• Journal of Korean Neurosurgical Society
• /
• v.41 no.2
• /
• pp.95-99
• /
• 2007

Objective : The purpose of this reports is to describe the influence of continuous external ventricular drainage [EVD] on delayed ischemic neurologic deficit [DIND] after early surgery in ruptured aneurysmal patients. Methods : The authors reviewed 229 patients with aneurysmal subarachnoid hemorrhage [SAH] who had been treated with clipping at a single institution between 1998 and 2004. Of these, 121 patients underwent continuous EVD [Group A] postoperatively, whereas 108 patients did not [Group B]. EVD was performed at ipsilateral Kocher's point and maintained 2 to 14 days postoperatively. Results : DIND occurred in 15.7% [19 cases] of patients in Group A, 25% [27 cases] from Group B [P value=0.112]. Compared with Group A, Group B was more likely to suffer acute symptom of DIND and showed poor response to 3- H therapy. Major symptoms of DIND in Group A were mild confusion [36.8%] and mild deterioration of mental state [26.3%], contrary to weakness of extremities [59.2%] in Group B. At discharge, Glasgow Outcome Scales [GOS] of Group A were : good recovery [63.2%], moderately disabled [21%], severely disabled [10.5%], dead [5.3%] and Group B : good recovery [48.1%], moderately disabled [37%], severely disabled [14.8%] and dead [0%]. Of 121 patients from group A, 35 patients [28.9%] suffered ventriculitis. Conclusion : Continuous EVD after aneurysmal clipping in patients with SAH reduced the risk of DIND and its sequelae, relieved its symptoms, and improved the outcome.

• Journal of Korean Neurosurgical Society
• /
• v.56 no.6
• /
• pp.455-462
• /
• 2014

Objective : To propose a new measure for effective monitoring of intraoperative somatosensory evoked potentials (SEP) and to validate the feasibility of this measure for evoked potentials (EP) and single trials with a retrospective data analysis study. Methods : The proposed new measure (hereafter, a slope-measure) was defined as the relative slope of the amplitude and latency at each EP peak compared to the baseline value, which is sensitive to the change in the amplitude and latency simultaneously. We used the slope-measure for EP and single trials and compared the significant change detection time with that of the conventional peak-to-peak method. When applied to single trials, each single trial signal was processed with optimal filters before using the slope-measure. In this retrospective data analysis, 7 patients who underwent cerebral aneurysm clipping surgery for unruptured aneurysm middle cerebral artery (MCA) bifurcation were included. Results : We found that this simple slope-measure has a detection time that is as early or earlier than that of the conventional method; furthermore, using the slope-measure in optimally filtered single trials provides warning signs earlier than that of the conventional method during MCA clipping surgery. Conclusion : Our results have confirmed the feasibility of the slope-measure for intraoperative SEP monitoring. This is a novel study that provides a useful measure for either EP or single trials in intraoperative SEP monitoring.

• Progress in Superconductivity and Cryogenics
• /
• v.16 no.2
• /
• pp.29-32
• /
• 2014

The critical current, $I_c$ of HTS superconducting tapes can be measured by transport or contactless method. Practically, the transport method using the four-probe method is the most common. In this study, a simple test procedure by clipping the voltage lead taps have been introduced instead of soldering which reduces time and effort and thereby achieving a much faster measurement of $I_c$. When using a pair of iron clips, $I_c$ value decreased as compared with the measured one by standard method using soldered voltage taps and varies with the width of the clipped specimen part. However, when using a pure Cu clip, both by clipping and by soldering voltage taps give a comparable result and $I_c$ measured are equal and close to the samples specification. As a result, material to be used as voltage clip should be considered and should not influence the potential voltage between the leads during $I_c$ measurement. Furthermore, the simulation result of magnetic flux during $I_c$ measurement test showed that the decrease of $I_c$ observed in the experiment is due to the magnetic flux density, $B_y$ produced at the clipped part of the sample by the operating current with iron clips attached to the sample.

• Asian Journal of Turfgrass Science
• /
• v.4 no.2
• /
• pp.125-131
• /
• 1990

This experiment was carried out in drder to study the changes of morphological characters and thatch weight on N-level and survey times N-levels were 0, 21, 28, 35, 42 and 49 g/m$^2$), respectively. The results are as follows. 1. Thatch weight was significantly different among survey times, and the interaction of survey time N-level. 2. The growth of Zoysia grass and thatch accumulation were incresed by higher N~level The highest value was obtained in all survey times. 3. Most survey characters and thatch accumulation was decreased by growth progressed. 4. Thatch increase rate(TIR) was the lowest at 28g Nm$^2$and T2-T3 period. 5. TIR was the positive significant correlated(P<0.05) with N-level, root weight, clipping weight and thatch weight.

