• Microbiology and Biotechnology Letters
• /
• v.23 no.5
• /
• pp.609-616
• /
• 1995

Effects of lactate concentration, temperature, counter ions, pH as well as voltage (current) in batch electrodialysis (ED) experiments with a 3-compartment unit were investigated. The applied voltage was found to be the most critical factor as expected. The electrodialysis rate increased with the lactate concentration of the source solution. The amount of lactate transferred was limited by the lactate concentration difference between cathode and permeate compartments. The electrodialysis rate did not heavily depend on temperature change. The electrodialysis rate of NH$_{4}$-lactate was faster than that of Na-lactate and both lactates showed the highest electrodialysis rate at a pH of 4.0. A little amount of non-ionic glucose diffused through the anionic membrane to the permeate compartment. To test the effectiveness of the in situ recovery of lactic acid from fermentation broth by ED, three cases of batch culture were carried out; pH control only, ED only, and pH control and ED. The case with both pH control and ED was more efficient than that with pH control only in the aspects of productivity and product yield.

• Journal of Fisheries and Marine Sciences Education
• /
• v.25 no.4
• /
• pp.819-827
• /
• 2013

Water quality has been considered to be one of sanitation standard operating procedures (SSOP) for hazard analysis critical control points (HACCP) application in aquaculture farms. This study was conducted to evaluate a hazard caused by water used in aquaculture farm of rainbow trout. The water quality was analyzed to investigate both physiochemical and bacteriological level in water samples collected from aquaculture farm of rainbow trout, Oncorhynchus mykiss. No significant difference were observed on water temperature and pH from season to season. However, the levels of dissolved oxygen were decreased as the outside temperature was increased, even if the levels were adequate for aquaculture. Also, other physiochemical analysis including biochemical oxygen demand (BOD), chemical oxygen demand (COD) and suspended solid (SS) revealed that the waters for aquaculture analyzed in this study was suitable for rainbow trout aquaculture. The bacterial analyses were also revealed that the waters for aquaculture were met to both coliform group (<18 MPN/100mL) and viable cell count (<100 CFU/mL). However, some of waste waters from aquaculture farms showed higher levels of BOD and COD than those of waste water standard (<2 ppm), suggesting that regular cleaning of fish tank and precipitation tank is needed.

• Journal of the Korean Ceramic Society
• /
• v.33 no.10
• /
• pp.1170-1176
• /
• 1996

Porous silicon was prepared by anodic reaction. The process was controlled by current density and etching time an the thickness change and the room temperature PL was measured. The thickness of porous silicon was increased with etching time and was decreased after critical time. It was the same as increasing current density. It needed only 15 sec to electropolish the surface of porous silicon above current density 70 mA/cm2. We can understand that increasing etching time leads narrow size of Si column by porous silicon formation mechanism. And the sample with narrow Si column revealed PL blue shift. The specimens were heated in the range of 300-1000$^{\circ}C$ in order to see PL changes. The heat treatment was proceeded in H2 atmosphere vacuum system to avoid oxidation. The PL was disappeared above 600$^{\circ}C$. In high temperature some sintered Si columns were observed in SEM photography. There was no difference of -Hx bonds which was suggested as evidence of hydride compounds luminescence between 500$^{\circ}C$ and 600$^{\circ}C$. Thus it is concluded that quantum confinement is major factor of PL of porous silicon.

• Journal of the Korean Ceramic Society
• /
• v.24 no.4
• /
• pp.349-356
• /
• 1987

${\beta}$-Sialon powder was synthesized by the simultaneous reduction and nitridation of Hadong kaolin at 1350$^{\circ}C$ in N2-H2 atmosphere, using graphite as a reducing agent. The synthesized ${\beta}$-Sialon powder was pressurelessly sintered over 1450-1850$^{\circ}C$ in nitrogen atmosphere. The average particle size of ${\beta}$-Sialon powder was about 4.5$\mu\textrm{m}$. The relative density, M.O.R., fracture toughness and micro-hardness of ${\beta}$-Sialon ceramics sintered at 1800$^{\circ}C$ for 1 hour were 92%, 36 kpsi, 2.8MN/㎥/2 and 13.3 GN/㎡, respectively. The critical temperature difference (ΔT) in water quench thermal shock behavior showed about 375$^{\circ}C$ for the synthesized ${\beta}$-Sialon ceramics.

