• Journal of ILASS-Korea
• /
• v.16 no.3
• /
• pp.119-125
• /
• 2011

Due to the oxygen contents in biodiesel, application of the fuel to compression ignition engines has significant advantages in terms of lowering PM formation in the combustion chamber. In recent days, considerable studies have been performed to extend the low temperature combustion regime in diesel engines by applying biodiesel fuel. In this work, low temperature combustion characteristics of biodiesel blends in dilution controlled regime were investigated at a fixed engine operating condition in a single cylinder diesel engine, and the comparisons of engine performances and emission characteristics between biodiesel and conventional diesel fuel were carried out. Results show that low temperature combustion can be achieved at $O_2$ concentration of around 7~8% for both biodiesel and diesel fuels. Especially, by use of biodiesel, noticeable reduction (maximum 50% of smoke was observed at low and middle loads compared to conventional diesel fuel. In addition, THC(total hydrocarbon) and CO(Carbon monoxide) emissions decreased by substantial amounts for biodiesel fuel. Results also indicate that even though about 10% loss of engine power as well as 14% increase of fuel consumption rate was observed due to lower LHV(lower heating value) of biodiesel, thermal efficiencies for biodiesel fuel were slightly elevated because of power recovery phenomenon.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.11 no.3
• /
• pp.229-234
• /
• 2001

The EDXRF(Energy Dispersive X-ray Fluorescence Spectrometer) technique was applied to the determination of heavy metals in welding fume. The EDXRF method designed in this study was a non-destructive analysis method. Samples were analyzed directly by EDXRF without any pre-treatment such as digestion and dilution. The samples used to evaluate this method were laboratory samples exposed in a chamber connected with a welding fume generator. The samples were first analyzed using a non-destructive EDXRF method. The samples subsequently were analyzed using AAS method to verify accuray of the EDXRF method. The purpose of this study was to evaluate the possibility of the non-destructive analysis of heavy metals in welding fume by EDXRF. The results of this study were as follow: 1.When the samples were collected under the open-face sampling condition, a surface distribution of welding fume particles on sample filters was uniform, which made non-destructive analysis possible. 2. The method was statistically evaluated according to the NIOSH(National Institute for Occupational Safety and Health) and HSE(Health and Safety Executive) method. 3. The overall precision of the EDXRF method Was calculated at 3.45 % for Cr, 2.57 % for Fe and 3.78 % for Mn as relative standard deviation(RSD), respectively. The limits of detection were calculated at $0.46{\mu}g$/sample for Cr, $0.20{\mu}g$/sample for Fe and $1.14{\mu}g$/sample for Mn, respectively. 4. A comparison between the results of Cr, Fe, Mn analyzed by EDXRF and AAS was made in order to assess the accuracy of EDXRF method. The correlation coefficient between the results of EDXRF and AAS was 0.9985 for Cr, 0.9995 for Fe and 0.9982 for Mn, respectively. The overall uncertainty was determined to be ${\pm}12.31%$, 8.64 % and 11.91 % for Cr, Fe and Mn, respectively. In conclusion, this study showed that Cr, Fe, Mn in welding fume were successfully analyzed by the EDXRF without any sample pre-treatment such as digestion and dilution and a good correlation between the results of EDXRF and AAS was obtained. It was thus possible to use the EDXRF technique as an analysis method of working environment samples. The EDXRF method was an efficient method in a non-destructive analysis of heavy metals in welding fume.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.3
• /
• pp.178-184
• /
• 2014

In this study, monitoring method which is more economic and easier in maintenance comparing to existing monitoring system was scrutinized for application to sewer intercepting chamber of 10.2 ha basin area by estimating CSOs (Combined Sewer Overflows) quantity and quality with 2 rainfall events using electrical conductivity data and civil research model. The result showed that determination coefficient of flow estimation by EC (Electrical Conductivity) dilution ratio and observed data was over 0.86 for all cases and the accuracy of estimation was improved from 0.5 to 0.8 for determination coefficient ($R^2$) and from 54.1% to 68.5% for accumulation frequency of relative error by considering antecedent dry days and rainfall duration. CSOs water quality estimation results by civil research model showed that determination coefficients were 0.64~0.97 for BOD and 0.70~0.95 for SS.

