• Environmental Engineering Research
• /
• v.13 no.4
• /
• pp.171-176
• /
• 2008

Studies on visible-light-driven photocatalysis of air pollutants at indoor air quality (IAQ) levels have been limited. Current study investigated visible-light derived photocatalysis with N-doped and S-doped titanium dioxide ($TiO_2$) for the control of benzene at indoor levels. Two preparation processes were employed for each of the two types of photocatalyst: urea-Degussa P-25 $TiO_2$ and titania-colloid methods for the N-doped $TiO_2$; and titanium isopropoxid- and tetraisopropoxide-thiourea methods for the S-doped $TiO_2$. Furthermore, two coating methods (EDTA- and acetylacetone-dissolving methods) were tested for both the N-doped and S-doped $TiO_2$. The two coating methods exhibited different photocatalytic degradation efficiency for the N-doped photocatalysts, whereas they did not exhibit any difference for the S-doped photocatalysts. In addition, the two doping processes showed different photocatalytic degradation efficiency for both the S-doped and N-doped photocatalysts. For both the N-doped and S-doped $TiO_2$, the photocatalytic oxidation (PCO) efficiency increased as the hydraulic diameter (HD) decreased. The degradation efficiency determined via a PCO system with visible-light induced $TiO_2$ was lower than that with UV-light induced unmodified $TiO_2$, which was obtained from previous studies. Nevertheless, it is noteworthy that for the photocatalytic annular reactor with the HD of 0.5 cm, PCO efficiency increased up to 52% for the N-doped $TiO_2$ and 60% for the S-doped $TiO_2$. Consequently, when combined with the advantage of visible light use over UV light use, it is suggested that with appropriate HD conditions, the visible-light-assisted photocatalytic systems can also become an important tool for improving IAQ.

• Asian-Australasian Journal of Animal Sciences
• /
• v.18 no.7
• /
• pp.1003-1010
• /
• 2005

A study consisting of 3 trials was designed to assess the relative biological efficacy of DL-methionine (DL-Met) in comparison to liquid methionine hydroxy analogue (MHA-FA) in growing pigs. In trial I a basal diet was supplemented with three graded levels of DL-methionine (0.25, 0.50 and 0.75 g/kg) or liquid MHA-FA (0.0285, 0.0570 and 0.0855 g/kg) on equimolar basis. The basal diet contained 18.3% CP, 0.22% Met and 0.51% Met+Cys, which is below the methionine requirement for weaned pigs between 10 and 20 kg BW according to NRC (1998) but adequate in all other essential nutrients and energy. Using an exponential model, the efficacy of the two methionine sources was estimated from nitrogen retention data obtained in 42 piglets with an initial BW between 11.0 kg (Exp. 1) and 11.7 kg (Exp. 2). In trials II and III, with a total of 192 and 96 pigs, and with an initial BW of 10.6 and 21 kg, respectively, growth response criteria were assessed to determine if in agreement with previous studies in pigs and poultry a biological effectiveness of about 65% on average could be confirmed for liquid MHA-FA in comparison to DL-met. Based on N-retention (trial I) the biological efficacy of liquid MHA-FA on a weight-to-weight basis was calculated to be 62% relative to DL-met. Basically, these results were confirmed using growth response criteria as measures; the results of trial II and III revealed no significant differences in growth performance and feed conversion between treatments indicating that 100 parts of liquid MHA-FA can be replaced by 65 parts of DL-met.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.264-264
• /
• 2012

