• 한국해안해양공학회지
• /
• 제2권2호
• /
• pp.59-66
• /
• 1990

극지방의 해양 환경은 낮은 온도와 함께 여러 가지 형태로 존재하는 얼음의 분포에 의해 큰 영향을 받는다. 빙하와 빙산, 해빙 등 빙역학의 기초적인 이해를 위하여 본 연구는 polycrystalline ice의 재료적 특성과 파괴기구 등을 파악하고 극지 방하유동시 관측되는 creep 변경을 기술하기 위한 constitutive 모델을 제시하였다. 빙변형에 관여되는 여러 가지 물리적 변화 중 microcracking에 의한 재료의 손상을 주요인으로 간주하여 파손역학의 이론을 적용한 3차원 수치모델을 개발하였으며 기발표된 실험 결과와 비교하였다. 1축 균일압축을 받는 경우 실험 데이타와 수치모델은 유사한 거동을 보이고 있으며, 빙변형에 있어서 1, 2기 creep의 소성적 변형특성 뿐 아니라 microcracking에 의한3기(tertiary) creep의 특징까지도 잘 기술해 주고 있다.

• 한국항공우주학회지
• /
• 제39권4호
• /
• pp.321-331
• /
• 2011

본 연구는 theta 투영법을 이용하여 터보제트 터빈 블레이드 크리프 특성을 파악하는데 목적이 있다. Theta 투영법은 우수한 정확성을 지니고 있어 폭넓게 사용되고 있다. 크리프 특성을 파악하기 위해 고온 크리프 시험을 수행하였으며, 시험 조건은 터보제트 엔진 운용조건과 소재의 비선형 특성을 고려하여 선정하였으며, four theta 모델의 적합성을 평가하기 위해 크리프 시험 결과와 비교하였다. 크리프 시험결과를 활용하여 크리프 곡선은 four theta model을 이용하여 생성하였다. 반복적인 계산을 통하여 비선형 최소자승법을 이용하여 시험 결과에 대해 최적의 theta 값을 도출하였다. Theta 투영법을 이용하여 크리프 곡선을 생성한 결과 $R^2$값이 0.95이상의 우수한 정확성을 지니는 것을 확인하였다. 또한 four theta 모델의 검정을 위해 수행한 시험 결과와 비교하여 예측된 theta 값이 90.0%의 정확도를 가지어, theta 투영법은 크리프 거동을 예측하여 설계목적에 이용하기 위해 유용하게 사용될 수 있다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2003년도 봄 학술발표회 논문집
• /
• pp.1071-1076
• /
• 2003

Basic creep of concrete during very early ages is an important factor on the behavior of young concrete and a great deal of research has been executed. However, in recent studies, it was revealed that the basic creep measured by sealed concrete was inaccurate, especially for high strength concrete because of autogenous shrinkage at early age. This paper presents the results from experimental study that investigate to explore the effect of autogenous shrinkage in basic creep. More specifically, four different mix proportions were casted and the primary variables were water-cement ratios. Through this research, it was found that the differences between apparent specific creep and real specific creep were remarkable in low water-cement ratio at early age. Therefore, it is recommended to modify existing creep model by considering autogenous shrinkage

• 한국건축시공학회지
• /
• 제19권6호
• /
• pp.503-510
• /
• 2019

최근 RC 구조물의 건설기술에서는 콘크리트의 크리프에 대한 검토가 이루어져야 한다. 본 연구에서는 콘크리트의 크리프 예측 및 국내 건설현장의 크리프 결과에 영향을 미치는 요인을 검토했다. 크리프 테스트 기간이 길고 압축 강도가 높을수록 크리프 예측 정확도가 높아졌다. 경화 온도가 높을수록 콘크리트의 초기 강도가 높아지지만 크리프 계수의 차이는 시간이 지남에 따라 증가했다. 국내 건설현장 및 실험실에서의 크리프 평가 결과를 기반으로 ACI-209모델을 보완하는 수정 된 예측 모델을 제안했다. 일반~고강도 콘크리트를 사용한 실제 부재의 크리프 예측에서는 테스트 기간과 온도를 정확하게 고려해야한다.

• Journal of Biosystems Engineering
• /
• 제15권3호
• /
• pp.219-229
• /
• 1990

The compression creep behavior of grains when loaded depends not only on load but also on duration of load application. The most common methods of studying the load-time characteristics of agricultural products is by employing rheological models such as Burger's model. However it is sometimes not sufficient to describe the viscoelastic behavior of grains to be Burger's model. For this reason, this study was conducted to develop the rheological model which represented the creep compliance response of the rough rice kernel and was a function of initial stress applied and time. The effects of the initial stress applied and the moisture content on the compression creep behavior of the rough rice kernel were analyzed. The results were obtained from the study as follows: 1. Since the viscoelastic behavior of the rough rice kernel was nonlinear, the transient and steady state creep compliance was satisfactorily modelled as follows: $$J({\sigma},t)=A{\sigma}^B[C+Dt-exp(-Ft)]$$ But, for the every stress applied, the compression creep behavior of the samples tested can be well described by Burger's model respectively. 2. The creep compliance, the instantaneous elastic strain, the retarded elastic strain and the viscous strain of the sample tested generally increased in magnitude with increasing the applied initial stress and the moisture content used in the tests. At low moisture content, the creep compliance for the Japonica-type rough rice kernel Was a little higher than those for Indica-type and at high moisture content, vice versa at high moisture content. 3. The retardation times of the samples had not an uniform tendency by the initial stress and the moisture content. The retardation times ranged from 0.66 to 6.76 seconds, and the creep progressed from transient to steady state at a relatively high rate. 4. The less viscous strain than the instantaneous elastic strain for the samples tested indicated that rough rice kernel behaved as a viscoelastic body characterized by elasticity than viscosity.

