• Journal of the Korean Recycled Construction Resources Institute
• /
• v.2 no.3
• /
• pp.173-179
• /
• 2014

This is an experimental study for recycling coal ash left over from coal use as a potential fine aggregate in concrete. Coal ash is generally divided into either fly ash or bottom ash. Fly ash has been utilized as a substitution material for cement in concrete mixes. On the other hand, bottom ash has the problem of low recycling rates, and thus it has been primarily reclaimed. This study partially substituted fine concrete aggregates with bottom ash to increase its application rate and therefore its recycling rate; its suitability for this purpose was confirmed. The concrete's workability dropped noticeably with increasing bottom ash content when a fixed water-cement ratio of concrete mix was used. Thus, concrete mixes with higher ratio levels are required. To address this problem, concrete was mixed using a polycarboxylate high-range water reducing agent. The fluidity and air entrainment immediately after mixing the concrete and 1 h after mixing were measured, thereby replicating the time concrete is placed in the field when produced either in a ready-mixed concrete or in a batch plant. As a result of this research, the workability and air entrainment were maintained 1 h after mixing for a concrete mixture with approximately 30% of its fine concrete aggregates substituted with the bottom ash. A slight drop in compression strength was seen; however, this confirmed that potential of using bottom ash as a fine aggregate in concrete.

• The korean journal of orthodontics
• /
• v.34 no.4 s.105
• /
• pp.289-301
• /
• 2004

It is the purpose of this study to characterize oral symptoms and to comprehend the cause and the relapse possibility of patients with open bite. This case study examines the orthodontic treatment of a group of female patients with open bite and Angle's Class I malocclusion. A cephalograph of the patient was taken and tracing of the radiograph was completed. In addition to Bjork and Ricketts analysis, additional measurements of specific areas were taken. The occlusal plane was determined by drawing a line connecting the mesiobuccal cusp tip of the maxillary first molar and the incisal edge of the maxillary central incisors. Patients were divided into two groups depending on the relationship between the marginal ridge of the maxillayy first premolar and the drawn line. Those patients with marginal ridges above the occlusal plane were placed into Group 1, while Group 2 subjects exhibited marginal ridges lower than the occlusal plane. The common characteristics within each group and the characteristic differences between each group both prior to and after orthodontic treatment were examined, and finally, the functional oral volume of each patient was analyzed. The results of the case study were as follows: 1. An examination of the skeletal relationship and anatomical form for both Group 1 and 2 showed that all subjects exhibited hyperdivergent skeletal forms, but Group 2 subjects generally demonstrated underdevelopment of the mandible and a smaller articular angle, resulting in an anterior positioning tendency of the mandible. 2. An analysis of the maxillary arches of Group 1 subjects prior to and after orthodontic treatment showed that the antero-inferior direction had changed to an antero-superior directional tendency, while the maxillary arches of the Group 2 patients showed a trend from an antero-superior direction to an antero-inferior relationship. The mandibular arches in both groups showed a change to an antero-superior direction. 3. Functional space analysis showed that Group 2 patients exhibited a greater tendency of haying palatal planes that drop in a postero-inferior direction, resulting in a more severe open bite than their Group 1 counterparts. The results of this case study show that although patients belonging to either Group 1 or 2 exhibited few external differences in the appearance of open bite, an examination of the dental and skeletal relationships by analyzing patient cephalographs showed that patients presenting with flat maxillary occlusal planes exhibited more severe open bite relationships than patients with curved occlusal planes.

• The KIPS Transactions:PartD
• /
• v.14D no.1 s.111
• /
• pp.21-34
• /
• 2007

According to recent rapid price drop and capacity growth of main memory, the number of applications on main memory databases is dramatically increasing. Cache miss, which means a phenomenon that the data required by CPU is not resident in cache and is accessed from main memory, is one of the major causes of performance degradation of main memory databases. Several cache-conscious trees have been proposed for reducing cache miss and making the most use of cache in main memory databases. Since each cache-conscious tree has its own unique features, more than one cache-conscious tree can be used in a single application depending on the application's requirement. Moreover, if there is no existing cache-conscious tree that satisfies the application's requirement, we should implement a new cache-conscious tree only for the application's sake. In this paper, we propose the cache-conscious generalized search tree (CC-GiST). The CC-GiST is an extension of the disk-based generalized search tree (GiST) [HNP95] to be tache-conscious, and provides the entire common features and algorithms in the existing cache-conscious trees including pointer compression and key compression techniques. For implementing a cache-conscious tree based on the CC-GiST proposed in this paper, one should implement only a few functions specific to the cache-conscious tree. We show how to implement the most representative cache-conscious trees such as the CSB+-tree, the pkB-tree, and the CR-tree based on the CC-GiST. The CC-GiST eliminates the troublesomeness caused by managing mire than one cache-conscious tree in an application, and provides a framework for efficiently implementing arbitrary cache-conscious trees with new features.

