• Journal of the Korean Society of Safety
• /
• v.35 no.3
• /
• pp.96-104
• /
• 2020

The numerical simulations were conducted to investigate the thermal-fluid phenomena occurred inside the experimental apparatus during a PCCS, used to remove heat released in accidents from a containment of light water nuclear power plant, operation. Numerical simulations of the flow and heat transfer caused by wall condensation inside the containment simulation vessel (CSV), which equipped with 18 vertical heat exchanger tubes, were conducted using the commercial computational fluid dynamics (CFD) software ANSYS-CFX. Shear stress transport (SST) and the wall condensation model were used for turbulence closure and wall condensation, respectively. The simulation using the actual size of the apparatus. However, rather than simulating the whole experimental apparatus in consideration of the experimental cases, calculation resources, and calculation time, the simulation model was prepared only in CSV. Selective simulation was conducted to verify the effects of non-condensable gas(NC gas) concentration, CSV internal pressure, and wall sub-cooling conditions. First, as a result of the internal flow of CSV, it was observed that downward flow due to condensation occurred surface of the vertical tube and upward flow occurred in the distant place. Natural convection occurred actively around the heat exchanger tube. Due to this rising and falling internal flow, natural circulation occurred actively around the heat exchanger tubes. Next, in order to check the performance of built-in condensation model using according to the non-condensable gas concentration, CSV internal flow and wall sub-cooling, the heat flux values were compared with the experimental results. On average, the results were underestimated with and error of about 25%. In addition, the influence of CSV internal pressure and wall sub-cooling was small, but when the condensate was highly generated due to the low non-condensable gas concentration, the error was large compared to the experimental values. This is considered to be due to the nature of the condensation model of the CFX code. However, in spite of the limitations of CFD, it is valid to use the built-in condensation model of CFD for PCCS performance prediction from a conservative perspective.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.62 no.2
• /
• pp.57-64
• /
• 2013

Many accidents are being occurred due to many missteps, etc. at the railway platform. Recently in Korea, efforts to prevent casualties fundamentally are being made by installing and operating the PSD(Platform Screen Door) with underground station building as its center to prevent these casualties of passengers. Although this PSD can solve the problem of public casualties at platform fundamentally, it is impossible to install it at whole station buildings since its installation cost is high, and in case of the ground station building of general railway whose operation speed is higher, installation of PSD is impossible due to the characteristics of railway system. This paper proposes the novel safety equipment using Laser radar sensors for the prevention against casualties of passengers at station buildings where the PSDs are not installed like this. The safety equipment using Laser radar sensors is the safety equipment making an approaching train stopped if the falling object is a person by detecting the obstacle at platform through, and it has the merit possible to apply it to station buildings not only in the underground section but also in the ground section since it may detect accurately under ambient environmental elements such as the snow, rain and yellow dust, etc. also. We developed the prototype of the safety equipment to reduce public casualties at platform by using Laser radar sensors and carried out its performance test, and the result is presented in this paper.

• Journal of the Korean Society of Safety
• /
• v.32 no.6
• /
• pp.54-60
• /
• 2017

A railway rail will be corroded by the repetitive sea wind and fog in the splash and tidal zone such as Youngjong grand bridge. And these rusts of rail could be increased by increasing service period, and it frequently occurred the safety accidents or disorders in electrical problem. In this study, the sacrificial anode cathodic protection method was proposed as a measures for reducing the corrosion of the railway rails in the oceanic climate conditions. As the results of immersion test using the salt water during four months, the sacrificial anode cathodic protection method using the aluminum anode(Al-anode) was evaluated that a distinct effect on corrosion reduction in the rails. Therefore the sacrificial anode cathodic protection method was experimentally proven that a disorders in aspects electric and signal of railway operation condition such as direct fixation track system in Youngjong grand bridge could be prevented by reducing rust falling from the rail. In addition, the installation conditions of the anodes directly affect the transmission range of corrosion potential, the sectional loss of anode, and the corrosion reduction effect. Therefore, to expect the corrosion reduction effect of rails under the oceanic climate conditions for railway track, it was important to adopted the appropriate spacing of anode installation by considering the actual field conditions.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.15 no.6
• /
• pp.83-88
• /
• 2016

