• Membrane and Water Treatment
• /
• v.10 no.4
• /
• pp.313-320
• /
• 2019

Increasing the concentration of nitrate ions in the soil solution and then leaching it to underground aquifers increases the concentration of nitrate in the water, and can cause many health and ecological problems. This study was conducted to evaluate the vulnerability of Meymeh aquifer to nitrate pollution. In this research, sampling of 10 wells was performed according to standard sampling principles and analyzed in the laboratory by spectrophotometric method, then; the nitrate concentration zonation map was drawn by using intermediate models. In the drastic model, the effective parameters for assessing the vulnerability of groundwater aquifers, including the depth of ground water, pure feeding, aquifer environment, soil type, topography slope, non-saturated area and hydraulic conductivity. Which were prepared in the form of seven layers in the ARC GIS software, and by weighting and ranking and integrating these seven layers, the final map of groundwater vulnerability to contamination was prepared. Drastic index estimated for the region between 75-128. For verification of the model, nitrate concentration data in groundwater of the region were used, which showed a relative correlation between the concentration of nitrate and the prepared version of the model. A combination of two vulnerability map and nitrate concentration zonation was provided a qualitative aquifer classification map. According to this map, most of the study areas are within safe and low risk, and only a small portion of the Meymeh Aquifer, which has a nitrate concentration of more than 50 mg / L in groundwater, is classified in a hazardous area.

• Earthquakes and Structures
• /
• v.22 no.4
• /
• pp.387-399
• /
• 2022

To study the seismic damage of masonry structures and understand the characteristics of the multi-intensity region, according to the Dujiang weir urbanization of China Wenchuan earthquake, the deterioration of 3991 masonry structures was summarized and statistically analysed. First, the seismic damage of multistory masonry structures in this area was investigated. The primary seismic damage of components was as follows: Damage of walls, openings, joints of longitudinal and transverse walls, windows (lower) walls, and tie columns. Many masonry structures with seismic designs were basically intact. Second, according to the main factors of construction, seismic intensity code levels survey, and influence on the seismic capacity, a vulnerability matrix calculation model was proposed to establish a vulnerability prediction matrix, and a comparative analysis was made based on the empirical seismic damage investigation matrix. The vulnerability prediction matrix was established using the proposed vulnerability matrix calculation model. The fitting relationship between the vulnerability prediction matrix and the actual seismic damage investigation matrix was compared and analysed. The relationship curves of the mean damage index for macrointensity and ground motion parameters were drawn through calculation and analysis, respectively. The numerical analysis was performed based on actual ground motion observation records, and fitting models of PGA, PGV, and MSDI were proposed.

• Geomechanics and Engineering
• /
• v.13 no.6
• /
• pp.893-906
• /
• 2017

Automatic large scale soil model generation is very critical stage for earthquake hazard simulation of urban areas. Manual model development may cause some data losses and may not be effective when there are too many data from different soil observations in a wide area. Geographic information systems (GIS) for storing and analyzing spatial data help scientists to generate better models automatically. Although the original soil observations were limited to soil profile data, the recent developments in mapping technology, interpolation methods, and remote sensing have provided advanced soil model developments. Together with advanced computational technology, it is possible to handle much larger volumes of data. The scientists may solve difficult problems of describing the spatial variation of soil. In this study, an algorithm is proposed for automatic three dimensional soil and velocity model development of southern part of the European side of Istanbul next to Sea of Marmara based on GIS data. In the proposed algorithm, firstly bedrock surface is generated from integration of geological and geophysical measurements. Then, layer surface contacts are integrated with data gathered in vertical borings, and interpolations are interpreted on sections between the borings automatically. Three dimensional underground geology model is prepared using boring data, geologic cross sections and formation base contours drawn in the light of these data. During the preparation of the model, classification studies are made based on formation models. Then, 3D velocity models are developed by using geophysical measurements such as refraction-microtremor, array microtremor and PS logging. The soil and velocity models are integrated and final soil model is obtained. All stages of this algorithm are carried out automatically in the selected urban area. The system directly reads the GIS soil data in the selected part of urban area and 3D soil model is automatically developed for large scale earthquake hazard simulation studies.

• Magazine of the Korea Concrete Institute
• /
• v.8 no.2
• /
• pp.139-150
• /
• 1996

The objective of this study is to provide the information on the manufacturing and exper- , ructures. imental techniques of small scale modeling of precast concrete(P.C.) large panel :-t The ad~~pted scale was one-fifth. 4 types of experiments were performed : nlaterial tests for model concrete and model reinforcement, compressive test of horizontal joint, shear test of vertical joint and cyclic static test of 2-story subassemblage structure. Based on the experimental results, the following conclusions are drawn : i 1) Model concrete had in general larger compressive strength than expected. (2) Model reinforcement showed less ductility if the annealing processes were performed without using vaccuum tube. 131 Failure niotles of horizontal and vertical joints were almost same for both prototype and model. But the strength of model appears to be higher than required by similitude law. (41 Hysteretic behavior of 1 /T, scale subassemblage model can be made quite similar to that of prototype if the ductility of model reinforcement and compressive strength of model concrete could be representative of those of prototype.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.4
• /
• pp.1269-1278
• /
• 2014

