• International Journal of High-Rise Buildings
• /
• v.6 no.3
• /
• pp.227-235
• /
• 2017

This paper describes some of the challenges for structural design of a mid-story seismic isolated high-rise building, which is located near Tokyo station, completed in 2015. The building is a mixed-use complex and encompasses three volumes: one substructure including basement and lower floors, and a pair of seismic isolated superstructures on the substructure. One is a 136.5m high Main Tower (office use), and the other is a 98.5 m high South Tower (hotel use). The seismic isolation systems are arranged in the $3^{rd}$ floor of the Main Tower and $5^{th}$ floor of the South Tower, so that we call this isolation system as the mid-story seismic isolation. The primary goal of the structural design of this building was to secure high seismic safety against the largest earthquake expected in Tokyo. We adopted optimal seismic isolation equipment simulated by dynamic analysis to minimize building damage. On the other hand, wind-induced vibration of a seismic isolated high-rise building tends to be excited. To reduce the vibration, the following strategies were adopted respectively. In the Main Tower with a large wind receiving area, we adopted a mechanism that locks oil dampers at the isolation level during strong wind. In the South Tower, two tuned mass dampers (TMDs) are installed at the top of the building to control the vibration. In addition, our paper will also report the building performance evaluated for wind and seismic observation after completion of the building. In 2016, an earthquake of seismic intensity 3 (JMA scale) occurred twice in Tokyo. The acceleration reduction rate of the seismic isolation level due to these earthquakes was approximately 30 to 60%. These are also verified by dynamic analysis using observed acceleration data. Also, in April 2016, a strong wind exceeding the speed of 25m/s occurred in Tokyo. On the basis of the record at the strong wind, we confirmed that the locking mechanism of oil damper worked as designed.

• Journal of the Korea Concrete Institute
• /
• v.27 no.4
• /
• pp.427-434
• /
• 2015

The objective of this study is to establish an rational mixture-proportioning procedure for low-$CO_2$ concrete using supplementary cementitious materials (SCMs) achieving the targeted $CO_2$ reduction ratio as well as the conventional requirements such as initial slump, air content, and 28-day compressive strength of concrete. To evaluate the effect of SCM level on the $CO_2$ emission and compressive strength of concrete, a total of 12537 data sets were compiled from the available literature and ready-mixed concrete plants. The amount of $CO_2$ emission of concrete was assessed under the system boundary from cradle to concrete production stage at a ready-mixed concrete plant. Based on regression analysis using the established database, simple equations were proposed to determine the mixture proportions of concrete such as the type and level of SCMs, water-to-binder ratio, and fine aggregate-to-total aggregate ratio. Furthermore, the $CO_2$ emissions for a given concrete mixture can be straightforwardly calculated using the proposed equations. Overall, the developed mixture-proportioning procedure is practically useful for determining the initial mixture proportions of low-$CO_2$ concrete in the ready-mixed concrete field.

• Journal of Technology Innovation
• /
• v.19 no.1
• /
• pp.1-27
• /
• 2011

This paper aims to measure and analyze R&D productivities and efficiencies of 17 major OECD countries including Korea over the 1984-2008 period by using the Malmquist Productivity Index and Data Envelopment Analysis, classifying R&D performance into an output and outcome aspects. It also searches the Korea's current status and characteristics in each R&D stage to enhance Total Factor Productivity (TFP) compared with other developed countries. Our major findings are the followings: (i) Korea's productivity index of R&D input vis-a-vis R&D output is very high (13.39% annual growth rate) compared with those of major advanced countries, whereas the annual average of efficiency index is very low (0.33), i.e. Korea's technical efficiency index has risen to 0.83 at the last time series started at 0.10 point and come up to the level of major advanced countries. (ii) the Korea's productivity index of R&D output vis-a-vis R&D outcome is very low (14.02% annual reduction rate) compared with those of major advanced countries, whereas the annual average of efficiency index is very high (0.22), i.e. Korea's integrated frontier technical efficiency index has dropped to 0.057 at the last time series started at 1.00 point and coming up to the level of major advanced countries. (iii) The productivity of R&D input vis-a-vis R&D outcome is positively correlated with that of R&D output vis-a-vis R&D outcome and the growth of R&D input factors. In a nutshell, it implicates that the effort to take advantage of R&D outputs, namely establishing the diffusion and commercialization system of technical knowledge to the level of developed countries, should be strengthened over that on the growth of R&D investment and output for enhancing R&D productivity and efficiency in Korea.

