• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 1999.10a
• /
• pp.27-27
• /
• 1999

To illustrate the global variation of the droplet mean diameters and the turbulent flow characteristics in counterflowing internal mixing pneumatic nozzle, the experimental measurements at five axial downstream locations(i.e., at Z=30, 50, 80, 120, and 170mm) were made using a PDPA(Phase Doppler Particle Analyzer) under the different air injection pressures ranging from 40 ㎪ to 120 ㎪. A nozzle with axi-symmetric tangential-drilled four holes at an angle of 15$^{\circ}$ has been designed and manufactured. The distributions of velocities, turbulence intensities, turbulence kinetic energy, turbulent correlation coefficients, spray angle, droplet mean diameters, volume flux, number density are quantitatively analyzed. It is possible to discern the effects of increasing air pressure. It indicates that the strong axial momentum in spite of more or less disparity between the velocity components means more reluctant to disperse radially, and that axial fluctuating velocities are substantially higher than those of radial and tangential ones, suggesting that the disintegration process is enhanced under higher air assist. The larger droplets are detected in the spray centerline at the near stations and smaller ones are generated due to further subsequent breakup at farther axial locations are attributed to the internal mixing type nozzle characteristics. Despite of the strong axial momentum, the poor atomization around the centre close to the nozzle exit is attributed to the lower rates of spherical particles which are not subject to instantaneous breakup. As it goes downstream, however, substantial increases in SMD(Sauter Mean Diameter) from the central part toward spray periphery are understandable because the droplet relative velocity is too low to bring about any subsequent disintegration.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5C
• /
• pp.302-308
• /
• 2011

In this paper we propose a coordinated beamforming(CBF) scheme considering the effects of feedback quantization and delay in time-varying multiple-input multiple-output(MIMO) broadcast channels. By equal power allocation per data stream, the proposed CBF scheme transmits multiple data streams per user terminals without additional feedback overhead when quantized feedback information is used. The proposed CBF scheme also applies a linear channel predictor to each user terminals to prevent errors due to feedback delays that are not evitable in practical wireless systems. Each user terminal utilizes Wiener filter to predict future channel responses and generates feedback information based on the predicted channels. Consequently the proposed CBF scheme adapting Wiener filter improves system performances compared with the conventional scheme using delayed feedback.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.9C
• /
• pp.906-914
• /
• 2009

SC-FDMA is employed in the 3GPP-LTE standard as the uplink transmission scheme. SC-FDMA has advantages that the signal has a low PAPR property and a simple equalizer such as FD-LE can be implemented. But FD-LE has inferior performance to Hybrid-DFE composed of frequency-domain feedforward filter and time-domain feedback filter. Recently, several IB-DFE algorithms have been proposed to overcome the disadvantages of implementation and processing complexity of Hybrid-DFE and to obtain superior performance to FD-LE. In this paper, we apply several IB-DFE algorithms to 3GPP-LTE uplink system and compare their performance by calculating BER. We investigate the effects of channel estimation errors and Doppler shift on performance. Finally, by analyzing computational complexity of IB-DFEs, we present some criteria to choose appropriate algorithm and to decide the number of iterative processes.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.3A
• /
• pp.267-273
• /
• 2006

This paper improves the effects of clustered OFCDM scheme considering the frequency diversity effect over a frequency selective fading channel. In OFCDM with frequency domain spreading compared to OFDM, we can increase uncorrelated symbols by frequency allocation method of correspondent symbols over the same antenna and different antenna after spreading. The simulation results show that the performance of proposed system is improved by approximately 4 dB in ${\sigma}=0.02{\mu}sec$, the performance is improved by approximately 2.5dB in large delay spread in a 12-path Rayleigh fading channel with overall the root mean squared delay spread and the maximum Doppler frequency of 20 Hz. Also, the required average received Eb/No at the average BER of $10^{-3}$ by optimum method is improved by approximately 2.0 dB, compared to that of STA-OFCDM with frequency rearrange. The new method does not require any bandwidth expansion any feedback from the receiver to the transmitter and its computation complexity is similar to clustered OFCDM.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.2 no.2
• /
• pp.249-258
• /
• 1998

In land mobile communication, very extensive studies on pilot symbol assisted modulation (PSAM) have been made on fading compensation. This paper analyzes the effect of power amplifier nonlinearity on PSA-QAM with maximal ratio combining space diversity. In practical PSAM, information on fading is obtained through interpolation of the pilot symbols. We employed the interpolation filter which could minimize the average power of error and analyzed effects on the system performance of the number of filter taps, period of the pilot symbol frame, and the Doppler frequency. Nonlinear power amplifiers of class AB, B, and C were incorporated in the system models and their AM/AM and AM/PM characteristics were taken into account in the performance analysis. We showed the performance variations according to the types of the nonlinear power amplifiers in the AWGN and Rayleigh fading channels using nonlinear compensation technique, Cartesian Feedback Loop (CFB).

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.347-352
• /
• 2006

Narrowband interference can severely degrade the performance of GPS receivers. Detecting the presence of interference and then characterizing it can lead to its removal. Receivers can be reconfigured to focus on other signals or satellites that are less vulnerable to that interference at that moment. Using hardware reconfigurability of FPGA receivers and characterizing the effect of narrowband interference on the GNSS signal quality lead us to a new RFI mitigation technique in which the highest quality and less vulnerable signal can be chosen at each moment. In the previous work [1], the post processing capability of a software GPS receiver, has been used to detect and characterize the CW interference. This is achieved by passing the GPS signal and the interference through the correlator. Then, using the conventional definition of C/No as the squared mean of the correlator output divided by its variance, the actual C/No for each satellite is calculated. In this work, first the 'Exclusion zone' for each satellite signal has been defined and then by using some experiments the effects of different parameters like signal power, jamming power and the environmental noise power on the Exclusion zone have been analyzed. By monitoring the Doppler frequency of each satellite and using the actual C/No of each satellite using the traditional definition of C/No and actual data from a software GPS receiver, the decision to reconfigure the receiver to other signal can be made.

