• JSTS:Journal of Semiconductor Technology and Science
• /
• v.7 no.2
• /
• pp.94-97
• /
• 2007

The desin and implementation of a CMOS analog integrated circuit that provides dual-mode modulations, PWM for active clamp reset converter and PFM for LLC resonant converter, is described. The proposed controller is capable of implementing programmable soft start and current-mode control with compensating ramp for PWM and frequency shifting soft start for PFM. Also it provides delay time for both modes. PWM mode is implemented by active clamp reset converter and PFM mode is implemented by LLC resonant convereter, respectively. The chip is fabricated using the 0.6um high voltage CMOS process.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.11
• /
• pp.23-29
• /
• 2008

This paper presents a new conceptual electromagnetic induction eddy current based stainless steel plate spiral type heater for heat exchanger or dual packs heater in hot water system boiler steamer and super heated steamer, which is more suitable and acceptable for new generation consumer power applications. In addition, an active clamping quasi-resonant PWM high frequency inverter using trench gate IGBTs power module can operate under a principle of zero voltage soft commutation with PWM is developed and demonstrated for a high efficient induction heated hot water system and boiler in the consumer power applications. This consumer induction heater power appliance using active clamping soft switching PWM high frequency inverter is evaluated and discussed on the basis of experimental results.

• Journal of IKEEE
• /
• v.17 no.3
• /
• pp.267-274
• /
• 2013

This paper presents a design of LLC resonant converter IC for LED backlight unit based on PFM/PWM dual-mode feedback. Dual output LLC resonant architecture with a single inductor is proposed, where the master output is controlled by the PFM and slave output is controlled by the PWM. To regulate the master output PFM is used as feedback to control the frequency of the power switch. On the other hand, PWM feedback is used to control the pulse width of the power switch and to regulate the slave output. This chip is fabricated in 0.35um 2P3M BC(Bipolar-CMOS-DMOS) Process and the die area is $2.3mm{\times}2.2mm$. Current consumptions is 26mA from 5V supply.

• Proceedings of the KIPE Conference
• /
• 2003.07b
• /
• pp.491-494
• /
• 2003

This paper presents a new conceptual electromagnetic induction eddy current-based stainless steel plate spiral type heater for heat exchanger or Dual Packs Heater in hot water producer, boiler steamer and super heated steamer, which is more suitable and acceptable for new generation consumer power applications. In addition, all active clamped edge resonant PWM high frequency inverter using trench gate IGBTs power module can operate under a principle oi zero voltage soft communication with PWM is developed and demonstrated for a high efficient Induction heated hot water producer and boiler in the consumer power applications. This consumer induction heater power appliance using active clamp soft switching PWM high frequency inverter is evaluated and discussed on the basis of the simulation and experimental results.

• ETRI Journal
• /
• v.32 no.4
• /
• pp.614-617
• /
• 2010

For an antenna-in-package (AiP), via holes are used to connect the antenna ground and system ground. In this letter, a dual-frequency AiP with a U-slot embedded in the patch is proposed. By properly arranging three via holes under the non-radiating edge, an AiP with two resonant frequencies is realized. Then a U-slot is embedded in the patch to further improve the bandwidth of the AiP. To validate the proposed design, an AiP with the bandwidth of 4.49% at 2.45 GHz and 6.02% at 5.32 GHz is achieved and fabricated. The measured results agree with the simulated results.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.219-220
• /
• 2006

In this paper, we designed and implemented the Dual Band Dipole Antenna with Tapered Microstrip Balun for WLAN Access Point. Two dipole antennas with different resonant frequency and the antenna structure combined additional line were implemented for dual band performance. In order to feed the balun current, the tapered microstrip balun was used. Produced the Dual Band Antenna shows a special quality. The quality is that all VSWR is less than 1.5 in the 2.4GHz and 5GHz frequency bands in 802.11 standards, and it profits not less than 1.7dBi having typical Dipole Antenna pattern the very "a form of 8"pattern and Omni-directional pattern.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.10
• /
• pp.2016-2021
• /
• 2009

In this paper, a dual-band antenna aimed for a mobile communication repeater was designed and measured. The operating frequency ranges are GSM(870${\sim}$960 MHz) and WCDMA(1920${\sim}$2170 MHz) bands. Experimental and numerical studies are performed for various design variables such as slot lengths. Using two meandering slots in the ground plane, we can obtain two higher resonant frequencies significantly with broader bandwidths. The measured maximum gain of antenna is 2 dBi in the GSM band and 2.45 dBi in the WCDMA band.

• 한국정보통신설비학회:학술대회논문집
• /
• 2008.08a
• /
• pp.433-436
• /
• 2008

In this paper, a novel compact broadband dual frequency microstrip antenna is presented. The meander type patch has been designed to have dual resonant frequencies, and the ground with slot was employed to expand the bandwidth in WCDMA band. The simulated results were obtained using HFSS, and the measurement on the proposed antenna was conducted in an anechoic chamber equipped with a network analyzer and a far field measurement system. As a result, measured maximum gain of antenna is 2.07$\sim$2.87 dBi in the GSM band and 3.91$\sim$5.61 dBi in the WCDMA band.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.13 no.6
• /
• pp.453-460
• /
• 2008

This paper proposes a new multi-output LLC resonant converter by using single control IC, which has the tight-regulated dual output voltage without additional power devices and controller. The proposed converter has master and slave outputs, of which regulations are achieved by the PWM(pulse width modulation) and PFM(pulse frequency modulation), respectively. Different from the conventional dual-output LLC resonant converter, the proposed converter has no additional post-regulators like a boost converter. Therefore, it features a low cost, small size, and high efficiency. To confirm the validity and prove the superiority of proposed converter, simulated and experimental results on a 50" FHD PDP power set prototype are presented.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.1
• /
• pp.9-15
• /
• 2011

In this paper, we designed and fabricated a dual-band bandpass filter which can control upper and lower bandwidth using the transformed E-shaped dual-mode resonator. The filter is made the coupling between even-mode not to affect odd-mode resonant frequency by the transformed resonator to control upper bandwidth effectively. The cross coupling between input and output feed lines was employed to improve stopband characteristic. The bandpass filter has been designed to indicate the same bandwidth at center frequency 2 GHz and 3 GHz to show to control bandwidth.