• Korean Journal of Optics and Photonics
• /
• v.9 no.3
• /
• pp.181-185
• /
• 1998

Gain characteristic of concatenated erbium-doped fiber amplifiers(EDFA) are studied with a recirculating EDFA loop. For a non-flat gain EDFA, the 3 dB gain bandwidth was reduced to 6 nm after the 20th EDFA. However, for an optimized gain flattened EDFA, in a simple configuration, the 5 dB gain bandwidth was found to be 9nm, even after the 100th EDFA, corresponding to 8000km transmission. This results suggest that the simple optimized flat gain amplifier could be a good candidate for ultra-long distance wavelength division multiplexed transmissions.

• The Journal of Engineering Research
• /
• v.2 no.1
• /
• pp.103-111
• /
• 1997

EDFA (Erbium Doped Fiber Amplifier) is widely used to compensate the loss in fiber optic transmission system. The characteristics of EDFA are investigated by analyzing the mechanism amplifying the optical power of an input with several factors to obtain the criteria for designing EDFA. When it is used in fiber optic transmission system, signal to noise characteristics in the receiver is deteriorated due to the spontaneous emission noise of EDFA. We investigate the operating conditions of EDFA to reduce BER (Bit Error Rate).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.7
• /
• pp.1249-1255
• /
• 2008

1530nm band has been studied as pump wavelength for long-wavelength-band erbium-doped fiber amplifier (L-band EDFA). The pump source is built using a tunable light source and cascaded conventional-band (C-band) EDFA. The L-band EDFA uses a forward pumping scheme. Within the 1530nm band, 1545nm pump demonstrates 0.45dB/mW gain coefficient, which is twice better than that of conventional 1480nm pumped EDFA. The noise figure of 1530nm pump is at worst 6.36dB, which is 0.75dB higher than that of 1480nm pumped EDFA. Such high gain coefficient indicates that the L-band EDFA consumes low power.

• Korean Journal of Optics and Photonics
• /
• v.9 no.6
• /
• pp.413-416
• /
• 1998

We have flattened the gain of EDFA by using a long-period FBG filter and AOTF's. The gain and optical SNR characteristics of the gain-flattened EDFA in long-haul transmission been evaluated in a recirculating EDFA loop. The gain variation was less than 4.6 dB and the optical SNR was higher than 14 dB over 20-nm wavelength range when the optical signal went through the EDFA as many as 200 times. These results indicate that this gain-flattened EDFA is applicable for ultra long-haul WDM optical transmissions over 8000 km.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.02a
• /
• pp.142-143
• /
• 2003

EDFA의 이득(gain)과 잡음지수(noise figure)는 매우 중요한 특성 중의 하나이다. 전송 시스템에서 필연적으로 발생하는 ASE 잡음을 제거하는 것이 중요하다. EDFA의 중간에 필터(filter)와 아이솔레이터(isolator)를 삽입하여 불필요한 ASE를 제거함으로써 이득과 잡음지수를 향상시킬 수 있으며, 기존의 단일경로(single-pass) EDFA에서 필터의 위치가 40-60％ 근처에서 이득과 잡음지수 향상이 가장 크게 된다. 그러나, 거울(mirror)을 사용하여 증폭 효율을 높인 이중경로(double-pass) EDFA에서 필터에 의한 이득 향상에 관한 연구발표는 아직까지 없다. (중략)

• Journal of the Korean Geophysical Society
• /
• v.4 no.4
• /
• pp.297-311
• /
• 2001

The gain-clamped EDFA has been developed to eliminate the output power change of WDM surving channels to occur with added or dropped channels, which degrades the performance of WDM optical network. It maintains the constant gain of surviving channels when WDM channels are added or dropped in a network amplifying node. In this paper, the bi-directionally pumped gain-clamped EDFA is implemented to compensate the change of the input power by a lasing. The results show that the lasing of a short wavelength and backward propagation is the optimal condition to minimize the transient response of surviving channels in terms of the overshoot and gain saturation due to the inhomogeneous broadening effect.

• The Journal of Engineering Research
• /
• v.5 no.1
• /
• pp.119-133
• /
• 2004

The gain-clamped EDFA has been developed to eliminate the output power change of WDM surviving channels to occur with added or dropped channels, which degrades the performance of EDM optical network. It maintains the constant gain of surviving channels when WDM channels are added or dropped in a network amplifying node. In this paper, the bi-directionally pumped gain-clamped EDFA is implemented to compensate the change of the input power by a lasing. The results show that the alsing of a short wavelength and backward propagation is the optimal condition to minimize the transient response of surviving channels in terms of the overshoot and gain saturation sue to the inhomogeneous broadening effect.

• Journal of IKEEE
• /
• v.13 no.4
• /
• pp.96-102
• /
• 2009

We investigate the characteristics of RJ (random jitter) in an analog fiber-optic link employing a MZM (Mach-Zehnder modulator) and an EDFA (Erbium-doped fiber amplifier). RJ has been measured using two methods, one of which derived from the noise spectrum of a RF spectrum analyzer and the other from the histogram data of a sampling oscilloscope. If the optical power and/or the RF power input to the MZM increase, RJ decreases due to the output signal power increase. For the optical link without EDFA, the minimum RJ is about 1 ps at an RF power of 10 dBm and an optical power of 8 dBm measured using the noise spectrum method. For the optical link with an EDFA, RJ decreases toward a jitter floor as the EDFA gain increases. If the gain increases further, it has been observed that RJ increases from the minimum. If the EDFA gain is fixed, RJ is smaller for the case of larger optical input power. As the EDFA gain increases, RJ reduction rate becomes greater for the case of lower optical input power.

• Korean Journal of Optics and Photonics
• /
• v.14 no.2
• /
• pp.146-149
• /
• 2003

Nanosecond pulses are efficiently amplified by a two-stage EDFA. The EDFA employs an optical bandpass filter between stages to remove the amplified spontaneous emission of the first EDFA that strongly saturates the gain of the second EDFA. The peak power of the amplified output pulse is 83 W when that of the input pulse of 10 ㎱width and 100 $mutextrm{s}$ period is 1 ㎽.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.7
• /
• pp.1777-1784
• /
• 1998

The packet error rates of an optical packet switching node with an optical address processor using an EDFA in order to detect M-ary correlation pulses at a fiber-optical delay line matched filter output have been evaluated. Effects of A PIN diode NEP, the gain and noise figure of the EDFA, and the bandwidth of an optical filter on the packet error rate of the switching node have been compared. There is negligible error rate change depending upon the variation of the PIN diode NEP and the EDFA gain. If the bandwidth of the optical filter is below 10 times of the data rate, there is no appreciable effect on the error rate. If the noise figure of the EDFA increases, however, the power penalty increases as much as the noise figure increment at all the bit rates and for address code sets considered in this work.