Over the last five years, 568 people have died while hiking according to 2015 statistics from the public safety ministry. Among those deaths, approximately 33% were due to loss of footing or falling. In this respect, the highly advanced functions of hiking boots should be considered to prevent these unfortunate accidents. For example, by utilizing the Internet of Things (IoT) and Information and Communications Technology (ICT), hiking boots equipped with a Global Positioning System (GPS) or vital signs monitoring systems should be considered. In addition, many challenges remain for the production of 3D printed hiking boots, because the functions of hiking boots are variable, which is important when handling changing terrains and situations. The design of customized hiking boots was introduced in this paper, and 3D printing applications for midsoles using a Porous Polymer Printing (PPP) method was also suggested to verify the possibility of manufacturing hiking boots.

• Journal of Korea Society of Industrial Information Systems
• /
• v.5 no.1
• /
• pp.77-86
• /
• 2000

Even manual materials handling tasks(MMHT) is decreasing by adopt of automatic manufacturing system & transportation supporting machine because of increase of productivity, wage lack of labor, safety, in fact working at inclined & complicated slope such as farm, orchard, harbor loading & unloading, logging place and mining place can't be substituted by machine perfectly. So, workers should do MMHT at this place by themselves, lifting on slope can cause much of hazard, include falling. Keeping balance net to slip can be a reason of low back pain(LBP) by overloaded musculoskeletal system but, there's no enough study about lift on slope. Therefore, In this study, we assessed and analyzed change of center of pressure(COP) when lifting on slope by force platform. The result showed that the length lengthen as increasing angle of slope. Especially, the length extremely increased over 15°. Through These basic result, present proper angle boundary, prevent industrial accidents and give proper data not only lifting but also pushing and pulling on slope someday.

• Journal of Fisheries and Marine Sciences Education
• /
• v.29 no.1
• /
• pp.137-147
• /
• 2017

An accident during pilotage may cause several problems such as crippling the harbour function, environmental disruption, loss of life. Since the pilot plays an important role in the safe operation of the port, securing their safety is directly connected to the vessel's safety coming into port in Korea. Pilotage service is offered on request without distinction of day and night. And traveling by helicopter and boarding/disembarking using a pilot ladder from and to a pilot boat have a high risk of falling into the sea. So, pilots can fall into the sea while boarding/disembarking from ship which can lead to serious injury by cardiac arrest. A number of pilots have died or severely injured due to fall from the pilot ladder during embarkation and disembarkation up to now. Current safety measures at embarkation and disembarkation required by pilotage act and IMO resolutions could not prevent all the pilot related accidents. Therefore, to prevent pilot accident during boarding/disembarking from ship, it is necessary to include safety training requirement for new pilots under the requirements for licensing of pilotage act. It is also necessary to compel pilots to take necessary personal protective equipment when they use a pilot ladder. In addition, the placement of emergency kit on pilot boats and first-aid training are required in order to deal with emergency situation promptly.

