• Journal of Adhesion and Interface
• /
• v.12 no.1
• /
• pp.1-10
• /
• 2011

An automated reaction calorimeter was used to directly monitor the rate of emulsion polymerization of vinyl acetate using poly(vinyl alcohol) (PVAs) having different degrees of blockiness. By using this technique in conjunction with other off-line measurements of the evolution of particle size distributions, important details of the process were observed. No constant graft rate period was observed for both low and high initial monomer-water ratios. The gel effect was observed for the low monomer-water ratio recipe. The particle size distributions were broad (particle diameter 40~100 nm) and bimodal. Continuous nucleation was observed to be accompanied by 'limited aggregation' and flocculation during the particle growth stages. It was speculated to be due to the occurrence of the extensive 'limited aggregation' and chain transfer to PVA leading to grafting.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.7
• /
• pp.2320-2324
• /
• 2012

A novel approach for metabolite extraction and fingerprinting was introduced based upon the nano-baskets and emulsion liquid membrane-nuclear magnetic resonance (ELM-NMR) technique. The objective of this method is optimizing the fingerprints, minimizing the metabolic variation from analysis, increasing the likelihood differences, and obtaining the maximum extraction yield. Low molecular weight metabolites in rat serum were recovered by ELMs using 12 nano-baskets of calixarene, as both emulsifier and carrier. The yields of ELMs were optimized by the method of one-at-a-time. According to NMR data, the maximum metabolic variation was achieved using scaffold 4 (4 wt %), n-decane membrane, stirring rate of 300 rpm, treat and phase ratios of 0.3 and 0.8, respectively. The results revealed that some calixarenes tend to extract non-specific macromolecules; and repeatability of fingerprints for 7-mediated ELM was maximum and for 3-mediated ELM was minimum. The yield of extractions was obtained to be higher for n-decane and lower for carbon tetrachloride. Among different membranes, the fingerprints by chlorinated liquid membranes were more repeatable than using toluene or n-decane.

• Macromolecular Research
• /
• v.12 no.3
• /
• pp.303-310
• /
• 2004

We have prepared an aqueous dispersion of poly(aniline-dodecyl benzene sulfonic acid complex) (PANI-DC) that has an intrinsic viscosity (〔η〕) near 1.3 dL/g using aniline as a monomer, dodecyl benzene sulfonic acid(DBSA) as a dopant/emulsifier, and ammonium peroxodisulfate(APS) as an oxidant. We found that the electrical conductivity of a PANI-DC pellet was 0.7 S/cm. A waterborne-polyurethane (WBPU) dispersion, obtained from isophorone diisocyanate/polytetramethylene oxide glycol/dimethylol propionic acid/ethylene diamine/triethylene amine, was used as a matrix polymer. We prepared blend films of WBPU/PANI-DC with variable weight ratios (from 99/1 to 66/34) by solution blending/casting and investigated the effects that the PANI-DC content has on the mechanical and dynamic mechanical properties, hardness, electrical conductivity, and antistaticity of these films. The tensile strength, percentage of elongation, and hardness of WBPU/PANI-DC blend films all decreased markedly upon increasing the PANI-DC content. The antistatic half-life time ($\tau$$\sub$$\frac{1}{2}$/) of pure WBPU film was about 110 s, but we found that those of WBPU/ultrasound-treated PANI-DC blend films decreased exponentially from 1.2 s to 0.1 s to almost 0 s upon increasing the PANI-DC content from 1 wt% to 15 wt% to > 15 wt%, respectively.

• Polymer(Korea)
• /
• v.38 no.6
• /
• pp.744-751
• /
• 2014

Electrospinning was used to load curcumin (a natural compound that has antiinflammatory properties) into zein nanofibers. An emulsifier, Tween 80, was combined with curcumin in the zein nanofibers. The morphology of the curcumin-loaded zein nanofibers (CLZNFs) was observed using field emission scanning electron microscopy. Investigation of curcumin released from the zein nanofibers into phosphate buffer saline at pH 7 indicated that the Tween 80 had increased the amount of curcumin released from the CLZNFs. The antibacterial activity of the CLZNFs against Staphylococcus aureus (S. aureus) was determined by measuring the optical density of bacterial solutions containing CLZNFs. The zein nanofibers fabricated with 10 wt% surfactant and 1.6 wt% curcumin showed high (i.e., 83%) efficiency in inhibiting the growth of S. aureus in the solution incubated for 21 h. These results suggest that the electrospun CLZNFs show potential application as antibacterial nonwoven mats.

• Archives of Pharmacal Research
• /
• v.26 no.6
• /
• pp.504-510
• /
• 2003

The aim of this study is to prepare biodegradable microspheres without the use of surfactants or emulsifiers for a novel sustained delivery carriers of protein drugs. A poly($\varepsilon$-caprolactone)/poly(ethylene glycol)/poly($\varepsilon$-caprolactone) (CEC) triblock copolymer was synthesized by the ring-opening of $\varepsilon$-caprolactone with dihydroxy poly (ethylene glycol) to prepare surfactant-free microspheres. When dichloromethane (DCM) or ethyl formate (EF) was used as a solvent, the formation of microspheres did not occur. Although the microspheres could be formed prior to lyophilization under certain conditions, the morphology of microspheres was not maintained during the filtration and lyophilization process. Surfactant-free microspheres were only formed when ethyl acetate (EA) was used as the organic solvent and showed good spherical micro-spheres although the surfaces appeared irregular. The content of the protein in the micro-sphere was lower than expected, probably because of the presence of water channels and pores. The protein release kinetics showed a burst release until 2 days and after that sustained release pattern was showed. Therefore, these observations indicated that the formation of microsphere without the use of surfactant is feasible, and, this the improved process, the protein is readily incorporated in the microsphere.

