• 공업화학
• /
• 제9권5호
• /
• pp.619-623
• /
• 1998

불화된 금속 산화물 촉매상에서 이염화메탄을 불화하여 이불화메탄을 합성하는 연구를 하였다. 실험 변수는 반응온도, HF/DCM (dichloromethane) 몰비, 접촉시간 그리고 촉매의 형태이었다. 촉매의 성능은 불화된 알루미나 보다는 크롬이 담지된 불화된 알루미나가 우수하였으며 크롬을 담지한 촉매에서 전처리 하지 않은 경우가 수소와 공기 분위기로 소성처리한 경우보다 더욱 우수하였다. 최적 반응 조건은 반응온도 $340^{\circ}C$, HF/DCM 몰비 5이상 그리고 접촉시간 20 초 이상이었다. 이들 조건에서 얻은 이불화메탄의 최대 수율은 80% 이상이었다. 특히 반응시간이 8시간까지 촉매의 활성 감소나 이불화메탄의 선택성의 감소가 나타나지 않았다.

• Bulletin of the Korean Chemical Society
• /
• 제8권1호
• /
• pp.10-15
• /
• 1987

The results of an ab initio (6-31G) molecular orbital calculation of the dipole moment derivatives and gas phase IR intensities of difluoromethane are reported. The results are compared with corresponding values obtained from a CNDO calculation. The directions of the dipole derivatives calculated by the two methods agree very well, whereas the intensities differ significantly. The results are also analyzed for the charge-charge flux-overlap electronic contributions to the dipole derivatives.

• 설비공학논문집
• /
• 제5권2호
• /
• pp.141-155
• /
• 1993

Thermodynamic properties of R-32 are calculated and its refrigeration performance is evaluated for the purpose the feasibility study of replacing R-22 with R-32. (1) Refrigeration effect of R-32 is superior to that of R-22 because heat of evaporation of R 32 is about 50% higher than that of R-22. However, COP of R-32 system is 10-30% lower than that of R-22 system. It is mainly attributed to the vapor pressore of R-32 being about 62% higher than R-22. (2) Since the pressure ratio and the specific heat ratio of R-32 system is higher than those of R -22, compressor discharging temperature rises as high as to $130-150^{\circ}C$. It may cause mechanical failure of compressor due to the breakdown of lubricant. Compressor should be improved to lower the temperature if R-32 is to replace R-22. (3) Averaged two-phase heat transfer coefficient of R-32 is about 10-20% higher than that of R-22. It may assume better heat exchanger effectiveness but not guarantee the better COP of R-32 system than R-22. (4) The high vapor pressure is the first reason to drop R-32 out of the line of R-22 alternative refrigerant. So, refrigerant mixtures based on R-32 are recommended to adjust the vapor pressure first and keep superior volumetric capacity of R-32.

• 마이크로전자및패키징학회지
• /
• 제8권2호
• /
• pp.31-36
• /
• 2001

Plasma Polymerization를 이용하여 Teflon-like 불화 유기 박막을 Si, $SiO_2$, Al, TEOS 위에 증착하였다. Difluoromethane $(CH_2F_2$)에 Ar, $O_2$, 그리고 $CH_4$를 첨가하여 첨가 가스에 따른 불화 유기 박막의 특성을 평가하였다. 각각의 첨가가스에 대하여 압력, 온도, 그리고 첨가가스의 비율을 변화시켜 박막을 증착하여 정접촉각 통한 표면의 친수성 (hydrophilicity)과 소수성(hydrophobicity) 정도를 관찰하였다. Ar을 첨가한 경우 Ar 첨가량과 power의 증가에 따라 정접촉각의 감소를 관찰하였다. 그러나 증착압력이 증가함에 따라 정접촉각이 증가하였다. Ar 첨가시 2 Torr이상의 증착압력에서 분말형태의 초소수성 불화 유기박막을 얻을 수 있었다. $O_2$를 첨가한 경우, $O_2$의 첨가량과 증착압력이 증가함에 따라 정접촉각은 감소하였다. 약 100W까지의 power에서는 정접촉각은 일정하였지만 power의 증가에 따라 정접촉각은 감소하여 200W에서는 천수성표면을 얻을 수 있었다. $CH_4$를 첨가하여 불화유기박막을 증착하였을 경우 $CH_4/CH_2F_2$비율이 5까지 급격한 증가를 나타내었고, 비율이 5이상인 경우에서는 일정한 정접촉각을 나타내었다. 화학기상증착에 의해 제조된 박막보다 plasma polymerization으로 제작된 불화유기박막이 히스테리시스(hysteresis)가 낮은 불화유기박막을 형성하였다.

• 한국지하수토양환경학회지:지하수토양환경
• /
• 제16권5호
• /
• pp.42-52
• /
• 2011

In this laboratory study, the changes in gas-exposed perchloroethene (PCE) saturation in sand during a PCE removal process were measured using gaseous tracers. The flux of fresh air through a glass column packed with PCEcontaminated, partially water-saturated sand drove the removal of PCE from the column. During the removal of PCE, methane, n-pentane, difluoromethane and chloroform were used as the non-reactive, PCE-partitioning, water-partitioning, and PCE and water-partitioning tracers, respectively. N-pentane was used to detect the PCE fraction exposed to the mobile gas. At water saturation of 0.11, only 65% of the PCE was found to be exposed to the mobile gas prior to the removal of PCE, as calculated from the n-pentane retardation factor. More PCE than that detected by n-pentane was depleted from the column due to volatilization through the aqueous phase. However, the ratio of gas-exposed to total PCE decreased on the removal of PCE, implying gas-exposed PCE was preferentially removed by vaporization. These results suggest that the water-insoluble, PCE-partitioning tracer (n-pentane in this study), along with other tracers, can be used to investigate the changes in fluid (including nonaqueous phase liquid) saturation and the removal mechanism during the remediation process.