• 한국의학물리학회:학술대회논문집
• /
• 한국의학물리학회 2003년도 제27회 추계학술대회
• /
• pp.69-69
• /
• 2003

Flat panel based digital radiography (DR) systems have recently become useful and important in the field of diagnostic radiology. For DRs with amorphous silicon photosensors, CsI(TI) is normally used as the scintillator, which produces visible light corresponding to the absorbed energy. The visible light photons are converted into an electric signal in the amorphous silicon photodiode. In order to produce good quality images, we need to understand the detailed behavior of DR detectors in radiation. We, therefore, investigated the relationship between DR outputs and X -ray in terms of absorbed energy, using the SPEC-78, X-ray energy spectrum model. We calculated the total filtration of X-ray equipment measuring air exposure and this value was used in the calculation of absorbed energy. The relationship between DR output and the absorbed energy of the X-ray was obtained by matching the absorbed energy with pixel values of real images under various conditions. It was found that the relationship between these two values was almost linear. The results were verified using phantoms made of water and aluminium. The pixel value of the phantom image was estimated and compared with previous results under various conditions. The estimated pixel value coincided with the results, although the effect of scattered photons introduced some errors.

• Journal of Pharmaceutical Investigation
• /
• 제41권4호
• /
• pp.239-247
• /
• 2011

Simvastatin is an inhibitor of 3-hydroxy-3-methylglutaryl-coenzyme A (HMG-CoA) reductase, which catalyzes the conversion of HMG-CoA to mevalonate, an early and rate-limiting step in the biosynthesis of cholesterol. Simvastatin has good permeability, but it also has low solubility (BCS class II), which reduces its bioavailability. To overcome this problem, a solid dispersion is formed using a spray-dryer with polymeric material carrier to potentially enhance the dissolution rate and extend drug absorption. As carriers for solid dispersion, Gelucire$^{(R)}$44/14 and Gelucire$^{(R)}$ 50/13 are semisolid excipients that greatly improve the bioavailability of poorly-soluble drugs. To avoid any toxic effects of an organic solvent, we used aqueous medium to melt Tween$^{(R)}$ 80 and distilled water. The structural behaviors of the raw materials and the solid dispersion were analyzed by differential scanning calorimetry (DSC), powder X-ray diffraction (PXRD) and scanning electron microscopy (SEM). The DSC and PXRD data indicated that the crystalline structure of simvastatin was transformed to an amorphous structure through solid dispersion. Then, solid dispersion-based tablets containing 20 mg simvastatin were prepared with excipients. Dissolution tests were performed in distilled water and artificial intestinal fluid using the USP paddle II method. Compared with that of the commercial tablet (Zocor$^{(R)}$ 20 mg), the release of simvastatin from solid dispersion based-tablet was more efficient. Although the stability study is not complete, this solid dispersion system is expected to deliver poorly water-soluble drugs with enhanced bioavailability and less toxicity.

• 한국자기학회지
• /
• 제5권4호
• /
• pp.304-308
• /
• 1995

일차코일에 흐르는 전류에 의하여 코아의 피상 보자력을 측정하여 자기장을 측정 할 수 있는 두개의 플럭스게이트센서로, 두 지점에서 자기장 차이를 측정할 수 있는 플럭스게이트 마그네토미터를 제작하였다. 센서코아는 교류 자기이력곡선상에서 각형성이 좋은 Co-계 비정질리본 $VITROVAC^{\circledR}6030$을 $2\;mm{\times}30\;mm$의 크기로 에칭하여 사용 하였으며, 일차코일 및 이차코일은 각각 315회 권선하였다. 두 센서의 일차코일은 외 부 자기장의 차이를 측정하기 위해 같은 극성으로 병렬로 연결하였고, 이차코일은 직렬 연결하여 적분하므로서 두 코아의 평균 자속밀도를 얻게 하였다. 본 연구에서 제작 한 자기장 차이 측정용 플럭스게이트 마그네토미터는 $1.6{\times}10^{6}V/T$의 민감도와 1 Hz 주파수 대역폭에서 1nT의 분해능을 얻었다.

