• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.6 no.2
• /
• pp.70-80
• /
• 2007

Inter-vehicular communication suffers from a variety of the problem on the road, resulting in large delay in propagating emergency warning. An energy depletion as well as a transmission delay may induced by traffic accident. A transmission delay are caused by direct contention from nodes that can hear each other or indirect contention from nodes that can not hear each other, but simultaneously transmit to the same destination. A variety of works have been researched to solve the transmission delay and energy consumption problem in intelligent cars transportation systems. We consider a vehicle-to-vehicle communication protocol for disseminating an emergency information that include end-to-end and energy efficient transmission. In this paper, we propose A vehicle-to-vehicle communication protocol scheme for dissemination emergency information in intelligent cars communication based on IEEE 802.15.3 wireless personal area networks. Results from a simulation study reveal that our scheme can achieves low latency in delivering emergency warnings, and efficiency in consuming energy in stressful road scenarios.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.7
• /
• pp.1313-1319
• /
• 2017

In this paper, we evaluate the performance of multi-hop transmissions in IEEE 802.15.6 ultra wide band (UWB) wireless body area network (WBAN). The packet structure in the physical layer, and encoding and decoding are considered for multi-hop transmissions in IEEE 802.15.6 UWB WBAN. We analyze the data success rate and energy efficiency of multi-hop transmissions with considering the length of data payload, transmission power, and distances between the nodes in IEEE 802.15.6 UWB WBAN. Through simulations, we evaluate the data success rate and energy efficiency of multi-hop transmissions with varying the length of data payload, transmission power, and distances between the nodes in IEEE 802.15.6 UWB WBAN. Finally, we can select an energy-efficient multi-hop transmission in IEEE 802.15.6 UWB WBAN depending on the length of data payload, transmission power, and distances between the nodes.

• Journal of Radiation Industry
• /
• v.7 no.2_3
• /
• pp.115-119
• /
• 2013

The density profile measurement technology by gamma transmission has been widely used to diagnose processes in the field of refinery and petrochemical industry. This technology can reveal a clue and position of abnormal phenomenon of industrial processes during their operation. In this paper, the feasibility of the gamma transmission technology for detecting changes in the amount of fluid in a distillation column was evaluated by using Monte Carlo simulations. The simulations assumed that $^{60}Co$ (1.17, 1.33 MeV) sources and NaI (Tl) detectors (${\Phi}5{\times}5cm$) are located in opposite sides of a column and it concurrently moves in vertical direction. To determine the dependency of a spatial resolution on aperture size of a collimator, the simulation model for a tray in a column were simulated with the aperture sizes of 1 and 2 cm. The thickness of the high density area including a tray and fluid was 7.6 cm in the simulation. The spatial resolution of the tray was 8.2 and 8.5 cm, respectively. As a result, it was revealed that the conventional density profile measurement technique is not able to show the deviation of liquid level on a tray in a column.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.17 no.7
• /
• pp.1823-1840
• /
• 2023

In order to improve spectral efficiency and reduce power consumption for reconfigurable intelligent surface (RIS) assisted wireless communication systems, a joint design considering irregular RIS topology, RIS on-off switch, power allocation and phase adjustment is investigated in this paper. Firstly, a multi-dimensional variable joint optimization problem is established under multiple constraints, such as the minimum data requirement and power constraints, with the goal of maximizing the system energy efficiency. However, the proposed optimization problem is hard to be resolved due to its property of nonlinear nonconvex integer programming. Then, to tackle this issue, the problem is decomposed into four sub-problems: topology design, phase shift adjustment, power allocation and switch selection. In terms of topology design, Tabu search algorithm is introduced to select the components that play the main role. For RIS switch selection, greedy algorithm is used to turn off the RISs that play the secondary role. Finally, an iterative optimization algorithm with high data-rate and low power consumption is proposed. The simulation results show that the performance of the irregular RIS aided system with topology design and RIS selection is better than that of the fixed topology and the fix number of RISs. In addition, the proposed joint optimization algorithm can effectively improve the data rate and energy efficiency by changing the propagation environment.

• Progress in Medical Physics
• /
• v.33 no.4
• /
• pp.108-113
• /
• 2022

Purpose: Proton therapy has been used for optimal cancer treatment by adapting its Bragg-peak characteristics. Recently, a tissue-sparing effect was introduced in ultrahigh-dose-rate (FLASH) radiation; the high-energy transmission proton beam is considered in proton FLASH therapy. In measuring high-energy/ultrahigh-dose-rate proton beam, Faraday Cup is considered as a dose-rate-independent measurement device, which has been widely studied. In this paper, the feasibility of the simply designed Faraday Cup (Poor Man's Faraday Cup, PMFC) for transmission proton FLASH therapy is investigated. Methods: In general, Faraday cups were used in the measurement of charged particles. The simply designed Faraday Cup and Advanced Markus ion chamber were used for high-energy proton beam measurement in this study. Results: The PMFC shows an acceptable performance, including accuracy in general dosimetric tests. The PMFC has a linear response to the dose and dose rate. The proton fluence was decreased with the increase of depth until the depth was near the proton beam range. Regarding secondary particles backscatter from PMFC, the effect was negligible. Conclusions: In this study, we performed an experiment to investigate the feasibility of PMFC for measuring high-energy proton beams. The PMFC can be used as a beam stopper and secondary monitoring system for transmission proton beam FLASH therapy.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.5
• /
• pp.1215-1223
• /
• 2014

