• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.3 s.345
• /
• pp.49-58
• /
• 2006

In this paper, a curve-fitting channel estimation method is proposed for orthogonal frequency division multiplexing (OFDM) system in a time-varying frequency-selective fading channel. The method can greatly improve channel state information (CSI) estimation accuracy by performing smoothing and interpolation through consecutive curve-fitting processes in both time domain and frequency domain. It first evaluates least-squares (LS) estimates using pilot symbols and then the estimates are approximated to a polynomial with proper degree in the LS error sense, starting from one preferred domain in which pilots we densely distributed. Smoothing, interpolation, and prediction are performed subsequently to obtain CSI estimates for data transmission. The channel estimation processes are completed by smoothing and interpolating CSI estimates in the other domain once again using the channel estimates obtained in one domain. The performance of proposed method is influenced heavily on the time variation and frequency selectivity of channel and pilot arrangement. Hence, a proper degree of polynomial and an optimum approximation interval according to various system and channel conditions are required for curve-fitting. From extensive simulation results in various channel environments, we see that the proposed method performs better than the conventional methods including the optimal Wiener filtering method, in terms of the mean square error (MSE) and bit error rate (BER).

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.8 s.338
• /
• pp.33-40
• /
• 2005

This paper presents a structure of the searcher using a diversity in array antenna systems operating in the cdma2000 1x signal environments. The new technique exploits the fact that the In-phase and quadrature components of interferers can respectively be viewed as an independent gaussian noise at each antnna element in most practical cdma signal environments. The proposed PN acquisition scheme is a singles-dwell PN acquisition system consisting of two stages, that is, the searching stage and the verification stage. The searching stage independently correlates the receiver multiple signals with PN generator of each antenna element for obtaining the synchronous energy at the entire region. Then, the searching results of each antenna element are non-coherently combinind. The verification stage compares the searching energy with the optimal threshold, which is predesigned in the lock detector, and decides whether the acquisition is successful or fail. In this paper, we analyzed the effect of tile diversity order to determine the mean acquisition time. In general, it is known that the mean acquisition time significantly decrease as the number of antenna elements increases. But, as the diversity order goes up, the enhancement of the performance is saturated. Therefore, to decrease the mean acquisition time of the searcher, we must design the optimal array antenna systems by considering the operating SNR range of the receiver, the probability of detection $P_D$ and that of false alarm $P_{FA}$ . The Performance of the proposed PN acquisition scheme is analyzed in frequency selective Rayleigh fading channels. In this paper, the effect of the number of antenna elements on PN acquisition scheme is shown according to the probability of detection $P_D$ and that of false alarm $P_{FA}$.

• Journal of KIISE:Computer Systems and Theory
• /
• v.26 no.8
• /
• pp.984-998
• /
• 1999