As an environment-friendly alternative energy resource, ethanol may be used to obtain hydrogen, a clean energy source. Thus, studies on catalytic reactions involving ethanol have been studied to understand the underlying principles in the reaction mechanism using various oxide-supported catalysts. Among them, Au-based catalysts have shown a superior activity in producing hydrogen gas. In the present study, Au/$TiO_2$ catalysts were prepared by deposition-precipitation method to understand their catalytic activities toward ethanol and acetaldehyde with increasing gold loading, especially at the very low Au loading regime. A commercially available $TiO_2$ (Degussa P-25) was employed and the Au loading was varied to 0, 0.1, 0.5, and 1.0 wt% respectively. The catalysts showed characteristic x-ray diffraction (XRD) features at $2{\theta}=78.5^{\circ}$ that could be assigned to the presence of gold nanoparticles. Its reactivity measurements were performed under a constant flow of ethanol and acetaldehyde at a flow rate of ${\sim}0.6{\mu}mol/sec$ and the substrate temperature was slowly raised at a rate of 0.2 K/sec. We observed that the overall reactivity of the catalysts increased with increasing Au loading along with selectivity favoring dehydrogenation to product hydrogen gas. In addition, we disclosed various reaction channels involving competitive reaction paths such as dehydrogenation, dehydration, and condensation. In addition, subsequent reactions of acetaldehyde obtained from dehydrogenation of ethanol, were found to occur and produce butene, crotonaldehyde, furan, and benzene. Based on the results, we proposed overall reaction pathways of such reaction channels.

• Journal of the Mineralogical Society of Korea
• /
• v.28 no.3
• /
• pp.245-253
• /
• 2015

The performance of $TiO_2$ photo-catalytic oxidation process is significantly dependent on the amount of hydroxyl radicals produced during the process, and it is an essential prerequisite to quantify its production. However, precise and accurate methods for quantification of hydroxyl radicals have not been developed so far. For this reason, this study was initiated to compare existing methods for analysis of hydroxyl radicals produced by $TiO_2$ photo-catalytic oxidation and to propose a new method to overcome the limitation of established methods. To simulate $TiO_2$ photo-catalytic oxidation process, Degussa P25 which has been widely used as a standard $TiO_2$ photo-catalyst was used with the dose of 0.05 g/L. The light source of process was UVC mercury low-pressure lamp (11 W, $2,975mW/cm^2$). The results indicate that both potassium iodide (KI)/UV-vis spectrometer and terephthalic acid (TPA)/fluorescence spectrometer methods could be applied to qualitatively measure hydroxyl radicals via detection of triiodide ion ($I_3{^-}$) and 2-hydroxyterephthalic acid which are produced by reactions of iodine ion ($I^-$) and TPA with hydroxyl radicals, respectively. However, it was possible to quantitatively measure hydroxyl radicals using TPA method coupled with high-performance liquid chromatograph (HPLC). The analytical results using TPA/HPLC method show that hydroxyl radical of 0.013 M was produced after 8 hours operation of photo-catalytic oxidation under specific experimental conditions of this study. The proposed method is expected to contribute to precise the evaluation of the performance of photo-catalytic oxidation process.

• Clean Technology
• /
• v.11 no.3
• /
• pp.123-128
• /
• 2005

Among various metal oxides semiconductors, $TiO_2$ is the most studied semiconductor for environmental clean-up applications due to its unique ability in photocatalyzing various organic contaminants, its chemical inertness, and nontoxicity. $TiO_2$, however, has a few drawbacks to be solved such as reactivity mainly working under ultraviolet irradiation (${\lambda}$ < 387 nm) and electron - hole recombination on $TiO_2$. In this study, to extend the absorption range of $TiO_2$ into the visible range and enhance electron - hole separation, we synthesized platinum (Pt) deposited $C-TiO_2$. The presence of Pt as an electron sink has been known to snhance the separation of photogenerated electron-hole pairs and induce the thermal decomposition. The characterization of as-synthesized $Pt-C-TiO_2$ was performed by Transmission Electron Microscopic (TEM), the Brunuer-Emmett-Teller (BET) method, X-ray Diffractometer (XRD), UV-vis spectrometer (UV-DRS), and X-ray Photoelectron Spectroscopy (XPS). In order to estimate the photocatalytic activity of the synthesized materials, the photoelectron Spectroscopy (XPS). In order to estimate the photocatalytic activity of the synthesized materials, the photodegradation experiment of an azo dye (Acid Red 44; $C_{10}H_7N=NC_{10}H_3(SO_3Na)_2OH$)was carried out by using an Xe arc lamp (300 W, Oriel). A 420 nm cut-off filter was used for visible light irradiation. From the results, Pt-deposited $C-TiO_2$ showed a far superior phothdegradation activity to Degussa P25, the commercial product under the irradiation of visible light and enhanced photocatalytic activity of visible-working $C-TiO_2$. This is a useful result into the application for the purification system of dye wastewater using visible energy of sun light.