• Journal of the Korean Geotechnical Society
• /
• v.18 no.5
• /
• pp.251-260
• /
• 2002

Geotextile tribes are made of sewn geotextile sheet and hydraulically or mechanically filled with dredged materials. They have been applied in hydraulic and coastal engineering in recent years(shore protection structure, detached breakwater, groins, and jetty). Therefore, it is composed of geotextile and confined fill material. Recently, new preliminary design criteria supported by model and prototype tests, and some stability analysis calculations have been studied. The stability analysis of geotextile tube is composed of geotechnical and hydrodynamic analysis. The stability check points are sliding failure, overturning, bearing capacity failure against the wave attack. In this paper are presented the stability analysis method by empirical equation and 2-D equilibrium analysis for geotextile tube. Also, the hydraulic model tests were performed to verify the theoretical stability analysis with geotextile tube shape, filling ratio, significant wave height, and so on. The results of this study show that the stability of geotextile tube depends on the tube shape, contact area, projection area. The theoretical analysis and hydraulic model test show almost the same results.

• Journal of the Korea Institute of Building Construction
• /
• v.17 no.3
• /
• pp.227-234
• /
• 2017

This research analyzes the properties of mortar following the rise in water-cement ratio and applicability as an eco-friendly construction supply by using the mudflats of a dredged arena as a substitute for aggregate. The results of a experiment of the flow showed that the flow value decreases as the amount of mudflats increases. A test for chloride content showed that the chloride content increases with the amount of mudflats. In the compression of specimen mixed with mudflat and the testing of tensile strength, the strength weakened as the addition ratio of mudflats rose. However, with 14-day strength as the standard, most specimen showed more strength than the plain, and 14-day strength was higher than 28-day strength. It appears to be experimental error in the mixing process from the viscosity and cohesion of mudflats, and it is considered that there will be a need for an experiment on mixing methods of mudflats in the future. The compressive strength of this research was the strongest with 70% in water-cement ratio, and the tensile strength was strongest with 80% in water-cement ratio. In the evaluation of surface analysis, 70% water-cement ratio, which is finest in strength, mixing, and compactness, was selected to analyze the roughness of the surface, and the results showed that the surface became smoother as the addition ratio of mudflats increases. In conclusion, it appears that 70% water-cement ratio is the optimal mixing ratio for mortar and 10 to 30% addition ratio of mudflats the optimal ratio. It also appears that the application of interior finishing material like bricks and tiles and interior plastering material using the mudflats are possible.

• Journal of the Korean Geosynthetics Society
• /
• v.5 no.4
• /
• pp.11-18
• /
• 2006

Geotextile has been used for various types of containers, such as small hand-filled sandbags, 3-dimensional fabric forms for concrete paste, large soil and aggregate filled geotextile gabion, prefabricated hydraulically filled containers. They are hydraulically filled with dredged materials and have been applied in coastal protection and scour protection, dewatering method of slurry, temporary working platform for bridge construction, temporary embankment for spill way dam construction. Recently, geotextile tube technology is no longer alternative construction technique but suitable desired solution. The paper presents the stability behavior of geotextile tube composite structure by 2-D limit equilibrium and slope stability analysis. 2-D limit equilibrium analysis was performed to evaluate the stability of geotextile tube composite structure to the lateral earth pressure and also transient seepage and stability analysis were conducted to determine the pore pressure distribution by tide variation and slope stability. Based on the results of this paper, the three types of geotextile tube composite structure is stable and also slope stability of overall geotextile tube composite structures is stable with the variation of tidal conditions.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.6 no.2
• /
• pp.38-45
• /
• 2003

