• Journal of Environmental Science International
• /
• v.19 no.9
• /
• pp.1119-1127
• /
• 2010

The behavior of copper throughout the whole process of wastewater treatment plant that uses the activated sludge process to treat the wastewater of petrochemical industry that contains low concentration of copper was investigated. Total inflow rate of wastewater that flows into the aeration tank was $697\;m^3$/day with 0.369 mg/L of copper concentration, that is, total copper influx was 257.2 g/day. The ranges of copper concentrations of the influent to the aeration tank and effluent from the one were 0.315 ~ 0.398 mg/L and 0.159 ~ 0.192 mg/L, respectively. The average removal rate of copper in the aeration tank was 50.8 %. The bioconcentration factor (BCF) of copper by microbes in the aeration tank was 3,320. The accumulated removal rate of copper throughout the activated sludge process was 71.3%, showing a high removal ratio by physical and chemical reactions in addition to biosorption by microbes. The concentration of copper in the solid dehydrated by filter press ranged from 74.8 mg/kg to 77.2 mg/kg and the concentration of copper by elution test of waste was 2.690 ~ 2.920 mg/L. It was judged that the copper concentration in dehydrated solid by bioconcentration could be managed with the control of that in the influent.

• Journal of the Korean Wood Science and Technology
• /
• v.30 no.3
• /
• pp.12-17
• /
• 2002

The extracellular invertase (EC 3.2.1.26) (Candida utilis) preparation was obtained from the liquid medium after desalting and freeze drying. This prepared enzyme was used for the comparative purification on 4 activated matrices by liquid column affinity chromatography method. In this method there were used controlled porous glass (CPG) silanized covalently activated by keratin, silanized silica gel and silica gel covalently covered by keratin. It was found that the invertase purification process was better using both CPG matrices (silanized CPG and keratin activated CPG) than these with two silica gel supports. Also the elution coefficient of the invertase from the two CPG columns was about 93 to 94%. Two silica gel supports found to be superior in terms of purification efficiency. The invertase purification process was confirmed by PAGE electrophoresis.

• Korean Journal of Medicinal Crop Science
• /
• v.22 no.5
• /
• pp.378-383
• /
• 2014

Curcuma longa L. leaf was extracted by water at $60^{\circ}C$ for 12 hours after being treatment of Ultra High Pressure under 500 MPa for 5-15 minute. The high pressure extraction for 15 minute (HPE15) was measured the highest extraction yield of 25.48% (w/w), compared to those from conventional extraction methods. The HPE15 showed the lowest cytotoxicity as 11.97% in adding $1.0mg/m{\ell}$ of concentration. Also, HPE15 was measured the highest inhibition of hyaluronidase as 44.48% in adding $1.0mg/m{\ell}$. In addition, The production of NO from macrophages was measured as $7.06{\mu}M$ in adding $1.0mg/m{\ell}$ of HPE15, which was lower than the those from others processes. Finally, HPE15 significantly reduced up to $649.44pg/m{\ell}$ of $ProstaglandinE_2$ production from UV-irradiation. These results suggest that the Curcuma longa Linne leaf extract from high pressure process might enhance the skin immune activities possibly by high elution of active components than other processes.

• Journal of Radiopharmaceuticals and Molecular Probes
• /
• v.4 no.2
• /
• pp.51-56
• /
• 2018

Azeotropic drying process is routinely applied to enhance nucleophilicity of $[^{18}F]$fluoride ion during the nucleophilic production of PET radiotracers; however, the drying process requires usually 15-25 min. Due to the high demand of employing fluorine-18 ($t_{1/2}=109.8min$) in PET radiopharmaceutical production, several research groups have focused on the method development, obviating tedious removal process of the residual target water ($[^{18}O]H_2O$) for $[^{18}F]$fluoride ion complex to be used in radiofluorination. Some development in radiofluorination in a mixed organic solvent system was demonstrated with various aliphatic substrates, but only kryptand as a phase transfer agent was utilized in the reported method. Here, we extend to investigate the development scope of applicability with basic alkyl ammonium salt as a phase transfer agent through the extensive elution efficiency study and radiofluorination outcome for aliphatic radiofluorination.

• Journal of Korean Society on Water Environment
• /
• v.22 no.5
• /
• pp.879-886
• /
• 2006

The analytical methods of polychlorinated dibenzo-p-dioxins, polychlorinated dibenzofurans (PCDD/Fs) for water sample with extremely low concentration was developed to extract large volume and to improve fast chromatography for clean up. Semi-automated solid phase extraction (SPE) system and column coupling chromatography using elution pump was optimized and applied to each processes of treatment plant. Results of disk type SPE indicated that this system was applicable below 40 L of aqueous sample with a flow rate of 0.08 ~ 0.2 L/min. Average recoveries of SPE using labeled sampling spike of $^{37}Cl$-2,3,7,8-TCDD was 97%. Column coupling method resulted in reduced clean up time, solvent volume, increased average recoveries with constant elution rate. The combined methods were applied to the monitoring of drinking water treatment plant. Limits of detection (LOD) of each process were calculated. For example, LOD of raw and treated water ranged 0.094~0.968 pg/L and 0.028~0.364 pg/L, respectively. Combined methods of extraction and cleanup techniques provided fast analysis of PCDD/Fs with high accuracy and low LODs for water samples.

