• 한국항행학회논문지
• /
• 제25권5호
• /
• pp.363-369
• /
• 2021

본 논문에서는 텔레메트리 시스템을 위한 가변 컷 오프 주파수 및 가변 샘플레이트 특성을 지니는 저면적 다채널 디지털 필터구조를 제안한다. 제안하는 디지털 필터는 임의의 컷 비율에 대해 필터 뱅크의 추가적인 설계 없이 컷 오프 주파수와 샘플레이트를 가변적으로 사용할 수 있는 필터 뱅크를 구현함으로써 하드웨어 면적을 줄일 수 있었다. 또한, 멀티플렉서 (MUX; Multiplexer) 컨트롤을 통해 통과하는 필터의 개수에 따라 샘플레이트를 가변적으로 선택할 수 있는 구조를 제안한다. 제안하는 디지털 필터는 Quartus의 FIR (finite impulse response) IP (intellectual property)의 TDM (time division multiplexing)을 이용함으로써, TDM을 사용하지 않았을 때보다 면적이 큰 DSP (digital signal processing) 블록을 80개에서 1개로 줄일 수 있었다. Kaiser 창 함수를 이용하여 Matlab을 통해 필터의 차수와 계수를 계산하였으며, VHDL (very high speed integrated circuits hardware description language)을 통해 하드웨어로 구현하였다. 텔레메트리 시스템에 적용 후, 실험 결과를 통해 제안하는 디지털 필터가 정상적으로 동작하고 있음을 확인하였다.

• 한국인쇄학회지
• /
• 제26권2호
• /
• pp.31-43
• /
• 2008

The functional dyes, which has various optical characteristics that can be applicable to field of electronic, photo electronic, such as sensor or electrode, were synthesized. Physical property and optical stability was studied with preparation of conductive type film as a kind of optical filter of plasma display panel, by adapting neon cut off dye, which can selectively absorbing between 580 and 610nm wavelength. The filter was prepared with PSA resin, which has functional group of - COOH and - OH, as binder. And the characters such as spectroscopy, heat-proof / wet-proof, thermal stability and commerciality, which must be held by functional dyes, were examined. Conductive type film is the kind of film includes only neon cut off dyes. For the neon cut off dyes, cyanine dyes can be applied. And it is observed that spectrum of before and after the durability test are not changed due to stability of dyes, as the result of coating on the mesh film with PSA binder.

• ETRI Journal
• /
• 제37권5호
• /
• pp.945-950
• /
• 2015

A novel microstrip low-pass filter is presented to achieve an ultra-wide stopband with 11 harmonic suppression and very sharp skirt characteristics. The filter is composed of a modified U-shaped resonator (which creates two fully adjustable transmission zeroes), a T-shaped resonator (which determines a cut-off frequency), and four radial stubs (which provide a wider stopband). The operating mechanism of the filter is investigated based on a proposed equivalent-circuit model, and the role of each section of the proposed filter in creating null points is theoretically discussed in detail. The presented filter with 3 dB cut-off frequency ($f_c=2.35GHz$) has been fabricated and measured. Results show that a relative stopband bandwidth of 164% (referred to as a 22 dB suppression) is obtained while achieving a high figure-of-merit of 15,221.

• 한국소음진동공학회논문집
• /
• 제21권5호
• /
• pp.447-454
• /
• 2011

This paper reports a filtered velocity feedback(FVF) controller, which is an alternative to direct velocity feedback(DVFB) controller. The instability problems due to high frequency response under DVFB can be alleviated by the suggested FVF controller. The FVF controller is designed to filter out the unstable high frequency response. The FVF controller and the dynamics of clamped beams under forces and moments are first formulated. The effects of the design parameters(cut-off frequency, gain, and damping ratio) on the stability and the performance are then investigated. The cut-off frequency should be selected not to affect the system stability. The magnitude of the open loop transfer function(OLTF) at the cut-off frequency should be small. As increasing the gain of the FVF controller, the magnitude of the OLTF is increased, so that the closed loop response can be reduced more. The enhancement of the OLTF at the cut-off frequency is reduced but the phase behavior around the cut-off frequency is distorted, as the damping ratio is increased. The control performance is finally estimated for the clamped beam. More than 10 dB reductions in velocity response can be achieved at the modal frequencies from the first to eighth modes.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2011년도 춘계학술대회 논문집
• /
• pp.264-270
• /
• 2011

This paper reports a filtered velocity feedback (FVF) controller, which is an alternative to direct velocity feedback (DVFB) controller. The instability problems due to high frequency response under DVFB can be alleviated by the suggested FVF controller. The FVF controller is designed to filter out the unstable high frequency response. The FVF controller and the dynamics of clamped beams under forces and moments are first formulated The effects of the design parameters (cut-off frequency, gain, and damping ratio) on the stability and the performance are then investigated. The cut-off frequency should be selected not to affect the system stability. The magnitude of the open loop transfer function (OLTF) at the cut-off frequency should be small. As increasing the gain of the FVF controller, the magnitude of the OLTF is increased, so that the closed loop response can be reduced more. The enhancement of the OLTF at the cut-off frequency is reduced but the phase behavior around the cut-off frequency is distorted, as the damping ratio is increased The control performance is finally estimated for the clamped beam. More than 10dB reductions in velocity response can be achieved at the modal frequencies from the first to eighth modes.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2013년도 춘계학술대회 논문집
• /
• pp.973-974
• /
• 2013

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2011년도 추계학술대회
• /
• pp.396-397
• /
• 2011

