• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.373-377
• /
• 2006

The valve is used on control of flow and hydraulic in a ship. Flow coefficient of valve importance in the design of valve. In this paper, three-dimensional computer simulations by commercial code CFX were conducted to observe the value type and to measure valve flow coefficient when valve with various angles and uniform incoming velocity were used in a piping system. By contrast, a group of experimental data is used to compare with the data obtained by CFX simulation to investigate the validity of numerical method.

• Journal of Navigation and Port Research
• /
• v.31 no.1 s.117
• /
• pp.49-53
• /
• 2007

The valve is used on control of flow in a ship. Flow coefficient of valve is very importance in the design of valve. In this paper, three-dimensional computer simulations by commercial code CFX were conducted to observe the valve type and to measure flow coefficient when valves with various angles and uniform incoming velocity were used in a piping system. By contrast, a group of experimental data is used to compare with the data obtained by CFX simulation to investigate the validity of numerical method.

• Journal of Navigation and Port Research
• /
• v.34 no.5
• /
• pp.325-330
• /
• 2010

An open water rudder test was carried out to figure out the flow characteristics around a twin rudder at $Re=1.5{\times}10^4$. In the analysis, the unique characteristics of a twin rudder, which affects rudder forces, were explained. The analysis includes varying angles of attack from 10 to 30 degrees. In this paper, the measured results have been compared with each other to predict the performance characteristics of a twin rudder's 2-dimensional section by 2-frame grey level cross correlation PIV method. The length L=0.75C between upper and lower rudders could be defined as the critical length.

• Journal of Crop Science and Biotechnology
• /
• v.10 no.2
• /
• pp.112-116
• /
• 2007

Kinetin(KN) is an inducer of rice(Oryza sativa L.) defense/stress responses, as evidenced by the induction of inducible secondary metabolite and defense/stress protein markers in leaf. We show a novel light-dependent effect of KN-triggered defense stress responses in rice leaf. Leaf segments treated with KN(100 ${\mu}M$) show hypersensitive-like necrotic lesion formation only under continuous light illumination. Potent accumulation of two phytoalexins, sakuranetin and momilactone A(MoA) by KN that peaks at 48 h after treatment under continuous light is completely suppressed by incubation under continuous dark. Using two-dimensional gel electrophoresis we identified KN-induced changes in ribulose-1, 5-bisphosphate carboxylase/oxygenase, energy- and pathogenesis-related proteins(OsPR class 5 and 10 members) by N-terminal amino acid sequencing and mass spectrometry. These changes were light-inducible and could not be observed in the dark(and control). Present results provide a new dimension(light modulation/regulation) to our finding that KN has a potential role in the rice plant self-defense mechanism.

• Archives of design research
• /
• v.17 no.1
• /
• pp.63-76
• /
• 2004

Although information design principles had originated from the graphic design field including publishing design in 1970s, information design have taken one of the most important positions in multimedia design fields as the present since Richard Saul Wurmn started his researches on information design and its practical application on internet environments. However, relatively little researches have been performed for building identity of information design in multimedia design fields so far and moreover in some cases, information design is likely to be narrowly viewed as 'the representation of a piece of information and its visualization' which was defined in traditional graphic design field. This research circumstance leads the study to investigate characteristics of information design in current multimedia design with contingent perspective which is compared to the traditional information design. The study results suggest 5 characteristics of information design including 'suggesting context & finding out information hierarchy', 'access of integrated consideration & share of information control', 'using of multi-dimensional media & content first', 'stabilization of information quality & combinational understanding of meaning', 'bilateral information representation & user's knowledge expansion'. Future researches, based on the results of the study, are expected to be expanded to a degree with argument for inter-dependent and/or exclusive characteristics of adjacent fields of information design such as interface design, interaction design and experience design.

• Journal of KIISE:Computing Practices and Letters
• /
• v.16 no.11
• /
• pp.1126-1130
• /
• 2010

Research on intelligent robot is in active progress as the next generation IT education area. Since intelligent robots are closely related to the real human world, they should provide human behaviors or judging ability as their functions. For this reason, research is recently done not only on diverse hardware of robot education but also on service component architecture which includes various functions. In this paper we propose a study on learning to creative solve problems using RDS(Robotics Developer Studio). RDS is a software tool to control or program intelligence robot as a software module. Using service component framework which considers standardization of the integrated development of intelligent robot, we expect to provide 3-dimensional visual simulation environment, and save time and costs in education the environment for the intelligence robot experiment.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07a
• /
• pp.292-295
• /
• 2004