• Proceedings of the KIEE Conference
• /
• 2006.07c
• /
• pp.1621-1622
• /
• 2006

This paper presents the effect of driving waveform for piezoelectric bend mode inkjet printhead with optimized mechanical design. Experimental and theoretical studies on the applied driving waveform versus jetting characteristic s were performed. The inkjet head has been designed to maximize the droplet velocity, minimize voltage response of the actuator and optimize the firing frequency to eject ink droplet. The head design was carried out by using mechanical simulation. The printhead has been fabricated with Si(100) and SOI wafers by MEMS process and silicon direct bonding method. To investigate how performance of the piezoelectric ceramic actuator influences on droplet diameter and droplet velocity, the method of stroboscopy was used. Also we observed the movement characteristics of PZT actuator with LDV(Laser Doppler Vibrometer) system, oscilloscope and dynamic signal analyzer. Missing nozzles caused by bubbles in chamber were monitored by their resonance frequency. Using the water based ink of viscosity of 4.8 cps and surface tension of 0.025N/m, it is possible to eject stable droplets up to 20kHz, 4.4m/s and above 8pL at the different applied driving waveforms.

• Journal of Korea Water Resources Association
• /
• v.52 no.2
• /
• pp.115-123
• /
• 2019

The effects of the Froude numbers on turbulent flow patterns downstream of a non-submerged spur dike were investigated in a laboratory flume. Three-dimensional velocities and water depths were measured using Acoustic Doppler Velocimetry and distance sensors under three Froude number conditions ($Fr_d=0.31$, 0.38, and 0.46). The results show that there are marginal differences in the velocity fields downstream of a spur dike due to the change of the Froude number. However, an increase of the Froude number was found to reduce cross-sectional area in the flow and to increase the strength of the jet-like flow. The jet-like flow was observed to displace the location of the maximum turbulence kinetic energy within a cross section toward the inner bank in the transverse direction.

• Journal of Ocean Engineering and Technology
• /
• v.33 no.5
• /
• pp.470-478
• /
• 2019

Because the global positioning system (GPS) is not available in underwater environments, an inertial navigation system (INS)/doppler velocity log (DVL) integrated navigation system is generally implemented. In general, an INS/DVL integrated system adopts a loosely coupled method. However, in this loosely coupled method, although the measurement equation for the filter design is simple, the velocity of the body frame cannot be accurately measured if even one of the DVL transducer signals is not received. In contrast, even if only one or two velocities are measured by the DVL transducers, the tightly coupled method can utilize them as measurements and suppress the error increase of the INS. In this paper, a filter was designed to regenerate the measurements of failed transducers by taking advantage of the tightly coupled method. The regenerated measurements were the normal DVL transducer measurements and the estimated velocity in RPM. In order to effectively estimate the velocity in RPM, a filter was designed considering the effects of the tide. The proposed filter does not switch all of the measurements to RPM if the DVL transducer fails, but only switches information from the failed transducer. In this case, the filter has the advantage of being able to be used as a measurement while continuously estimating the RPM error state. A Monte Carlo simulation was used to determine the performance of the proposed filters, and the scope of the analysis was shown by the standard deviation ($1{\sigma}$, 68%). Finally, the performance of the proposed filter was verified by comparison with the conventional tightly coupled method.

• Annals of Hepato-Biliary-Pancreatic Surgery
• /
• v.27 no.3
• /
• pp.264-270
• /
• 2023

Backgrounds/Aims: Proximal splenorenal shunt (PSRS) is a commonly performed procedure to decompress portal hypertension, in patients with refractory variceal bleed, especially in non-cirrhotic portal hypertension (NCPH). If conventional methods are hindered by any technical or pathological factors, alternative surgical techniques may be required. This study analyzes the effectiveness of various unconventional shunt surgeries performed for NCPH. Methods: A retrospective analysis of NCPH patients who underwent unconventional shunt surgeries during the period July 2011 to June 2022 was conducted. All patients were followed up for a minimum of 12 months with doppler study of the shunt to assess shunt patency, and upper gastrointestinal endoscopy to evaluate the regression of varices. Results: During the study period, 130 patients underwent shunt surgery; among these, 31 underwent unconventional shunts (splenoadrenal shunt [SAS], 12; interposition mesocaval shunt [iMCS], 8; interposition PSRS [iPSRS], 6; jejunal vein-cava shunt [JCS], 3; left gastroepiploic-renal shunt [LGERS], 2). The main indications for unconventional shunts were left renal vein aberration (SAS, 8/12), splenic vein narrowing (iMCS, 5/8), portalhypertensive vascular changes (iPSRS, 6/6), and portomesenteric thrombosis (JCS, 3/3). The median fall in portal pressure was more in SAS (12.1 mm Hg), and operative time more in JCS, 8.4 hours (range, 5-9 hours). During a median follow-up of 36 months (6-54 months), shunt thrombosis had been reported in all cases of LGERS, and less in SAS (3/12). Variceal regression rate was high in SAS, and least in LGERS. Hypersplenism had reversed in all patients, and 6/31 patients had a recurrent bleed. Conclusions: Unconventional shunt surgery is effective in patients unsuited for other shunts, especially PSRS, and it achieves the desired effects in a significant proportion of patients.