• 전기학회논문지
• /
• 제64권3호
• /
• pp.473-479
• /
• 2015

Thermal relays are sometimes used instead of long time overcurrent relays for motor protection. But, it is difficult for any relay design engineer to adequately approximate motor heating curves which represent the average of a difficult-to-define thermal zone. Thermal relays frequently may not provide sufficient protection on heavy overloads. Digital multifunction relays are microprocessor-based devices. These relays offer highly reliable and advanced protection of motors. If a situation can be mathematically described, the microprocessor in a digital relay can be programmed to tackle that problem. Today's motor protection is accomplished with digital protective relays. Digital relays offer additional, highly important features to complement protection. The best way to prevent short in motor is to not overheat and degrade the insulation.

• 전기학회논문지
• /
• 제56권2호
• /
• pp.240-247
• /
• 2007

This paper presents an implementation of the generator protective relay using Real Time Digital Simulator (RTDS) user defined component (UDC) model designed to facilitate the investigation and evaluation of protective relays. The UDC for RTDS is a convenient model that allows user to develop new component models and run them on the RTDS. The developed model has major features related to the development of six models such as distance, frequency, reverse power, volts per Hz, over voltage, and out-of-step relays. Also, the generator relay models have been used to support and enhance power engineering education at both the undergraduate and graduate levels. The developed model functions are verified and tested by both static test and dynamic test. The simulation results show the capabilities of the developed generator relay using RTDS UDC.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 A
• /
• pp.444-446
• /
• 1994

This paper describes the design of a digital multifunction controller for the intelligent high voltage customer switchboard and proposes a relaying algorithm for high impedance faults using back-propagation neural network. The hardware design uses the three microprocessors and global memory architecture to achive real time operation and control 4 feeders. The controller uses a 64-point radix-4 DIF FFT algorithm to measure the harmonic and relay parameters. Synthesized fault current waveforms are used to train and test the back - propagation network.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1993년도 하계학술대회 논문집 B
• /
• pp.803-805
• /
• 1993

This paper describes the development of a digital multifunction controller for the protection, measurement and control of the high voltage customer switchboard. The magnitude of the fundamental component is estimated using a simple filter based on cross-correlation with a heptagonal wave. The characteristics of flexible relay functions such as adjustable pickup and time-dial settings, various time-magnitude curve and directional capability including measurement functions are presented. The controller implementation is carried out on two microprocessors for real time operation.