The SIT was introduced by Nishizawa. in 1972. When compared with high-voltage, power bipolar junction transistors, SITs have several advantages as power switching devices. They have a higher input impedance than do bipolar transistors and a negative temperature coefficient for the drain current that prevents thermal runaway, thus allowing the coupling of many devices in parallel to increase the current handling capability. Furthermore, the SIT is majority carrier device with a higher inherent switching speed because of the absence of minority carrier recombination, which limits the speed of bipolar transistors. This also eliminates the stringent lifetime control requirements that are essential during the fabrication of high-speed bipolar transistors. This results in a much larger safe operating area(SOA) in comparison to bipolar transistors. In this paper, vertical SIT structures are proposed to improve their electrical characteristics including the blocking voltage. Besides, the two dimensional numerical simulations were carried out using ISE-TCAD to verify the validity of the device and examine the electrical characteristics. A trench gate region oxide power SIT device is proposed to improve forward blocking characteristics. The proposed devices have superior electrical characteristics when compared to conventional device. Consequently, the fabrication of trench oxide power SIT with superior stability and electrical characteristics is simplified.

• Korean Journal of Remote Sensing
• /
• v.30 no.5
• /
• pp.547-557
• /
• 2014

This paper presents a method for designing circular template used in similarity measurement for image registration. Circular template has translation and rotation invariant property, which results in correct matching of control points for image registration under the condition of translation and rotation between reference and sensed images. Circular template consisting of the pixels located on the multiple circumferences of the circles whose radii vary from zero to a certain distance, is converted to two-dimensional Discrete Polar Coordinate Matrix (DPCM), whose elements are the pixels of the circular template. For sensed image, the same type of circular template and DPCM are created by rotating the circular template repeatedly by a certain degree in the range between 0 and 360 degrees and then similarity is calculated using mutual information of the two DPCMs. The best match is determined when the mutual information for each rotation angle at each pixel in search area is maximum. The proposed algorithm was tested using KOMPSAT-2 images acquired at two different times and the results indicate high accurate matching performance under image rotation.

• Korean Journal of Applied Biomechanics
• /
• v.26 no.4
• /
• pp.369-375
• /
• 2016

Objective: The purpose of this study was to investigate the possibility of injuries and the types of movement related to damage by body parts, and to prepare for prevention of injuries and development of a training program. Method: For this study, the experiment was conducted according to levels of 60 percentages (ST) and 85 percentages (MA) and 10 subjects from the Korean elite national weightlifting team were included. Furthermore, we analyzed joint moment and muscle activation pattern with three-dimensional video analysis. Ground reaction force and EMG analyses were performed to measure the factors related to injuries and motion. Results: Knee reinjuries such as anterior cruciate ligament damage caused by deterioration of the control ability for the forward movement function of the tibia based on the movement of the biceps femoris when the rectus femoris is activated with the powerful last-pull movement. In particular, athletes with previous or current injuries should perceive a careful contiguity of the ratio of the biceps femoris to the rectus femoris. This shows that athletes can exert five times greater force than the injury threshold in contrast to the inversion moment of the ankle, which is actively performed for a powerful last pull motion and is positively considered in terms of intentional motion. It is activated by excessive adduction and internal rotation moment to avoid excessive abduction and external rotation of the knee at lockout motion. It is an injury risk to muscles and ligaments, causing large adduction moment and internal rotation moment at the knee. Adduction moment in the elbow joint increased to higher than the injury threshold at ST (60% level) in the lockout phase. Hence, all athletes are indicated to be at a high risk of injury of the elbow adductor muscle. Lockout motion is similar to the "high five" posture, and repetitive training in this motion increases the likelihood of injuries because of occurrence of strong internal rotation and adduction of the shoulder. Training volume of lockout motion has to be considered when developing a training program. Conclusion: The important factors related to injury at snatch include B/R rate, muscles to activate the adduction moment and internal rotation moment at the elbow joint in the lockout phase, and muscles to activate the internal rotation moment at the shoulder joint in the lockout phase.

• Journal of Korea Water Resources Association
• /
• v.39 no.1 s.162
• /
• pp.11-22
• /
• 2006

This study is that MD-FDA and the existing method were applied together the outlet project under the construction in the Gulpo River basin. The results of both of them mot the economic feasibility of the Project. But, MD-FDA evaluated the suitable damage according to situations; 1) without project, 2) after 20m outlet construction, 3) after 80m outlet construction. That is, MD-FDA could exactly evaluate the Annual Expected Flood Damage by considering the characteristics to the inundated area. If M-FDA may use in the flood control projects, the projects will be able to be taken into account all characteristics of the total damage area and performed by reasonable criteria.