• International Journal of Automotive Technology
• /
• 제5권4호
• /
• pp.311-319
• /
• 2004

There are many methods to test engine emissions depending on the regulations used such as FTP-75(CYS-75) mode, 10-15 mode and ECE-15 mode. Most of these modes consist of transient conditions such as cranking, rapid acceleration or deceleration modes. In this experimental research, the transient characteristics including cranking and accelerating mode in SI engines were studied to compare pure gasoline with methanol-reformulated fuels for performance and exhaust emissions. The results show that methanol-reformulated fuels have a better emissions reduction rate than that of pure gasoline especially for HC, CO and NOx emissions during cranking mode. The acceleration performances conform to the results of the distillation curve and the CO concentration for RM50 varies slightly in acceleration mode.

• 대한기계학회논문집B
• /
• 제25권9호
• /
• pp.1193-1200
• /
• 2001

There are many regulation test methods to be related with engine emissions such as CVS-75, D-13, ECE-15 modes and so on. Most of these modes are consisted of lots of transient conditions that have rapid acceleration, deceleration and cranking modes. In this experimental research, the engine characteristics of cranking, accelerating and power output in a S.I. engine were studied to compare with neat gasoline and alternative fuels of M30 (methanol 30%, aromatic series 32%, non-aromatic 38%) and M50 (methanol 50%, aromatic 30%, non-aromatic 20%) for performance and exhaust emissions. The results show that reformulated methanol fuels are better emissions reduction of 15.7% over than that of neat gasoline fuel especially in HC and CO emissions at cranking mode. And the accelerating performances coincide with the results of distillation curve. CO concentration for M50 fuel is varied in a just little for the condition of slow acceleration. At wide-open throttle condition, brake specific energy consumption of reformulated fuels is increased and thermal efficiency is some what lower than that of gasoline fuel.

• 동력기계공학회지
• /
• 제14권2호
• /
• pp.12-15
• /
• 2010

It is requested to shorten the starting duration for idle stop function equipped cars without harmful effects on the environment. Higher cranking speeds can be achieved with high torque starter. The object of this study is to develope the high torque starter and evaluate its effect on the exhaust emissions. The test was conducted on a 1.5 L, 4-cylinder, 16 valve, multipoint-port-fuel-injection gasoline engine. Engine out emissions such as HC, CO, $CO_2$, and the excess air ratios, lambda were measured using MEXA-554JK. The result showed that a high torque starter, HTS-II shortened the starting duration and reduced engine out emissions of HC, CO and improved starting performance with larger excess air ratio than that of the original starter, Org. S and a high torque starter, HTS-I.

• 한국운동역학회지
• /
• 제13권1호
• /
• pp.109-119
• /
• 2003

The purpose of this study was to investigate differences of the mechanical efficiency on the characteristics of the basketball wheelchairs(cambers & size of the handrims). Nine healthy and normal wheelchair basketball players who had no impairments to their upper extremities were volunteered to participate in this study. $VO_2$ was collected using automatic gas analyzer(vmax29). Gross efficiency, net efficiency and work efficiency were analyzed from the calculated external power output and energy expenditure. The results were followed. First, gross efficiency in the basketball wheelchairs was observed across the range from 4 to 10%. Gross efficiency in this study showed less values than that from the literature reviewed in the arm cranking(15%), racing wheelchair(above 30%), gait(27%) and cycling(18-23%). Second, the small size of handrim(61cm) at the 16 degrees of camber produced higher efficiency values than the large size of handrim(66cm) whereas the different sizes of handrim at the 20 degrees of camber did not show any pattern. Third, both faster speed($1.11^m/s{\rightarrow}1.39^m/s$) and increases in treadmill inclination produced increases in energy expenditure. The results of this study may provide not only better understanding of the mechanical efficiency with adequate camber degree and proper size of handrim but also fundamental information for manufacturing the wheelchair.

