• Journal of the Korean Institute of Telematics and Electronics
• /
• v.20 no.2
• /
• pp.29-34
• /
• 1983

A simulated inductance, with a phase parameter control circuit containing only two resistors and one operational amplifier, is realized as a two terminal network. Analytical results of the proposed circuit avow that we can realize a simulated inductance for constant inductance value, and experimental results confirm the theoretical predictions. Error of maximum 4%, between theoretical and experimental results of equivalent inductance, has been observed over a wide range of frequencies up to about 100 KHz.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.991-994
• /
• 1998

We demonstrate wavelength conversion of 2.5 Gb/s optical signals by cross-gain modulation (XGM) in a semiconductor optical amplifier (SOA). We investigate the effect of input pump and probe powers on the extinction ratio and power penalty to be a measure of performance in wavelength converters. As a result, we show that the best bit error rate (BER) performance can be obtained when the probe power is kept 3 dB weaker than the pump power. And we investigate the effect of wavelength detuning on performance in wavelength converters.

• Proceedings of the IEEK Conference
• /
• 2000.09a
• /
• pp.951-954
• /
• 2000

In this paper, we present a multi-code parallel combinatory CDMA system using bi-orthogonal modulation to reduce envelope variation and improve bit error. .rate (BER) performance. In general, the dynamic range of the amplitude of the transmit signal is very large in the case of conventional multi-code CDMA systems, resulting in severe nonlinear distortion due to high power amplifier and thus significant BER performance degradation. The proposed system exhibits reduction of peak-to-average power ratio (PAPR) of the transmit signal amplitudes and significant performance improvement. We verify the performance of the proposed system by computer simulations under AWGN channel and flat fading channel.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.33B no.3
• /
• pp.56-61
• /
• 1996

In this paper, new buck converter of a TV power system is presented. First, we devised a revised driving circuit for an emitter-coupled type buck converter, by which it is possible to reduce the material cost of transformers and voltage stress of power device. Secondly, we adopted a hybrid oscillation technique. When TV system is in off-stage, initial standby power which is necessary for remote controllable TV system is supplied by self-oscillating mode. Main power which is necessry in TV system bing on state is provided by an externally triggered oscillating mode. The switching frequency is synchronized to the oscillating frequency of horizontal deflection in TV, by which we can reduce picture noises and the size of power transformer. Thirdly, a simple error amplifier is inserted to the feed-back loop to keep the output voltage constant which means pulse width modulatio mode is added in driving part of power device. Finally, we showed by experiments that our proposed converter performs well enough to be close to the theoretically predicted values.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2005.05a
• /
• pp.106-110
• /
• 2005

In this paper, LED traffic signal lamp's operating circuit using Flyback converter and PFC IC has been presented. Most power conversion circuits use PFC IC for Power Factor Correction. The design parameter's value of Flyback converter has been proposed and the error amplifier which regulates the output voltage has been designed Besides, the under voltage protection circuit and the over voltage protection circuit for protecting the operating circuit kin unbalance of common electric power source and the temperature compensation circuit for fixed optical output power have been proposed.

• Journal of Power Electronics
• /
• v.14 no.6
• /
• pp.1263-1271
• /
• 2014

A novel hysteresis PWM control strategy for synchronous buck converter is proposed. The proposed control strategy is based on ampere-second balance of the modulate capacitor, which not only offers faster transient response to meet the challenges of the power supply requirements of fast dynamic load changes, but also provides better stability and solves the compensation problem of error amplifier in the conversional voltage PWM control. Finally, the steady-state and dynamic operation of the control method is analyzed and verified by simulation and experimental results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.4B
• /
• pp.520-527
• /
• 2001

육상이동위성 채널에서 고속 광대역의 정보를 효율적으로 전송하기 위한 최적 방안으로 OFDM(Orthogonal Frequency Division Multiplexing) M-ary PSK를 들 수 있다. 그러나 가입자 단말기 또는 위성중계기의 송신단 고출력 증폭기(HPA : High Power Amplifier)를 전력효율적인 비선형 mode에서 동작할 때, OFDM M-ary PSK 시스템의 최대 전력 대 평균전력의 비(PAPR : Peak-to-Average Power Ratio)가 부바송파 개수만큼 선형적으로 커져 단일 반송파 변조방식에 비해 비선형 왜곡에 의한 성능 열화가 심각하다. 본 논문에서는 이와 같은 성능 열화를 개선하기 위하여 전송채널에서 대역효율과 BER(Bit Error Rate) 성능이 우수한 PC(Parallel Combinatory) OFDM 방식과 개선된 PAPR을 가지는 PTS(Partial Transmit Sequence) OFDM 방식을 결합한 Combined PC & PTS OFDM 방식을 제안하고 그 성능을 분석하였다.

• Proceedings of the KSRS Conference
• /
• 2006.03a
• /
• pp.315-318
• /
• 2006

Pushbroom 방식의 CCD 영상에서 발생하는 pixel들 사이의 Non-uniformity 원인은 CCD pixel 면적의 차이, Dark current 영향, Output amplifier 차이, input radiance의 차이 등과 같은 CCD의 특성에 의해 발생하게 되며, CCD의 특성에 의해 발생되는 pixel사이의 상대복사량 차이인 Non-uniformity errors은 위성영상에서 줄무늬의 일차적 원인이 된다. 이러한 CCD의 상대복사보정을 위해서는 일차적으로 CCD의 특성을 잘 파악할 수 있는 지상에서 보정 값이 계산되어져야 하며 위성발사 후 보정 값이 다시 update 되어야 한다. 본 연구에서는 다목적실용위성2호의 상대복사보정을 위한 준비로서, 지상에서 만들어진 MSC CCD PAN1 영상과 Pushbroom 방식의 다목적실용위성1호 영상을 시험자료로 이용하여 pixel 사이의 줄무늬를 제거하기 위한 상대복사보정을 수행하였다.

• Proceedings of the KWS Conference
• /
• 2000.04a
• /
• pp.99-102
• /
• 2000

Conventionally, ZVS FB DC/DC converter was controlled by monolithic IC UC3879, which includes the functions of oscillator, error amplifier and phase-shift circuit. Also, microprocessor and DSP have been widely used for the remote control and for the immediate waveform control in ZVS FB DC/DC converter. However the conventional microprocessor controller is complex and difficult to control because the controller consists of analog and digital parts. In the case of the control of FB DC/DC converter, the output is required of driving a direct signal to the switch drive circuits by the digital controller. So, this paper presents the method and realization of designing the digital-to-phase shift PWM circuit controlled by DSP (TMX320C32) in a 2,500A, 40㎾ WS FB DC/DC converter.

• Journal of the Optical Society of Korea
• /
• v.15 no.3
• /
• pp.222-226
• /
• 2011

We demonstrated the feasibility of an amplified wavelength-division multiplexed passive optical network (WDM-PON) architecture based on broadband light source (BLS) seeded optical sources and a novel bidirectional reach extender. Our bidirectional reach extender could provide an amplification of both downstream and upstream signals as well as a BLS output for the upstream WDM signal generation. An error-free 1.25 Gb/s signal transmission over a 100-km long single-mode fiber was achieved in a bidirectional WDM-PON using BLS seeded reflective semiconductor optical amplifier (RSOA) sources.