• 한국재료학회지
• /
• 제12권2호
• /
• pp.160-165
• /
• 2002

High-frequency dielectric and microwave absorbing properties have been investigated in ferroelectric materials (BaTiO$_3$(BT), (1-x)Pb$Mg_{\frac{1}{3}}Nb_{\frac{2}{3}}$)O$_3$-xPbTiO$_3$(PMN-PT), (1-x)Pb$Mg_{\frac{1}{3}}Nb_{\frac{2}{3}}$O$_3$-xPb(Zn_{\frac{1}{3}}Nb_{\frac{2}{3}}$)O$_3$(PMN-PZN) for the aim of thin microwave absorbers in the frequency range of mobile telecommunication. The specimenns are prepared by conventional ceramic processing and complex permittivity has been measured by transmission/reflection method. The ferroelectric materials show high dielectric constant and dielectric loss in the microwave range and their domiant loss mechanism is considered to be domain wall relaxation. The microwave absorbance of BT 0.9PMN-0.1PT, and 0.8PMN-0.2PZN specimen (determined at 2) are found to be 99.5% (at a thickness of 4.5 mm), 50% (2.5 mm), and 30% (2.5 mm), respectively. It is suggested that PMN-PT or PMN-PZN ferroelectrics are good candidate materials for the spacer of λ/4 absorber. The use of ferroelectric materials is effective in reducing the thickness of absorber with their advantage of high dielectric constant.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 춘계학술대회 논문집 전자세라믹스 센서 및 박막재료 반도체재료 일렉트렛트 및 응용기술
• /
• pp.84-87
• /
• 2000

The microwave dielectric properties of complex perovskite-structured $Ba(Mg_{1/3}Ta_{2/3})O_3$ ceramics were investigated with calcining condition. The BMT ceramics were prepared by conventional mixed oxide method. Calcining conditions were $1200^{\circ}C$ for 10hr., $1300^{\circ}C$ for 2hr., and 5hr., respectively. And the specimens were sintered at $1650{\mu}m$. The structural and microwave properties of BMT ceramics were investigated by XRD, SEM and network analyzer. In the case of BMT ceramics calcined at $1300^{\circ}C$ for 5 hr., dielectric constant, quality factor and temperature coefficient of resonant frequency were 20.26, 31,144(at 1GHz), 6.11[ppm/$^{\circ}C$], respectively.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제51권8호
• /
• pp.335-339
• /
• 2002

Ba(Mgl-xCox)TaO3[BMCT] ceramics were prepared by the conventional mixed oxide method. The ceramics were sintered at the temperature of 1525~$1625^{\circ}C$ for 5hr. in air. The crystal structure of BMCT ceramics was investigated by the XRD. The microstructure of the specimens were observed by SEM. The Microwave dielectric properties of BMCT specimens were investigated as a function of composition and sintering temperature. All BMCT ceramics sintered over 1575$^{\circ}C$ were showed a polycrystalline complex perovskite structure. The density of BMCT (90/10) specimen sintered at $1575^{\circ}C$ was 7.75g/㎤. As the Co contents decreased, the ordering parameter of B-site in BMCT increased. In the case of the BMCT(90/10) ceramics sintered at $1575^{\circ}C$ for 5 hours, dielectric constant, quality factor and temperature coefficient of resonant frequency for microwave dielectrics application were a good value o( 25, 17, 845 at 10㎓ and +2.4 ppm/${\circ}$, respectively.

• 한국해양환경ㆍ에너지학회지
• /
• 제15권1호
• /
• pp.19-21
• /
• 2012

내연 기관의 엔진오일은 열화작용에 의해서 수명이 짧아지고 대기오염을 유발하게 된다. 엔진오일의 상태를 정확히 측정하여 새오일로 교환함으로 엔진의 수명 연장 및 환경오염을 줄일 수 있다. 정전용량 프로브는 엔진오일과 같은 유체의 유전율을 측정하는데 사용 할 수 있다. 본 논문은 엔진 오일의 열화 정도에 따라서 달라지는 유전율 특성을 분석하였다. 오일의 상태에 따라서 달라지는 프로브의 정전용량을 각각 LCR Meter로 측정하여 엔진오일의 유전율을 계산하였다. 또한, 프로브의 크기에 따른 정전용량의 변화를 측정하여 유전율 측정의 정확도를 제시한다. 오염된 오일 일수록 유전율이 증가하며, 유전율로 오일의 오염정도를 판단하는 것이 가능하다.