In multi-hop wireless networks, a message transmission path is set up on demand by a route discovery step, where a shortest path is used in general. The shortest path, however, normally uses the nodes near the center area, which causes a high traffic load in that area and reduces the message transmission reliability. We propose a stable routing protocol considering the remaining energy of nodes. Our protocol uses ETX as a link performance estimator and tries to avoid the nodes with smaller energy. By doing this, we can reduce the route failure probability and packet loss. We have evaluated the performance of the proposed protocol using QualNet and compared with AODV and MRFR protocols. The simulation result shows that our protocol has a similar performance as MRFR in terms of end-to-end message reception ratio, average message delay and delay jitter, but outperforms MRFR in terms of traffic load distribution.

• New & Renewable Energy
• /
• v.16 no.1
• /
• pp.47-57
• /
• 2020

In Floating PV (Photovoltaic) systems, PV modules are installed on water by utilizing the surface of idle water such as a reservoir and multipurpose dam. A floating PV system, therefore, has the advantage of efficiency in national land use and improved energy yield owing to cooling effect compared to on-land PV systems. Owing to the limitation of installation environment for a floating PV system, the system, however, has the disadvantage of an increase in transmission distance of DC (Direct current) cables. A longer transmission distance of a DC cable results in greater power loss due to a voltage drop. This leads to a decline in economic feasibility for the floating PV system. In this paper, the economic analysis for 10 floating PV systems installed in a reservoir has been conducted in terms of a change in annual power sales according to the variation of transmission losses depending on the factors affecting the voltage drop, such as transmission distance, cross-section area of underwater cable, the presence of joint box, and PV capacity.

• Journal of Korea Multimedia Society
• /
• v.14 no.9
• /
• pp.1138-1151
• /
• 2011

Sensor network clustering scheme is an efficient method that prolongs network lifetime. However, when it is applied to an environment in which collected data of the sensor nodes easily overlap, sensor node unnecessarily consumes energy. Accordingly, we proposed a data prediction scheme that sensor node can predict current data to exclude redundant data transmission and to minimize data transmission among the cluster head node and member nodes. Our scheme excludes redundant data collection by neighbor nodes. Thus it is possible that energy efficient data transmission. Moreover, to alleviate unnecessary data transmission, we introduce data prediction graph whether transmit or not through analyze between prediction and current data. According to the result of performance analysis, our method consume less energy than the existing clustering method. Nevertheless, transmission efficiency and data accuracy is increased. Consequently, network lifetime is prolonged.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.3
• /
• pp.1144-1153
• /
• 2015

The resonant mechanism of reradiation interference (RRI) over 1.7MHz from power transmission lines cannot be obtained from IEEE standards, which are based on researches of field intensity. Hence, the resonance is ignored in National Standards of protecting distance between UHV power lines and radio stations in China, which would result in an excessive redundancy of protecting distance. Therefore, based on the generalized resonance theory, we proposed the idea of applying model-based parameter estimation (MBPE) to estimate the generalized resonance frequency of electrically large scattering objects. We also deduced equation expressions of the generalized resonance frequency and its quality factor Q in a lossy open electromagnetic system, i.e. an antenna-transmission line system in this paper. Taking the frequency band studied by IEEE and the frequency band over 1.7 MHz as object, we established three models of the RRI from transmission lines, namely the simplified line model, the tower line model considering cross arms and the line-surface mixed model. With the models, we calculated the scattering field of sampling points with equal intervals using method of moments, and then inferred expressions of Padé rational function. After calculating the zero-pole points of the Padé rational function, we eventually got the estimation of the RRI’s generalized resonant frequency. Our case studies indicate that the proposed estimation method is effective for predicting the generalized resonant frequency of RRI in medium frequency (MF, 0.3~3 MHz) band over 1.7 MHz, which expands the frequency band studied by IEEE.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.10B
• /
• pp.955-963
• /
• 2009

In this paper, we propose a medium access control(MAC) protocol for reducing the energy efficiency and for improving the transmission efficiency in underwater acoustic sensor networks. In underwater environment, the transmission delay is longer and bandwidth is smaller than terrestrial environment. Considering these points, we propose a new MAC protocol to enhance throughput and to manage efficiently the energy of nodes. The proposed protocol operates as a channel reservation scheme to decrease data collisions, and uses a mechanism to control the hidden node problem and the exposed node problem occurred in ad hoc networks. The proposed protocol consists of the slotted based transmission frame and reduces data collisions between nodes by putting separately the reservation period in the transmission frame. In addition, it is able to solve the hidden node problem and the exposed node problem by reservation information between nodes. We carry out the simulation to evaluate the proposed protocol in terms of the average energy consumption, the ratio of collision, throughput, and the average transmission delay, and compare the proposed protocol to a traditional MAC protocol in the underwater environment. The simulation results show that the proposed protocol outperforms the traditional protocol under a various of network parameters.