• 태양에너지
• /
• 제9권3호
• /
• pp.13-24
• /
• 1989

Direct and diffuse components of solar radiation were measured inside and outside a single-span plastic greenhouse. To analyze the direct solar radiation inside the plastic greenhouse, the cross-section of the greenhouse was assumed to be circular. Then the direct solar radiation transmitted into the greenhouse was calculated theoretically, and compared with the experimental measurements. The results are summarized as follows: (1) The transmissivities of total solar radiation were about 65% on cloudy days and 50% on clear days. For cloudy days, the transmissivity of the total solar radiation was regarded as the transmissivity of sky diffuse radiation. (2) The ratio of the inside effective scattered component of direct solar radiation to the diffuse radiation was 60-65%. (3) It appeared that the seasonal variation of the transmissivity of total solar radiation was adversely affected by the transmissivity of direct solar radiation and the effective scattered coefficient. But the effect of the transmissivity of direct solar radiation was dominant factor. (4) Computer simulation showed that the inside direct solar radiation was decreased as the floor of the plastic greenhouse was higher. (5) The predicted value of the inside direct solar radiation was 3.3% to 29.0% higher than the measured value.

• Journal of Biosystems Engineering
• /
• 제23권5호
• /
• pp.439-444
• /
• 1998

Effects of the number of spans, orientation and latitude on the transmissivities of direct and diffuse solar radiation in multispan glasshouse were analyzed using a computer simulation model (Kim and Lee, 1997). The number of spans did not affect the transmissivity of diffuse solar radiation, ranging 60∼61%. The transmissivities of direct solar radiation were 55∼64% for E-W orientation and 47∼70% for N-S orientation in ten multispan glasshouse. There was no effect of the latitude on the transmissivity of direct solar radiation in domestic regions. Differences in the transmissivity of direct solar radiation between single-span and multispan glasshouse were significant for E-W orientation during winter season; however, those were relatively small for N-S orientation throughout the year. Transmissivity of direct solar radiation decreased with the increasing number of spans for E-W glasshouse, whereas those for N-S glasshouse was hardly affected by the number of spans.

• 생물환경조절학회지
• /
• 제6권3호
• /
• pp.176-182
• /
• 1997

온실의 동방위 및 지붕경사각, 구조물의 재원, 설치 지역의 위도 등이 단동형 유리 온실내의 직달 및 산란일사 투과에 미치는 효과를 분석하고자 컴퓨터 시뮬레이션 모형이 개발되었다. 개발된 모형은 년중 일수, 온실의 방위 및 설치된 지점의 윈도, 지붕경사각이 서로 다른 단동 및 연동 온실에 대하여 적용할 수 있다. 본 연구에서 수행된 온실의 동방위가 온실내의 직달 및 산란일사 투과율에 미치는 영향에서 얻어진 결과를 요약하면 다음과 같다. 1. 단동의 유리온실에서 계산된 산란일사의 투과율은 60.4％로서, 동방위에 무관하게 일정한 값을 갖는 것으로 나타났다. 2. 겨울철에 직달일사의 투과율은 동서동에서 67∼69％ 정도이고, 남북동의 경우 51∼55％ 정도로서 동서동에서 14∼16％ 정도 높게 나타났다. 3. 여름철에 직달일사의 투과율은 동서동에 서보다 남북동에서 높게 나타났다. 4. 직달일사의 투과율에 미치는 국내 지역간의 차이는 거의 없는 것으로 나타났다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2003년도 춘계학술대회
• /
• pp.2198-2204
• /
• 2003

In order to make a match of the insufficient direct solar radiation, in this study, the target output is lowered to 9 kW smaller than 25 kW in former studies. It is also necessary to match the collector/receiver with engine/generator systems to accomplish the power level of a system. The simulation analyses of a dish solar power system with stirling engine are totally carried out to predict the system performance with the designed values. In addition, an influence of direct solar radiation on system performance and operation control is discussed in simulation. It is found that the diameter of concentrator could be made small to 8 m regardless of slope errors with 2.5 and 5.0 mrad radiation, and the operation range of mean pressure control. is wide even if the direct solar radiation is a quit low.

