• Proceedings of the KIEE Conference
• /
• 1992.07b
• /
• pp.843-846
• /
• 1992

This thesis was investigated on optical-and ion-induced characteristics in positive(a-$Se_{75}Ge_{25}$) and negative (Ag/a-$Se_{75}Ge_{25}$) resists for focused-ion-beam microlithogaphy. The a-$Se_{75}Ge_{25}$ inorganic thin film shows an increase in optical absorption after exposure to$\sim$$10^{16}$ dose(ions/$cm^{2}$) of Ga ions. The observed shift in the absorption edge toward longer wavelengths is consistent with that in films exposed to band-gap photons ($\sim$$10^{20}$ photons/$cm^{2}$). But, ion induced shift is twice as much as that in film exposed to optical radiation. This result may be related with microstructural rearrangements with in the short range of SeGe network. Due to changes in the short range order, the chemical bonding may be affected, which results in increased chemical dissolution in ion-induced film. Also, this resist exhibits good thermal stability because of its high Tg(~220$^{\circ}C$). The composition of deposited film measured by AES is consistent with that of bulk.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.4
• /
• pp.107-113
• /
• 2008

We investigated the electro-optical characteristics of an ICP(Inductively Coupled Plasma) light source depending on driving temperature, and length of discharge tube. An electro-optical stability of a sample at operating was measured to see a steady state of a sample. In this results, we can see that a stability of power loss and luminous flux of a sample at operating of upper 70[min] was 1.45[%1 and 0.36[%]. We measured the optical characteristics of a sample in a thermal chamber operated at a specific temperature divided into 5 steps. While luminance increased with temperature increasing, the decrement of luminance a eared at u or $46.7[^{\circ}C]$. According to Parchen's and Boyle-Charles' law, we can speculate that a pressure was increased and a higher voltage was needed but a ballaster having a rating power can't support a higher voltage corresponding to a pressure change, 0.02[Torr] at $46.7[^{\circ}C]$. Moreover, we measured an a lied power and current of samples depending to a various length of a discharge tube.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.37 no.3
• /
• pp.240-247
• /
• 2009

Wind tunnel test for Electro-Optical Targeting System(EOTS) has been conducted to investigate the aerodynamic characteristics, especially the torque characteristics of the rotating parts to insure the enough actuator power during the actual operation. The influence of EOTS's complex configuration, such as the observation window, has been investigated by comparing with the results of the simplified models made of half sphere and the cylinder. It has been found that the position of the observation window of EOTS has an effect on surface pressure distribution and the torque characteristics of the rotating observation part.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.433-433
• /
• 2007

In this paper, we investigated the feasibility of applying ZnO:Al films to display devices as transparent electrodes, and reported the electro-optical (EO) characteristics of VA cells using ZnO:Al electrodes and compared them with those of VA cells using ITO electrodes. The experiment results show that a uniform vertical LC alignment and a large pretilt angle were achieved. Also, the good voltage-transmittance curve, response time, and capacitance-voltage characteristics were observed for the rubbing aligned VA-LCD using ZnO:Al electrodes m comparison with ITO electrodes. In other words, the vertical alignment mode based on the ZnO:Al electrodes showed appropriate electro-optical characteristics and high transparency in comparison with that based on the ITO electrodes. These results indicated that the transparent ZnO:Al electrodes of the liquid crystal displays could substitute the ITO electrodes.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.12a
• /
• pp.114-118
• /
• 2006

We investigated the transient electroluminescence (EL) and modulation characteristics of red organic light-emitting diodes (OLEDs), which consist with 4-(dicyanomethylene)-2-i -propyl-6-(1,1,7,7-tetramethyljulolidyl-9-cnyl)-4H-pyran (DCJTI) and rubrene doped into tris(8-hydroxyquinoline)aluminum ($Alq_3$). The transient EL waveforms showed two components, the overshooting peak and constant component, indicating that the excess amount of accumulated charges simultaneously recombine at the onset moment. This overshooting effect reduced the rise time of transient EL and enhanced the optical output of OLEDs when the pulse voltage applied to the device. We demonstrated that the red OLEDs could be use for the high-speed switching application by driving at more than 100 MHz and transmitting the video signals utilized as the electro-optical conversion device