• 한국재료학회지
• /
• 제20권9호
• /
• pp.488-493
• /
• 2010

Geopolymer is a term covering a class of synthetic aluminosilicate materials with potential use in a number of areas, but mainly as a replacement for Portland cement. In this study, geopolymers with fly ash and meta kaolin were prepared using KOH as an alkali activator and water glass. The effect of water glass on the microstructures and the compressive strength of the geopolymer was investigated. As the amount of water glass increased, the dissolved inorganic binder particles in the geopolymers increased due to polymerization, resulting in a dense microstructure. The meta kaolin-based geopolymer showed a better extent of polymerization and densification than that of the fly ash-based geopolymer. XRD data also suggested that polymerization in meta kaolin-based geopolymers should be active resulting in the formation of an amorphous phase with an increasing amount of water glass. The compressive strength of the geopolymer was also dependent on the amount of water glass. The compressive strength of the geopolymers from both fly ash and meta kaolin increased with an increasing amount of water glass because water glass improved the extent of polymerization of the inorganic binder and resulted in a dense microstructure. However, the addition of water glass to the geopolymer did not seem to be effective for the improvement of compressive strength because the meta kaolin-based geopolymer mainly consisted of a clay component. For this reason, the fly ash-based geopolymer showed a higher value of compressive strength than the meta-kaolin geopolymer.

• 전기화학회지
• /
• 제6권2호
• /
• pp.93-97
• /
• 2003

[ $RuCI_3{\cdot}xH_2O$ ]로부터 제조한 비정질의 $RuO_2{\cdot}nH_2O$을 사용하여 탄탈륨 집전체상의 수퍼캐패시터 전극을 제조하였다. $RuO_2{\cdot}nH_2O$ 전극과 4.8 M 황산 전해액을 사용하여 $RuO_2$ 수퍼캐패시터를 제조하였다. 탄탈륨 박막은 0.0-1.1 V(vs.SCE)에서 안정적임을 AC impedance로 확인하고 수퍼캐패시터에 적용하였다. 루테늄 산화물 수퍼캐패시터는 약 1.0 V(vs. SCE)이상에서 비가역 가수분해 반응이 진행되었다 수퍼캐패시터를 0.5V(vs. SCE)의 protonation leve을 조정하고, 전압범위를 1V로 하여 충방전 시험할 경우 우수한 특성을 나타내었다. 이때 전극전위는 $-0.004\~0.995V(vs.SCE)$의 범위이고 positive 전극 및 negative 전극의 전위범위는 각각 $-0.004\~0.515V(vs.SCE)$ 및 $-0.515\~0.995V(vs.SCE)$이었다.

• 한국분말재료학회지
• /
• 제15권4호
• /
• pp.292-296
• /
• 2008

The electromagnetic (EM) wave absorption properties of the $Fe_{73}Si_{16}B_7Nb_3Cu_1$ nanocrystalline powder mixed with 5 to 20 vol% of Ni-Zn ferrites has been investigated in a frequency range from 100MHz to 10GHz. Amorphous ribbons prepared by a planar flow casting process were pulverized and milled after annealing at 425 for 1 hour. The powder was mixed with a ferrite powder at various volume ratios to tape-cast into a 1.0mm thick sheet. Results showed that the EM wave absorption sheet with Ni-Zn ferrite powder reduced complex permittivity due to low dielectric constant of ferrite compared with nanocrystalline powder, while that with 5 vol% of ferrite showed relatively higher imaginary part of permeability. The sheet mixed with 5 vol% ferrite powder showed the best electromagnetic wave absorption properties at high frequency ranges, which resulted from the increased imaginary part of permeability due to reduced eddy current.

