• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.12
• /
• pp.6159-6166
• /
• 2012

A discharge measurement is difficult in flood season which is especially important in the water resources field and the continuous discharge measurement for all rivers is impossible on the present system. So, the stage-discharge curve has been used for a long time to produce discharge data of rivers. However, there has been problems from a reliability angle due to the fact that this method uses only stage-discharge relationship, although the stage-discharge curve has the convenience. Therefore, a new mean velocity equation was derived by using Chiu's 2D velocity formula of the entropy concept in this paper. The derived equation reflected hydraulic characteristics such as the depth, gravity acceleration, hydraulic radius, energy slope, kinematic coefficient of viscosity, etc. and estimated also a maximum velocity. In addition, this method verified the relationship between a mean and maximum velocity and estimates an equilibrium state ${\phi}(M)$ well presenting properties of a river cross section as the results. The mean velocity was estimated by using the equilibrium state ${\phi}(M)$, and then the discharge was estimated. To prove this equation to be accurate, the comparison between the measured and estimated discharge is conducted by using the measured laboratory data in the unsteady condition flow showing loop state and the results are consistent. If this study is constantly carried out by using various laboratory and river data, this method will be widely utilized in water resources field.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.16 no.6
• /
• pp.585-597
• /
• 2014

In this study, the cutter acting forces were measured by 3-directional load cell at two different skew angles and various S/d ratios during a series of linear cutting tests using a slim conical pick. The analysis for cutting performance were carried out after calculating average values of the measured results. The increase of penetration depth results in the decrease of specific energy. And the variations of the cutter acting forces depending on penetration depth in the case of 6 degree skew angle were smaller than in the case of 0 degree skew angle. From this results, 6 degree skew angle is more effective than 0 degree skew angle in designing optimal specifications of cutting head. In addition, $F_c/F_n$ under the setting of 6 degree skew angle was smaller than under the setting of 0 degree skew angle. However, it should be considered that the increase of cutter acting force in the cutting direction accompanied the increase of driving force in the case of the setting for 6 degree skew angle.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.18 no.2
• /
• pp.221-233
• /
• 2016

In order to estimate the performance of a conical cutter depending on the insert size, this study measured forces acting on conical cutters with different cutter spacings, penetration depths and skew angles using slim and heavy conical cutters. When cutter spacings ranged from 12 to 27 mm, the deviations of mean cutter forces with cutter depths appeared smaller compared to other cutter spacings. When skew angle is $0^{\circ}$, the optimal S/d ratio was obtained in the range of 4 to 4.5 for which specific energy of cutting was minimized. It were usually found in the range of 1 to 5. However, when skew angle is $6^{\circ}$, the optimal S/d ratio was obtained in the range of 1 to 3. The simple comparison results shows that the performance of slim cutter was superior to that of heavy cutter, but the use of heavy cutter can be effective, considering the cutter consumption and cutter damage when the strength of the ground is high enough.

• The Korean Journal of Quaternary Research
• /
• v.1 no.1
• /
• pp.3-20
• /
• 1987

With regard to the Quaternary formations in the Korean Peninsula, very few studies have been done specially from a stratigraphic viewpoint. The alluvial sediments filling in the valleys have often been considered as the only formation of Quaternary age (more precisely of the Holocone) and so the Pleistocene was regarded as an erosional or nondepositional episode. This is apparently evident from a quick look at the general geological maps of the Peninsula, which show a lithological sequence of Mesozoic or Paleozoic substrata immediately overlain by Holocene alluvium. Likewise, the Pleistocene period was described in terms of unconformity in most local or regional stratigraphical successions of the Peninsula. Recently several different types of Quaternary formation, besides the so-called Holocene alluvium in the valley plain have been found around the Peninsula. They consist of coastal deposits, marine or fluviatile terrace deposits, ancient valley fill deposits or slope deposits. Some parts of the volcanic sediments in Jeju Is. are also known as the Quaternary sequence. Thus the Quaternary deposits in the Peninsula are far more developed than previously known to gelolgists. Moreover the importance of Quaternary research became recently apparent in Korea due to the shortage of raw materials and to the policy of an optimum land-use. Advanced constructions and land reclamation have required more precise engineering parameters of loose materials and an estimation of land stability. This does not imply only the engineering, or the structural properties of the loose material, but at the same time the basic study of the sediments from the stratigraphical and environmental viewpoints has been necessary. In this connection, Quaternary outcrops specially along the coastal fringe of the Peninsula have been mapped, profiled and sampled for sedimentological, clay-mineralogical and palaeomagnetic studies. All these results are compiled for the core of the Quaternary stratigraphy of the Peninsula.