• ETRI Journal
• /
• v.30 no.6
• /
• pp.833-843
• /
• 2008

The effect of forward and reverse electrostatic discharge (ESD) on the electro-optical characteristics of oxide vertical-cavity surface-emitting lasers is investigated using a human body model for the purpose of understanding degradation behavior. Forward ESD-induced degradation is complicated, showing three degradation phases depending on ESD voltage, while reverse ESD-induced degradation is relatively simple, exhibiting two phases of degradation divided by a sudden distinctive change in electro-optical characteristics. We demonstrate that the increase in the threshold current is mainly due to the increase in leakage current, nonradiative recombination current, and optical loss. The decrease in the slope efficiency is mainly due to the increase in optical loss.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.8
• /
• pp.6-11
• /
• 2009

The electro-optical characteristics of the Liquid Crystal on Silicon (hereinafter "LCOS") micro-display on vertically alignment (VA) mode were studied with 3-dimensional LC code. 5 different cell gaps, such as 1.4 ${\mu}m$, 1.8 ${\mu}m$, 2.1 ${\mu}m$, 2.4 ${\mu}m$ and 2.8 ${\mu}m$, were selected. The reflectance-voltage (R-V) characteristics, distribution of reflected light, reflectance, optical fill factor and contrast ratio were calculated and investigated depending on various cell gaps. Due to the surface anchoring effect, higher cell gap showed higher reflectance. However, considering the optical fill factor and contrast ratio, middle-height 2.1 ${\mu}m$ showed the best electro-optical characteristic. 0.7 inch Full-HD LCOS panels having same geometry and material property were fabricated. The reflected light intensity and contrast ratio were measured and the measured results were well-matched to the calculated results.

• Macromolecular Research
• /
• v.12 no.3
• /
• pp.251-257
• /
• 2004

The nature of the nematic liquid crystal (LC) alignment induced by the rubbed polyimide (PI) alignment layers (ALs) and the electro-optical (EO) properties of the LC cells are expected to depend on the chemical and physical features of the PI. By employing five pyromellitic dianhydride (PMDA)-type PIs having different functionalities, we have studied the effects of the PI's structure and chemistry on the alignment characteristics and the cell's EO properties. Increasing the flexibility of the PI increases the pretilt angle and tends to improve the alignment stability. On the other hand, the rigid, fluorinated PI displays poor stability for LCs and induces a less stable/uniform LC alignment and, subsequently, a small pre tilt angle. It also transpired that fluorination of the PI deteriorated the voltage-transmittance characteristics and the voltage holding ratio; increasing the flexibility of the PI structure improves these EO properties. The finding that the qualitative trends for the PI's functionalities are similar for both the alignment and EO properties suggests that the EO properties are closely related to the alignment characteristics, which are determined by short-range interactions between LC and PI molecules.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07b
• /
• pp.1195-1198
• /
• 2005

The improvement of efficiency is the one of the most important part in AC PDPs . To achieve high efficiency, high VUV emission efficiency and High ion induces secondary electron emission coefficient are needed. We have measured the emission spectra of vacuum ultraviolet rays and ion induced secondary electron emission coefficient of MgO protective layer in surface discharge AC-PDP with binary and ternary gas mixtures. We have investigated electro-optical characteristics of AC-PDPs to optimum gas mixture for high efficient.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07b
• /
• pp.1086-1089
• /
• 2003

We investigated the electro-optical (EO) performances of the super twisted nematic liquid crystal display (STN-LCD) on the polyimide (PI) surface using polymer film. Monodomain alignment of the plastic STN-LCD can be observed. A stable voltage-transmittance (V-T) curve of the plastic STN-LCD was observed on the polyimide (PI) surfaces using polymer film. Also, a faster response time for the plastic STN-LCD on the polyimide (PI) surfaces using polymer film can be achieved. Therefore, the EO performances of the plastic STN-LCD on the polyimide (PI) surfaces using polymer film is almost the same as that of the glass STN-LCD on a polyimide (PI) surface.