• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.2
• /
• pp.9-17
• /
• 2010

Recently, there has been much interest in orthogonal frequency division multiplexing (OFDM) for next generation wireless wideband communication systems. OFDM is a special case of multicarrier transmission, where a single data stream is transmitted over a number of lower-rate subcarriers. One of the main reasons to use OFDM is to increase robustness against frequency-selective fading or narrowband interference. However, in the radio systems it is also important to distortion introduced by high power amplifiers (HPA's) such as solid state power amplifier (SSPA) considered in this paper. Since the signal amplitude of the OFDM system is Rayleigh-distributed, the performance of the OFDM system is significantly degraded by the nonlinearity of the HPA in the OFDM transmitter. In this paper, we propose a canonical piecewise-linear (PWL) model based digital predistorter to prevent signal distortion and spectral re-growth due to the high peak-to-average power ratio (PAPR) of OFDM signal and the nonlinearity of HPA's. Computer simulation on an OFDM system under additive white Gaussian noise (AWGN) channels with QPSK, 16-QAM and 64-QAM modulation schemes and modulator/demodulator implemented with 1024-point FFT/IFFT, demonstrate that the proposed predistorter achieves significant performance improvement by effectively compensating for the nonlinearity introduced by the SSPA.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.1
• /
• pp.13-22
• /
• 2004

This paper drives the exact expression of bit error rate(BER) performance for successive interference cancellation(SIC) algorithm against multipath interference components in a high-speed downlink packet access(HSDPA) system of W-CDMA downlink and the BER performance is evaluated by numerical analysis. Numerical results showed that the average BER performance is rapidly saturated in terms of increasing the number of multipath and is revealed significant improvement for improvement Processing gain(PG). For example, the average BER Performance of the SIC algorithm is superior to the performance of conventional scheme by more than 7dB and 1.4dB for processing gain PG=54 and 128 under the two-path channel and average BER=$1.0{\times}10^{-3}$, respectively. This results also indicated that the average BER saturation is occurred at nearly one weight factor which is assigned to pilot and data channels. Likewise, the average BER performance is greatly degraded due to increasing the interference power in proportional to the number of multipath with increasing multicode K. And the smaller multipath fading channel gain is arrived later, the more the average BER performance is improved. The results of performance analysis in this paper indicated that the multipath interference cancellation is required to improve the BER performance in a HSDPA system under multicode for high-speed packet transmission, low spreading factor, and multipath fading channel.

• Proceedings of the Korean Society of Medical Physics Conference
• /
• 2002.09a
• /
• pp.314-317
• /
• 2002

The purpose of this study was to evaluate the clinical application of Patlak tool on GE PET workstation for quantitative analysis of dynamic PET images in cardiac patients. Three patients including coronary artery disease (CAD), myocardial infarction (MI), and angina were studied. All subjects underwent dynamic cardiac PET scan using a GE Advance scanner. After 10 min transmission scan for attenuation correction using two rotating $\^$68/Ge rod sources, three patients with cardiac disease were performed dynamic cardiac PET scan after the administration of approximately 370 MBq of FDG. The dynamic scan consisted of 36 frames with variable frame length (12${\times}$10s, 6${\times}$20s, 6${\times}$60s, 12${\times}$300s) for a total time of 70 min. Blood samples were obtained to determine the plasma substrate concentration. Region of interest of circular and rectangular shape to acquire input functions and tissue data were placed on left ventricle and myocardium. A value of 0.67 was used for lumped constant. Mean plasma substrate concentrations for three patients were 100 mg/dl (CAD), 100 mg/dl (MI), 132 mg/dl (angina), respectively. Regional MMRGlc values (mean${\pm}$SD) at lateral myocardium area for CAD, MI, and angina were 8.43${\pm}$0.24, 4.08${\pm}$0.16, and 6.15${\pm}$0.23 mg/min/100ml, respectively. Patlak tool on GE PET workstation appeared to be useful for quantitative analysis of dynamic PET images in cardiac patients, although further studies may be required for absolute quantitation.