• E2M - 전기 전자와 첨단 소재
• /
• 제9권6호
• /
• pp.572-577
• /
• 1996

Alternating current and direct current of pure, ball milled, and $Al_{2}$O$_{3}$ added ZnO were investigated by means of complex impedance measurement and voltage-current source measurement unit. The electrical conductivity of A1$_{2}$O$_{3}$ added ZnO samples increases when the content of A1$_{2}$O$_{3}$ is used within 1 at% and decreases when it's used more than that. The increase and decrease of electrical conductivity seem to be the donor effect of $Al_{2}$O$_{3}$ and the increase of the number of ZnO grains, respectively. Impedance spectrum seems to be one semircicle. The size of semicircle increase with increasing the A1$_{2}$O$_{3}$ contents. The calculated dielectric constant(at 50.deg. C) were about 70-140 at the peak of the semicircle. The semicircles seem not to be the resistance of ZnO grain as compared to that of 10 for pure ZnO.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 하계학술대회 논문집
• /
• pp.198-198
• /
• 2010

The low-k SiOCH thin films were prepared by CCP-PECVD method using BTMSM(Bis-trimethylsilylmethane) precursors deposited on p-Si wafer. The structural complexity originate the complex refractive constants of the films, and resulted the elliptical polarization of the incident linearly polarized light source of Xe-ramp in the range from 190nm to 2100nm. Phase difference and amplitude ratio between s wave and p wave propagating through SiOCH thin film was studied. After annealing, the amplitude of p wave was reduced more than s wave, and phase difference between p and s wave was also reduced.

• ETRI Journal
• /
• 제31권6호
• /
• pp.667-674
• /
• 2009

Terahertz time-domain spectroscopy has been used to study the optical and dielectric properties of three chalcogenide glasses: $Ge_{30}As_8Ga_2Se_{60}$, $Ge_{35}Ga_5Se_{60}$, and $Ge_{10}As_{20}S_{70}$. The absorption coefficients ${\alpha}({\nu})$, complex refractive index n(${\nu}$), and complex dielectric constants ${\varepsilon}({\nu})$ were measured in a frequency range from 0.3 THz to 1.5 THz. The measured real refractive indices were fitted using a Sellmeier equation. The results show that the Sellmeier equation fits well with the data throughout the frequency range and imply that the phonon modes of glasses vary with the glass compositions. The theory of far-infrared absorption in amorphous materials is used to analyze the results and to understand the differences in THz absorption among the sample glasses.

• Tribology and Lubricants
• /
• 제27권3호
• /
• pp.156-161
• /
• 2011

The rectangular waveguide technique can be used to measure the complex permittivity of dielectric material of various thickness and cross section. This paper presents the analysis system of engine oil permittivity at which deterioration of engine oil is measured at the X-band(8-12.5 GHz). The middle of the rectangular waveguide has engine oil case and is connected with VNA(Vector Network Analyzer) for the measurement of the transmission$(S_{21})$ and reflection$(S_11)$ and then the permittivity is extracted. The deterioration of engine oil is proved by the comparison with both the extracted data and reference data. As the additional research, This paper suggest that an accurate permittivity is considered by not only the wave guide length but the air gap between oil case and the waveguide.

• Tribology and Lubricants
• /
• 제27권4호
• /
• pp.209-212
• /
• 2011

The capacitive application(prove) can be used to measure the complex permittivity of dielectric material of various thickness and cross section. This paper presents that we designed the analysis system of engine oil permittivity to know the relation between the engine oil deterioration and the prove dimension. Each of the dimension of capacitive prove is changed and then electric capacity is measured by LCR {Inductance(L), Capacitance (C), and Resistance (R)} meter. The engine oil permittivity has extracted in the prove measurement. As the additional research, this paper suggest the best of the prove dimension for the permittivity measurement.

• 한국정보통신학회논문지
• /
• 제4권2호
• /
• pp.357-363
• /
• 2000

가시거리 환경에서 수신 전계강도는 반사매질의 전기적 특성에 의해 변화한다. 매질의 전기적 특성을 구하기 위해 안테나의 편파특성에 대한 반사계수 식과 매질에 대한 복소 유전상수의 관계식을 유도하고 수신전력 식을 이용하여 반사계수와 송수신전력의 관계를 원의 방정식으로 표현하였다. 그리고 측정된 전계강도로부터 매질의 전기적 특성을 구하는 알고리즘을 제시하였다.