• International Commerce and Information Review
• /
• v.13 no.3
• /
• pp.77-95
• /
• 2011

This paper investigates the relationship between export and economic variables such as trade insurance, world economy activity, relative price, unemployment rate, exchange rate volatility, using monthly data. I employ Johansen cointegration methodology since the model must be stationary to avoid the spurious results. The results indicate that there is a long-run relationship between export and variables. Also, the empirical analysis of cointegrating vector using the CCR, DOLS, FMOLS reveals that the increases of trade insurance has positive relations and the increases of exchange rate volatility have negative relations with export. Especially, DOLS based on Monte Carlo simulations, of this estimator being superior in small samples compared to a number of alternative estimators, as well as being able not only to accommodate higher orders of integration but also to account for possible simultaneity within regressors of a potential system. This paper also applies impulse-response functions to get the additional information regarding the responses of the export to the shocks of the variables. The result indicates that export positively to trade insurance and then decay fast compare with exchange rate volatility. Consequently, trade insurance plays the role of trade policy for export promotion in Korea. Whereas, increase of exchange risk result in reduction of export. Therefore, the support of trade insurance should be expanded and the stabilization of the foreign exchange market must be done for the export promotion.

• Journal of Korean Society of Transportation
• /
• v.32 no.2
• /
• pp.83-92
• /
• 2014

Weather condition is one of the crucial factors affecting travelers' mode choice. Nevertheless, there are numerous indefinite traffic phenomena under various weather conditions. This study was conducted to verify the hypothesis that transit riderships decrease as precipitation increases. To clarify the relationship between precipitation and transit ridership, a seemingly unrelated regression model was employed with data such as daily precipitation and daily transit riderships of 3 transit modes (bus, metro, and shuttle bus) collected in Busan for recent 24 months. The estimation results show that transit riderships decreased as the daily precipitation increased when the daily precipitation is greater or equal to 10mm/day (0.169%, 0.101%, and 0.172% reduction in bus, metro, and shuttle bus riderships, respectively, when the daily precipitation increased by 1mm). When comparing the impact of precipitation on transit riderships by modes using a cross-equation parameter restriction test, the decrease in metro ridership is relatively insensitive to the change in precipitation. However, the negative coefficient of precipitation in the metro ridership estimation model indicates that the transit users in Busan may alter their mode to taxi or automobile and/or may give up the trip itself in bad weather condition.

• Journal of Environmental Impact Assessment
• /
• v.24 no.1
• /
• pp.1-15
• /
• 2015

To mitigate the impacts of climate change on agricultural ecosystems, development of agricultural management for enhanced soil carbon sequestration is required. In this study, the effects of fertilizer types (chemical fertilizer and manure compost), cropping systems, and crop residue management on SOC(Soil Organic Carbon) sequestration were investigated. Summer corn and winter barley were cultivated on experimental plots under natural rainfall conditions for two years with chemical fertilizer and manure compost. Soil samples were collected conducted and analyzed for SOC for soil. To estimate long-term variation patterns of SOC, DNDC was run with the experimental data and the weather input parameters from 1981 to 2010. DNDC simulation demonstrated SOC reduction by chemical fertilizer treatment unless plant residues are returned; whereas compost treatments increased SOC under the same conditions and SOC increment was proportional to compost application rate. In addition, SOC further increased under corn-barley cropping system over single corn cropping due to more compost application. Regardless of nutrient input type, residue return increased SOC; however, the magnitude of SOC increase by residue return was lower than by compost application.

• The Journal of Korean Society for Radiation Therapy
• /
• v.25 no.1
• /
• pp.87-90
• /
• 2013

Purpose: Introducing CR (Computed Radiography) system created a process of printing therapy irradiation images and converting the degree of enlargement. This is to increase job efficiency and contribute to work improvement using a computerized method with home grown software to simplify this process, work efficiency. Materials and Methods: Microsoft EXCEL (ver. 2007) and VISUAL BASIC (ver. 6.0) have been used to make the software. A window for each shield block was designed to enter patients' treatment information. Distances on the digital images were measured, the measured data were entered to the Excel program to calculate the degree of enlargement, and printouts were produced to manufacture shield blocks. Results: By computerizing the existing method with this program, the degree of enlargement can easily be calculated and patients' treatment information can be entered into the printouts by using macro function. As a result, errors in calculation which may occur during the process of production or errors that the treatment information may be delivered wrongly can be reduced. In addition, with the simplification of the conversion process of the degree of enlargement, no copy machine was needed, which resulted in the reduction of use of paper. Conclusion: Works have been improved by computerizing the process of block production and applying it to practice which would simplify the existing method. This software can apply to and improve the actual conditions of each hospital in various ways using various features of EXCEL and VISUAL BASIC which has already been proven and used widely.