• Journal of Korean Ophthalmic Optics Society
• /
• v.7 no.1
• /
• pp.15-20
• /
• 2002

The Hydroxyethyl methacrylate(HEMA) was developped in 1960's and later the use of contact lenses increased. At present more and more people use RGP contact lenses. Due to the wide range of optical corrections available and due to their high oxygen transmission Japanese and Korean people like them. Nevertheless one of nine CL users(beginners) stopped wearing the CL within the first year. We conducted a survey to evaluate the level of patient compliance in lens care and maintenance and to assess practitioner knowledge of contact lens information. Generally 6% of contact lens wearers drop out per year. The aim of this research was to find out what opticians can do to reduce the drop-out rate by getting information on handling, on general data of the patient and on optical prescription. Lens wearer were asked to complete a 10 question survey that focused on lens care-wear modality, lens replacement, storage, symptoms and case disinfection. There were total 180 participants in the study. Most of contact lens wearers have an inadequate understanding of contact lens care system. Therefore, it is important that contact lens specialists place more emphasis on practitioner education about general contact lens fields and reinforce patient education during the dispensing visit.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.12
• /
• pp.1084-1096
• /
• 2016

This paper presents method of design and analysis of a high-speed serial interface connector with a data rate of 12.5 Gbps. A high-speed serial interface connector is composed of various material and complex structures. It is very difficult to match the impedance of each discontinuous portion of connector. Therefore, this paper proposes the structure of a connector line that be simplified a connector. In the structure of proposed connector line, this research presents a method for extracting R, L, C and G parameters, analyzing the differential mode impedance, and minimizing the impedance discontinuity using time domain transmissometry and time domain reflectometry. This paper applies the proposed methods in the connector line to the high-speed serial interface connector. The proposed high-speed serial interface connector, which consists of forty-four pins, is analyzed signal transmission characteristics by changing the width and spacing of the four pins. According to the analysis result, as the width of the ground pin increases, the impedance decreases slightly. And as the distance between the ground pin and the signal pin increases, the impedance increases. In addition, as the width of the signal pin increases, the impedance decreases. And as the distance between the signal pin and the signal pin increases, the impedance decreases. The impedance characteristic of initial connector presents ranges from 96 to $139{\Omega}$. Impedance characteristic after applying the structure of proposed connector is shown as a value between 92.6 to $107.5{\Omega}$. This value satisfies the design objective $100{\Omega}{\pm}10%$.

• Journal of KIISE:Information Networking
• /
• v.30 no.1
• /
• pp.134-142
• /
• 2003

We present an ATM switch architectures based on the multistage interconnection network(MIN) for the efficient multicast traffic control. Many of these applications require multicast connections as well as point-to-point connections. Muiticast connection in which the same message is delivered from a source to arbitrary number of destinations is fundamental in the areas such as teleconferencing, VOD(video on demand), distributed data processing, etc. In designing the multicast ATM switches to support those services, we should consider the fairness(impartiality) and priority control, in addition to the overflow problem, cell processing with large number of copies, and the blocking problem. In particular, the fairness problem which is to distribute the incoming cells to input ports smoothly is occurred when a cell with the large copy number enters upper input port. In this case, the upper input port sends before the lower input port because of the calculating method of running sum, and therefore cell arrived into lower input port Is delayed to next cycle to be sent and transmission delay time becomes longer. In this paper, we propose the cell splitting and group splitting algorithm, and also the fairness scheme on the basis of the nonblocking characteristics for issuing appropriate copy number depending on the number of Input cell in demand. We evaluate the performance of the proposed schemes in terms of the throughput, cell loss rate and cell delay.

• The KIPS Transactions:PartC
• /
• v.9C no.1
• /
• pp.73-78
• /
• 2002

In WATM networks, in order to perform dynamic slot allocation required slots of mobile terminals are estimated based on DP (Dynamic Parameter) reflecting characteristics of traffic. In VBR (Variable Bit Rate) traffic, slot allocation is done at MT considering both time-dependent characteristics and QoS (Quality of Service) requirements. In this paper, DPs-buffer state information and buffer state change-are transmitted through in-band signaling. BS (Base Station) performs dynamic slot allocation considering traffic characteristics of each MT (Mobile Terminal), in other words, buffer state information informs the potentiality of 'buffer full state'to BS if MT buffer is over the specific threshold value and buffer state change notifies change in buffer state of incoming cells to MT. If buffer state information is equal to 'low (more than threshold)' and 'abrupt increase' it generates 'buffer full' state cell transmission delay or cell loss might occur. At this time BS should assign additional slots to MT, and then MT consumes cells in its buffer. In simulation, the proposed scheme shows better performance in cell delay and loss than EPSA (Estimation-Prorated Slot Assignment) in-band scheme.