본 논문은 LTE-Advanced 시스템을 위한 멀티채널을 선택할 수 있는 저역통과필터를 제안한다. 제안하는 필터는 5 MHz, 10 MHz, 그리고 40 MHz의 3가지 모드의 차단주파수를 제공하며 Active-RC 5차 Chebyshev 구조로 설계되었다. 저전력을 확보하면서 40 MHz의 높은 차단 주파수를 확보하기 위해서 부성 저항을 가지는 PMOS Cross-Connection Load를 사용한 연산증폭기를 필터에 적용하였다. 더불어 공정, 전압, 그리고 온도에 의한 각각의 차단주파수 변화에 대응할 수 있도록 각각 3-bit 제어 가능한 튜닝회로를 추가하였다. 제안하는 필터는 $0.13-{\mu}m$ CMOS 공정을 사용하여 설계하였으며 1.2V 전압에서 총 20.2 mW 전력을 소모한다.

• 전기학회논문지
• /
• 제66권6호
• /
• pp.898-904
• /
• 2017

DFT(Discrete Fourier Transform) is one of the most widely used method to estimate the phasor of a relaying signal. The harmonics are eliminated by the DFT. However, high frequency components, except for harmonics, are not removed and cause an error in DFT-based phasor estimation process. This paper suggests high frequency noise reduction method by using a newly designed low-pass filter to estimate a signal phasor. When selecting a stop-band cut-off frequency of the low-pass filter, high frequency components generated by faults are considered. To reduce the phasor estimation delay caused by a low-pass filter, this paper proposes a low-pass filter whose settling time is reduced. An adverse effect of high frequency noise on DFT-based phasor estimation is reduced. To evaluate the performance of the proposed method, signals which are collected under a fault condition at a 345[kV] transmission system modeled by EMTP-RV are used.

• 핵의학기술
• /
• 제18권1호
• /
• pp.62-68
• /
• 2014

치료 후 I-131 SPECT/CT는 잔류 갑상선 위치확인 및 전이유무를 판단하기 위하여 시행된다. 잔류 갑상선에 집적이 심한 경우 영상은 ringing artifact에 의하여 왜곡된다. 본 연구는 ringing artifact를 제거하고 영상의 질을 향상시키기 위한 적절한 post-filter의 적용에 대하여 제시하고자 한다. 본 실험은 hollow sphere와 아크릴통으로 구성된 phantom을 사용하여 SPECT/CT Discovery 670 (GE Healthcare, USA) 장비로 수행하였다. I-131용액을 hollow sphere에 184, 46, 9.2, 2.3 MBq/cc, 아크릴통에 46 kBq/cc을 각각 주입하였고 sphere 대 background의 비를 4000:1, 1000:1, 200:1, 50:1로 설정하였다. 데이터는 다음과 같은 조건으로 획득하였다(HEGP collimator 사용, Attenuation collection 적용, scan time 40 secs/frame, step angle 6도, scan mode non circular, evolution 적용과 미적용). 획득된 데이터는 OSEM (iteration 2, subset 10) 방식으로 재구성하였다. Post-filer의 사용에 따른 이미지의 변화를 보기 위해 3가지의 다른 post-filer들이 사용되었다(butterworth filter cut-off: 0.38, 0.43, 0.48, 0.53, 0.58, hanning filter cut-off: 0.8, 0.85, 0.9, 0.95, 1, gaussian FWHM: 3, 3.4, 4, 4.5, 5). 각각의 데이터는 MRIcro를 사용하여 contrast ratio, background variability를 분석하였고 e.soft ROI tool을 사용하여 FWHM값을 구하였다. Evolution을 적용한 경우, 모든 결과에서 contrast ratio값이 높게 나타났다. Evolution을 적용하지 않은 경우 star artifact 등 왜곡이 발생하였고 영상의 질이 현저히 낮아짐을 확인할 수 있었다. 4000:1, 1000:1, 200:1의 경우, butterworth filter 사용 시 ringing artifact가 발생하였으며 cut-off값이 커질수록 artifact가 감소하였다. Hanning filter를 사용한 경우 ringing artifact는 발생하지 않았다. Contrast ratio와 FWHM값이 butterworth filter나 hanning filter 적용 시 우수하였다. Gaussian filter경우 contrast ratio와 FWHM값에서 저조한 결과를 얻을 수 있었다. 50:1의 경우, 모든 경우에서 ringing artifact가 발생하지 않았다. Butterworth filter를 적용한 경우 가장 높은 contrast ratio와 가장 우수한 FWHM값을 나타내었다. 본 논문을 통하여 I-131 SPECT에서 ringing artifact가 발생 할 경우(thyroid remnant를 포함) hanning filter를 사용하여 영상을 재구성하고, ringing artifact가 발생하지 않을(remnant thyroid를 포함하지 않음) 경우 butterworth filter를 사용하여 재구성하는 것이 바람직하다는 사실을 알 수 있었다.

• ETRI Journal
• /
• 제33권6호
• /
• pp.985-988
• /
• 2011

A novel application of a dual-transmission line is proposed to design a lowpass filter (LPF). The proposed structure uses only transmission line elements to produce an equiripple LPF response with sharp roll-off. Design equations are derived using a lossless transmission line model. Controlling the electrical lengths, three transmission-zeros are realized in the stopband to obtain a sharp roll-off rate and wide stopband bandwidth. A single unit microstrip LPF with a 3-dB cut-off frequency at 1.0 GHz having a roll-off of 135 dB/GHz along with a stopband bandwidth of 69.5% is designed for validation.