• Membrane Journal
• /
• v.13 no.4
• /
• pp.283-290
• /
• 2003

To improve membrane performance, the dead-end and Cross-flow ultrafiltration with or without ultrasound irradiation onto the membrane module were carried out using a BSA protein solution. Intermittent or continuous irradiation of ultrasound effectively suppressed the formation of fouling on membrane or removed the fouling layers from membrane. Effect of ultrasound irradiation on the enhancement of ultrafiltration performance was more increased at the operating conditions which form more membrane fouling (at the operating conditions of higher feed concentration and TMP, and lower flow rate). The permeate flukes were enhanced up to 1.9 times in case of the dead-end ultrafiltration and 1.5 times in case of the cross-flow ultrafiltration by ultrasound irradiation onto the membrane module.

• Membrane Journal
• /
• v.26 no.4
• /
• pp.266-272
• /
• 2016

The separation and purification of lysozyme enzyme from chicken egg white (CEW) solution was studied using the dead-end filtration. The optimum operation conditions of the dead-end filtration reveal that the maximum value of permselectivity of lysozyme to the other proteins of ovalbumin and conalbumin in the CEW solution was tested with change of molecular weight cut-off (MWCO) of ultrafitration membrane and pH of the CEW solution. The optimum operation conditions for the efficient permeable separation of lysozyme from the CEW solution are that the membrane MWCO is 30 kD and the pH of CEW solution is 11. At this optimum operation conditions, the maximum value of permselectivity of lysozyme to total proteins in CEW solution is about 83.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.9
• /
• pp.57-63
• /
• 2007

The occurrence of a corona is that electrical discharge due to the heterogeneity that occurs when an electrical field is concentrated in an electrode due to a cusp formed on said electrode. Wire treatment at the end of a 154[kV] dead end clamp for end users accelerates the occurrence of corona, which in turn leads to power loss and noise. In this study, the characteristics of the corona which occurs between porcelain insulators and support clamps of overhead lines used in 154[kV] power receiving facilities for end users were investigated. The corona, which cannot be identified by one common method, was measured utilizing a UV image camera. A risk assessment for fire damage and its status was suggested. The stress distribution of the electrical field by length of bare wire was suggested by means of the finite element method(FEMLAB). As a result, it was found to affect a porcelain insulators. These results can be utilized for the enhancement of clamp installation and safety in power facilities.

• Journal of the Korean Society of Radiology
• /
• v.12 no.7
• /
• pp.801-806
• /
• 2018

Germanium crystals have a dead layer that causes efficiency deterioration because the layer is not useful for detection but strongly weakens the photons. Thus, when the data provided by the manufacturer is used in the detector simulation model, there is a slight difference between the calculated efficiency and the measured efficiency.The shape and dimensions of the high purity germanium (HPGe) detector were determined by CT scans to accurately characterize the shape for the Monte Carlo roll simulation. It is found that the adjustment of the dead layer is a good match with the relative deviation of ${\pm}3%$ between the measurement efficiency and the simulation efficiency at the energy range of 50 - 1500 keV. Simulation data were compared by varying the thickness of the dead layer. The new Monte Carlo simulations were compared with the experimental results to obtain new blank layer thicknesses. The difference in dead layer results for the 1.5 mm thick end cap simulation model in 1.4 and 1.6 mm thick End Cap simulation models was a systematic error due to the accuracy of the end cap dimensions. After considering all errors including statistical errors and systematic errors, the thickness of the detector was calculated as $1.02{\pm}0.14mm$. Therefore, it was confirmed that the increase in the thickness of the dead layer causes the effect to be effected on the efficiency reduction.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1998.10a
• /
• pp.133-136
• /
• 1998

0.1 내지 $4 \mum$의 입도분포를 가진 kaolin용액을 dead-end형 여과 장치(Amicon Cell, 8050)를 이용하여 공칭세공이 $0.2 \mum$인 PTFE막으로 농도 및 운전압력에 따른 투과실험을 하였다. Kaolin 용액의 투과유속은 케이크 저항이 지배적이었으며 초기에는 분리막 표면에 케이크가 형성되고 그 후에 분리막 세공의 오염이 발생하는 것으로 관찰되었다.

• Transactions of the Korean hydrogen and new energy society
• /
• v.26 no.2
• /
• pp.136-147
• /
• 2015

Dead-ended operation of Proton Exchange Membrane Fuel Cell(PEMFC) provides the simplification of fuel cell systems to reduce fuel consumption and weight of fuel cell. However, the water accumulation within the channel prohibits a uniform supply of fuel. Optimization of the purge strategy is required to increase the fuel cell efficiency since fuel and water are removed during the purge process. In this study, we investigated the average voltage output which depends on two interrelated conditions, namely, the supply gas pressure, purging valve open time. In addition, flow visualization was performed to better understand the water build-up on the anode side and cathode side of PEMFC in terms of a variety of the current density. We analyzed the correlation between the purge condition and water flooding.