This paper intends to analyze the movement characteristics of the suspended solid(SS) generated in a riprap work which is the most widespread process in harbor construction. The generation and movement behaviors of SS are investigated when 1) basic ripraps (0.001~0.03㎥) are cast for breakwater construction, 2) ripraps are loaded on carrier for riprap casting in the sea-wall construction of dredged material pocket, and 3) ripraps for inner filling are cast. The result of the present study shows that the SS generation is considerable when basic ripraps are cast for breakwater construction and the SS diffusion reaches up to 500m in high tide period. When ripraps are loaded on carrier, the SS is generated by the ripraps running down into sea from carrier, thereby showing a high concentration of SS in the vicinity of carrier. In the surface layer, SS distribution is confined in the vicinity of the carrier due to the prompt sinking of the SS. However the SS in the bottom layer is diffused approximately up to loom and then the SS concentration reaches to the background one. In the riprap (less than 0.03㎥) casting for inner filling using pork crane, SS is diffused approximately up to 300m in the surface layer and more than 300m in the bottom layer. It is quite interesting that the movement of the SS generated in harbor construction is mainly controlled by wind drift in the surface layer and tidal current in the bottom layer, and also the diffusion range of SS in the bottom layer is much larger than that in the surface layer.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.6 no.2
• /
• pp.46-53
• /
• 2003

In order to analyze the movement characteristics of suspended solid(SS) in harbor construction, we investigate the generation and movement processes of the SS for the landfill construction by direct casting method and the grab dredging construction which is the most frequent process in harbor construction. We find that the SS is generated into a very high concentration right after the direct casting of landfill soil and continued up to 60 minutes in the landfill construction using the direct casting method with dredged materials by a ship of 700-tonnage. In the grab dredging construction, the SS is generated in a high density of concentration near at its source regardless of water depth, formed belt and diffused up to 700m along the trajectory of tidal current. Based on the result of the present study, it is recommended for the mitigation of SS generation that the silt protector be deployed near at construction site close enough to block the diffusion of SS and the body length of silt protector be long enough to mitigate the SS diffusion in the bottom layer.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.8 no.4
• /
• pp.411-419
• /
• 2003

Dredged material during Masan Bay cleaning in 1990-1994 was deposited in Gapo area. The site provides an ideal experimental condition to monitor environmental remediation and benthic ecosystem stabilization processes after the disturbance. Sea water samples were taken during one tidal cycle in one hour interval from Oct. 2001 to Apr. 2002 (4 times) to estimate the organic matter and nutrient fluxes in Gapo area. Hourly material fluxes were estimated from the water balance estimated from 3 dimensional topography of Gapo area and from material concentration. Net material fluxes were estimated from the difference between total influx and total outflux during one tidal cycle. Chemical oxygen demand showed net outflux in Nov. 2001, Dec. 2001 and Apr. 2002 (2.2∼3.9 g m$\^$-2/ h$\^$-1/) and showed net influx in Mar. 2002 (1.4 g m$\^$-2/ h$\^$-1/). Ammonium showed net outflux during the study (0.1∼118 mg m$\^$-2/ h$\^$-1/m-2h-I). According to this investigation, Gapo area was a source rather than a sink of organic matter. However, the variability of the material fluxes was high so that a long term study may be required.

• Journal of the Korean GEO-environmental Society
• /
• v.17 no.5
• /
• pp.37-46
• /
• 2016

In order to determine the variability of environmental characteristics of lightweight air-foamed soil using marine clay according to freezing-thawing and soaking conditions, unconfined compressive strength of the lightweight air-foamed soil samples made by changing the amount of cement under curing conditions of outdoor low temperature, underground or indoor wetting were observed. Compressive strength was not increased under freezing-thawing (temperature range of $-9.1^{\circ}C{\sim}17.2^{\circ}C$) regardless of the amount of cement but the more cement using, it was increased rapidly by underground curing conditions within 30 cm beneath ground level. Therefore, it is necessary to install insulation layer cutting off exterior cold air after construction of lightweight air-foamed soil in condition of freezing-thawing. Bulk density was increased too small under the long-time soaking condition, it tended to decrease rapidly when samples were dried up and had below 6% of water contents. But variability of compressive strength and bulk density was very small for preventing drying and keeping its wet state. The lightweight air-foamed soil that installed beneath ground water level or covered by soil can be evaluated as a long-term reliable construction material.