• 한국태양에너지학회 논문집
• /
• 제26권3호
• /
• pp.53-62
• /
• 2006

Since the direct normal radiation and clear day are a main factor for designing any solar thermal and photovoltaic concentrating system, it is necessary to evaluate its characteristics all over the country. The work presented here are the investigation of direct normal radiation and clear day in Korea. The data utilized in the investigation consist of direct normal radiation collected for 14 years('90. 12${\sim}$2004. 12) and clear-day collected for 23 years($1982{\sim}2004$) at measuring stations across the country. The analysis shows that the annual-average daily direct normal radiation is 5.4 kWh/m2 and the annual-average total clear-day is 92.7 days in Korea. We also constructed the contour map of direct normal radiation and clear-day in Korea by interpolating actually measured data across the country.

• 태양에너지
• /
• 제18권4호
• /
• pp.33-38
• /
• 1998

This paper reports the experimental results concerning the thermal performance of a freeze-protected direct solar water heating system. The direct system tested has been manufactured to prevent any breakage during harsh wintry conditions by specially designed riser and downcomer headers capable of relieving extra pressure due to freezing of water. The direct system tested has shown 10% improvement in its efficiency over that of a indirect type system using antifreeze as the heat transfer medium. It is felt that any direct system of its kind could galvanize the whole solar industry if further improvements are made to ensure its durability.

• 한국태양에너지학회 논문집
• /
• 제29권4호
• /
• pp.15-21
• /
• 2009

Since the solar radiation is main input for sizing any solar photovoltaic system and solar thermal power system, it will be necessary to understand and evaluate the insolation data. The Korea Institute of Energy Research(KIER) has begun collecting horizontal global insolation data since May, 1982 and direct normal insolation data since December 1992 at 16 different locations. Because of a poor reliability of existing data, KIER's new data will be extensively used by solar energy system users as well as by research institutes. Among some significant results, the yearly averaged horizontal global insolation was turned out 3.60 kWh/$m^2$/day and the yearly mean 2.62 kWh/$m^2$/day of the direct normal insolation was evaluated for all days.

• 한국태양에너지학회 논문집
• /
• 제25권1호
• /
• pp.11-18
• /
• 2005

Since the direct normal insolation is a main factor for designing any solar thermal power system, it is necessary to evaluate its characteristics all over the country. We have begun collecting direct normal insolation data since December 1990 at 16 different locations and considerable effort has been made for constructing a standard value from measured data at each station. KIER(Korea Institute of Energy Research's new data will be extensively used by solar thermal concentrating system users or designers as well as by research institutes. From the results, we can conclude that 1) Yearly mean $5.4kWh/m^2/day$ of the direct normal insolation was evaluated for clear day all over 16 areas in Korea. 2) Clear day's direct normal insolation of spring and summer were $5.53kWh/m^2/day$ and $5.84kWh/m^2/day$, and for fall and winter their values were $5.3kWh/m^2/day$ and $4.94kWh/m^2/day$ respectively. So, spring and summer were higher, and fall and winter were lower than the yearly mean value.

• 한국태양에너지학회 논문집
• /
• 제32권3호
• /
• pp.77-87
• /
• 2012

Images taken by geostationary satellite may be used to estimate solar irradiance fluxes at earth's surface. It is based on the empirical correlation between a satellite derived cloud index and the irradiance at the ground. For the validation, estimated direct normal Insolation is compared with observed direct normal Insolation at 16 sites over the Korean peninsular from January 1982 to December 2010. Estimated direct normal Insolation shows reliable results with average deviation of -5.4 to +5.9% from the measured values and the yearly averaged direct normal Insolation of Korean peninsula was turned out to be 2.93 $kW/m^2/day$.

• Design & Manufacturing
• /
• 제2권6호
• /
• pp.28-32
• /
• 2008

Polymer solar cells are a type of organic solar cell (also called plastic solar cell), or organic photovoltaic cell that produce electricity from sunlight using polymers. It is a relatively novel technology, they are being researched by universities, national laboratories and several companies around the world. In this paper, stamping mold of barrier ribs for polymer solar cells was manufactured by lithography and electroforming which can control the height of pattern and 80nl of barrier ribs was manufactured by using hot embossing.