• Journal of Power Electronics
• /
• 제9권1호
• /
• pp.51-60
• /
• 2009

Hybrid Electric Vehicles (HEVs) utilize electric power as well as a mechanical engine for propulsion; therefore the performance of HEV s can be directly influenced by the characteristics of the Energy Storage System (ESS). The ESS for HEVs generally requires high power performance, long cycle life and reliability, as well as cost effectiveness. So the Hybrid Energy Storage System (HESS), which combines different kinds of storage devices, has been considered to fulfill both performance and cost requirements. To improve operating efficiency, cycle life, and cold cranking of the HESS, an advanced dynamic control regime with which pertinent storage devices in the HESS can be selectively operated based on their status was presented. Verification tests were performed to confirm the degree of improvement in energy efficiency. In this paper, an advanced HESS with improved an Battery Management System (BMS), which has optimal switching control function based on the estimated State of Charge (SOC), has been developed and verified.

• Tribology and Lubricants
• /
• 제30권3호
• /
• pp.189-198
• /
• 2014

This paper presents the results of an experimental investigation of the correlation between the lubrication characteristics of an engine and its fuel economy. Improving the lubrication characteristics of the engine oil is one of the most efficient ways to improve a car's fuel economy. The methods to accomplish this include lowering the viscosity, adding a friction modifier and optimizing the shear stability index of a viscosity index improver. In addition, it is necessary to use different methods to reduce the friction to individual lubrication areas, because different lubrication regimes are used for different engine parts. The experimental investigation in this study is based on design of experiments ; this paper presents the results of a modified Sequence VID test, which is an ASTM standard test used to measure the effects of automotive engine oils on the fuel economy of passenger cars. The results demonstrate the effects of the following lubrication factors on the fuel economy : the low temperature cranking viscosity, high-temperature high shear (HTHS) viscosity, friction modifier, polymer type and shear stability index of the viscosity index improver. Moreover, this study involves an analysis of variance based on design of experiments. The test results show that the HTHS viscosity, friction modifier and shear stability index of the viscosity index improver are more effective than the other factors. Therefore, lowering the viscosity, adding a friction modifier and optimizing the shear stability index of a viscosity index improver should be considered to improve fuel economy.

• 공업화학
• /
• 제28권6호
• /
• pp.714-719
• /
• 2017

연료가 혼합된 엔진오일은 차량의 문제(엔진마모, 화재, 급발진 등)를 초래하여, 운전자의 안전을 위협할 수 있다. 본 연구에서는 연료가 혼합된 엔진오일의 다양한 성능을 분석하였다. 분석결과, 연료혼합 엔진오일은 인화점, 유동점, 밀도, 동점도, 저온 겉보기점도가 낮아졌다. 사구법 내마모성능시험에서는 연료가 혼합된 엔진오일이 열악한 윤활성으로 마모흔(wear scar)이 증가하였다. 또한 우리 연구팀은 ASTM D2887 방법을 적용한 고온모사증류시험(SIMDIST, simulated distillation)을 통해 엔진오일 내 연료성분을 분석하였다. SIMDIST 분석결과 연료는 엔진오일보다 짧은 머무름시간을 보였으며, 엔진오일 내 연료성분의 정량분석이 가능하였다. 이 SIMDIST 분석방법을 통해 기존 많은 분석장비, 시료양, 분석시간이 필요한 물성분석법을 대신하여 엔진오일 내 연료 오염여부 및 정도를 효과적으로 판단할 수 있을 것이다.

• 에너지공학
• /
• 제22권2호
• /
• pp.237-244
• /
• 2013

엔진오일은 다양한 내연기관의 윤활을 위한 가장 기본적인 윤활제이다. 최근 자동차사 및 엔진오일 제조사 등은 엔진오일의 교환주기를 15000~20000 km를 권장하고 있는 반면, 대부분의 정비관련업자 및 운전자들은 엔진오일의 성능진보와는 별개로 관습적으로 매5000 km 마다 엔진오일을 교환권유 또는 인식하고 있다. 빈번한 엔진오일의 교환은 폐엔진오일로 인한 환경오염과 차량 유지비 등의 증가요인으로 대두되고 있다. 따라서 본 연구에서는 신유와 실제 운행조건의 차량을 활용하여 5000 km, 10000 km를 각각 주행한 후 회수된 사용엔진오일의 다양한 물성으로 인화점, 유동점, 동점도, 저온겉보기점도, 전산가, 4구식 내마모시험 및 금속분을 조사 분석하였다. 결과적으로 사용엔진오일은 신유에 비해 전산가, 마모흔, 철과 구리 성분 증가가 다소 관찰되었지만, 주행거리별 사용엔진오일의 물성 및 금속분 변화는 거의 유사하였다.