• 한국가스학회지
• /
• 제14권3호
• /
• pp.14-20
• /
• 2010

본 논문은 리튬이온전지의 불꽃방전에 의한 폭발위험성에 관한 연구로서 휴대용기기의 전원으로 사용되는 리튬이온전지(일반용, 노트북용)를 시료로 선정하고, 폭발성 시험가스인 메탄, 프로판, 에틸렌, 수소를 대상으로 IEC형 불꽃점화 시험장치를 이용하여 불꽃점화실험을 실시하여 불꽃방전에 의한 폭발위험성을 규명하였다. 또한, 사고 시 단락전류에 의한 자체점화 가능성을 확인하고자 열화상카메라를 이용하여 온도변화를 측정하였다. 실험결과 리튜이온전지는 폭발성가스가 존재하는 폭발위험장소에서 사용할 때는 안전에 각별히 주의하여 사용 설계되어야 한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 추계학술대회 논문집 전기물성,응용부문
• /
• pp.217-219
• /
• 2005

To detect partial discharge of 154kV joint box, we have made experiment by using the HFCT sensor. Generally the signals which are detected in partial discharge test of underground power transmission cable are accompanied with both noises of high voltage and noises of surrounding power cable. The most noise in near to end part of joint box is corona, beside other noises flowed from surrounding area. Partial discharge test is difficulty due to these noises. First, we test reliability on both injection of calibration signal in NJB and removal of low frequency. After that, we had analyzed frequencies by measuring signals in IJB with 300[m] distance from NJB. Also we had measured S/N ratio by using the indirected injection method of calibration signal in IJB. In this experiment, two measurement methods were difference of detection acquisition, but these had the equal frequency properties.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2009년도 춘계 학술발표회
• /
• pp.692-701
• /
• 2009

The use of vertical drain method to improve the soft soil ground has been continuously increased in Korea such as Busan New Port, Saemangeum reclamation project and so on in Korea. Especially PBD(Plastic Board Drain), one of the vertical drain, has been widely used due to the economic feasibility, construction compatibility and quality control. However in case of using PBD, discharge capacity reduction caused by creep deformation of the PBD filter, bending, kinking and so on can be occurred. Therefore the purpose of this study is to solve these problems by developing Deformation-Compatible Vertical Drain, DCVD which allows to deform with consolidation settlement without bending and kinking of vertical drain. In order to investigate the performance of DCVD developed in this study, discharge capacity test, centrifuge model test and complex discharge capacity test for both PBD and DCVD are performed and the results are compared.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2010년도 제35회 추계학술대회논문집
• /
• pp.726-728
• /
• 2010

75톤급 가스발생기 개발을 위한 분사기의 설계 변수에 따른 유량계수의 영향을 파악하기 위하여 축소형 가스발생기를 설계, 제작하였으며, 연소시험을 성공적으로 수행하였다. 연소시험 결과 연료 및 산화제 분사기의 유량계수는 혼합비와 연소압에 상관없이 거의 일정한 것으로 나타났으며, 산화제 분사기의 노즐 지름을 줄인 경우 분사기 차압이 줄어들어 유량계수가 증가하는 것을 확인하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 춘계학술대회 논문집 전기설비전문위원
• /
• pp.75-78
• /
• 2007

To detect partial discharge of 154kV joint box, we have made experiment by using the HFCT sensor. Generally the signals which are detected in partial discharge test of underground power transmission cable are accompanied with both noises of high voltage and noises of surrounding power cable. The most noise in near to end part of joint box is corona, beside other noises flowed from surrounding area. Partial discharge test is difficulty due to these noises. First, we test reliability on both injection of calibration signal in NJB and removal of low frequency. After that, we had analyzed frequencies by measuring signals in IJB with 300[m] distance from NJB. Also we had measured S/N ratio by using the indirected injection method of calibration signal in IJB. In this experiment, two measurement methods were difference of detection acquisition, but these had the equal frequency properties.

• 전기학회논문지
• /
• 제60권4호
• /
• pp.805-810
• /
• 2011

This paper deals with the method and algorithm used to find fault locations in gas insulated transmission line. The method uses UHF sensors and digital oscilloscope to detect discharge signals emitted to the outside through insulating spacer in the event of breakdown inside GIL. UHF sensors are the external type and installed at outside of insulating spacers of GIL. And we used wavelet signal processing to analyze the discharge signals and confirm the exact fault location findings in the GIL test line. This method can overcome demerit of TDR(Time Domain Reflectometer) method having been applied to detect fault location for conventional underground transmission lines, and Ground Fault Sensors used in conventional GIS systems. TDR method requires high level of specialty and experience in analyzing the measured signals. Ground fault sensors are installed inside GIL and can be destroyed by high transient voltage. This paper's method can simplify the fault location process and minimize the damage of sensors. In addition, this method can estimate the fault location only by the time difference when discharge signals are arrived to detecting sensors at the ends of GIL sections without reasons of breakdown. To test the performance of our method, we installed sensors at the ends of test line of GIL(84m) and sensed discharge signals occurred in GIL, energized with AC voltage generator up to 700kV.

