• International Journal of Highway Engineering
• /
• v.20 no.3
• /
• pp.1-9
• /
• 2018

PURPOSES : In order to evaluate a crack resistance at cold joint, sealing tape was adopted to apply at cold joint instead of typical tack coat material(RSC-4). The sealing tape was made by hot sealing material. The crack resistance as function of environmental and traffic loading was measured with visual observation. METHODS : In this study, the crack resistance was evaluated as function of environmental and traffic loading. The freeze-thaw method was adopted for environmental loading of asphalt pavement. condition. The damage of cold joint under freeze-thaw action is initiated by ice expansion load and accelerated by the interfacial damage between new and old asphalt pavement. The traffic loading was applied with wheel tracking machine on the cold joint area of the asphalt pavement for 3 hours at $25^{\circ}C$. The evaluation of crack resistance was measured with visual observation. The freeze-thaw results shows that the sealing tape was significantly increased the crack resistance based on. RESULTS : To estimate the crack resistance at cold joint area due to the environmental loading, the Freeze-thaw test was conducted by exposing the product to freezing temperature(approximately $-18^{\circ}C$) for 24 hours, and then allowing it to thaw at $60^{\circ}C$ for 24 hours. The tack coat material(RSC-4) was debonded after 21 cycles of the Freeze-thaw test. The first crack was observed after 14 freeze-thaw cycle with RSC-4 material. But, the sealing tape was not debonded after 24 cycle test. Also, the sealing tape shows the better performance of the crack resistance under the traffic loading with wheel track test. The crack was generated the under traffic loading with RSC-4(tack coating), however, the crack was not shown with sealing tape. It indicates that the sealing tape has a strong resistance of tensile stress due to traffic loading. CONCLUSIONS :Based on limited laboratory test result, a performance of crack resistance using the sealing tape is better than that of general tack coat material(RSC-4). It means that the sealing tape is possible to extend a pavement service life because the crack, one of the main pavement distresses, will be delayed.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2003.10a
• /
• pp.134-135
• /
• 2003

The dental implant materials required good mechanical properties, such as fatigue strength, combined with a high resistance to corrosion. For increasing fatigue resistance and delaying onset of stress corrosion cracking, shot peening has been used for > 50 years to extend service life of metal components. However, there is no information on the electrochemical behavior of shot peened and hydroxyapatite(HA) coated Ti-6Al-4V alloys. To increase fatigue strength, good corrosion resistance, and biocompatibility, the electrochemical characteristics of Ti/TiN/HA coated and shot peened Ti-6Al-4V alloys by electron beam physical vapor deposition(EB-PVD) have been researched by various electrochemical method in 0.9%NaCl. Ti-6Al-4V alloys were prepared under the condition of hydrogen and vacuum arc furnace. The produced materials were quenched at 1000$^{\circ}C$ under high purity dried Ar atmosphere and were hold at 500$^{\circ}C$ for 2 hrs to achieve the fatigue strength(1140㎫) of materials. Ti-6Al-4V alloys were prepared under the condition of hydrogen and vacuum arc furnace. Shot peening(SP) and sand blasting treatment was carried out for 1, 5, and 10min. On the surface of Ti-6Al-4V alloys using the steel balls of 0.5mm and alumina sand of 40$\mu\textrm{m}$ size. Ti/TiN/HA multilayer coatings were carried out by using electron-beam deposition method(EB-PVD) as shown Fig. 1. Bulk Ti, powder TiN and hydroxyapatite were used as the source of the deposition materials. Electrons were accelerated by high voltage of 4.2kV with 80 - 120mA on the deposition materials at 350$^{\circ}C$ in 2.0 X 10-6 torr vacuum. Ti/TiN/HA multilayer coated surfaces and layers were investigated by SEM and XRD. A saturated calomel electrode as a reference electrode, and high density carbon electrode as a counter electrode, were set according to ASTM GS-87. The potentials were controlled at a scan rate of 100 mV/min. by a potentiostat (EG&G Co.273A) connected to a computer system. Electrochemical tests were used to investigate the electrochemical characteristics of Ti/TiN/HA coated and shot peened materials in 0.9% NaCl solution at 36.5$^{\circ}C$. After each electrochemical measurement, the corrosion surface of each sample was investigated by SEM.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.35 no.1
• /
• pp.1-7
• /
• 2002