• Macromolecular Research
• /
• 제14권4호
• /
• pp.416-423
• /
• 2006

The dynamic mechanical thermal properties of poly(hexamethylene terephthalate) (PHT), poly(1,4-cyclohexylenedimethylene terephthalate) (PCT) and their P(HT-co-CT) random copolymers in the amorphous state were examined as a function of temperature and frequency. All the samples exhibited two main relaxation processes in the plot of tan ${\delta}$ versus temperature: the primary ${\alpha}$-relaxation associated with the glass transition and the secondary ${\beta}$-relaxation attributed to the local segmental motions of mostly cyclohexylene rings for PCT and to cooperative motions of methylene, carboxyl, and phenylene groups for PHT. Both ${\alpha}$- and ${\beta}$-relaxation temperatures increased with increasing CT content. The activation energy of the ${\alpha}$-relaxation increased with increasing CT content, whereas that of the ${\beta}$-relaxation decreased. The sub-glassy secondary ${\beta}$-relaxation processes of PCT and PHT were investigated in terms of the cooperativity of main-chain segmental motions.

• Bulletin of the Korean Chemical Society
• /
• 제29권2호
• /
• pp.335-338
• /
• 2008

New efficient red emitter having short p?-conjugation length and asymmetric bulky structure, 2-(7-diphenylamino-benzo[1,2,5]thiadiazole-4-ylmethylene)-malononitrile, was synthesized and characterized. Using this material as a dopant, we fabricated electroluminescence device with a structure of ITO/DNTPD/NPD/BTZA (5 wt% in Alq3)/Alq3/LiF/Al. The device exhibited a high brightness of 761 cd/m2 at a driving voltage of 4.8 V, and current efficiency is 0.75 cd/A. The Commission International de IEclairage (CIE) coordinates of the EL device were found to be (0.62, 0.37) at 10 mA/cm2.

• 한국재료학회지
• /
• 제19권4호
• /
• pp.203-206
• /
• 2009

$Sn_XSe_{100-X}$ (15|X|30) alloys have been studied to explore their suitability as phase change materials for nonvolatile memory applications. The phase change characteristics of thin films prepared by a Radio Frequency (RF) magnetron co-sputtering system were analyzed by an X-ray diffractometer and 4-point probe measurement. A phase change static tester was also used to determine their crystallization under the pulsed laser irradiation. X-ray diffraction measurements show that the transition in sheet resistance is accompanied by crystallization. The amorphous state showed sheet resistances five orders of magnitude higher than that of the crystalline state in $Sn_XSe_{100-X}$ (x = 15, 20, 25, 30) films. In the optimum composition, the minimum time of $Sn_XSe_{100-X}$ alloys for crystallization was 160, 140, 150, and 30ns at 15mW, respectively. The crystallization temperature and the minimum time for crystallization of thin films were increased by increasing the amount of Sn, which is correlated with the activation energy for crystallization.

• 한국수소및신에너지학회논문집
• /
• 제9권3호
• /
• pp.111-118
• /
• 1998

The intrinsic degradation behavior of $(V_{0.53}Ti_{0.47})_{0.925}Fe_{0.075}$ alloy with BCC structure and the two plateau regions (the low and high plateau region) has been investigate during the temperature-induced hydrogen absorption-desorption cycling (thermal cycling). After 400 thermal cycles between room temperature and $600^{\circ}C$ under 10atm $H_2$, the total reversible hydrogen absorption capacity decreased by about 40%. From thermal desorption analysis it was found that the degradation behavior at each plateau region was different. In addition, XRD analysis showed that the crystal structure of the sample in de-hydrided state was changed from BCC to BCT after degradation, and that of the sample in hydrided state it was maintained as FCC although peaks were broadened after degradation. From the result of static isothermal hydrogenation treatment it were found that crystal structure change from BCC to BCT was caused by the thermal energy. TEM analysis showed that the peak broadening was due to the formation of an amorphous phase in FCC matrix.