• Journal of Biomedical Engineering Research
• /
• v.30 no.6
• /
• pp.489-494
• /
• 2009

In this study, we fabricated a plastic optical fiber based sensor which can monitor the respiration of a patient. The circumference changes of the abdomen were measured using a mirror, a light source and optical detectors because the circumferences of the abdomen could be varied with respiration. The intensity of the reflected lights were measured according to the changes of distance between mirror and plastic optical fiber connected to a light source and a photodiode-amplifier system using a Y-coupler. The respiration signals of fiber-optic sensor system were compared with those of the respiratory and temperature transducers of the $BIOPAC^{(R)}$ system. It is expected that a fiber-optic respiration sensor could be developed for real time respiration monitoring during MRI procedure based on this study.

• Journal of Sensor Science and Technology
• /
• v.7 no.3
• /
• pp.147-153
• /
• 1998

The strain characteristics of a fiber optic Fabry-Perot pressure sensor with high sensitivity using a $Si_{3}N_{4}/SiO_{2}/Si_{3}N_{4}$ (N/O/N) diaphragm is experimentally investigated. A 600 nm thick N/O/N diaphragm was fabricated by silicon anisotropic etching technology in 44 wt% KOH solution. An interferometric fiber optic pressure sensor has been manufactured by using a fiber optic Fabry-Perot intereferometer and a N/O/N diaphragm. The 2 cm length fiber optic Fabry-Perot interferometers in the continuous length of single mode fiber were produced with two pieces of single mode fiber coated with $TiO_{2}$ dielectric film utilizing the fusion splicing technique. The one end of the fiber optic Fabry-Perot interferometer was bonded to a N/O/N diaphragm. and the other end was connected to an optical setup through a 3 dB coupler. For the N/O/N diaphragm sized $2{\times}2\;mm^{2}$ and $8{\times}8\;mm^{2}$, the pressure sensitivity was measured 0.11 rad/kPa and 1.57 rad/kPa, respectively, and both of the nonlinearities were less than 0.2% FS.

• Korean Journal of Optics and Photonics
• /
• v.7 no.4
• /
• pp.386-389
• /
• 1996

We report on comparative results obtained from harmonically mode-locked laser operations of ring-type and figure-of-eight(F8) type erbium-doped fiber lasers by using a directional-coupler type electro-optic modulator as an active mode-locker. The mode-locked and transform-limited pulses of 10.6 ps width were obtained at harmonics of the fundamental cavity frequency with the F8 type laser while mode-locked laser pulses greater than 15 ps were achieved with the ring type laser.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.07a
• /
• pp.20-21
• /
• 2003

Erbium doped fiber (EDF) sources are useful devices for characterization of optical components for wavelength division multiplexing (WDM) fiber optic communication system. Therefore, there are many efforts to extend the bandwidth and to increase the power of the light source. Especially, L-band ASE source uses the low inversion state of EDF. It makes the power efficiency very low and needs a lot of fiber as several times as the fiber needed in C-band ASE generation. (omitted)

• Journal of Sensor Science and Technology
• /
• v.9 no.1
• /
• pp.15-21
• /
• 2000

Optical fiber temperature sensor, using resonance wavelength shifting of single mode fiber-to-planar waveguide coupler by heat, was fabricated. Thermo-optic polymers, have large change of refractive index due to heat, were used for planar waveguide. The device fabrication procedure including fiber polishing steps was illustrated and the device structure with independent polarization was demonstrated experimentally. The resonance wavelength difference of fabricated device was less than 2nm. The resonance wavelength shifting owing to temperature variation, from room temperature($24^{\circ}C$) to $90^{\circ}C$, was showed $-0.54nm/^{\circ}C$, $-3nm/^{\circ}C$.

