiments with, theories of that the larger the dia of the unloaded hole, it can be allowed wider secondary free faces and closes distances of each holes make more developed stress relief, between loaded and unloaded holes. It was suggested that most ideal distance between holes is about 4 clearance in U. S. A., but the author, according to the experiments, it results that the less distance allow, the more effective blasting with increased broken rock volume and longer drifted length can be accomplished. Developed large hole burn-cut method aimed to increase drifting length technically under the above considerations, and progressive success resulted to achieve maximum 7 blasting cycles per day with 3.1m drifting length per cycle. This achievement originated high-speed-drifting works, and it was also proven that application of Metallic AN-FO on large hole burn-cut method overcomes resistance of one-free-face. AN-FO which was favored with low price and safety handling is the mixture of the fertilizer or industrial Ammonium-Nitrate and fuel oil, and it is also experienced that it shows insensible property before the initiation, but once it is initiated by the booster, it has equal explosive power of Ammonium Nitrate Explosives (ANE). There was many reports about AN-FO. On AN-FO mixing ratio, according to these experiments, prowdered AN-FO, 93.5 : 6.5 and prilled AN-FO 94 : 6, are the best ratios. Detonation, shock, and friction sensities are all more insensitive than any other explosives. Residual gas is not toxic, too. On initation and propagation of the detonation test, prilled AN-FO is more effective than powered AN-FO. AN-FO has the best explosion power at 7 days elapsed after it has mixed. While AN-FO was used at open pit in past years prior to other conditions, the author developed new improved explosives, Metallic AN-FO and Underwater explosive, based on the experiments of these fundmental characteristics by study on its usage utilizing AN-FO. Metallic AN-FO is the mixture of AN-FO and Al, Fe-Si powder, and Underwater explosive is made from usual explosive and AN-FO. The explanations about them are described in the other paper. In this study, it is confirmed that the blasting effects of utilizing AN-FO explosives are very good.
Go bears significant meanings in terms of cultural and entertaining functions in Asia Eastern such as China and Japan. Beyond the mere entertaining level, it produces philosophical and mythic discourse as well. As a part of effort to seek an identity of Korean traditional garden culture, this study traced back to find meanings of rock-go-board and taste for the arts which ancestors pursued in playing Go game, through analysis and interpretation of correlation among origin of place name, nearby scenery, carved letters and vicinal handed-down place name. At the same time, their position, shape and location types were interpreted through comprehensive research and analysis of stone-go-boards including rock-go-board. Particularly, it focused on the rock names related to Sundoism(仙道) Ideal world, fixed due to a connection between traces of Sundoism and places in a folk etymology. Series of this work is to highlight features of the immortal sceneries, one of traditional landscaping ideals, by understanding place identity and scenic features of where the rock-go-boards are carved. These works are expected to become foundation for promotion and preservation of the traditional landscaping remains. The contents of this study could be summarized as follows; First, round stone and square board for round sky and angled land, black and white color for harmony of yin and yang and 361paths for rotating sky are symbols projecting order of universe. Sayings of Gyuljungjirak(橘中之樂), Sangsansaho(商山四皓), Nangagosa(爛柯故事) formed based on the idea of eternity stand for union of sky and sun. It indicates Go game which matches life and nature spatiotemporally and elegant taste for arts pursuing beauty and leisure. Second, the stone-go-boards found through this research, are 18 in total. 3 of those(16.1%), Gangjin Weolnamsaji, Yangsan Sohanjeong and Banryongdae ones were classified into movable Seokguk and 15(83.9%) including Banghakdong were turned out to be non-movable rock-go-boards carved on natural rocks. Third, upon the result of materializing location types of rock-go-boards, 15 are mountain stream type(83.9%) and 3 are rock peak type(16.1%). Among those, the one at Sobaeksam Sinseonbong is located at the highest place(1,389m). Considering the fact that all of 15 rock-go-boards were found at mountainous areas lower than 500m, it is recognizable that where the Go-boards are the parts of the living space, not far from secular world. Fourth, there are 7 Sunjang(巡將) Go with 17 Hwajeoms(花點), which is a traditional Go board type, but their existences, numbers and shapes of Hwajeom appear variously. Based on the fact, it is recognizable that culture of making go-board had been handed down for an extended period of time. Among the studied rock-goboards, the biggest one was Muju Sasunam[