• 한국지반환경공학회 논문집
• /
• 제1권1호
• /
• pp.35-42
• /
• 2000

매립지의 침하특성들은 위생매립장을 설계할 때 뿐만 아니라 쓰레기매립토를 복원하는 과정에서도 반드시 고려해야 할 사항들이다. 매립지의 침하를 예측하는 여러 방법들이 연구되었는데 이들 중 특히 Gibson and Lo 모델과 Power Creep Law 방법들은 침하량이 크고 이차압축이 현저하게 나타나는 매립장에 잘 부합된다. 따라서 Gibson and Lo 모델과 Power Creep Law 방법에 사용되는 매개변수들이 유기물함량에 따라 어떠한 변화를 보이는지 대형압밀시험기를 이용하여 관찰하였다. 유기물함량이 각각 20%, 40%, 60%이고 압밀하중을 $0.1{\sim}1.6kg/cm^2$로 가했을 때 Power Creep Law의 m(기준압축성)은 압밀하중의 증가에 따라 감소하였으며, 그 감소율이 유기물함량 증가량에 따라 증가하는 것으로 나타났다. 그리고 현장계측치에 의한 침하량분석결과 Gibson and Lo model보다는 Power Creep Law에 의한 침하예측이 본 현장과 부합되는 것으로 나타났다.

• Geomechanics and Engineering
• /
• 제28권2호
• /
• pp.171-180
• /
• 2022

Time-dependent stress-strain behaviour significantly influences the compressibility characteristics of the clayey soil. In this paper, a series of oedometer tests were conducted in two loading patterns and investigated the time-dependent compressibility characteristics of Indian Montmorillonite Clay, also known as black cotton soil (BC) soil, during loading-unloading stages. The experimental data are analyzed using a new non-linear function of the Elasto-Visco-Plastic Model considering Swelling behaviour (EVPS model). From the experimental result, it is found that BC soil exhibits significant time-dependent behaviour during creep compared to the swelling stage. Pore water entrance restriction due to consolidated overburden pressure and decrease in cation hydrations are responsible factors. Apart from it, particle sliding is also evident during creep. The time-dependent parameters like strain limit, creep coefficient and C_αe/C_c are observed to be significant during the loading stage than the swelling stage. The relationship between creep coefficients and applied stresses is found to be nonlinear. The creep coefficient increases significantly up to 630 kPa-760 kPa (during reloading), and beyond it, the creep coefficient decreases continuously. Several parameters like loading duration, the magnitude of applied stress, loading history, and loading path have also influenced secondary compressibility characteristics. The time-dependent compressibility characteristics of BC soil are presented and discussed in detail.

• 소성∙가공
• /
• 제13권2호
• /
• pp.160-167
• /
• 2004

In order to theoretically analyze the creep behavior of high Cr steel at $600^{\circ}C$, a unified elasto-viscoplastic constitutive model based on the consideration of dislocation density is proposed. A combination of a kinetic equation describing the mechanical response of a material at a given microstructure in terms of dislocation glide and evolution equations for internal variables characterizing the microstructure provides the constitutive equations of the model. Microstructural features of the material such as the grain size and spacing between second phase particles are directly implemented in the constitutive equations. The internal variables are associated with the total dislocation density in a simple model. The model has a modular structure and can be adjusted to describe a creep behavior using the material parameters obtained from uniaxial tensile tests.

• 한국정밀공학회지
• /
• 제21권2호
• /
• pp.168-176
• /
• 2004

Interrupted creep tests were carried out on the Mod.9Cr-1Mo steel in order to investigate the structural degradation during creep. The ranges of creep stress and temperature were from 71 to 167MPa and 873 to 923k, respectively. The change of hardness and tempered martensitic lath width were measured in the grip and gauge parts of interrupted specimens. The lath structure was thermally stable in static conditions, but was not stable during creep, and the structural evolution was enhanced by creep strain. The relation between the change in lath width and strain was described in the from, $\delta$W= a ($W_s-W_o$)$cdot;varepsilon$, where $\varepsilon$ is the strain, $W_o$is the initial lath width, $W_s$ is the final lath width depending solely on stress, and a is the constant of the magnitude of 0.67 $\mu$m /strain. The change in Victors hardness was expressed by a one-valued function of creep life consumption ratio. Based on the empirical relation between strain and lath width, a model was proposed to explain the relation between change in hardness and creep life consumption ratio. The model revealed that about 65$%$ of dislocations in lath structures were eliminated by the migration of subboundaries.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1999년도 학회창립 10주년 기념 1999년도 가을 학술발표회 논문집
• /
• pp.285-288
• /
• 1999

Creep is a major parameter to represent long-term behavior of concrete structures concerning serviceability and durability. The effect of creep is recently taking account into crack resistance analysis of early-age concrete concerning durability evaluation. Since existing creep prediction models were proposed to predict creep for hardened concrete, most of them cannot consider effectively the information on microstructure formation and hydration developed in the early-age concrete. In this study, creep tests for early-age concrete made of the type I cement and the type V cement are carried out respectively and creep prediction models are evaluated for the prediction of creep behavior in early-age concrete. A creep prediction model is modified for the prediction of creep in early-age concrete and also verified by comparing prediction results with results of creep tests on early-age concrete.