• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2007년도 추계학술대회논문집
• /
• pp.178-188
• /
• 2007

In this paper, a half-scaled substructure test was performed to evaluate the buckling and structural safety of an existing transmission tower subjected to wind load. A loading scheme was devised to reproduce the dead and wind loads of a prototype transmission tower, which uses a triangular jig that is mounted on the reduced model to which the similarity law of a half length was applied. As a result of the preliminary numerical analysis carried out to evaluate the stability of a specimen for the design load, it was confirmed that the calculated axial forces of tower leg members were distributed to $80{\sim}90%$ of an admissible buckling load. When the substructured transmission tower was loaded by 270% of its maximum admissible buckling load, it was failed due to the local buckling that is occurred in joints with weak constraints for out-of-plane behavior of leg members. By inspection of load-displacement curves, displacements and strains of members, it is considered that this local buckling was due to additional eccentric force by unbalanced deformation because the time that is reached to yielding stress due to the bending moment is different at each point of a same section.

• 대한전기학회논문지:전력기술부문A
• /
• 제51권8호
• /
• pp.398-402
• /
• 2002

The ELD computation has been based upon the so-called B-coefficient which uses a quadratic approximation of system loss as a function of generation output. Direct derivation of system loss sensitivity based on the Jacobian-based method was developed in early 1970s', which could eliminate the dependence upon the approximate loss formula. However, both the B-coefficient and the Jacobian-based method require a complicated Procedure for calculating the system loss sensitivity included in the constraints of the optimization problem. In this paper, an ELD formulation in which only the bus power equations are defined as the constraints has been introduced. Derivation of the partial derivatives of the system loss with respect to the generator output and calculation of the penalty factors for individual generators are not required anymore in proposed method. A comprehensive solution procedure including calculation of the Jacobians and Hessians of the formulation has been presented in detail. Proposed ELD formulation has been tested on a sample system and the simulation indicated a satisfactory result.

• 대한전기학회논문지:전력기술부문A
• /
• 제50권10호
• /
• pp.480-488
• /
• 2001

This paper presents a technique that can obtain an optimal solution for the Security-Constrained Economic Dispatch (SCED) problems using the Interior Point Method (IPM) while taking into account of the power flow constraints. The SCED equations are formulated by using only the real power flow equations from the optimal power flow. Then an algorithm is presented that can linearize the SCED equations based on the relationships among generation real power outputs, loads, and transmission losses to obtain the optimal solutions by applying the linear programming (LP) technique. The objective function of the proposed linearization algorithm are formulated based on the fuel cost functions of the power plants. The power balance equations utilize the Incremental Transmission Loss Factor (ITLF) corresponding to the incremental generation outputs and the line constraints equations are linearized based on the Generalized Generation Distribution Factor (GGDF). Finally, the application of the Primal Interior Point Method (PIPM) for solving the optimization problem based on the proposed linearized objective function is presented. The results are compared with the Simplex Method and the promising results ard obtained.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 학술대회 논문집 정보 및 제어부문
• /
• pp.388-390
• /
• 2004

In this paper, we performed the implementation of image transmission server system using embedded system that is for the specified object and easy to install at any places and move to wherever. Since the embedded system has lower capability than PC, we have to reduce the quantity of calculation and transmission. The image compression like JPEG, needs that the server calculates for making compressed image, makes the server carry the load. So we compresses the image at the server and transmit the codes to the clients connected, then the received codes from server are decoded and displayed at the clients. In this process to make the image compression and transmission effectively, we decrease the procedure as simple as possible to transmit the data in almost real-time. We used the Redhat linux 9.0 OS at the host PC and the target board based on embedded linux. The image sequences are obtained from the camera attached to the FPGA board with ALTERA chip. For effectiveness and avoiding some constraints, we made the device driver. Generally the image transmission server is PC, but using the embedded system as a server makes the server portable and cheaper than the system based on PC.