• Applied Biological Chemistry
• /
• v.27 no.1
• /
• pp.52-54
• /
• 1984

Ethanol fermentation from the chemically gelatinized starchy material was examined. The critical concentration of sodium hydroxide solution for gelatinization was dependent on the species of starch; 0.4M for potato and 0.6M for tapioca at room temperature. For alcohol fermention the starchy material was gelatinized by addition of sodium hydroxide solution, neutralized by sulfuric acid, and then yeast was added. The amount of $CO_2$ evolved during ethanol fermentation indicates that non-fermentable material was not produced from the starch by chemical gelatinization. In ethanol fermentation of potato and tapioca starch no significant difference was observed between the thermal and the chemical gelatinization.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07a
• /
• pp.527-530
• /
• 2002

A lot of efforts have been focused on the optimization of PIT parameters for Bi-2223/Ag wire. In this paper, initial annealing of Bi-2223/Ag wire to transform Bi-2212 orthorhombic from Bi-2212 tetragonal Precursor was investigated. This initial annealing step at low oxygen partial pressure were to transform Bi-2212 orthorhombic structure and to reduce the formation of second phases at superconducting wire. However Bi-2223 Phases were appeared at higher annealing temperature. Critical currents(Je) of Bi-2223/Ag tapes were sintered at low oxygen Partial pressure were higher than that of the wires sintered at atmosphere condition. In order to investigate the effect of rolling reduction ratio, Bi-2223/Ag HTS tapes were rolled with different reduction ratio. There were no clear difference of Je and filaments shape with various rolling reduction ratio.

• Journal of the Korean Ceramic Society
• /
• v.19 no.1
• /
• pp.35-43
• /
• 1982

It was found that the burnability of raw mix and characteristics of clinker was affected by the difference in grades of limestones. The thermal decomposition temperature of raw mix which used low grade limestone was lower than that of high grade, and the fast formation of $C_2S$ was due to the rich content of calcite and quartz over critical grain size, which caused the bad effects in the burnability, but $C_3S$ was formed slowly. The structure of clinker had many pores, and the growth of clinker minerals was inferior.

• KSTLE International Journal
• /
• v.10 no.1_2
• /
• pp.27-32
• /
• 2009

In this study, fretting wear tests of nuclear fuel rods have been performed by using two kinds of spacer grid springs with a concave and a convex shape in room temperature dry and distilled water conditions. The objectives were to examine the variation of the wear mechanism with increasing fretting cycles and to evaluate the difference of the wear debris detachment behavior at each test environment. From the test results, the wear volume of each spring condition increased with increasing fretting cycles regardless of the test environments. However, the wear rate did not show a regular tendency and apparently changed with increasing fretting cycles. This is because the formation of the wear particle layer and/or the variation of the contact condition between the fuel rod and spring surfaces could affect a critical plastic deformation for detaching the wear debris. Based on the test results, the relationship between the wear behavior of each spring shape and test environment condition, and the variation of the surface characteristics are discussed in detail.

• Korean Institute of Interior Design Journal
• /
• no.33
• /
• pp.83-89
• /
• 2002

This paper describes the experiments to examine the sense of continuity produced by lighting between physically separated spaces. Tolerable limits of illuminance were measured for providing a sense of continuity between two rooms connected by a window. In the experiments the illuminance and color of lighting of the subjects room were changed while those of the other room were kept constant. The results show that the observers could certainly determine the range of optimum illuminance for them to recognize continuity, and the variance of the results between observers is very small. Moreover, the tolerable range of illuminance was almost constant as far as the color difference was less than some critical value. This finding would be helpful in designing a lighting system for providing a sense of continuity.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.28 no.11
• /
• pp.1440-1448
• /
• 2004

Multiple solutions in natural convection of air (Pr=0.7) between two horizontal walls with mean temperature difference and the same periodic nob-uniformities are investigated. An analytical solution is found for small Rayleigh number, and the general solution is investigated by using a numerical method. In the conduction-dominated regime, two upright cells are formed between two walls over one wave length. When the wave number is small, the flow becomes unstable with increase of the Rayleigh number, and multicellular convection occurs above a critical Rayleigh number. The multicellular flows at high Rayleigh numbers consist of approximately square-shape cells. And several kinds of multiple flows classified by the number of cells are found.