• Journal of Broadcast Engineering
• /
• v.15 no.1
• /
• pp.122-132
• /
• 2010

AT-DMB system has been developed to increase data rate up to double of conventional T-DMB in the same bandwidth while maintaining backward compatibility. The AT-DMB system adopted hierarchical modulation which adds BPSK or QPSK signal as enhancement layer to existing DQPSK signal. The enhancement layer signal should be small enough to maintain backward compatibility and to minimize the coverage loss of conventional T-DMB service coverage. But this causes the enhancement layer signal of AT-DMB susceptible to fading effect in transmission channel. A turbo code which has improved error correction capability than convolutional code, is applied to the enhancement layer signal of the AT-DMB system for compensating channel distortion. However there is a need for other solutions for better reception of AT-DMB signal in receiver side without increasing transmitting power. In this paper, we propose adaptive array antenna system with Eigen-space beamforming algorithm which benefits beamforming gain along with diversity gain. We analyzed the reception performances of AT-DMB system in indoor and mobile environments when this new smart antenna system and algorithm is introduced. The computer simulation results are presented along with analysis comments.

• Pediatric Gastroenterology, Hepatology & Nutrition
• /
• v.5 no.1
• /
• pp.39-50
• /
• 2002

Hepatitis B viral infection which affect about 10% of Korean population manifests asymptomatic carrier, chronic hepatitis and liver cirrhosis and even associates with hepatocellular carcinoma. Clinical manifestations induced by hepatitis B virus vary depending on the degree of immune response by cytotoxic T cells against viral epitope-presenting liver cells. Since hepatitis B virus presents high rate of mutaton that might change the presented epitope and eventually alter immune response, viral mutations, especially in promoters and enhancers, have an important implication in hepatic inflammation and viral replication. To identify mutations related to the hepatic inflammation, we investigated sequence variations of hepatitis B viral promotor regions in the presence or absence of symptoms in hepatitis B carriers. For this, sera from persistently hepatitis B virus-infected mother-child pairs were collected. After PCR amplifiation of all hepatitis B viral promoters (C promoter, S1 promoter, S2/S promoter, X promoter) using serum DNA from each pair, viral promotors were sequenced by automatic sequencer and then sequence data were analyzed by ClustalW. In most cases, the dominant type of maternal virus was transmitted to the child. However, in some children, some new host specific viral variants could be observed in Cp, S1p and S2/Sp. The mutations in C promoter did not seem to be vertically transmitted but arose in new host independently after the wild type had been transmitted. Enhancer I containing X promoter revealed high host specific variations as has been reported before. Two S promoters, S1p and S2/Sp, have shown some point mutations in children, but no deletion mutations were detected as in chronic hepatitis patients in whom deletion mutations are frequently found. In conclusion, the children with the vertically transmitted hepatitis B virus mostly retain the dominant type virus that had been transmitted. However, host specific variants tended to accumulate over time, possibly as clinical symptoms develop.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.27 no.1
• /
• pp.1-6
• /
• 2017

Recent researches on radio frequency energy harvesting networks(RF-EHNs) with limited energy resource like battery have been focusing on the development of a new scheme that can effectively extend the whole lifetime of a network to semipermanent. In order for considerable increase both in the amount of energy obtained from radio frequency energy harvesting and its charging effectiveness, it is very important to design a network that supports energy harvesting and data transfer simultaneously with the full consideration of various characteristics affecting the performance of a RF-EHN. In this paper, we proposes an interference-based charging aware routing protocol(ICARP) that utilizes interference information and charging time to maximize the amount of energy harvesting and to minimize the end-to-end delay from a source to the given destination node. To accomplish the research objectives, this paper gives a design of ICARP adopting new network metrics such as interference information and charging time to minimize end-to-end delay in energy harvesting wireless networks. The proposed method enables a RF-EHN to reduce the number of packet losses and retransmissions significantly for better energy consumption. Finally, simulation results show that the network performance in the aspects of packet transmission rate and end-to-end delay has enhanced with the comparison of existing routing protocols.