• Journal of Environmental Science International
• /
• v.13 no.3
• /
• pp.279-288
• /
• 2004

This study aimed at improving the $TiO_2$ photocatalytic degradation of HA. A set of tests was first conducted in the dark to study the adsorption of HA at different coexisting material concentration. Adsorption rate increased with adding cation ion but decreased with adding bicarbonate ion. The photodegradation of HA in the presence of UV irradiation was investigated as a function of different experimental condition: initial concentration of HA, $TiO_2$ weight, pH, air flow rate and coexisting material. It was increased either at low pH or by adding cation ion. The increase of cation strength in aqueous solution could provide a favorable condition for adsorption of HA on the $TiO_2$ surface and therefore enhance the photodegradation rate. It was found that bicarbonate ions slowed down the degradation rate by scavening the hydroxyl radicals.

• Journal of Korean Society on Water Environment
• /
• v.21 no.1
• /
• pp.14-20
• /
• 2005

A feasibility study has been conducted regarding the application of waste coffee grounds as an adsorbent for the treatment of nickel ion containing wastewater. The major variables which considered to influence the adsorbability of nickel ion were its initial concentration, reaction temperature, pH, and coexisting ion. The specific surface area of coffee grounds used in the experiment was found to be ca. $39.67m^2/g$, which suggesting its potential applicability as an adsorbent due to its relatively high surface area. In the experimental conditions, more than 90% of the initial amount of nickel ion was shown to adsorb within 15 minutes and equilibrium in adsorption was attained after 3 hours. The adsorption behavior of nickel ion was well explained by Freundlich model and kinetics study showed that the adsorption reaction was second-order. Adsorption was reduced with temperature and its change of enthalpy in standard state was estimated to be -807.05 kJ/mol. Arrhenius equation was employed for the calculation of the activation energy of adsorption and nickel ion was observed to adsorb on coffee grounds exoentropically based on thermodynamic estimations. As pH rose, the adsorption of nickel ion was diminished presumably due to the formation of cuboidal complex with hydroxide ion and the coexistence of cadmium ion was found to decrease the amount of nickel ion adsorption, which was proportional to the concentration of cadmium ion.

• Journal of environmental and Sanitary engineering
• /
• v.14 no.1
• /
• pp.42-53
• /
• 1999

A study on the synthesis of zeolite from coal fly ash from power plant was carried out to reduce environmental problems and reuse industrial waste. The synthesized zeolite was proved to be Zeolite 4A type by means of the XRD and SEM analysis, and then the synthesized zeolite was used as an absorbent to remove the $NH_4^+$ ions in the wastewater and water. In the ion exchange of single $NH_4^+$ ions by the natural zeolite and the synthesized zeolite, the ion exchange reached equilibrium within 10 min. and 1hr, respectively. The amount of ion exchanged $NH_4^+$ to the unit weight of natural zeolite and zeolite 4A were 1.09 and 3.54 meq/g respectively, and the amount of $NH_4$ ion exchanged by the synthesized zeolite was higher than by the natural zeolite. The ion exchange kinetics fitted very well to the Feundlich and Langmuir isotherm. The effects of coexisting cations on the ion-exchange properties of zeolites were studied in order to apply them to water treatment. In the bisolute-system of the $NH_4^+-K^+$ and $NH_4^+-Na^+$ systems, the ion exchange capacity was smaller than the single $NH_4^+$ ion system. The effects of coexisting cations on the ion exchange system by the natural zeolite and the synthesized zeolite were found to be $K^+>Na^+$ and $Na^+>K^+>>Mg^{2+}>Ca^{2+}$, respectively.

• Journal of Korean Society on Water Environment
• /
• v.23 no.3
• /
• pp.371-376
• /
• 2007

The features of precipitating reaction of fluorine have been examined under several aquatic conditions by employing calcium ion as a precipitant. Based on MINTEQ program, fluorine was found to exist in the forms of $H_2F_2$ and HF in strong acidic environment and change into $F^-$ with increasing pH. In the experimental condition, the precipitating reaction of fluorine progressed rapidly within a few minutes after the reaction started and reached its equilibrium in 10 minutes. As the addition of precipitant was increased, removal of fluorine by the formation of precipitate was promoted and its was also enhanced by the rise of pH. The precipitating reaction of fluorine was impeded when its initial concentration was low and X-ray analysis showed that the crystalline structure of precipitate was mainly $CaF_2$ with partly NaF. Coexisting phosphate in solution influenced the fluorine removal by impeding the precipitate formation and similar effect was found when metallic ion such as $Zn^{2+}$ was present with fluorine.

• Journal of Korean Society on Water Environment
• /
• v.23 no.3
• /
• pp.314-318
• /
• 2007

The feasibility of the employment of waste oyster shell as an adsorbent for fluoride ion has been tested by considering the effect ionic condition on the adsorption of fluoride ion on oyster shell. The adsorption capacity of oyster shell for fluoride ion was found not to be significantly influenced by the ionic strength of aqueous environment. The existence of complexing agent such as nitrilotriacetic acid in wastewater decreased the adsorbed amount of fluoride ion by forming a stable complex of $CaT^-$ and the adsorption reaction of fluoride ion on oyster shell was examined to be endothermic. The coexisting heavy metal ionic adsorbate in wastewater hindered the adsorption of fluoride ion, however, its adsorbed amount was increased as the particulate size of adsorbent was decreased. Finally, a serial adsorption column test has been conducted for a practical application of adsorption process and the breakthrough of the column adsorption was observed in 22 hours under the experimental condition.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.5
• /
• pp.1309-1313
• /
• 2010

