• Journal of Korean Society on Water Environment
• /
• v.26 no.1
• /
• pp.19-27
• /
• 2010

Submerged plants whose most of vegetative mass are below the water surface can have great effects on wetland biogeochemistry and water purification through their photosynthesis and nutrient uptake processes. In this study, change of dissolved oxygen concentration and pH as well as nutrient removal capacity of the submerged plant dominant wetland were investigated using wetland mesocosm experiments. Obvious periodic DO and pH fluctuation was observed due to photosynthetic activities of the submerged plants. It implies that the submerged plants can provide periodic or sequential changes of oxic and anoxic conditions that affect nitrification and denitrification processes and contribute permanent nitrogen removal in the wetland system. The pH changes in the wetland mesocosm suggested that submerged plant could also play an important role as a temporary $CO_2$ storage. Higher nutrient removal efficiency was observed in the submerged plant dominant wetland mesocosm. The removal efficiencies under experimental conditions were 38.89, 84.70, 91.21, 70.76, 75.30% of TN, DIN, $NH_4-N$, TP, $PO_4-P$ in the wetland mesocosm, while those were 26.11, 57.34, 63.87, 28.19, 55.15% in the control treatment, respectively.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.4
• /
• pp.491-497
• /
• 2009

The purpose of this study is to propose a method of controlling redtide microbes which grow abundantly and form harmful algal bloom in eutrophic waterbody with yellow loess and hydrogen peroxide. In the laboratory test, hydrogen peroxide was applied to single species of C. polykrikoides and multispecies of redtide microbes. The seawater was evaluated by the pre-test analysis including chlorophyll-a, luminance and transmittance. The test results showed that both single and mixed species of redtide microbes could be controlled with the dose of 30mg $H_2O_2/L$. Residual hydrogen peroxide was completely decomposed with the addition of powdered yellow loess at 2g/L~10g/L. However, the decomposition rate of residual hydrogen peroxide for sintered granular yellow loess was relatively low compared to the use of powdered one. With the addition of dissolved oxygen concentration was increased at a rate of 0.013 mg DO/mg $H_2O_2$, which is a little lower than the one predicted theoretically. No evidence for any detrimental effects on Artemia, a type of brine shrimps, was shown up to the concentration of 100mg $H_2O_2/L$.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.5 no.5
• /
• pp.340-344
• /
• 2000

Microbial oxidation of D-sorbitol to L-sorbose by Acetobacter suboxydans is of commercial importance since it is the only biochemical process in vitamin C synthesis. The main bottleneck in the batch oxidation of sorbitol to sorbose is that the process is severely inhibited by sorbitol. Suitable fed-batch fermentation designs can eliminate the inherent substrate inhibition and improve sorbose productivity. Fed-batch sorbose fermentations were conducted by using two nutrient feeding strategies. For fed-batch fermentation with pulse feeding, highly concentrated sorbitor (600g/L) along with other nutrients were fed intermittently in four pulses of 0.5 liter in response to the increased DO signal. The fed-batch fermentation was over in 24h with a sorbose productivity of 13.40g/L/h and a final sorbose concentration of 320.48g/L. On the other hand, in fed-batch fermentation with multiple feeds, two pulse feeds of 0.5 liter nutrient medium containing 600g/L sorbitol was followed by the addition of 1.5 liter nutrient medium containing 600g/L sorbitol at a constant feed rate of 0.36L/h till the full working capacity of the reactor. The fermentation was completed in 24h with an enhanced sorbose productivity of 15.09g/L/h and a sorbose concentration of 332.60g/L. The sorbose concentration and productivity obtained by multiple feeding of nutrients was found to be higher than that obtained by pulse feeding and was therefore a better strategy for fed-batch sorbose fermentation.

• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.2
• /
• pp.121-127
• /
• 2004

It is necessary to supply external carbon source for enhancement of biological nitrogen removal from domestic wastewater with low influent C/N ratio. Sulfide was chosen as a cost effective electron donor and reaction stoichiometry for autotrophic denitrification was investigated by conducting bench-scale experiments in this study. Higher sulfur to nitrogen (S/N) ratio than the calculated value from theoretical reaction stoichiometry was required when the anoxic reactor was operated at open condition because dissolved oxygen introduced by surface aeration reacted with sulfide with ease. In addition, higher sulfate production and lower yield of microorganism could be observed under the same condition. It was possible to obtain reliable reaction stoichiometry for autotrophic denitrification by establishing pure anoxic condition. Linear relationship between bacterial growth and consumption of nitrate, sulfide, alkalinity, and sulfate production enabled to derive a relatively correct reaction stoichiometry for autotrophic denitrification when sulfide was used as an electron donor.

• The KSFM Journal of Fluid Machinery
• /
• v.13 no.1
• /
• pp.23-28
• /
• 2010

A draft tube which has impeller to elevate bottom water and spread it over surface of lake water, induces convective circulation of lake water, a Long-Distance Circulation (LDC). Circulation of lake water make stratified water mixed and enhance DO (Dissolved Oxygen) of bottom water. Circulation rate of water is determined by draft rate of the tube, which is dependent on design parameters of the draft tube system, i. e. dimension of impeller and diffuser, inclined angle of impeller, impeller shape, and rotational speed. In this study, change in draft rate and power consumption of circulation equipment was investigated numerically with changing impeller dimension, angle and rotational speed. It was found that flowrate of draft water was increased as the dimensions of draft tube and impeller, and rotational speed and inclined angle of impeller increased. The power consumption was also elevated with increasing parameter values, and final selection of parameter values was made to satisfy target flowrates and power consumption.