• International journal of advanced smart convergence
• /
• 제1권2호
• /
• pp.34-38
• /
• 2012

The recent increase in use of the IEEE 802.15.4 standard for wireless connectivity in personal area networks makes of it an important technology for low-cost low-power wireless personal area networks. Studies showed that voice communications over IEEE 802.15.4 networks is feasible by Guaranteed Time Slot (GTS) allocation; but there are some constraints to accommodate voice transmission beyond two hops due to the excessive transmission delay. In this paper, we propose a GTS allocation scheme for bidirectional voice traffic in IEEE 802.15.4 multihop networks with the goal of achieving fairness and optimization of resource allocation. The proposed scheme uses a greedy algorithm to allocate GTSs to devices for successful completion of voice transmission with efficient use of bandwidth while considering closest devices with another factor for starvation avoidance. We analyze and validate the proposed scheme in terms of fairness and resource optimization through numeral analysis.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 C
• /
• pp.1111-1113
• /
• 1998

A robust economic dispatch algorithm involving transmission losses is proposed and investigated for a possibility of on-line applications. In this paper, the penalty factors are calculated directly from transposed Jacobian of load flow analysis with advantages of superiority to B-coefficients method based on its computation time and suitability for real time application since the approach is based on a current system condition. The proposed algorithm is systematically handling the generation capacity constraints with transmission losses. Implementation of the algorithm for IEEE systems and EPRI Scenario systems shows that computation time is enough to apply on-line economic dispatch to large power system and production cost is saved compared with the crude classical economic dispatch algorithm without considering transmission losses.

• 한국멀티미디어학회논문지
• /
• 제8권9호
• /
• pp.1216-1226
• /
• 2005

본 논문에서는 동적 대역 할당이 가능한 네트워크에서 라이브 비디오의 고화질 전송을 위한 예방형 전송률 결정 방식을 제안한다. 부호기 앞단의 화면 분석기에서 입력 화면의 분산과 장면전환 정도로부터 향후 화면의 비트율을 예측하고, 부호기와 복호기 버퍼의 제약조건에 의한 전송률 범위를 구한다. 이를 토대로 빈번한 전송률 재협상에 따른 비용 증가 문제를 해결하기 위해 최근 재협상 시점으로부터 경과 시간, 비디오 수신 품질 등을 고려한 예방형 전송률 결정 방식을 제안한다. 모의실험을 통해 제안 방식은 정규화된 Least Mean Square 기반 전송률 결정 방식과 비교되었고, 적은 재협상 비용으로도 지연 위반 화면 없이 높은 채널 이용률 달성이 가능함을 보였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 A
• /
• pp.46-49
• /
• 2003

This paper proposes a method to solve expansion problem for a transmission network, given future generation and load strategy, and alternative types of lines available, subject to load, reliability and right of way constraints, the problem is formulated as a series of zero one integer programs which are solved by an efficient branch and bound algorithm A study test result on the 63-buses test system shows that the proposed method is practical and efficiently applicable to the transmission expansion planning.

• 한국산학기술학회논문지
• /
• 제4권3호
• /
• pp.242-247
• /
• 2003

본 논문은 유전자 알고리듬을 이용하여 자동차 부품인 자동변속레버의 최적 설계 방법론에 대한 연구이다. 현재 업계에서의 자동변속레버는 구성 부품들을 순서적으로 설계하고 있으나, 본 연구에서는 구성 부품들의 설계 파라미터들을 동시에 고려하여 설계할 수 있는 새로운 방법론을 제안한다. 유전자 알고리듬 접근방법은 자동변속레버의 최적 설계 파라미터 집합을 결정하기 위해 적용된다. 본 연구에서는 자동변속레버의 구성 부품들로 구성된 제약조건하에 디텐트 스프링의 각 변위를 최소화하는 목적함수를 가지는 설계 문제를 모델링하였고, 유전자 알고리듬을 적용하여 최적 설계를 수행하였다.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제7권2호
• /
• pp.184-201
• /
• 2013

In this paper, we study the problem of designing the power and number of cooperative node (CN) in the cooperation phase to maximize the average throughput for secondary user (SU), under the constraint of the total cooperation and transmission power. We first investigate the scheme of cooperative spectrum sensing without a separated control channel. Then, we prove that there indeed exist an optimal CN power when the number of CNs is fixed and an optimal CN number when CN power is fixed. The case without the constraints of the power and number of CN is also studied. Finally, numerical results demonstrate the characteristics and existences of optimal CN power and number. Meanwhile, Monte Carlo simulation results match to the theoretical results well.