To study the increased resistance in fish against Vibrio vulnificus known as an important agent of vibrio septicemia in human, we analyzed specific and nonspecific immune response in flounder after administration of V. vulnificus bacterins by oral route. It contained the comparison of antibody concentrations in the sera of flounder after oral administration by two different protocols with uncoated heat killed bacterin of V vulnificus (UHKB, 20 mg/kg body weight), i.e., 4 weeks continuously (group 4W) and taking 2 weeks resting period between the 1st and last week of administration (group 1-2-1W). Even though, 1-2-1W group showed significantly increased level of specific antibody in serum, it did not reach to that of 4W group. Certainly, flounder vaccinated twice a week for four weeks (20 mg/kg b.w.) showed increased concentration of specific antibody against V. vulnificus at week 2 after last administration by oral route and maintained throughout the experimental period. It also was confirmed by the increased numbers of specific antibody secreting cells (SASC) in the leukocytes isolated from the splenocytes of the flounder of 4W group at week 1 after last administration until the end of experimental period. However, enteric, acid-resistant film coated heat killed bacterin (ECHB) did not show both greater immune reaction for antibody production and faster elimination of a challenge dose of V. vulnificus compared with those of the UHKB. These results suggested that UHKB administered by oral route was very effective method to prevent the contamination of V vulnificus in flounder, and did not show the increased antigenicity by coating the surface with acid-resistant film.

• The Korean Journal of Archival Studies
• /
• no.1
• /
• pp.23-76
• /
• 2000

In this paper, I examined what have been researched and determined about preservation strategy and selection of preservation media in the western archival community. Archivists have primarily been concerned with 'preservation' and 'use' of archival materials worth of being preserved permanently. In the new information era, preservation and use of archival materials were faced with new challenge. Life expectancy of paper records was shortened due to acidification and brittleness of the modem papers. Also emergence of information technology affects the traditional way of preservation and use of archival materials. User expectations are becoming so high technology-oriented and so complicated as to make archivists act like information managers using computer technology rather than traditional archival handicraft. Preservation strategy plays an important role in archival management as well as information management. For a cost-effective management of archives and archival institutions, preservation strategy is a must. The preservation strategy encompasses all aspects of archival preservation process and practices, from selection of archives, appraisal, inventorying, arrangement, description, conservation, microfilming or digitization, archival buildings, and access service. Those archival functions should be considered in their relations to each other to ensure proper preservation of archival materials. In the integrated preservation strategy, 'preservation' and 'use' should be combined and fulfilled without sacrificing the other. Preservation strategy planning is essential to determine the policies of archives to preserve their holdings safe and provide people with a maximum access in most effective ways. Preservation microfilming is to ensure permanent preservation of information held in important archival materials. To do this, a detailed standardization has been developed to guarantee the permanence of microfilm as well as its product quality. Silver gelatin film can last up to 500 years in the optimum storage environment and the most viable option for permanent preservation media. ISO and ANIS developed such standards for the quality of microfilms and microfilming technology. Preservation microfilming guidelines was also developed to ensure effective archival management and picture quality of microfilms. It is essential to assess the need of preservation microfilming. Limit in resources always put a restraint on preservation management. Appraisal (and selection) of what to be preserved was the most important part of preservation microfilming. In addition, microfilms with standard quality can be scanned to produce quality digital images for instant use through internet. As information technology develops, archivists began to utilize information technology to make preservation easier and more economical, and to promote use of archival materials through computer communication network. Digitization was introduced to provide easy and universal access to unique archives, and its large capacity of preserving archival data seems very promising. However, digitization, i.e., transferring images of records to electronic codes, still, needs to be standardized. Digitized data are electronic records, and st present electronic records are very unstable and not to be preserved permanently. Digital media including optical disks materials have not been proved as reliable media for permanent preservation. Due to their chemical coating and physical character using light, they are not stable and can be preserved at best 100 years in the optimum storage environment. Most CD-R can last only 20 years. Furthermore, obsolescence of hardware and software makes hard to reproduce digital images made from earlier versions. Even if when reformatting is possible, the cost of refreshing or upgrading of digital images is very expensive and the very process has to be done at least every five to ten years. No standard for this obsolescence of hardware and software has come into being yet. In short, digital permanence is not a fact, but remains to be uncertain possibility. Archivists must consider in their preservation planning both risk of introducing new technology and promising possibility of new technology at the same time. In planning digitization of historical materials, archivists should incorporate planning for maintaining digitized images and reformatting them in the coming generations of new applications. Without the comprehensive planning, future use of the expensive digital images will become unavailable. And that is a loss of information, and a final failure of both 'preservation' and 'use' of archival materials. As peter Adelstein said, it is wise to be conservative when considerations of conservations are involved.