• Korean Chemical Engineering Research
• /
• v.56 no.2
• /
• pp.143-150
• /
• 2018

Oil-in-water emulsion was prepared using cinnamoyl surfactants as emulsifiers. Cinnamoyl surfactants used in the present study were polyoxyethylene (20) sorbitan monolaurate-cinnamic acid conjugate (TW20CA), polyoxyethylene (20) cetyl ether-cinnamic acid conjugate (CE20CA), and polyoxyethylene(20) oleyl ether-cinnamic acid conjugate (OE20CA). The emulsion stabilized with TW20CA was the most stable, possibly because the polyoxyethylene segment of TW20CA would sterically stabilize the oil droplets effectively. In vivo UV protecting efficacy of surfactant and emulsion was investigated by determining the minimum amount of UV light (MAUL) to induce a black point on the back of hairless mice (HRM2). The mean MAUL of PARSOL, OE20CA, and emulsion stabilized with TW20CA was $1046.5mJ/cm^2$, $1163mJ/cm^2$, and $1308.5mJ/cm^2$, respectively. The high UV-protecting efficacy of the emulsion could be ascribed to not only the UV-absorbing property of cinnamoyl group but also the UV-scattering property of the oil droplets.

• Journal of the Korean Professional Engineers Association
• /
• v.33 no.3
• /
• pp.71-79
• /
• 2000

The effects of alkali salts adding on the cooking quality improving in dried noodles were investigated in the good texture maintaining for preventing solid soluble losses ,through chemical analysis and actual manufacturing practice ,the following results were obtained. Experiments were took a special flour of ASW:DNS=70:30, thickening agent(TA) composed of K2CO3 58%, Na2CO3 36% and Na4P2076%, and emulsified oil(EO) mixing of corn oil 44%, polysorbate 23%, emulsifier(ester of glycerin and fatty acids) 21%, soy lecithin 12%. When the mixing ratio of TA and EO to flour, is 0.03 and 1.5%(w/w) or morel than, satisfied the good quality. The water soluble solid matters content of the lowest 3.2% in the treating group that TA and EO is 0.03 and 1.5%(w/w) respectively, comparing to the 7.3% in the control group provides a excellent cooking quality. The research achieves the similar effects at specific gravity, water absorption ratio, weight increasing rate and volume expansion ratio. According to appearance test the more treating of TA turn the noodle into deeper yellow-green color. Turning to the deeper yellow color according to the increasing of EO provides better

• Journal of Pharmaceutical Investigation
• /
• v.16 no.2
• /
• pp.68-71
• /
• 1986

Oil in water microemulsion which has many pharmaceutical applications was prepared and evaluated. As oil sources and emulsifier, two grades of oil and egg phosphatide were used, respectively. Vacuum high shear mixing and high pressure homogenizing were performed and in the homogenizing step, effect of the number of passes in the homogenizer on the stability of microemulsion was studied, using Coulter counter, photographic microscope and pH-meter. From above results, it was concluded that the stability of microemulsion made of refined soy-bean oil was better than that of food grade soybean oil and by five passes in the homogenizer at 6,000 psi, we could make stable microemulsion with average particle diameter below $1\;{\mu}m$, with no particle above $5\;{\mu}m$ and no significant change during 6 weeks stored.

• Textile Coloration and Finishing
• /
• v.7 no.4
• /
• pp.45-53
• /
• 1995

Natural rubber(NR)-polyacrylamide(PAAm) graft copolymers(GP)(toluene soluble GP : TSGP, water dispersible GP : WDGP) have been synthesized as coupling agents by pre-emulsification methods based on "inverse emulsion graft polymerization" technique. The polymerization was carried out at $65^{\circ}C$ using Azobisisobytyro nitrile(AIBN) as an initiator in the inverse emulsion system formed by inxing NR toluene solution with inverse emulsion of awueous AAm solution emulsified with $Tween^{\#}$ 80 in toluene. The mechanism of inverse emulsion graft copolymerization was studied on AAm conversion, % grafting, grafting efficiency, NR conversion, production ratio of TSGP and amount of GP(sum of TSGP and WDGP). The reaction has been confirmed through use of optical microscope to proceed via adsorption of emulsifier colloid particles onto the stretched NR molecule. From the analysis of the effects of various polymerization conditions on the grafting, it has also been found that the present rection system can easily yield high(over 90%) grafting efficiency and AAm conversion and relatively high(over 80%) NR conversion.onversion.

• Journal of the Korean Applied Science and Technology
• /
• v.18 no.1
• /
• pp.55-59
• /
• 2001

These N-acyl amino acid surfactants is normally produced by reaction of acid anhydride with sodium ${\ell}-glutamate$ hydrolysates under Schotten-Baumann condition i.e., in alkaline aqueous medium. To avoid using fatty acid chlorides, acylations were also carried out with the fatty acids themselves or with their methyl esters, but unfortunately these methods cannot be used in practice, dodecenyl succinic anhydride, was to be studied for their suitability as acylating agents the production if acylated glutamine hydrolysates. The surface activities including surface tension forming power, forming stability and emulsifying power were measured. The experimental results revealed that the products have a good emulsifying power. Thus, there derivatives will be expected to be used an emulsifying agent for O/W type cosmetic emulsion.