• Journal of the Korean Society of Propulsion Engineers
• /
• v.17 no.6
• /
• pp.30-37
• /
• 2013

A ground hot-firing test was conducted to take out the optimal design configurations for the catalyst bed of liquid-monopropellant hydrazine thruster which could be used for primary engine or attitude control thruster of space vehicles. Performance characteristics with the variation of thrust-chamber length are investigated in terms of thrust, specific impulse, chamber pressure, characteristic velocity, and hydrazine decomposition rate. Additionally, the correlations between propellant-supply pressure and performance parameters are given. As results, increase of catalyst-bed length leads to performance degradation in this test condition, and also decreases propellant consumption efficiency with the supply pressure variation.

• Earthquakes and Structures
• /
• v.8 no.3
• /
• pp.761-778
• /
• 2015

The objective of this paper is to report the result of an experimental program conducted on the strengthening of nonductile RC frames by using external mesh reinforcement and plaster application. The main objective was to test an alternative strengthening technique for reinforced concrete buildings, which could be applied with minimum disturbance to the occupants. Generic specimen is two floors and one bay RC frame in 1/2 scales. The basic aim of tested strengthening techniques is to upgrade strength, ductility and stiffness of the member and/or the structural system. Six specimens, two of which were reference specimens and the remaining four of which had deficient steel detailing and poor concrete quality were strengthened and tested in an experimental program under cyclic loading. The parameters of the experimental study are mesh reinforcement ratio and plaster thickness of the infilled wall. The effects of the mesh reinforced plaster application for strengthening on behavior, strength, stiffness, failure mode and ductility of the specimens were investigated. Premature and unexpected failure mode has been observed at first and second specimens failed due to inadequate plaster thickness. Also third strengthened specimen failed due to inadequate lap splice of the external mesh reinforcement. The last modified specimen behaved satisfactorily with higher ultimate load carrying capacity. Externally reinforced infill wall composites improve seismic behavior by increasing lateral strength, lateral stiffness, and energy dissipation capacity of reinforced concrete buildings, and limit both structural and nonstructural damages caused by earthquakes.

• Journal of the Korea Society for Simulation
• /
• v.20 no.4
• /
• pp.91-96
• /
• 2011

As the user's demand for ultra high-speed wireless internet has increased, the standardization, research and development of future mobile communication systems have been done for several years. IMT-Advanced system which is called fourth generation mobile communication should support the data rate of 1 Gbps for nomadic users and 100 Mbps for mobile users. Also, the system should hold call connection at the mobile speed of 350 km/h. Meanwhile, since Doppler spread is linearly proportional to mobile speed, high mobility leads to the increase of interference between subcarriers and the deterioration of detection performance consequently. In this paper, we evaluate and analyze detection probability with respect to equalization methods in time-varying channels under system parameters complying with IMT-Advanced requirements. According to computer simulation conducted by varying mobile speed and code rate, MMSE based equalization can mitigate performance degradation of IMT-Advanced system considerably in time-varying channels.

• Journal of the Korean Magnetics Society
• /
• v.8 no.5
• /
• pp.249-254
• /
• 1998

In relation to the application of magnetic method to the evaluation of irradiation damage (embrittlement) changes in the magnetic parameters(hysteresis loop and Barkhausen noise) and Vickers microhardness due to neutron irradiation and heat treatment were measured and compared. In the case of irradiation $(2.3{\times}10^{19}\;n/cm^2,\; E{\ge}1\;Mev,\; 288{\circ}C)$ hysteresis loop measurements show that susceptibility decreases as coercivity increase. Saturation magnetization do not show any change. Barkhausen noise amplitude and Barkhausen noise energy have decreased while Vickers microhardness has increased. For isothermally heat treated condition of irradiated specimen at 470 $^{\circ}C$ and 540 $^{\circ}C$, Barkhausen noise energy has increased while Vickers microhardness has decreased. Results of BNE and Vickers microhardness are reversed to the results on irradiated condition. All these consistent changes in magnetic parameter and Vickers microhardness measurement, which are thought to be resulted from the interaction between irradiation-induced defects and dislocation, and magnetic domain, respectively, show a possibility that magnetic measurement may be used to the evaluation of material degradation and recovery due to neutron irradiation and heat treatment, respectively, if a relevant large database in prepared.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.30 no.5
• /
• pp.781-793
• /
• 2020

In this paper, we propose a new RLWE-based scheme named μ-Hope that exploits Error Correcting Code(ECC) on NewHope. The previous parameters of NewHope uses 12289 as a prime modulus, and the size of the public key, private key, and ciphertext is 928-byte, 1888-byte, and 1120-byte respectively, which can be said to be larger than other RLWE based algorithms. In this paper, we propose μ-Hope, which changes modulus 12289 to 769 to reduce the size of the public key, private key, and ciphertext. Also, we adopts XE1 as an Error Correcting Code(ECC) to solve the increased decryption failure rate caused by using a small prime modulus. As a result, the size of the public key, private key, and ciphertext decreased by 38%, 37%, and 37% respectively. As the computational efficiency caused by using a small prime modulus exceeds the performance degradation by exploiting ECC, this result in 25% performance improvement for a single key exchange.

