• Journal of environmental and Sanitary engineering
• /
• v.23 no.3
• /
• pp.47-57
• /
• 2008

This study was predicted the diffusion of the conservative contaminant using a two-dimensional hydraulic model. The research area is upper basin of Jakwang river where the possibility where the pollutant of vast quantity will flow is high. Using SMS model, we calculated two-dimensional stream flow. And using this result, predicted the conduct of the conservative contaminant by pollutant transfer diffusion calculation. And also we predicted flow and contaminant diffusion in the near estuary by constructed guide bank. As a result of study, pollutant effect scope of the conservative contaminant was predicted with the fact that will broaden because of interception by guide bank. As discharge was increased from the Jakwang river, The diffusion of the pollutant is accelerated, also the effect scope increases.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.09a
• /
• pp.327-330
• /
• 2002

In this study, analyses of contaminant transport are peformed to evaluate the diffusion effect of A sewage tunnel. First, Crank's analytical method is used to measure the concentration change of contaminant with time and space. Two dimensional numerical analysis is performed to measure concentration distribution of contaminant. Both methods show that the diffusion effect is little even after 500 years. This means that when flow converges into the tunnel, the environmental effect of contaminant in tunnel is not serious because there is no advection occurs.

• Wind and Structures
• /
• v.3 no.1
• /
• pp.11-21
• /
• 2000

This paper presents results of modeling of the passive contaminant diffusion from a continuous line finite-size source located on the underlying surface of a neutral near-ground atmospheric layer obtained by using the non-local two-parameteric turbulence model and the transport equation of mean concentration. In the proposed diffusion model the turbulent diffusion coefficient changes not only with the vertical coordinate but also with the distance downstream from the source according to the experimental data. The results of the modeling reproduce structural features of the concentration field.

• Journal of Soil and Groundwater Environment
• /
• v.8 no.1
• /
• pp.35-41
• /
• 2003

Laboratory procedures are available for estimating contaminant migration from sediment into caps by diffusion, but diffusion may not be the major process affecting capping effectiveness. Movement of contaminated pore water from sediment into caps due to sediment consolidation during and after cap placement may be much more significant than contaminant diffusion into caps. To verify this phenomenon, model tests were conducted by utilizing a research centrifuge. In this study, test was modeled for 22.5 hours at 100 g, which modeled a contaminant migration time of 25 years for a prototype that was 100 times larger than the centrifuge model. Centrifuge test results illustrate that advection and dispersion due to consolidation are dominating the migration of contaminants.

• Journal of Ocean Engineering and Technology
• /
• v.24 no.4
• /
• pp.78-85
• /
• 2010

This study investigates reducing characteristics for the spreading of dredged soil and the diffusion of contaminant by silt protector curtain through three dimensional numerical experiment. The numerical medel is modified by combining the sediment transport characteristics for cohesive sediment into the previously developed model. Several numerical experiments have been given in order to investigate the reducing effect of silt protector using two dimensional numerical channel model under various parameters such as upstream flow velocity, depth of silt curtain and the position of dumped materials. Through the evaluation of several simulation results, we knew that the careful design has to be given in the determination of depth and position of silt protector.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.20 no.4
• /
• pp.252-259
• /
• 2008

The purpose of this study is to estimate the movement of microbial contaminant caused by bio-attack using bio-agent such as bacillus anthracis for preventing contaminant diffusion. multizone simulation was carried out in the case of three types of bio-attack scenario in the government building. Simulation results show that severe contaminant diffusion is brought about in all cases of bio-attack scenario in one hour, though pollution boundaries have different mode according to bio-attack scenarios. Simulation results also show that immune building technology such as filter and UVGI technology gives us powerful alternatives to meet the emergent situation caused by unexpected bio-attack.

• Advances in environmental research
• /
• v.4 no.3
• /
• pp.183-196
• /
• 2015

Migration of leachate generated through embankment of construction waste soil (CWS) in low-lying areas was studied through physical and chemical analysis. A leachate solution containing soluble cations from CWS was found to have a pH above 9.0. To determine the distribution coefficients in the alkali solution, column and migration tests were conducted in the laboratory. The physical and chemical properties of CWS satisfied environmental soil criteria; however, the pH was high. The effective diffusion coefficients for CWS ions fell within the range of $0.725-3.3{\times}10^{-6}cm^2/s$. Properties of pore water and the amount of undissolved gas in pore water influenced advection-diffusion behavior. Contaminants migrating from CWS exhibited time-dependent concentration profiles and an advective component of transport. Thus, the transport equations for CWS contaminant concentrations satisfied the differential equations in accordance with Fick's 2nd law. Therefore, the migration of the contaminant plume when the landfilling CWS reaches water table can be predicted based on pH using the effective diffusion coefficient determined in a laboratory test.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.1
• /
• pp.35-40
• /
• 2011

Dredging and disposal is a conventional method to remove contaminated sediments. However, there are some problems in dredging and disposal, such as disturbance of contaminated sediments, disposal site determination, and high construction cost. Recently, in-situ capping which overcomes the problems of dredging and disposal is widely applied to isolate local contaminated sites. Numerical studies, which have been conducted to simulate contaminant transport during in-situ capping, have been concerned mainly with diffusive transport. However, contaminated sediments experience large strain consolidation induced by self-weight because of initially high moisture content of sediments, and contaminant transport results from advection and diffusion. Previous studies focus on contaminant transport during consolidation, but have neglected consolidation effect on long-term contaminant transport in sediments. This study presents numerical simulation results of consolidation effect on long-term contaminant transport in sediments.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.8
• /
• pp.1124-1131
• /
• 2011

This study performed the prediction about the indoor contaminant's diffusion characteristics which can be affected by the mechanical ventilation system on a training ship. The results are as followings. It is clear that the contaminants are spread to most of the indoors, regardless of the contamination beginning zone. About 65~100 minutes later, the contaminant densities of whole indoor zones are evaluated as clean. Comparing the contamination beginning zone being located at higher deck(scenario A) to the contamination beginning zone being located at lower deck(scenario B), although the contaminant density by scenario A is 10 times higher than that by scenario B, the number of contaminated zones are 50% less. The contaminant densities are evaluated as to be rapidly decreased when the outside air induction ratio against design volume is over 75%.

• Proceedings of the SAREK Conference
• /
• 2006.06a
• /
• pp.311-318
• /
• 2006

CFD simulation is a tool very useful to predict the generation and absorption of the contaminant from the construction materials for the single room condition. However, there is a limit in multi-room simulation for analyzing air movement and contaminant concentration at the condition that the door of each room was closed. A lot of network simulation tool were developed which can used to analyze the mass transfer and contaminant concentration as results in the multi-room condition. However, existing network simulation method was not able to analyze the change of the heating and cooling load with the ventilation as though the change of the indoor air-pollution density was predictable. In this study, new approach to predict heating/cooling load and indoor contaminant concentration will be reviewed. New indoor contaminant concentration module reviewed in this study wad coupled with existing ESP-r network simulation method. The validity of new approach will be analysed for comparison the results of simulation and field measurement results.