• The Korean Journal of Mycology
• /
• v.41 no.4
• /
• pp.274-279
• /
• 2013

Slightly acidic hypochlorous water (SAHW) is well known for having a powerful and broad spectrum antimicrobial activity, and is harmless to the environment and humans. SAHW (pH 5~6.5, 20~30 ppm available chlorine concentration) was generated by electrolysis of dilute solution of HCl (4%) in a chamber of a non-membrane electrolytic cell. Our objective was to determine SAHW has a potential fungicidal activity on some phytopathogenic fungi. Spores of Botrytis cinerea, Colletotrichum acutatum and Phytophthora capsici were not culturable on agar media at approximately 10 seconds after treatment by SAHW. However, inactivation of Penicillium hirsutum was required over 3 min. Dilution of SAHW with sterilized distilled water (SDW) at the ratio of 1:1 (SAHW:SDW) against C. acutatum showed 100% inactivation but, the efficacy in 1:2 decreased until 63.2%. Control value of SAHW was 70.4% against C. acutatum on pepper fruits when applied upto 24 h postinoculation. SAHW has a powerful and wide spectrum antifungal activity and could be applied as a potential alternative to fungicidal agent for control of plant disease.

• Particle and aerosol research
• /
• v.13 no.3
• /
• pp.105-110
• /
• 2017

Real-time measurements of fine particles from stack emission gases are necessary due to the needs of continuous environmental monitoring of PM10 and PM2.5. The porous tube dilutor using hot and cold dilutions was developed to measure fine particles without condensable particles from highly humid emission gases and compared to the commercialized ejector-type dilutor. Particle size distributions were measured at the emission gases from a diesel engine and a coal-fired boiler. The porous tube dilutor could successfully measure the accumulation mode particles including relatively large particles more than $3{\mu}m$ without nuclei particles, while the ejector dilutor detected some condensable particles and could not detect large particles. The porous tube dilutor could successfully remove the already condensed water droplet particles generated by a humidifier in a $30m^3$ chamber.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.22 no.7
• /
• pp.884-891
• /
• 2016

A secondary injection system in a diesel engine has benefits: it can be controlled independently without interrupting engine control, it can be adapted to various layouts for exhaust systems, and it pose no reductant dilution problems compared to post injection systems in the combustion chamber or other supplemental reductant injections. In a secondary injection system, the efficiency of the catalyst depends on the method of reducing the supply. The reductant needs to be maintained and optimized with constant pressure, the positions and angles of injector is a very important factor. The concentration and amount of reductant can be changed by adjusting secondary injection conditions. However, secondary injection is highly dependent upon the type of injector, injection pressure, atomization, spray technology, etc. Therefore, it is necessary to establish injection conditions the spray characteristics must be well-understood, such as spray penetration, sauter mean diameter, spray angle, injection quantity, etc. Uniform distribution of the reductant corresponding to the maximum NOx reduction in the DeNOx catalyst system must also assured. With this goal in mind, the spray characteristics and impingement plate types of a secondary injector were analyzed using visualization and digital image processing techniques.

• Journal of Korean Neurosurgical Society
• /
• v.29 no.4
• /
• pp.477-484
• /
• 2000