• Analytical Science and Technology
• /
• v.19 no.6
• /
• pp.519-528
• /
• 2006

An analytical method for the determination of thyroid hormones in urine samples has been studied by using solid-phase extraction and high-performance liquid chromatography/diode array detector/electro-spray mass spectrometry. Seven thyroid hormones were successfully separated by gradient elution on the reverse phase Hypersil ODS column (4.6 mm I.D., 100 mm length, particle size $5{\mu}m$) with ammonium formate buffer and acetonitrile, and UV spectra and mass fragment could be confirmed. The extraction recoveries of thyroid hormones in the urine samples (pH 3) were in the range of 89.0-113.1% with solid-phase extraction by C18, followed by elution with 4 ml of methanol/ammonium hydroxide (9 : 1). The calibration curves showed good linearity with the correlation coefficients ($r^2$) varying from 0.992 to 0.998 and the detection limits of all analytes were obtained in the range of 2-4 ng/ml (3.8-13.0 pmol/ml).

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.9 no.3
• /
• pp.141-148
• /
• 2011

It is clarified in the radioactive waste transfer regulation that the concentration of radioactive waste for the major radio nuclide has to be examined when radioactive waste is guided to the radioactive waste stores. In case of the low level radioactive waste sample, the analytical results of radioactive waste concentration frequently show a value lower than minimum detectable activity (MDA). Since the MDA value basically depends on the amount of a sample, background value, measurement time, counting efficiency, and etc, it would be necessary to increase a sample amount with a intention of minimizing MDA. In order to measure a concentration of $^{129}I$ in low and medium level radioactive waste, $^{129}I$ was collected by using a distillation technique after leaching the simulated radioactive waste sample with a non-volatile acid. The recovery of $^{129}I$ measured was compared with that measured with column elution technique which is a conventional method using an anion-exchange resin. The recovery of inactive iodide by using the distillation method and column elution were found as $86.5{\pm}0.9%$ and $87.3{\pm}2.7%$, respectively. The recovery and MDA value calculated for distillation technique when 100 g of extracted solution of $^{129}I$ was taken, were found to be $84.6{\pm}1.6%$ and $1.2{\times}10^{-4}Bq/g$, respectively. Consequently, the proposed technique with simplified process lowered the MDA value more than 10 times compared to the column elution technique that has a disadvantage of limited sampling amount.

• Korean Journal of Food Science and Technology
• /
• v.22 no.6
• /
• pp.711-715
• /
• 1990

Continuous column chromatographic separation of lysozyme from egg white was investigated. A weak acid type cation exchange resin, Duolite C-464, was used because of high lysozyme recovery and ease of column operation in this experiment. The resin was equilibrated at $pH\;7.9{\pm}0.1$ in Na+form. Continuous lysozyme separation was processed by repeating cycles(one cycle : resin equilibration, flow egg white, rinse, lysozyme elution) in automated preparative Liquid Chromatography(LC) system(column size ; i.d. 50 mm, resin bed volumn ; 1020 ml). At comparison of UV levels in rinse end point and elution end point of every cycle, the UV levels of rinse end point are maintained below 30% for 19 cycles and that of elution end point are also maintained below 30% for 17 cycles, stably, but was increased above 50% after 18 cycle. That indicated the eluting ability of lysozyme was reduced conspicuously after 18 cycle in continuous cycling process. The recovery of lysozyme was maintained above 90% from one to 17 cycle, but was decreased to 72% and 65% in 18 cycle and 19 cycle, respectively.

• Journal of Korean Society of Environmental Engineers
• /
• v.37 no.5
• /
• pp.262-268
• /
• 2015

This study established an analytical method to simultaneously determine six organophosphorous pesticides [methyldemetone-S, diazinon, fenitrothion, parathion, phentoate, and O-ethyl O-(4-nitrophenyl) phenylphosphonothioate (EPN)] and carbaryl in water using a gas chromatography/mass spectrometry (GC/MS) system coupled with on-line micro extraction by packed sorbent (MEPS) and programmed temperature vaporizer (PTV) injector. Polystyrene divinylbenzene (PDVB) was used as a sorbent of MEPS. The effects of elution solvents, pH, elution volume and draw-eject cycles of samples on sample pretreatment process were investigated. Also, quality assurance and quality control (QA/QC) and the recovery of the pesticides in environmental samples were evaluated. The elution was performed using $30{\mu}L$ of a mixed solvent (acetone : dichloromethane = 80 : 20 (v/v)). Sample pretreatment processes were optimized with seven cycles of draw-eject of sample (1 mL) spiking an internal standard and sulfuric acid. At lower pH, the analytical sensitivity of diazinon decreased, but that of carbaryl increased. The method detection limit and the limit of quantification for this method were 0.02~0.18 and $0.08{\sim}0.59{\mu}g/L$, respectively. The method precision and accuracy were 1.5~11.5% and 83.3~129.8%, respectively, at concentrations of $0.5{\sim}5.0{\mu}g/L$. The recovery rates for all the pesticides except carbaryl in various environmental samples ranged 75.7~129.3%. The recovery rate of carbaryl in effluent sample was over 200% whereas carbaryl in drinking water, groundwater, and river water were in the acceptable range.

• Korean Journal of Veterinary Service
• /
• v.36 no.4
• /
• pp.273-281
• /
• 2013

This study investigated the effects of the alkaline detergent and acid rinse used for cleaning milking machines on the eight commercially available teatcup liner materials. The sample liners prepared for use in the clean-in-place process were analyzed by ultraviolet spectrophotometer, ion chromatography and liquid chromatography. Among the eight liner materials, the ultraviolet spectra of 3 sample liners were shown to have a similar peak shape after cleaning, but the ultraviolet spectra peak shape of 5 sample liners was noticeably changed. No products were detected by ion chromatography in any of the liner materials used in this study. When the liner materials were only treated with alkaline detergent, some additional peaks were observed using liquid chromatography which indicate the creation of molecular substance and elution from liner materials, however, these peaks disappeared when the liner materials were cleaned with the acid rinse. Therefore, we propose that an acid rinse should be applied, after cleaning the milking machine with the alkaline detergent.