The urban highway, which is a motorway constructed to solve traffic issues, has the characteristic of extremely high damage to life during traffic accidents because the speed of vehicles is higher than typical roadways. In particular, because traffic accidents involving serious injuries hold a very important place among overall traffic accidents, analysis on factors affecting the occurrence of traffic accidents involving serious injuries must be considered with priority when establishing a reduction measure. Therefore, the study built a model that was capable of distinguishing the degree of the factors as part of microscopic analysis for investigating the complex effect of many elements concerning the occurrence of traffic accidents involving serious injuries in urban highways. The results are as follows. First, discriminant model showed a comparatively high level in overall accuracy rates, and, considering the correlation ratio, the models were determined to be valid, as all characteristics of the factors were clearly distinguished. Second, the problems of traffic accidents involving serious injuries on urban highways according to each factor, were clearly drawn out through the discriminant model. Third, the improvement measure for the problems drawn out from the discriminant models were clearly proposed.

• Environmental and Resource Economics Review
• /
• v.22 no.4
• /
• pp.671-689
• /
• 2013

Transmission mechanisms of volatility between two crude oil markets (WTI and Brent markets) have drawn the attention of numerous academics and practitioners because they both play crucial roles in portfolio and risk management in crude oil markets. In this context, we examined the volatility linkages between two representative crude oil markets using a VECM and an asymmetric bivariate GARCH model. First, looking at the return transmission through the VECM test, we found a long-run equilibrium and bidirectional relationship between two crude oil markets. However, the estimation results of the GARCH-BEKK model suggest that there is unidirectional volatility spillover from the WTI market to the Brent market, implying that the WTI market tends to exert influence over the Brent market and not vice versa. Regarding asymmetric volatility transmission, we also found that bad news volatility in the WTI market increases the volatility of the Brent market. Thus, WTI information is transmitted into the Brent market, indicating that the prices of the WTI market seem to lead the prices of the Brent market.

• Proceedings of the KSME Conference
• /
• 2001.06e
• /
• pp.219-222
• /
• 2001

The objective of the present study is to evaluate the effects of the stenting shapes on flow velocity and wall shear stress in angulated coronary stenosis by computer simulation. Coronary angiogram and Doppler ultrasound measurement in the patients with angulated coronary stenosis were obtained. Inlet wave velocity distribution obtained from in vivo intracoronary Doppler data was used for the numerical simulation. Spatial pattern of blood flow velocity and recirculation area were drawn through out the selected segment of coronary models. Wall shear stresses in the intracoronary stent models were calculated from three-dimensional computer simulation. A negative shear stress region, which is consistent with re-circulation area on flow pattern, was noted on the inner wall of post-stenotic area of pre-stenting model. The negative shear stress was disappeared after stenting. Shear stress in the post-stenting model was markedly reduced up to about two orders of magnitude compared to that of the pre-stenting model.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.6
• /
• pp.31-38
• /
• 2014

The purpose of this study is to make virtual machine using a 3D modeller to perform reverse engineering. Through the intuitive designer's ability, approximated model of the object is created and used to extract the data and NC tool path. The extracted data make approximated curve by using NURBS curve fitting. And the curve is used to remodel. From these series of process, the final reverse engineering data of the objects can be obtained. Two conclusions are drawn from this study. First, initial deviation of the intuitive model is one of the important factors that determine the number of repetitions of the experiment. Due to the characteristic of intuitive curve, after a certain number of repetitions the average deviation increase and radiate rather than decrease.

• The Journal of Asian Finance, Economics and Business
• /
• v.6 no.4
• /
• pp.147-158
• /
• 2019

The purpose of this study is to identify differences based on demographic characteristics and travel-related characteristics: first, whether travelers used a domestic travel agency and second whether travelers purchased a full-package travel program. A sample selection probit model was used to provide simultaneous evaluation of the different characteristics of outbound travelers. The present study investigates how tourists make decisions based on two travel-pattern choices. It then goes on to explore the characteristics of outbound travelers from South Korea. The data is drawn from a nationwide survey in South Korea, and a total of 859 surveys were used for analysis. Due to the interdependent nature of the choices, a sample selection probit model was used to estimate outbound tourists' use of domestic travel agency and purchase of full travel package. Significant determinants of domestic travel agency use are identified as age, gender, marital status, party size, children, length of travel, and travel distance, while those of full travel package purchase are age, marital status, and travel purpose. Estimated results provide manifestations of differing travel needs of outbound travelers. the results of this study demonstrate differences between travel-agency users and full-package travel-program consumers and provide determinants that affect the purchase of full-package travel.

• Journal of Astronomy and Space Sciences
• /
• v.6 no.2
• /
• pp.127-135
• /
• 1989

The UBV observations of Epsilon Aurigae from April 1982 to May 1985 had been made at Yonsei University Observatory. The light curves drawn from the observational data are combined with other light curves which are well fitted. In these light curves, secondary light variations, flare activity, mid-eclipse light brightening, and others are checked precisely. Contact times and time of mid-eclipse are determined and compared with the values which were presented on the other papers. Compared with previous eclipses, it is noted that the duration of totality is gradually contracted and the duration of total eclipse is gradually enlarged. Though these phenomena are applied to the disk model which has been more accepted than any other models, those are not explained explicitly. So, a new model, comet model, is suggested and is found to make a neat description to the phenomena revealed on the light curves.