• Journal of Trauma and Injury
• /
• v.23 no.2
• /
• pp.175-179
• /
• 2010

Purpose: Sternal fractures after blunt thoracic trauma can cause significant pain and disability. They are relatively uncommon as a result of direct trauma to the sternum and open reduction is reserved for those with debilitating pain and fracture displacement. We reviewed consecutive 11 cases of open reduction and fixation of sternum and tried to find standard approach to the traumatic sternal fractures with severe displacement. Methods: From December 2008 to August 2010, the medical records of 11 patients who underwent surgical reduction and fixation of sternum for sternal fractures with severe displacement were reviewed. We investigated patients' characteristics, chest trauma, associated other injuries, type of open reduction and fixation, combined operations, preoerative ventilator support and postoperative complications. Results: The mean patient age was 59.3years (range, 41~79). The group comprised 6 male and 5 female subjects. Among 11 patients who underwent open reduction and fixation for sternal fracture with severe displacement, 6 cases had isolated sternal fractures and the other 5 patients had associated other injuries. Sternal fractures were caused by car accidents (9/11, 81.8%), falling down (1/11, 9.1%) and direct blunt trauma to the sternum (1/11, 9.1%), respectively. 3 of the 7 patients (42.9%) who underwent sternal plating with longitudinal plates showed loosening of fixation. Otherwise, none of the 4 patients who underwent surgical fixation using T-shaped plate had stable alignment of the fracture. Conclusion: Sternal fractures with severe displacement need to be repaired to prevent chronic pain, instability of the anterior chest wall, deformity of the sternum, and even kyphosis. In the present study, a T-shaped plate with a compression-tension mechanism constitutes the treatment of choice for displaced sternal fractures.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.19 no.2
• /
• pp.122-134
• /
• 2020

To improve traffic congestion, reduce fuel consumption, and improve the stability of truck operations, truck platooning, in which several trucks are organized in a single platoon, is being actively researched globally. Compared to the operation of a single truck, the operation of a truck platoon requires more caution before the actual operation because an accident of one vehicle in the platoon can lead to an accident with all the vehicles in the platoon. Therefore, this study examined the types of trucks and cargo suitable for truck platooning to prevent safety accidents. The review showed that a closed-van-type truck is appropriate for truck platooning to prevent falling objects during driving. In the case of cargo types, it is necessary to exclude liquids and dangerous goods defined in related laws from truck platooning.

• Korean Institute of Interior Design Journal
• /
• v.26 no.1
• /
• pp.53-62
• /
• 2017

It is very important for the elderly to maintain their independence and to live safe and comfortable daily lives in order to lead an independent life. The bathroom in the house has the greatest number of fall accidents and has a great influence on the independence of the elderly. Therefore, the purpose of this study is to develop a bathroom design method that improves the independence of the elderly whose physical function is deteriorated through preventing falls. In this study, first of all, we investigated the causes of falling in bathrooms based on the previous studies, and identified the intelligent services that can prevent falls and selected them according to individual needs. Secondly, we investigated the bathroom size of the apartment among the various housing type, analyzed the type of the bathroom, and developed a standard type of the bathroom. Thirdly, we analyzed the design guidelines for the elderly residents in Korea and proposed improvement directions. We also divided the intelligent sanitary appliances and fall-prevention products and proposed the installation method and directions. Therefore, the comprehensive bathroom design standards and proposals proposed in this study will be the basis of bathroom design to prevent falls and improve independence of the elderly, and it will be easy to understand and help the designer in designing. Finally, this study is meaningful in that it provides independence of the elderly through fall prevention and increases the easiness of hygiene action and suggests direction to maintain self-sustaining life of the elderly.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.5
• /
• pp.452-458
• /
• 2016

This is a descriptive study on visiting caregivers' perception of restraint use. Data were collected from 113 caregivers working at long-term facilities using a structured questionnaire from Feb to March 2016. The caregivers' perception of restraint use was the medium score. The items they considered the most important reasons for the restraints was "Protecting an older person from falling out of bed", which was primarily intended to prevent accidents of the elderly. The score of the knowledge of restraint use was 11.23 points out of 18 and those affected were more than 50 years of age. The attitude score to the use restraints was 9.19, and caregivers thought it should be possible to refrain from using restraints. Work experience of 3 years or less were higher. The perception of using restraints is affected by the knowledge and attitudes of restraint use. This is very important for the elderly in long-term care facilities and is related to health and human rights. Therefore, it is important to provide continuous education related to the use of restraints and regulations on their management.