• Journal of Korea Multimedia Society
• /
• v.13 no.8
• /
• pp.1154-1162
• /
• 2010

Because it is easy to implement the scalar quantizer, it is used in various video coding systems. Although the scalar quantizer with a large quantization stepsize can reduce the amount of data, it has disadvantage that the reconstructed picture quality is poor. In this paper, we propose an efficient method which improves the coding performance by maintaining original quantization stepsize and increasing the number of quantization reconstruction levels. Simultaneously, for the purpose of solving the problem of transmitting the added symbol informations which is used to indicate the region of quantizer reconstruction level as the number of quantizer reconstruction level is increased, we also suggest the method to reduce the added informations. Therefore, for the intra-coded picture of H.264 video coding system, we generate the huffman codes for the symbol informations of quantization reconstruction regions by 4${\times}$4(horizontal 4 pixels, vertical pixels) block unit. Furthermore, for the inter-coded picture, we also generate the huffman codes for the symbol informations of quantization reconstruction regions by 8${\times}$8 blocks and 4${\times}$4 blocks within a macroblock. Adopting this method of reducing the added information by increasing the number of quantization reconstruction region, It is shown that the coding performance can be improved at the same bitrate.

• Journal of Korean Society for Atmospheric Environment
• /
• v.28 no.2
• /
• pp.211-221
• /
• 2012

The Ministry of Environment will enforce air quality standards for $PM_{2.5}$ in 2015 because it affects human health as well as climate change and brings about other adverse effects. Until recently, even though a number of researches have reported $PM_{2.5}$ emissions according to sources, they have not precisely considered the emission factors correspondent to each source for emission estimation. For the sake of establishing $PM_{2.5}$ emission inventories, this study was undertaken using activity data of each source taken from CAPSS (Clean Air Policy Support System) multiplied by each emission factor of U.S. EPA Speciate or EEA CORINAIR. The 2008's total annual $PM_{2.5}$ emission (73.971 ton/yr) can be apportioned into five sources, such as fuel combustion facilities (62.2%), mobiles (33.8%), production processes (3.2%), fires (0.4%), and waste treatments (0.3%). The results show that fuel combustion facilities and mobiles are the predominant sources of $PM_{2.5}$, and they should be taken into great account in establishing $PM_{2.5}$ standards. In addition, it is necessary and urgent to develop effective measures for reduction of $PM_{2.5}$ emissions from those two main sources as well.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.11
• /
• pp.271-284
• /
• 2016

This study was carried out to evaluate the efficacy of CBT for perinatal depression through systematic literature review and meta-analysis. The following databases were used to search the literature: CINAHL, PubMed, EMBASE, Koreamed, Library of Korean Congress, KISS, and Korean Academic Publication Database. Keywords included 'perinatal depression,' 'pregnant women,' and 'cognitive behavioral therapy,' and the evaluated articles were published up to May 2016. Using the R program, the effect size of perinatal depression and anxiety were calculated by random-effects model. The heterogeneity of the effect size was analyzed by data moderator analysis using the meta-ANOVA. Furthermore, the funnel plot, Egger's regression test, fail-safe N, trim-and-fill test, and publication bias analysis were conducted and used to verify the results. Out of the 180 selected articles, 16 clinical trial studies were meta-analyzed. Each articles were evaluated for the risk of bias by the checklist of SIGN; the overall risk of bias was low. The effect size of CBT for perinatal depression was Hedges' g=-0.55 (95% CI: -0.76~-0.33), which was a moderate level, while for anxiety reduction, Hedges' g=-0.20 (95% CI: -0.48~-0.08) and it was not statistically significant. Heterogeneity or risk of publication bias were low. This meta-analytic study found that CBT is moderately effective in reducing perinatal depression in pregnant women.