• Magazine of the Korea Concrete Institute
• /
• v.10 no.6
• /
• pp.269-280
• /
• 1998

Recently, application of composite materials such as fiber reinforced concretes(FRCs) and fiber reinforced plastics(FRPs) in conjunction with conventional structural components has become one of the main research areas. A proper use of advanced composite materials requires understanding their resistance mechanism and failure mode when they are applied to structures or their components. Particular considerations are given in this research to develop an analytical model which can predict the nonlinear flexural responses of bonded and unbonded prestressed concrete beams possibly having layers of different cementitious composite matrices in a section and/or FRP tendons. The block concept is used, which can be regarded as an intermediate modeling method between the couple method with one block and the layered method with multiply sliced layers in a section. In order to find a particular deflection point of a beam under load, solutions to the 2N-variables are found numerically by using approximate N-force equilibrium equations and N-moment equilibirum equations. The model is shown to successfully predict the flexual behavior of variously reinforced bonded and unbonded prestressed concrete beams. The model is also successful in simulating a gradually increasing load after sudden drop inload resistance due to fracture of one or more FRP tendons. This feature is useful in tracing the overall load-deflection response of a beam prestressed with brittle FRP tendons.

• Journal of the Korean Institute of Gas
• /
• v.16 no.5
• /
• pp.14-20
• /
• 2012

Biogas can be obtained from biogenic materials through an anaerobic digestion process. Since biogas has low calorific value and its composition significantly varies, appropriate combustion strategies need to be established to obtain stable combustion in engine applications. In this study, efforts have been made to investigate the effects of inert gas composition variations on engine performance and emissions. Results show that the MBT spark timing was advanced and $NO_x$ was reduced as the inert gas in the biogas rose. Moreover, $NO_x$ emission drop in $CO_2$ diluted biogas was more significant than that of $N_2$ due to higher heat capacity of $CO_2$, while THC emissions showed the opposite tendency. Thermal efficiency was increased in $N_2$ case with elevation of $N_2$ due to the decreased heat loss and PMEP. However, there is no difference in $CO_2$ case because of deteriorated flame propagation speed.

• Korean Chemical Engineering Research
• /
• v.52 no.2
• /
• pp.219-225
• /
• 2014

In this study, effect of cosurfactant on the solubilization rate of n-octane, n-decane and n-dodecane oil was performed by micellar solutions of polymeric nonionic surfactant Pluronic L64($EO_{13}PO_{30}EO_{13}$) at room temperature. It has been found that the solubilization rate of a hydrocarbon oil was enhanced with an increase in both chain length and amount of alcohol added. In case of addition of a short chain alcohol such as 1-butanol, the solubilization rate of a hydrocarbon oil was slightly increased since most of alcohol molecules remained in an aqueous surfactant solution. On the other hand, the addition of a relatively long chain alcohol such as 1-hexanol and 1-octanol produced a big increase in solubilization rate of a hydrocarbon oil mainly due to incorporation of alcohol molecules into micelles and thus producing more flexible micellar packing density. Dynamic interfacial tension measurements showed the same trend found in solubilization rate measurement. Both interfacial tension value at equilibrium and time required to reach equilibrium decreased with an increase in chain length of an alcohol.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.4
• /
• pp.17-27
• /
• 2007

The enhanced distributed channel access (EDCA) of IEEE 802.11e has been standardized for supporting Quality of Service (QoS) in wireless LANs. In the EDCA, support of QoS can be achieved statistically by reducing the probability of medium access for lower priority traffics. In other words, it provides statistical channel access rather than deterministically prioritized access to high priority traffic. Therefore, lower priority traffics affect the performance of higher priority traffics. Consequently, at the high loads, the EDCA does not guarantee the QoS of multimedia applications such as voice and video even though it provides higher priority. In this paper, we propose a simple and effective scheme, called deterministic priority channel access (DPCA), for improving the QoS performance of the EDCA mechanism. In order to provide guaranteed priority channel access to multimedia applications, the proposed scheme uses a busy tone for limiting the transmissions of lower priority traffics when higher priority traffic has data packets to send. Performance of the proposed scheme is investigated by numerical analysis and simulation. Our results show that the proposed scheme outperforms the EDCA in terms of throughput, delay, jitter, and drop under a wide range of contention levels.