최근 개인 휴대 통신에 대한 관심도가 증가하면서 B-ISDN (Broadband Integrated Services Digital Network)과 같은 기존의 유선 망에서 제공하던 다양한 멀티미디어 응용 지원을 무선 망으로 확장시키기 위한 연구가 활발히 진행되고 있다. 그러나 기존의 유선 망에서는 멀티미디어 응용 지원을 위해 QoS (Quality of Service) Provisioning에 관한 많은 연구가 되어 있으나 무선 망에서는 이동성과 무선 전파의 열악한 전송으로 인해 새로운 QoS Provisioning 방법에 관한 연구가 필수적이다. 본 논문에서는 이러한 무선 망의 특수성으로 인해 발생할 수 있는 서비스의 질 저하와 강제 종료를 줄임으로써 지속적인 QoS를 보장해 주고 한정된 무선 자원을 효율적으로 사용하며 처리에 의한 오버헤드를 줄이기 위하여 다음과 같은 세 가지 방법을 제안하였다. 첫째, 핸드오프 강제 종료율을 줄이기 위하여 대역폭 예약 방법을 사용하되 특정 셀의 트래픽 특성에 맞게 또한 시간대에 따른 트래픽 특성에 따라 예약 대역폭의 양을 조절하는 적응적 대역폭 예약 방법이다. 둘째, 많은 경우 각 셀의 트랙픽 변화는 일정한 주기로 변화한다는 특성에 따라 과거의 트래픽 정보를 이용하는 예측 기반의 대역폭 예약 방법이다. 마지막으로 호의 종류, 트래픽 특성, 단말기의 이동 속도에 따라 다른 우선 순위에 의해 호 수락 제어를 수행하는 우선 순위 기반의 호 수락 제어를 제안하였다. 시뮬레이션을 통하여 기존에 제안된 방법과 성능 비교하여, 요구되는 수준의 QoS 보장과 효율적인 자원의 사용, 요구되는 처리비용의 최소화를 통해 전체 시스템의 성능 향상을 입증하였다.Abstract As interest in wireless hand-held terminals and in personal communications services increases recently, there have been broad studies on the ways to support multimedia applications provided in wired networks such as B-ISDN (Broadband Integrated Services Digital Network) in wireless networks. However, since many studies have focused on Quality of Service (QoS) Provisioning in wired networks to provide multimedia applications, new methods of QoS Provisioning are needed in wireless networks to resolve the problem of wireless channel fading and the difficulty of mobility occurred in wireless networks. This paper proposes three schemes of QoS Provisioning in wireless networks which will make continuous QoS guarantee and efficient use of limited wireless resources possible. The first scheme reserves bandwidth in proportion to the amount of real-time traffic in the neighbor cells to decrease the handoff dropping rate of delay sensitive real-time connections, adapting reserved bandwidth for efficient resource utilization. The second scheme is predictive bandwidth reservation scheme that utilizes the past handoff information. It can decrease overheads required to adapt bandwidth reservation. The last scheme is priority-based call admission control prioritizing traffic type (real-time traffic/ non-real-time traffic), connection type (new connection /handoff connection), and mobile terminal speed (fast mobile/slow mobile). Simulation results show that the proposed QoS Provisioning schemes improve the total system performance by achieving three goals - required QoS guarantee, higher bandwidth utilization and less overhead.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.8A
• /
• pp.745-751
• /
• 2006

The transmitter requires knowledge of the channel status information in order to adopt the adaptive modulation and coding scheme(AMC) for OFDM system. But in the outdoor environment which the users have high mobility, the channel status information from the users is outdated, so that it induces the degradation of system throughput and packet error rate(PER) performance. To solve this problem, researches about applying channel prediction technique to the AMC scheme have been proceeded. Most channel prediction techniques assume that there is no channel variation in the predefined time duration, e.g., a slot. As a result, those techniques cannot compensate the degradation of PER performance resulting from the rapid variation of channel during the slot duration. This paper introduces a novel channel prediction technique for OFDM/FDD system to support adaptive modulation and coding scheme over rapidly time-varying multipath fading channel. The proposed channel prediction technique considers the time-varying nature of channel during the slot duration. Simulation results show that the AMC scheme of OFDM/FDD system utilizing the proposed channel prediction technique can guarantee the target PER of 1% without any loss of system throughput compared with the case supported by the conventional channel prediction under ITU-R Veh A 30km/h.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.5
• /
• pp.421-427
• /
• 2009

This paper has proposed 1-2-1 coded cooperative communication that is a combination of STBC and ARQ. Coded cooperative communication is a protocol that integrates channel coding with cooperative communication. In this paper consider convolution encoder. ARQ method can increase the spectral efficiency than conventional cooperative communication because if the received signal from source node is satisfied by the destination preferentially, the destination transmits ACK message to both relay node and source node and then recovers the received signal. Where each relay 1, 2 forwards a punctured portion of receive data. When relay transmit to destination apply STBC the reliability to increase. Moreover this protocol can get better BER performance of receiver using simple comparator. We verified BER performance for the proposed protocol through Monte-Carlo simulation over Rayleigh fading plus AWGN.