• 한국지반신소재학회논문집
• /
• 제5권1호
• /
• pp.25-32
• /
• 2006

방조제 공사는 바다를 막아 바닷물의 흐름을 차단해가는 과정으로 육상공사와는 달리 수심이 깊고 파랑이 심한 바다에서 이루어지는 공사이기 때문에 축조재료의 유실이 많고 심할 경우 방조제가 붕괴되는 위험이 큰 공사이다. 특히, 방조제의 끝막이 단면은 대규모 사석과 돌망태 등을 이용하여 시공하므로, 구성 재료가 불규칙하고 간극이 크기 때문에 일반적인 지반내의 침투흐름보다 상당히 빠른 침투가 발생된다. 본 연구에서는 방조제 끝막이 후 축조된 사석단면과 후속공정을 통하여 축조되는 방조제단면에 대한 실내 침투모형시험을 수행하여 침투거동을 예측 및 분석하였다. 다양한 조위변화를 재현하여 근고공 필터매트 시공에 따른 사석단면내의 유속변화, 침윤선 분포 등을 계측하여 침투거동을 분석하였다. 실내 침투모형시험 결과, 끝막이 사석단면의 침투유속은 최대 1.7m/sec 발생하였으며, 근고공 필터매트 시공에 따라 최대 침투유속이 23.7% 감소하였다.

• 가정∙방문간호학회지
• /
• 제10권2호
• /
• pp.123-131
• /
• 2003

This study was to compare the functional status. complication and readmission rates. and client satisfaction with nursing care of home-based care and hospital-based care for clients with Coronary Artery Bypass Graft. Raw data were collected by interviewing and reviewing charts of 41 clients with Coronary Artery Bypass Graft between June 2001 and July 2002 at an university hospital located in Seoul. Korea. Out of 41 clients. 15 were in home care group and 26 were in hospitalization group. The baseline characteristics of the groups were almost identical. Mean age was 61.7 and 75.6% of clients being male. For home care group. the data collection was made at discharge and at termination of home care. and for hospitalization group. at discharge and at the first visit of outpatient department. Complication and readmission rates were investigated at one month after operation. Collected data were then analysed by conducting Chi-square test. Wilcoxon rank sum test. and Wilcoxon signed ranks test with SPSS program. The level of significance was .05. The results of the study are summarized as follows: 1. Postoperative length of stay of the home care group was shorter than that of hospitalization group by 1. 14 days(8.45 days vs. 9.59 days). On average. 1.8 home visits per client were observed. 2. The functional status (Barthel Index) at the termination of home care was significantly increased from that at discharge. For hospitalization group. a significant increase was observed between the functional status at the discharge and that at the first visit of outpatient department. The differencies in incremental of the scores. between the groups. were however not significant. 3. Complication and readmission rates; no statistically significant difference between the groups was observed. 4. The client satisfaction with nursing care (CSS) at termination of home care was significantly higher than that at hospital discharge. In conclusion. the outcomes of the analysis suggest that the home care benefits clients with Coronary Artery Bypass Graft. Client satisfaction with nursing care rises at termination of home care as compare to that measured at hospital discharge. Meanwhile. there was no significant differences in functional status. and complication and readmission rates. Further. home care reduced the length of stay in hospital.

• 성인간호학회지
• /
• 제28권1호
• /
• pp.43-52
• /
• 2016

Purpose: The aim of this study was to identify demographic, clinical, physical, and psychosocial factors affecting discharge delay in lumbar spinal surgery patients who were treated according to a critical pathway. Methods: A sample of 170 patients with lumbar spinal surgery agreed to participate in the study, between April 1, 2014 and August 30, 2015. Data were analyzed by mean, standard deviation, t-test, ${\chi}^2$-test, ANCOVA, and logistic regression analysis using SPSS 22.0 program. Results: Approximately fifty-nine percent of the participants was delayed discharge. On logistic regression analysis, female gender (OR=2.63, 95% CI=1.40~4.94), age (OR=1.03, 95% CI=1.01~1.05), spondylolisthesis (OR=4.49, 95% CI=1.90~10.61), and spinal fusion operation (OR=4.14, 95% CI=1.89~9.05) were significant factors predicting discharge delay of the participants. However, discharge delay was not related with pain, physical function, depression, or family support. Conclusion: An analysis of discharge delay may assist in evaluating and revising critical pathway for optimal care. In addition, nurses need to understand the factors affecting discharge delay of the given population who were treated according to a critical pathway.

• 한국정보통신학회논문지
• /
• 제21권5호
• /
• pp.885-892
• /
• 2017

본 논문에서는 기존 전원차단회로의 공급전원 차단 복귀 시간 지연 문제를 해결하기 위하여 고속 방전 충전 스위칭 기능을 갖는 새로운 전원차단회로를 제안하였다. 제안된 전원차단회로는 공급전원 고속 차단 후 복귀(충전) 속도를 증가시키도록 설계함으로써 전자시스템의 방사선 노출 시간과 펄스 방사선이 지나간 후 정상동작하기 위한 시간을 줄였다. 하드웨어를 구현하기 전 방전 충전 시간의 시뮬레이션은 Cadence 사의 pspice tool을 이용하여 진행하였으며 소자레벨에서 DUT(Device Under Test) 보드를 제작하였다. 전원차단회로의 비교 측정은 24V용 인공위성 전자소자를 대상으로 수행되었다. 그 결과, 제안된 회로는 기존 회로에 비하여 방전속도 96.8%, 복귀속도 27.3% 향상으로 고속 기능이 구현됨을 확인하였다.