• Environmental Engineering Research
• /
• v.23 no.3
• /
• pp.288-293
• /
• 2018

The main objective of this study is to investigate the influence of hydraulic retention time (HRT) on biogas production during leachate treatment using an anaerobic reactor type Upflow Anaerobic Sludge Blanket. For this purpose, four HRTs ranging from 12 to 48 h were experienced. The obtained results showed that higher amount of biogas could be produced during longer HRTs. However, HRTs longer than 48 h could not affect clearly the biogas generation and considered as unnecessary given the small additional amount of biogas produced during the degradation process. A volume of $0.434L/L_{leachate}/d$ was achieved during the treatment with a HRT of 48 h. The higher biogas production, the smaller chemical oxygen demand (COD) values achieved. Besides, COD removal and biogas production positively correlate, showing that the active biomass has degraded effectively the organic load to produce biogas. Moreover, all the analyzed physicochemical parameters have experienced a decrease after 48 h except for the pH, which increased to approximately neutral value. More precisely, a decrease of 93.8%, 89.7%, 95%, 70%, 77%, and 84.4% was recorded for COD, electrical conductivity, total suspended solid, turbidity, $NH_4{^+}-N$, and $NO_3{^-}-N$, respectively.

• Journal of Animal Science and Technology
• /
• v.52 no.6
• /
• pp.513-519
• /
• 2010

A series of experiments were performed to study the influence of the following parameters on the physical traits and composition of swine manure compost: (1) addition of magnesium (Mg) at a molar ratio of 1.2 with respect to $PO_4$, and (2) reutilization of compost containing $MgNH_4PO_4{\cdot}6H_2O$ (magnesium ammonium phosphate, MAP). Three independent batch tests were conducted for replication: batch test I-control (C) and Mg added (T), batch test II-C, T and compost recycle ($T_{R1}$), and batch test III-C, T and compost recycle ($T_{R2}$). Magnesium addition and compost reutilization had no adverse effect on the degradation of organic matter. Reuse of the compost, however, had a clear effect on the total nitrogen (TN) and total phosphorus (TP) contents in the final compost. Repeated compost reutilization as a bulking material was resulted in composts rich in N and P. Upon adding the Mg supplement to the composting materials, the ortho-phosphate (OP) to TP ratio decreased due to the MAP crystallization reaction. The decrease in the OP/TP ratio and the increase in the TP content of the compost indicate that water-soluble phosphate is converted into a slow-release phosphate by the formation of crystals during composting. X-ray diffraction analysis of the irregular shaped crystals in the compost indicated that they are MAP crystals and that the crystallization of MAP begins immediately after the addition of the Mg supplement. The Mg addition to composting materials and the reutilization of compost as a bulking material would be a practical means to conserve nutrient content.

• Journal of Broadcast Engineering
• /
• v.9 no.4 s.25
• /
• pp.357-370
• /
• 2004

In this paper we propose Digital Signal Processing (DSP) techniques for the Equalization Digital On-Channel Repeater(EDOCR) in the ATSC digital TV (DTV) System. DSP techniques consist of demodulation. baseband equalization, and remodulation. Since the time delay caused by signal processing in the EDOCR can seriously affect the performance of ATSC legacy receivers, it is required that the processing time should be minimized as much as possible. To achieve this goal, we focus on the reduction of the EDOCR's time delay with the minimization of its performance degradation. In addition, we present recommended proper parameters for hardware implementation based on extensive simulation result.

• The Korean Journal of Physiology and Pharmacology
• /
• v.24 no.6
• /
• pp.453-462
• /
• 2020

Chronic joint pain due to loss of cartilage function, degradation of subchondral bone, and related conditions are common plights of an arthritis patient. Antioxidant compounds could solve the problems in arthritic condition. The objective of this study was to evaluate the anti-arthritic activity of D-carvone against complete Freund's adjuvant (CFA)-induced arthritis in rats. D-carvone was orally administered for 25 days at the doses of 30 and 60 mg/kg against CFA-induced arthritic rats. Changes in body weight, paw swelling, organ index, hematological parameters, oxidative stress markers, inflammatory cytokines, and histopathology were recorded. Oral treatment of D-carvone significantly improved the body weight, reduced the paw swelling, edema formation, and organ index in arthritic rats. The levels of white blood cells were reduced, red blood cells and hemoglobin levels were improved in D-carvone treated arthritic rats. Lipid peroxidation levels were lowered whereas enzymatic and non-enzymatic antioxidants were significantly elevated by D-carvone administration against arthritic rats. D-carvone significantly modulated inflammatory cytokine levels and improved the ankle joint pathology against CFA-induced arthritic inflammation. In conclusion, D-carvone proved significant anti-arthritic activity against CFA-induced arthritis in rats.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.12
• /
• pp.2812-2817
• /
• 2013

In this paper, an outage probability for the best relay selection in decode-and-forward relaying systems in the presence of interference is analyzed over Rayleigh fading channels. Based on the outage performance results, we propose a method to determine effective relay candidates for the best relay selection, where the effective relay candidates represent the relays except for relays that make no contribution to improving the performance. in all possible relays given in the system. By determining the effective relay candidates, the feedback overhead of channel state information and the energy consumption of relays can be significantly reduced while minimizing the performance degradation. In this paper, we provide important parameters that affect the determination of the effective relay candidates.