• Journal of Ginseng Research
• /
• v.28 no.2
• /
• pp.87-93
• /
• 2004

The effect of ginsenoside-Rb2, one of a major pharmacological component of Panax ginseng C.A. Meyer, on low density lipoprotein (LDL) receptor expression was investigated and compared with hypocholesterolemic drug lovastatin. In HepG2 cell, exogenous cholesterol decreased LDL receptor mRNA expression, but ginsenoside-Rb2 recovered this reduction of LDL receptor mRNA up to normal expression level. Lovastatin also increased LDL receptor mRNA expression as similar as ginsenoside-Rb2 did. The reduction of sterol regulatory element binding protein (SREBP) transcription by exogenous cholesterol was also similarly recovered by ginsenoside-Rb2 and lovastatin addition. Compound K, a metabolite of ginsenoside-Rb2 and -Rb1 by human intestinal bacteria also increased the SREBP mRNA expression in cholesterol-enriched condition. Ginsenoside-Rb2 seems to up-regulate LDL receptor mRNA expression through the induction of de novo SREBP transcription. Therefore, increased expression of SREBP mRNA by ginsenoside-Rb2 elevated the LDL receptor mRNA expression in HepG2 cells, and these inductions possibly drop the plasma cholesterol level in hypercholesterolemia patients, in vivo, as likely in case of lovastatin.

• Genomics & Informatics
• /
• v.15 no.1
• /
• pp.2-10
• /
• 2017

Early detection and proper management of kidney rejection are crucial for the long-term health of a transplant recipient. Recipients are normally monitored by serum creatinine measurement and sometimes with graft biopsies. Donor-derived cell-free deoxyribonucleic acid (cfDNA) in the recipient's plasma and/or urine may be a better indicator of acute rejection. We evaluated digital PCR (dPCR) as a system for monitoring graft status using single nucleotide polymorphism (SNP)-based detection of donor DNA in plasma or urine. We compared the detection abilities of the QX200, RainDrop, and QuantStudio 3D dPCR systems. The QX200 was the most accurate and sensitive. Plasma and/or urine samples were isolated from 34 kidney recipients at multiple time points after transplantation, and analyzed by dPCR using the QX200. We found that donor DNA was almost undetectable in plasma DNA samples, whereas a high percentage of donor DNA was measured in urine DNA samples, indicating that urine is a good source of cfDNA for patient monitoring. We found that at least 24% of the highly polymorphic SNPs used to identify individuals could also identify donor cfDNA in transplant patient samples. Our results further showed that autosomal, sex-specific, and mitochondrial SNPs were suitable markers for identifying donor cfDNA. Finally, we found that donor-derived cfDNA measurement by dPCR was not sufficient to predict a patient's clinical condition. Our results indicate that donor-derived cfDNA is not an accurate predictor of kidney status in kidney transplant patients.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.10
• /
• pp.454-461
• /
• 2017

The purpose of this study is to investigate the types of domestic safety accidents involving children and to verify the difference of safety knowledge according to variables of parents. Subjects include 226 parents who have 3-5 year old infants enrolled in kindergartens and day care centers in I-city, Jeollabuk-do. The study tools are modified and complemented questionnaire for the study purpose referred to the preceding research data and the literature. For the processing of collected data, frequency analysis, descriptive statistics, one-way ANOVA, and the Duncan post-test were utilized using the SPSS program. The results of this study are as follows: First, safety accidents occurred at the majority of homes which have infant children. On average, the occurrence frequency was 1.78 times per six months. The accidents involving infants occurred in the order of drop or slip, crash or impact, stricture or jamming, fall, stab or cut, burn, swallow or inhalation. Second, both parents had an average level of safety knowledge. There was a distinction in the areas of 'fall' and 'first aid' according the mother's age. In addition, stay-at-home mothers had the higher level of safety knowledge compared with working mothers in the areas of 'general safety knowledge' and 'fire'. There was a distinction in the area of 'fire' according to the father's age. Given these findings, safety training programs for parents to improve safety knowledge needs to be developed.