• Nuclear Engineering and Technology
• /
• v.32 no.5
• /
• pp.514-520
• /
• 2000

The mechanism of corrosion behavior has to be understood clearly to select an optimum material for handling molten salts to be used in the oxide reduction process of PWR spent fuel. In this study, the oxidation states of corrosion products on the surface of Inconel 600 and 800H as well as their chemical compositions and structural informations were determined by using XPS, ICP-AES, AAS, EPMA and XRD after the corrosion experiment with lithium molten salts at 75$0^{\circ}C$ for 25 hours. Nickel and oxygen were detected from the corrosion products on the surface of Inconel plates and chromium was found to be dissolved out into lithium molten salts leaving cracks on the surface. The corrosion products were identified as metal oxides such as Fe$_2$O$_3$, Cr$_2$O$_3$, NiO, NiFe$_2$O$_4$and MnO by using XPS and XRD.

• Journal of Information Processing Systems
• /
• v.17 no.6
• /
• pp.1179-1190
• /
• 2021

A data acquisition and monitoring system was developed for an automated system of a smart fish farm. The fish farm is located in Jang Hang, South Korea, and was designed as circulation filtration system. Information of every aquaculture pool was automatically measured by pH sensors, dissolved oxygen sensors, and water temperature sensors and the data were stored in the database in a remoted server. Modbus protocol was used for gathering the data which were further used to optimize the pool water quality to predict the rate of growth and death of fish, and to deliver food automatically as planned by the fish farmer. By using JSON protocol, the collected data was delivered to the user's PC and mobile phone for analysis and easy monitoring. The developed monitoring system allowed the fish farmers to improve fish productivity and maximize profits.

• Fisheries and Aquatic Sciences
• /
• v.24 no.12
• /
• pp.400-405
• /
• 2021

In this study, the relationship between the growth of abalone and the presence of epibionts was investigated in abalone cultured in Goheung, Jeollanam-do, where there are severe problems high water temperatures and attachment. The experiment was conducted for eight months (May-December 2020), and 40 abalone were collected every month. Water temperature was at its highest at a range of 13.5℃-26.6℃ and dissolved oxygen levels were at their lowest at a range of 4.0-10.2 ㎍/L in August. The shell height (mm) of abalone grew to 117.7% (81.8 ± 1.9 mm) in cultures where epibionts were removed (ER) and 111% (77.4 ± 3.3 mm) where they were not (non-epibionts, NER). Their total weight (TW) and body weight increased significantly and steadily with ER, whereas the TW increased sharply after August with NER. In the condition index, no significant difference was observed between ER and NER. The monthly proportion of epibionts increased significantly in July, accounting for the value of 69.9% reached in December.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.17 no.11
• /
• pp.3083-3098
• /
• 2023

As demands for efficient and echo-friendly production of marine products increase, smart aquaculture based on information and communication technology (ICT) has become a promising trend. The smart aquaculture is expected to control fundamental farm environment variables including water temperature and dissolved oxygen (DO) levels with less human intervention. A recirculating aquaculture system (RAS) is required for the smart aquaculture which utilizes a purification tank to reuse water drained from the water tank while blocking the external environment. Elaborate water treatment should be considered to properly operate RAS. However, analyzing the water treatment performance is a challenging issue because fish farm circumstance continuously changes and recursively affects water fluidity. To handle this issue, we introduce computational fluid dynamics (CFD) aided water treatment analysis including water fluidity and the solid particles removal efficiency. We adopt RAS parameters widely used in the real aquaculture field to better reflect the real situation. The simulation results provide several indicators for users to check performance metrics when planning to select appropriate RAS without actually using it which costs a lot to operate.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.7 no.2
• /
• pp.69-78
• /
• 1974

A study on the contents of dissolved oxygen and phytoplankton in the pond water has been carried out to determine the water quality and to investigate the cause of red water in fish ponds at Pusan Fisheries College in 1972-1973. The results obtained are as follows : 1. Measured oxygen content during the period from 6th to 7th of August 1972 was: 23.95ppm ($328\%$ in saturation rate) in daytime and 0.39 ppm($5\%$) in the early morning in the water which contains heavy bloom of phytoplankton, on the other hand, in clear water the range of oxygen content was 8.72 to 6.58ppm. 2. The occurrences of red water in 1972-1973 were always caused by the sudden death of Synechocystis aquatilis (Cyanophyta) when the water temperature was very high ($30-33.5^{\circ}C$) and then high mortality of fish under rearing followed. 3. The phytoplankon observed during this study period was 133 species belonging to 55 genera in 23 families, and those of Chlorophyta was dominant in number of species, and Cyanophyta in quantity. 4. Zooplankton observed was 12 species belonging to 11 genera in 11 families, and they were very small both in number of species and in quantity compared to those of phytoplankton.