• Environmental and Resource Economics Review
• /
• v.29 no.1
• /
• pp.23-45
• /
• 2020

The rapid economic growth has brought tremendous pressure on the environment and caused severe air pollution in China. This study empirically examines causes of air pollution in China. Panel-corrected standard errors procedure (PCSE) was used to analyze major determinants of increasing or reducing emissions of sulfur dioxide (SO₂) and nitrogen oxides (NO_X) in 30 Chinese provinces. The estimation results show that SO₂ emission is mitigated as per capita regional GDP increases, but the relation between emission of NO_X and per capita regional GDP is found to have an inverse N-shaped curve, which implies that emission of NO_X is ultimately expected to decline with economic growth. As for increasing factors of air pollutants, electricity consumption is a significant common source of SO₂ and NO_X emissions. Moreover, the results show that increment of coal consumption significantly affects emission of SO₂ while increase of natural gas consumption reduce emission of SO₂. On the other side, investment in energy industry, and investment on treatment of waste gases are determinants of mitigating emissions of SO₂, but have no impact on NO_X. Consumption of diesel, truck ratio and number of vehicles increase emission of NO_X. Meanwhile, higher precipitation rate is a common determinant of mitigating emissions of SO₂ and NO_X. Policy implications are suggested in the conclusion.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.7
• /
• pp.506-513
• /
• 2014

The objective of this study is to establish the greenhouse gases (GHG) inventories and estimate the GHG reduction plans for Daegu University from 2009 to 2011. The annual average of GHG emissions in Daegu University was estimated to be 19,413 ton $CO_2$ eq during the study period. Emissions of electricity usage in Scope 2 most contributed about 55.4% of the total GHG emissions. Also, GHG emissions of Scope 2, Scope 1, and Scope 3 contributed 60.4%, 22.6%, and 17.0%, respectively. In order to estimate reduction potential of GHG, the Long-range Energy Alternatives Planning (LEAP) model was calculated using three scenarios such as sensor installation, LED replacement, and solar facility. The GHG will be reduced by 1,656 ton $CO_2$ eq for LED scenario, by 1,041 ton $CO_2$ eq for sensor scenario, and by 737 ton $CO_2$ eq for solar scenario compared to 2020 business as usual (BAU). Therefore, the total GHG emissions in 2020 apply three scenarios can be reduced by 15% compared with 2020 BAU.

• Journal of Distribution Science
• /
• v.13 no.11
• /
• pp.101-109
• /
• 2015

Purpose - A traditional retail market is a place that offers economic opportunity to employees and employers alike it also is a place where the community can meet. The Korean government has invested three trillion won to improve physical and non-physical aspects in traditional retail markets since 2004. However, little research on this has been conducted. We explore this research gap that could lead to theory extension. We analyze consumption behavior with respect to traditional retail markets through an empirical analysis, thus overcoming limits in previous research. We empirically analyze policy effects of traditional retail market projects supported by the Korean government. Research design, data, and methodology - We propose a traditional retail market improvement plan via the relation between cause and effect resulting from the analysis. More specifically, logit analysis was carried out with 1,754 consumers in 16 cities nationwide. In order to analyze consumer consumption behaviors nationwide, the probability was analyzed using a logit model. This research analyzes the link between support and non-support by the Korean government using binary values. The dependent variable is whether Korean government support is implemented; the binomial logistic regression is used as the statistical estimation technique. The object variables are:1 (support) or 0 (nonsupport), and the prediction value is between 1 and 0. As a result of the factor analysis of questions related to attributes of service quality, four factors were extracted: convenience, product, facilities, and service. Results - The results indicate that convenience, product, and facilities have a significant influence on consumer satisfaction in accordance with the government's traditional retail market support. Additionally, the results reveal that convenience, product, facilities, and service all have a significant influence on consumer satisfaction in a traditional retail market's service quality and consumer satisfaction. Finally, the analysis indicates that the highly satisfied traditional retail market customer has a significant influence on revisit intention. Moreover, the results reveal that the highly satisfied traditional retail market customer has a significant influence on recommendation intention. Conclusions - This research focused on consumers nationwide to measure policy effects of traditional retail markets compared to previous research that focused on one traditional retail market or a specific area. We verified the relationship of service quality and customer satisfaction and consumer behavior based on service quality theory. The results indicate that consumer satisfaction of traditional retail markets supported by service quality factors has a significant impact. In a concrete form, the results indicate that these effects are from facility modernization projects and marketing support projects of the Korean government. The results also imply that these facility and management support effects from the Korean government have been consistent. We realize that the Korean government has to selectively support traditional retail markets in major cities and small and medium-sized cities. To that end, the Korean government needs to select a concentration strategy for the revitalization of traditional retail markets.