The effects of boronic acid on the fluoride-selective chemosignaling behavior of a merocyanine dye were investigated. In the presence of phenylboronic acid (PBA), N-methylquinolinium-based merocyanine dye displayed fluoride-selective chromogenic signaling behavior over other commonly coexisting anions in the micromolar concentration range. Signaling is produced by a fluoride-induced displacement of the dye from its complex with PBA, resulting in a significant chromogenic signal for the fluoride ion. This signaling was successfully analyzed using a ratiometric analysis of the UV-vis absorption in response to changes in fluoride ion concentration. A PBA substituted with an electron withdrawing group was found to exhibit a more pronounced signal. Polymer-bound PBA also exhibited useful fluoride-selective signaling behavior.

• Resources Recycling
• /
• v.15 no.3 s.71
• /
• pp.58-65
• /
• 2006

The applicability of the waste pulp which produced in the paper recycling process as an adsorbent for the treatment of $Ni^{2+}$ ion in wastewater has been investigated taking the initial concentration of adsorbate, temperature, the amount of adsorbent, and solution pH as the experimental variables. In addition, the effect of the concentration of coexisting solute and pre-treatment of adsorbent on the adsorbability of $Ni^{2+}$ ion were also examined. The electrokinetic potential of waste pulp was observed to be positive below pH 7.8 and negative above this pH. The adsorption reaction of $Ni^{2+}$ ion reached its equilibrium within 4 hours after the reaction was initiated and the adsorbed amount of adsorbate was found to increase with its initial concentration. The adsorbability of $Ni^{2+}$ was raised with temperature so that its adsorption reaction was considered to be exothermic, which was substantiated by thermodynamic calculation. Also, the adsorbed amount of $Ni^{2+}$ was raised with the amount of waste pulp and with pH in the range of pH $3{\sim}6$. This behavior of the adsorption of $Ni^{2+}$ according to the solution pH was well agreed with the electrokinetic characteristics of waste pulp in solution. The amount of coexisting solute was observed to reversely affect on the $Ni^{2+}$ adsorption onto waste pulp under the experimental conditions. With regard to the pre-treatment of adsorbent with NaOH, the adsorbability of $Ni^{2+}$ was increased with the concentration of NaOH to a certain extent. However, it was found to decrease contrarily when the concentration of NaOH became too high.

• Analytical Science and Technology
• /
• v.23 no.5
• /
• pp.429-436
• /
• 2010

The present research evaluates the efficiency of mixed resins between anion exchange resin and active carbon. We expected synergic effect from advantages of both adsorbents. Especially, this research focused on the removal of high cencentrated perchlorate ion from demilitarization solution. The total amount of the adsorbed perchlorate ion is increased considerably with mixed resins between mono functional anion exchange resin and granular active carbon from a single adsorbent. Results demonstated that this process not only improve the efficiency of adsorbing perchlorate, but save the time, space and cost for treating perchlotrate waste solution, because of reducing organic contaminant removing process. The interference effects from coexisting anions are not significant and can successfully applied to real demilitarization sample.

• Journal of Environmental Science International
• /
• v.8 no.4
• /
• pp.491-496
• /
• 1999

Removal of Cu(II), Cr(III) and Pb(II) ions from aqueous solutions using the adsorption process on the loesses has been investigated. Variations of contact time, pH, adsorption isotherms and selectivity of coexisting ions were experimental parameters. pH of KJ and YIK samples diluted to 1% solution, was rearly the same with each value of pH 5.58 and 5.49, and both samples showed weak acidic properties. From chemical analysis, both samples contain remarkably different amounts of ${SiO}_{2}$, ${Al}_{2}O_{3}$ and ${Fe}_{2}O_{3}$. From XRD measurement, quartz was mainly observed in both samples. Kaolinite was also observed, also in both samples, but Feldspar was only observed in KJ sample. Adsorption of metal ions on the loesses were reached at equilibrium by shaking for about 30min. The adsorption of Cr(III) ion was higher than that of Cu(II) oand Pb(II) ions. The order of amount adsorbed among the investigated ions was Cr(III)>Pb(II)>Cu(II). In acidic solution, the adsorptivity of loesses was increased as pH increased. The adsorption of Cr(III) ion on the loesses were fitted to the Freundlich isotherms. Freundlich constants(1/n) of KJ and YIK loesses were 0.54 and 0.55, respectively.

• Journal of Powder Materials
• /
• v.15 no.6
• /
• pp.450-457
• /
• 2008

The objectives of this study were the development of a synthesis technique for highly active nanosized ITO powder and the understanding of the reaction mechanisms of the ITO precursors. The precipitation and agglomeration phenomena in ITO and $In_{2}O_{3}$ precursors are very sensitive to reaction temperature, pH, and coexisting ion species. Excessive $Cl^-$ ion and $Sn^{+4}$ ions had a negative effect an synthesizing highly active powders. However, with a relevant stabilizing treatment the shape and size of ITO and $In_{2}O_{3}$ precursors could be controlled and high density sintered products of ITO were obtained. By applying the reprecipitation process (or stabilization technique), highly active ITO and $In_{2}O_{3}$ powders were synthesized. Sintering these powders at $1500^{\circ}C$ for 5 hours produced 97% dense ITO bodies.