• Journal of Forest and Environmental Science
• /
• v.35 no.4
• /
• pp.223-231
• /
• 2019

Castanopsis indica (Sil Batna) is an ecologically valuable multipurpose indigenous tree species of Bangladesh. Considering its high value but poor natural regeneration due to seed dormancy, the authors conducted an experiment at the Institute of Forestry and Environmental Sciences Chittagong University (IFESCU) during 2012-2013 to find out effective pre-sowing treatments. Ten pre-sowing seed treatments were applied on mature, even-sized seeds namely-control; sandpaper rubbing; nail clipping; immersion in normal water (at room temperature: 24℃) for 24 hrs., 48 hrs. and 72 hrs.; immersion in hot water (80℃) for 1 minute; soaking in 10% dilute H₂SO₄; soaking in 10% HCl for 5 minutes; and sowing in propagator house. Seeds sown after sandpaper rubbing at the distal end revealed best performances by providing highest germination percent (66.7%), germination energy (30%), germination index (0.17), germination rate (0.0145), germination value (30%) and plant percent (66.7%) within shortest period (38 days). The treatment also produced most vigor seedlings with 20.9 cm shoot height, 15 node number, and largest leaves (11.1 cm×2.9 cm). Hence, it is recommended to adopt sandpaper rubbing method for maximum germination and quality seedlings.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.1C
• /
• pp.9-17
• /
• 2004

We present a performance improvement of Binary CDMA by flattening the correlation values. A Binary CDMA system, in which multi-leveled transmission signal of multi-code CDMA is clipped into a binary value, is cost-efficient since the strict linearity of the power amplifier is relieved. However, a loss of orthogonality among user channels due to the clipping causes the correlation values at the receiver to have a random distribution. If the correlation value for even a single channel goes too low, the average BER drops considerably. We developed a method of correlation flattening, where the binary chip pattern at the transmitter is adjusted so that the correlation values have averaged magnitude. Experimental results on several spreading codes show that the correlation flattening method increases the number of available channels at reduced BER.

• Proceedings of the Korea Contents Association Conference
• /
• 2003.05a
• /
• pp.214-217
• /
• 2003

In this paper, we proposed an efficient blind watermarking algorithm using wavelet transform. The proposed algorithm inserts watermark into the high frequency subbands that were transformed by 1-level wavelet transform of original image. Watermark insertion is achieved by exchanging each the corresponding coefficients in the HL, LH, HH subbands according to be inserted watermark value. And watermark is extracted by the relation of wavelet coefficients without original image. Experimental results demonstrate that watermarked image has a good quality not to be able to be perceptible and is robust various attacks such as JEPG lossy compression, clipping and sharpening.

• Journal of the Korea Society of Computer and Information
• /
• v.9 no.4 s.32
• /
• pp.13-18
• /
• 2004

In this paper, we proposed a new digital watermarking technique. It uses frequency domain of discrete wavelet transform(DWT). watermarking technique is one of the most important tools for DRM(Digital Right Management) We proposed a new algorithm watermark insertion and detection. This technique cleats the watermark sequence using the edge image, spread spectrum technique and DWT. We tested the technique with various attacks. and found that it satisfies the watermarking evaluation criteria. Cox similarity measurement value is more than 6 on the Lena image and PSNR is more than 40dB on JPEG, Collusion. Clopping and Scatting. By the result, we proved that the new technique satisfies the requirement of Digital contents distribution, which are undeletablility tenacity, statistical undetectablility.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.4C
• /
• pp.401-407
• /
• 2010

In this paper, we consider a low-complex companding technique for peak-to-average power ratio (PAPR) reduction in orthogonal frequency division multiplexing (OFDM) systems. For the technique, we propose a novel companding function to compensate the problem of the conventional companding functions which are difficult to design complying with system requirements and deteriorate the bit error rate (BER) performance significantly. The proposed scalable companding function can provide an arbitrary value of the maximum PAPR with which the BER performance changes gracefully. In addition, the proposed companding function can be designed readily according to the PAPR and BER performance required by the system and is observed to provide better BER performance than the conventional clipping and $\mu$-low companding schemes under the similar PAPR condition.

• Smart Structures and Systems
• /
• v.5 no.1
• /
• pp.69-79
• /
• 2009

A non-clipped semi-active stochastic optimal control strategy for nonlinear structural systems with MR dampers is developed based on the stochastic averaging method and stochastic dynamical programming principle. A nonlinear stochastic control structure is first modeled as a semi-actively controlled, stochastically excited and dissipated Hamiltonian system. The control force of an MR damper is separated into passive and semi-active parts. The passive control force components, coupled in structural mode space, are incorporated in the drift coefficients by directly using the stochastic averaging method. Then the stochastic dynamical programming principle is applied to establish a dynamical programming equation, from which the semi-active optimal control law is determined and implementable by MR dampers without clipping in terms of the Bingham model. Under the condition on the control performance function given in section 3, the expressions of nonlinear and linear non-clipped semi-active optimal control force components are obtained as well as the non-clipped semi-active LQG control force, and thus the value function and semi-active nonlinear optimal control force are actually existent according to the developed strategy. An example of the controlled stochastic hysteretic column is given to illustrate the application and effectiveness of the developed semi-active optimal control strategy.