• The Journal of the Petrological Society of Korea
• /
• v.1 no.1
• /
• pp.71-84
• /
• 1992

This paper reports the results about the petrography and mineral chemistry of 13 representative dredged basaltic rocks from the western Caroline Ridge (WCR) and Yap Trench-Arc system, and provides the chemical and tectonic informations based on the compositions of clinopyroxene phenocrysts. Compositions of olivine phenocrysts in some analyzed samples are Fo$_{86-80}$. Plagioclase phenocrysts have variable compositions ranging from An$_{90}$ to An$_{55}$. The compositions of clinopyroxene phenocrysts vary according to geological environments; titansalite in atoll and guyot of WCR, diopside-augite in trough and bank of WCR, and endiopside in Yap Trench-Arc system. Application of the discrimination schemes proposed by Leterrier et al. (1982) suggests: (1) the samples from atoll-guyot belong to within plate alkali basalt, implying that western CR could be the continuation of eastern CR formed by hot spot magmatism, (2) the samples from the Yap Trench-Arc system with no present-day magmatism clearly indicate the occurrence of orogenic tholeiites presumably related to early island arc magmatisms in this area, however, (3) the samples from the bank and trough do not provide definitive informations, which might indicate the complexity of their origins.

• Journal of Environmental Impact Assessment
• /
• v.28 no.3
• /
• pp.312-331
• /
• 2019

An offshore waste disposal facility refers to a landfill site for final landfilling of stabilized inorganic solid waste such as land and marine waste incineration materials, and the aim of such a facility is to solve the problem of insufficient waste disposal space on land and create and develop environmentally friendly marine spaces. The purpose of this study is to prepare guidelines for the construction of offshore waste disposal facilities, which reflect the need and importance of paying sufficient heed to environmental considerations from the initial stage of the project, in order to investigate, predict, and assess how such guidelines will affect the marine environment in relation to the construction of offshore waste disposal facilities, with the goal of minimizing the impact on and damage to the environment. For the purpose of this research, guidelines focusing on the construction of offshore waste disposal facilities were derived through an analysis of domestic cases and similar foreign cases and an assessment of their level of compliance with existing EIA guidelines through the operation of a discussion forum. In order to review the EIA report on similar cases in Korea, 17 EIA documents (2005~2016) for dredged soil dumping areas and ash ponds of thermal power plants were analyzed to investigate the status of marine organisms, marine physics, marine water quality, and marine sediment and to understand what types of problems can occur and what improvement measures can be taken. The purpose of these guidelines were to minimize damage to the marine environment by promoting EIA protocols in accordance with scientific and systematic procedures, to reduce the consultation period related to projects, to resolve social conflicts, and to reduce economic costs.

• The Journal of Engineering Geology
• /
• v.28 no.4
• /
• pp.541-552
• /
• 2018

The implementation of drought measures in the upstream areas of river basins is seldom considered with respect to water supply. However, the demand for such measures is increasing rapidly owing to the occurrence of severe droughts, and interventions on streams and the water supply are needed. Physical interventions are an option to prevent streams from becoming dry and to maintain stream water flow, but dam construction is challenging because of environmental and ecological considerations. Here, a feasibility study was conducted to assess the potential effects of sand dams, which are widely used in arid regions in Africa. The SWAT-K model, which is a hydrologic model used for Korean watersheds, is used to estimate the flow rate of water in an ungauged watershed. The changes in water storage of the sand-dammed reservoir and in downstream flow rates are estimated for two types of sand dam (natural and dredged). The results show that sand dams are capable of increasing the downstream flow rate during normal conditions and of mitigating water supply problems caused by the withdrawal of water during drought periods.