• Korean Journal of Optics and Photonics
• /
• v.10 no.3
• /
• pp.201-207
• /
• 1999

The fiber-optical confocal scanning interference microscope with a simple configuration was constructed with a 4-port fiber-optic coupler, and the new method based on the phase shifting method was proposed for surface profiling by the system. In the method, the height of a specimen was determined from the phase of confocal beam. It was verified experimentally that the method was applicable to even the confocal interference microscope with a long-wavelength source and a low NA objective, and that the scanning time could be drastically reduced compared with the conventional method. Finally, it was found that our method is less sensitive to the variation of surface reflectivity than the conventional method.

• 대한공업교육학회지
• /
• v.31 no.1
• /
• pp.185-199
• /
• 2006

In this paper, to detect lateral direction sound pressure fiber optic sensor using Fabry-Perot interferometeric sensor array was fabricated and experimented. This parallel sensor array composed of one light source and the light split into each sensor using directional coupler and to see the output signal the array system do not need any digital signal processor. As a lateral direction sound source arbitrary sound frequency of 100Hz, 200Hz, and 655Hz using by nondirectional speaker were applied to the array sensor which installed on $60cm{\times}60cm{\times}60cm$ latticed structure. The detected signals from the two sensors were analyzed in the time and frequency domains. It was confirmed that the suggested sensor array detected applied sound source well but there were a little amplitude differences in between the sensors. Because the sensor supported simply at both ends theoretical analysis was performed and its solution was suggested. To compare the theoretical and experimental results arbitrary sound frequency of 2kHz was applied to the sensor array. It shows that experimental results was good agreement with theoretical results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.7C
• /
• pp.712-722
• /
• 2002

We have investigated a novel optical decoder for a fiber-optic code division multiple access(CDMA) communication systems. The conventional optical encoder and decoder have the advantage of simple structure. However the number of users in the system is limited by the auto- and cross-correlation properties generated in decoding process. In previous studies, to improve the system performance, although they used an optical code that minimize the sidelobe and cross-correlation, could not yet find a novel methods for performance improvement in fiber-optic CDMA system. Thus, it is necessary to investigate the novel optical decode in order to improve the performance of system. In this paper, we schematize the AND gate logic element(AGLE) composed with 1$\times$2 or 1$\times$3 coupler and the optical thyristor and propose the novel optical decoder using K(weight) AGLE. The optical thyristor only passes the overlapped signal and clips other signals. Such a novel concept means that the optical thyristor can operate as a hard-limiter. We analyze the fiber-optic CDMA system using the novel optical decoder with simulation and is found that the novel optical decoder using the AGLE and optical thyristor excludes the sidelobe and cross-correlation intensity between any two sequences.

• Journal of Sensor Science and Technology
• /
• v.20 no.4
• /
• pp.266-271
• /
• 2011

A reflection-type fiber-optic pH sensor, which is composed of a pH sol-gel film, plastic optical fibers, a mirror, a light source and a spectrometer, is developed in this study. As pH indicators, a bromthymol blue, a cresol red and a thymol blue are used, and they are immobilized in the sol-gel films. The emitted light from a light source is guided by a fiber-optic Y-coupler and plastic optical fibers to the pH sol-gel film in a pH sensing probe. The pH change in the sensing probe gives rise to a change in the color of the pH sol-gel film, and the optical characteristic of reflected light through the pH sol-gel film is also changed. Therefore, we have measured the spectra of reflected lights, which are changed according to the color variations of the pH sol-gel films with different pH values, by using of a spectrometer. Also, the relationships between the pH values and the intensities of reflected lights are obtained on the basis of the color variations of the pH sol-gel films.

• ETRI Journal
• /
• v.18 no.1
• /
• pp.1-14
• /
• 1996

We have experimentally observed and theoretically analyzed the gain dependent optimum repetition rates of a hybrid-type active and passive mode locked laser pulses in an erbium-doped fiber laser of the figure-of-eight geometry by utilizing a nonlinear amplifier loop mirror (NALM) as a saturable absorber and a directional-coupler type electro-optic modulator as an active mode locker. Transform-limited mode-locked pulses of about 10 ps width were obtained at repetition rates which correspond to harmonics of the cavity fundamental frequency and depend on the optical amplifier gain in the NALM.