• Korean Chemical Engineering Research
• /
• v.54 no.3
• /
• pp.404-409
• /
• 2016

Thermal Characteristics and kinetic parameters of $LaMnO_3$ synthesis reaction were investigated by means of TGA (Thermogravimetric analysis) at non-isothermal heating conditions (5.0, 10.0, 15.0 and 20.0 K/min). The reaction was occurred rapidly at 450~600K (X=0.4~0.7) depending on the heating rate. Activation energy for the synthesis of $LaMnO_3$ from the precursor, which was determined by different method such as Friedman, Ozawa-Flynn-Wall and Vyazovkin methods, was in the range of 23~243 kJ/g-mol depending on the fractional conversion level and estimation method. The reaction order decreased with increasing heating rate and fractional conversional level. The average reaction order was 4.50 in case of X=0.1~0.3, while it was 1.87 in case of X=0.7~0.9, respectively. The value of frequency factor of reaction rate increased with inceasing heating rate and fractional conversion level. The aveage value of frequency factor was 205.6 ($min^{-1}$) when X=0.1~0.3, while it was 475.2 ($min^{-1}$) when X=0.7~0.9, respectively.

• Journal of Korea Water Resources Association
• /
• v.43 no.5
• /
• pp.445-453
• /
• 2010

Energy loss at manholes, often exceeding friction loss of pipes under surcharged flow, is considered as one of the major causes of inundation in urban area. Therefore, it is necessary to analyze head losses at manholes, especially in case of surcharged flow. Hydraulic experimental apparatus which can change the manhole shape (square, circular) were installed for this study. In the experiments, two inflows ($Q_1,\;Q_2$) were varied from 0 to $4{\ell}$/sec and 15 combinations were tested in total. The flow ratios $Q_2/Q_3$ were varied from 0 to 1 for a total flow $Q_3$ ($Q_3=Q_1+Q_3$) of 2, 3, and $4{\ell}$/sec, respectively. The variation of head losses were strongly influenced by the lateral inflow because the head loss coefficient increases as the flow ratio $Q_2/Q_3$ increases. There was no significant difference of head loss between square manhole and circular one, and also no large variation of head loss as discharges change. The relation equations between K and $Q_2/Q_3$ were suggested in this paper.

• Journal of Korean Society of Transportation
• /
• v.23 no.5 s.83
• /
• pp.7-14
• /
• 2005

Traffic congestion causes enormous social costs as well as loss of travel time and waste of energy. Though the Seoul metropolitan government implemented various forms of transportation policies such as urban road pricing and public transportation reform, traffic volume which across the Seoul metropolitan borders have greatly increased because of housing land development in suburban area. The purpose of this study is to estimate individual's willingness-to-pay(WTP) for extensive implementation of congestion pricing through policy-mix with bus rapid transit(BRT) system. So the field survey interviews carried out. The empirical analysis was done with priority given to the following two topics; derivation of individual WTP and prior evaluation of policy effect from the equity aspect. To estimate individual WTP, we adopted contingent valuation method (CVM). The former is to estimate individual WTP for respondent's maintaining his/her transit pattern when he/she is faced with congestion pricing by using compensating variation(CV) concept. And, the latter aims at evaluating policy effect from the equity aspect by calculating the Proportion of WTP to average income using WTP in income bracket for policy scenarios.