• Journal of the Korean Chemical Society
• /
• v.38 no.12
• /
• pp.880-884
• /
• 1994

An indirect spectrophotometric method, presumably heretofore unmentioned, for the rapid determination of COD in the presence of chloride of high concentration is described. The alkaline sample is refluxed to react with a definite amount of permanganate, present in excess. A photometric measurement at 535 nm for the extent of the fading of the permanganate color after refluxing completes the procedure. The optimum conditions which give the absorbance-concentration plot the maximum linearity and slope in the range of 0∼5 ppm COD are as follows: reflux at $100\circC$ for 10 min in the presence of 0.15 mM permanganate and 0.2% NaOH with a sample size of 5 ml. An overall running time was less than 15 min. The t-test reveals that the proposed method is not significantly different from the official method.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.7
• /
• pp.1287-1294
• /
• 2006

In many current wireless packet data system, the short-burst transmissions are used, and training overhead is very significant for such short burst formats. So, the availability of the short training sequence and the fast converging algorithm is essential in the adaptive equalizer. In this paper, the new equalizer algorithm is proposed to improve the performance of a MTLMS (multiple-training least mean square) based DFE (decision feedback equalizer)using the short training sequence. In the proposed method, the output of the DFE is fed back to the LMS (least mean square) based adaptive DEF loop iteratively and used as an extended training sequence. Instead of the block operation using ML (maximum likelihood) estimator, the low-complexity adaptive LMS operation is used for overall processing. Simulation results show that the perfonnance of the proposed equalizer is improved with a linear computational increase as the iterations parameter in creases and can give the more robustness to the time-varying fading.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.6
• /
• pp.94-102
• /
• 2009

In [1], the authors have proposed a novel scheme to achieve full diversity and to combat the time delays from each relay node, but decode-and-forward (DF) model operation mode puts more processing burden on the relay. In this paper, we not only extend their model into amplify and forward (AF) model proposed in [2],[3], but also propose an efficient decoding algorithm, which is able to order the joint channel coefficients of overall channel consisting of source-relay link and relay-destination link and cancels the previous decoded symbols at the next decoding procedure. The simulation results show that this algorithm efficiently improves its performance achieving 2-3dB gain compared to [1] in high SNR region and also useful to DF achieving more than 3dB gain compared to an original algorithm.

• The Journal of Korea Robotics Society
• /
• v.12 no.3
• /
• pp.350-355
• /
• 2017

UWB (Ultra Wide Band) refers to a system with a bandwidth of over 500 MHz or a bandwidth of 20% of the center frequency. It is robust against channel fading and has a wide signal bandwidth. Using the IR-UWB based ranging system, it is possible to obtain decimeter-level ranging accuracy. Furthermore, IR-UWB system enables acquisition over glass or cement with high resolution. In recent years, IR-UWB-based ranging chipsets have become cheap and popular, and it has become possible to implement positioning systems of several tens of centimeters. The system can be configured as one-way ranging (OWR) positioning system for fast ranging and TWR (two-way ranging) positioning system for cheap and robust ranging. On the other hand, the ranging based positioning system has a limitation on the number of terminals for localization because it takes time to perform a communication procedure to perform ranging. To overcome this problem, code multiplexing and channel multiplexing are performed. However, errors occur in measurement due to interference between channels and code, multipath, and so on. The measurement filtering is used to reduce the measurement error, but more fundamentally, techniques for removing these measurements should be studied. First, the TWR based positioning was analyzed from a stochastic point of view and the effects of outlier measurements were summarized. The positioning algorithm for analytically identifying and removing single outlier is summarized and extended to three dimensions. Through the simulation, we have verified the algorithm to detect and remove single outliers.

• The Journal of the Korea Contents Association
• /
• v.14 no.11
• /
• pp.355-361
• /
• 2014

The aim of the present study was to evaluate a relative emission of image plate (IP) in computed radiography (CR) system by using relative sensitivity in film/screen methods. The characteristic curve was obtained by using the uniform aluminum 11-step wedge penetrometer. X-ray exposure factors on radiographic digital image were 50 kVp, 10 mAs. We adjusted zero of all parameter of algorithms (MUSICA) so proximate to raw data and applied to 200 of exposure class. Modeling on relative emission of IP are used IP without fading time and IP after 4 hours, 8 hours, 12 hours, 24 hours in the respective storage after X-ray exposure. The results of this study showed that the sensitivity point density at the measuring of relative sensitivity in CR was suited pixel values of the 2000 easy to relatively measure the characteristic curve and when relative sensitivity is decreased, the amount of light emitted from the image signal for generating was also decreased. In conclusion, the proposed method of measurement of relative sensitivity can be utilized to evaluate the quantity of relative emission of IP in CR system.