• Membrane Journal
• /
• v.8 no.4
• /
• pp.203-209
• /
• 1998

The cutting oil emulsion microfiltration was carried out on dead-end call and crossflow systems equipped with 0.22 $\mu$m GVHP Millipore and 0.2 m stainless steel Mott microfiltration membranes, respectivdy. The oil drop size in the emulsion was varied from 0.07 to 0.22 $\mu$m. Cake filtration(CFM) and standard pore blocking models(SPBM) were applied to predict the permeation flux. The permeation fluxes of 0.01 vol% oil emulsion followed CFM for dead-end system very well under the condition of 400 rpm and below 100 kPa. The SPBM was, however, suitable for the permeation flux at 400 rpm and above 150 kPa. The oil layer on the membrane surface was destroyed and reproduced repeatedly as operating pressure was suddenly changed from 60 to 200 kPa, and then returned to 60 kPa. Also, we estimated the critical entry pressure(CEP) which is changed from CFM to SPBM, and CEP for dead-end system was around 100 kPa. The CEP increased from around 100 to 150 kPa for the crossflow system as the oil concentration increased from 0.01 to 0.03 vol% when Reynolds number was 7080.

• Journal of the Korean housing association
• /
• v.26 no.4
• /
• pp.63-73
• /
• 2015

'Alley' is the community space as the fundamental living space for local residents and also it's the space which characterize the local community. Research is needed to rediscover the value of alleys which are disappearing due to urban planning. This research focuses on Seochon (current Saejong village) alleys and classify the types of alleys where residential density is seen. Further, this research aims the analysis of dwellings which use the alleys and the characteristics of the layout of alleys. Followings are the research results; 1) Major classifications are 'through alleys' and 'dead end alleys' and there is higher ratio for dead end alleys. 2) Majority of Seochon alleys have the width of more than 1.5 m and less than 3.6 m. 3) There are four types of alleys and straight alleys are most common. 4) Various type of alleys can be found where the width is wider. 5) In case of dead end alleys, there is a tendency of both sides layout rather than one side layout of dwellings. 6) Clusters of hanok can be found at Chebu-dong, Tongin-dong, Nuha-dong and Tongui-dong whereas modern dwellings and villas are more common in Nusang-dong and Ogin-dong. This research analyzes the current status of Seochon alleys and rediscover the value of alleys. This research also provides and presents the basic data materials for continuous sustainable method to keep alleys which characterize the local area.

• Journal of English Language & Literature
• /
• v.55 no.3
• /
• pp.429-440
• /
• 2009

This paper does not follow the well-known critical practice of Charles Perke, Edward Brandabur and Phillip Herring who, regarding The Dead, James Joyce s earliest masterpiece, as the conclusion of Dubliners, classify Gabriel as one of the dead. Instead it concurs with such critics as William York Tindal, Kenneth Burke and Allen Tate who, interpreting The Dead as a story of Gabriel s spiritual maturation, discuss the famous snow vision at the end of the story as a signifier of his rebirth experience. A new reading of The Dead, which is the aim of this paper, examines the very processes which produce both form and content, thereby demonstrating that The Dead is a story of Gabriel s spiritual growth and that the supreme snow vision is prepared for his spirit which progresses towards a richer synthesis of life and death, a higher altitude of flight and wider horizons.

• Journal of Korean Society of Water and Wastewater
• /
• v.22 no.4
• /
• pp.437-444
• /
• 2008

Many other countries have investigated the new backwash water treatment process to save the existing water resource. There are various methods for reusing backwash water, but the membrane system has received the most interest for its efficiency. The objective of this study was to certify the application of membrane filtration system for the backwash water treatment. The experiment equipment was composed of Lab scale tubular membrane filtration system. Generally, cross-flow operation mode is used in the tubular membrane system but cross-flow operation mode demands high electric cost mainly for the pump energy. So to cut off electric cost, dead-end operation mode was used in this experiment. Filtration and bleed operation cycle was used in this membrane system. Backwash water was concentrated during the filtration process and when backwash water reached our target suspended solid concentration, it was discharged from this system. For efficient operation of filtration and bleed, mathematical matrix was drawn up and with this matrix we could simulate various sets of filtration and bleed time.