Objective : Despite advances in the understanding of tumor biology and the tumor immunology, there has been no effective treatment. The Intercellular adhesion molecule-1(ICAM-1) has been shown to be important in interaction involving cells of the immune system and to be upregulated in a number of cell culture systems by cytokines, including immune interferon($IFN-{\gamma}$) and tumor necrosis $factor-{\alpha}$($TNF-{\alpha}$). ICAM-1 has been identified as one of the ligands for lymphocyte function-associated antigen-1(LFA-1). The effectiveness of various cytokines to ICAM-1 induction on cultured human glioblastoma cell lines and potential efficacy of immunotherapy were studied. Method : Human glioblastoma cell lines, U-251 MG, U-373 MG were trypsinized and suspended at $1{\times}10^5cells/ml$ and grown on 8 well chamber slide, the cells were incubated in 0.3ml medium alone or medium containing $IFN-{\gamma}$(1000U/ml) or $TNF-{\alpha}$(250U/ml) or $IFN-{\gamma}$ plus $TNF-{\alpha}$ for 6, 12, 24, 48 and 72 hours. The coverslip were then removed and stained with a 1/30 dilution of anti-ICAM-1 antibody. Result : Surface antigen expression of ICAM-1 was increased by incubating glioblastoma cell lines with $IFN-{\gamma}$ and $TNF-{\alpha}$. Combined effect of $IFN-{\gamma}$ and $TNF-{\alpha}$ has induced more ICAM-1 expression on glioblastoma cell lines. Upregulation of ICAM-1 expression in an established glioblastoma cell line was of greater magnitude and more rapid following incubation with $IFN-{\gamma}$ plus $TNF-{\alpha}$. Surface antigen expression of ICAM-1 was increased for up to 48 hours after cytokine treatment on both cell lines(p<0.05). There was no difference on both cell lines(p>0.05). Conclusion : The results of the present study indicate that ICAM-1 expression in glioblastoma cell lines, U-251 MG and U-373 MG, are induced and enhanced after treatment with $IFN-{\gamma}$ and $TNF-{\alpha}$. Combined effect of $IFN-{\alpha}$ and $TNF-{\gamma}$ is stronger and more rapid than $IFN-{\gamma}$ or $TNF-{\alpha}$ alone.

• Land and Housing Review
• /
• v.14 no.4
• /
• pp.111-120
• /
• 2023

Indoor air quality has become increasingly important with the increase in time spent in residential environments, impact of external fine dust, yellow dust, and the post-COVID 19 pandemic. Residential mechanical ventilation plays a key role in addressing indoor air quality. The legal standard for residential air changes per hour in Korea is 0.5 ACH. However, there are no standards for the location of supply and return vents. This study atempts to analyze the impact of ventilation performance based on the location of supply and return vents. An experiment was conducted using the CO₂ tracer gas concentration decay method in a mock-up house set inside a large chamber to minimize external influences. The experimental results indicated that the commonly used combination of 2 supply and 2 return vents in living room spaces had a lower mean age of air than the combination of 1 supply and 2 return vents. Using multiple supply and return vents had lower mean age of air than using just 1 supply and 1 return vent.

• Korean Journal of Microbiology
• /
• v.42 no.3
• /
• pp.185-194
• /
• 2006

The aim of this study was to identify the bacteria isolated from endodontic lesions by cell culture and to determine the antimicrobial susceptibility of them against 8 antibiotics. The necrotic pulpal tissues were collected from 27 infected root canals, which were diagnosed as endodontic infection. Samples were collected aseptically from the infected pulpal tissue of the infected root canals using a barbed broach and a paper point. The cut barbed broaches and paper points were transferred to an eppendorf tube containing $500{\mu}l\;of\;1{\times}PBS$. The sample solution was briefly mixed and plated onto a BHI-agar plate containing 5% sheep blood. The agar plates were incubated in a $37^{\circ}C$ anaerobic chamber for 2 to 5 days. The bacteria grown on the agar plates were identified by comparison of 16S rRNA gene (rDNA) sequencing method at the species level. To test the sensitivity of the bacteria isolated from the infected root canals against 8 antibiotics, minimum inhibitory concentrations (MIC) were determined using broth dilution assay. The data showed that 101 bacterial strains were isolated and were identified. Streptococcus spp. (29.7%) and Actinomyces spp. (21.8%) were predominantly isolated. The 9 strains were excluded in antimicrobial susceptibility test because they were lost during the experiment or were not grown in broth culture. The percentage of bacteria susceptible for each antibiotic in this study was clindamycin, 87.0% (80 of 92); tetracycline, 75.0% (69 of 92); cefuroxime axetil, 75.0% (69 of 92); amoxicillin + clavulanic acid (5:1), 71.7% (66 of 92); penicillin G, 66.3% (61 of 92); erythromycin, 66.3% (61 of 92); amoxicillin, 44.6% (41 of 92); and ciprofloxacin, 31.5% (29 of 92). The susceptibility pattern of 8 antibiotics was dependent on the host of the bacteria strains rather than the kinds of bacterial species. These results indicate that antibiotic susceptibility test should be performed when antibiotics are needed for the treatment of infected root canals.